Having problems with your Kenmore 15129 Built-in Dishwasher ?

No water supply

\015 My drain was clogged so i took it apart and cleaned it out. when i put everything back together and turned it on there was no water going into dishwasher to run a cycle. john\015

Answers :

There are a few checks. Try the #1 first and then proceed to the next one til you get water. Here are a few checks:
\015\012
    \015\012
  1. Turn off the supply and disconnect the supply line to the dishwasher, turn the water on to flush the line and to check for flow
  2. \015\012
  3. If you have water to to the supply line, your problem is the water solenoid. Replace the water solenoid.
  4. \015\012
  5. Turn off the supply, and disconnect the supply line at the shut off, turn the water on to check for flow.
  6. \015\012
  7. Shut the water off to the house, disassemblehe shut off, clean debris out of shut off. It may need to be flushed. I recommend using a hose to direct the flow into a 5 gallon bucket while someone cycles the water supply.
  8. \015\012
  9. Replacement of shut off is next.
\015\012
\015\012Please rate this solution.
Repair Help & Product Troubleshooting for Kenmore 15129 Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have Frigidaire FDB956RBC1 diswasher. I have to turn off the water to fix the faucet. When I turned the water back on, water did not go to the diswasher when I used it. The diswasher runs normal except with no water going into it. The water runs find at the facet. There is separate water supply underneath the sink for the faucet and the diswasher. I wonder if there is a mechanism with the dishwasher that stop the water from going into the dishwasher after the water supply been turn off. I did


FRIDG... EXPERT HERE \012\012\012Welcome to fixya\012\012Hello\012\012 \012\012 ... Frigidaire FDB956RB Built-in Dishwasher

Kleenmaid DW8 top washer does not operate. Apparent blockage in the water supply tube which runs up from the bottom water supply. How do I remove the bottom assembly comprising the main filter, waste trap and micro filter? I appears that these must be removed to access the water supply tube mentioned above.


... Dishwashers

No water will enter the dishwasher, There is no problem with the water supply or the supply line. The water flows from the supply line to the dishwasher connector but does not enter the dishwasher.


The water-inlet valve lets water enter the machine. Make sure it's not clogged. There is a screen on the inside of the valve, this sometimes gets clogged up with debris. Check to see if you get power to valve when unit is put into operation ... KitchenAid Dishwashers

My plumber just installed a new water supply line for my dishwasher. Now the pump comes on but no water fills up in the machine. If I fill the bottom of the unit with water, it works just fine. Even though the water supply is ON, it does not pump water into the 'box'. Thanks, Art


You don't know how many times I've heard and found the shutoff valve off or partly turned off. Water entering DW is from line pressure not pumping. Items to suspect (again) the water supply valve (would'nt be the first time a new valve is bad). The ... Whirlpool 24 in. DU915QW Built-in Dishwasher

Dishwasher I have a whirlpool dishwasher that does not appear to be getting hot water. The washer water is cold initially and only seems to get warm once the heater in the base of the machine heats it. The hot water supply line does not get hot so I presume no water is being supplied. Is the water supposed to be hot at the start. If yes could this be caused be a faulty inlet valve and if so how can I check. The dishes are dirty especially on the top rack. Thanks for your help. David


Gendos is on track with his question. I have the same dishwasher and it doesn't get enough hot water to clean the dishes and runs for hours because the heating element wasn't designed to heat water, just maintain it. The only solution we have found ... Whirlpool GU2400XTP Built-in Dishwasher

I installed according to guide, but dishwasher will not fill with water. Pump sounds much too loud to be normal. Wiring was checked three times for correct connections. Water supply was checked twice for water getting through, no leaks and water supply on. Drain hose is connected correctly and is connected to house drain.


You state the water supply is on.\015\012Have you loosened the compression nut at the dishwasher ell to see if you have pressure to the water inlet to the dishwasher?\015\012Remember the dishwasher will always run a little to make sure an ... Whirlpool GU2400XTP Built-in Dishwasher

No water entering the dishwater. water supply is hooked up and water supply valve is in the open position. Could this be a water pump problem or is there a cut off valve entering the back of the washer that could be in the closed position?


No cut off on washer check float switch make sure its free check water valve make sure wires are on it and water getting to it ... Kenmore Dishwashers

My Siemens dishwasher SL34A sometimes makes loud vibration noises from the supply line at the water pump connection. I can turn off the water and back on it will quit, but sometimes starts again. And it does not matter how open or closed the supply line valve is either. I'm told it is likely the water pump, but this model has a combination water pump/motor assembly and I do not care to put another $230 into it. thx, TS.


... Siemens 24 in. SL34A006UC Built-in Dishwasher

Hi. I have a Siemens SE65E331GB Built in Dishwasher with an aquastop system. The problem is that it seems to be stuck at the end of a cycle. The pump is constantly running when stitched on. I won't top after a reset and it continues to run even if you open the door. The water supply light also comes on indicating that there is no water getting to the machine. I have tried resetting the aquastop as per the advice in other threads. This has helped in that the water supply light now stays


... Siemens Dishwashers

Bosch shv55mo3gb Keeps stopping during cycle, when open door the little tap light is on meaning trouble with water, checked supply vavle is on, checked filters and no kinks in hose, if i turn the water supply valve on and off then sometimes you can here the water flow through and it will work again, onlt 13 months old??


Use this link then click on insruction manual download type in the model number remember 0 is a number.I know that sounds condesending but i forgot. I used the manual with the ending aus.\015\012\015\012 ... Bosch 24 in. SHV55M03GB Built-In Dishwasher

No water is getting inside my Bosch dishwasher compartment. Water supply to dishwasher is ok. Checked hose at input of dish washer and water supply is ok. Could pump have packed in? Model 004 920 378. Dishwasher used daily since 1999.


Normal\012 0\012 \012 \012 \012 \012 \012 \012 MicrosoftInternetExplorer4\012 \012\012\012\012\012\012 /* Style Definitions */\012 table.MsoNormalTable\012\011{mso-style-name:"Table Normal";\012\011mso-tstyle-rowband-size:0;\012\011mso-ts ... Bosch Dishwashers

I want to disconnect the water supply. I am replacing this 12 year old slimline smeg dishwasher and they are coming to take it away to morrow. The connection to the water supply is via a grey plastic box with and electrical sign on it ( a lightning flash with an arrow on the end). Although I have disconnected the eletricity supply (unplugged the cable to the machine) I am concerned about what this bos may be. Can I just unplug it?


Hello Henry,\015\012\015\012It's the aqua-stop safety valve and yes, you can just unplug it. Make sure you close the valve on the water-supply first or it's going to get rather messy!\015\012\015\012FYI, the aqua-stop is a sec ... Dishwashers

Water supply to my Bosch SHE43CO5UC/17 dishwasher seems interrupted and not being supplied to the unit. Water supply to the unit is checked and confirmed available. What are the possible causes, i.e. stuck solenoid valve?


Could be a dirty hose filter or faulty inlet valve. Ther could be a leak and the bottom of the unit has flooded activating the flood safety which will cut the water supply. The pressure chamber and/or the hose pressure chamber to sumo could be bloc ... Bosch Dishwashers

Water drips out where the prtable dishwasher hooks up to the water supply. It is not the washer. It looks like it could be an o-ring inside the assembly that hook up to the water supply


... Whirlpool 24 in. DP940PWP Free-standing Dishwasher

Hi there, I have just installed my DX203SK. Conected water supply, waste hose and power supply. Turned it on and there is a noise like its trying. But stop cycle and it is dry. I have tested water and power supply. Please help. Thanks


... Dishwashers

I DISCONNECTED WATER SUPPLY TO STOP LEAK. NOW WHEN I TURN ON THE MACHINE NO WATER ENTERS, IT JUST HUMES. THE WATER SUPPLY IS ON.


... Maytag 24 in. MDB8750A Jetclean II Built-in Dishwasher

DW fills up with water after sitting. When I turn off the water supply it does not fill up. Removed solenoid valve and cleaned the filter and check for possible blockage. Put back together and turned on water supply. did not fill up until we used it for the first time after my fix. Could the solenoid valve not be sealing off completly DW is a Bosch SH5316UC/U12


... Bosch Dishwashers

I have a Miele 590G dishwasher. Everything appears to work except for water supply. Any suggestions about what I could do or what could be broken? I opened the supply connection (the small gray box) and checked the filter - all seems good. But still - no water supply! Thanks in advance. Ross


You must to check also the tap of water which connect water to this small box may the water pressur out from tap is weak .\015\012you can use a small pan to help this test.\015\012 thanks ross ... Miele 24 in. G656SCi Plus SS Built-in Dishwasher

Dishwasher won't start. It keeps beeping and has error msg "check water supply". Water supply should be fine, and we tried turning power supply off/on to reboot. But no luck. HELP!!!


... Thermador DWHD94EP Stainless Steel Built-in Dishwasher

Bosch Dishwasher (model SHU43C05UC17/17) will not power power on after stopping in the middle of a wash cycle. AC power is present at input and water supply is connected and supplying water.


... Bosch 24 in. SHU5305UC Built-in Dishwasher

Bosch Exxcel Dishwasher (Enr SMS53E12GB/01 FD 9002) bought in July 2010. Error code 15 and "Check Water Supply" light on at same time. Have checked in-line filter in tap connection and all clear, water pressure OK, no kinks/twists in supply hose. Any help would be greatly appreciated - I'll have to call Customer Service in the end as it's outside of my problem-solving ability, but would like to check whether there's a known reset or fix I can try before I call.


... Bosch 24 in. SGS47E02 Exxcel Free-standing Dishwasher

Hi My dishwasher DS603 has a fault of F1 code beeping for the whole day. I have no clue that dont know how to do with it. It is not flooding however. I dont know if it has problem due to the water wasnt supplied this afternoon as the pipes are repairing outside. Now we got water supply back and it keeps beeping. i tried to dry it ALL UP but it still beeping. Please give me advice! cheers


... Fisher and Paykel 24 in. DS603H I Built-In Dishwasher

Hi My dishwasher DS603 has a fault of F1 code beeping for the whole day. I have no clue that dont know how to do with it. It is not flooding however. I dont know if it has problem due to the water wasnt supplied this afternoon as the pipes are repairing outside. Now we got water supply back and it keeps beeping. i tried to dry it ALL UP but it still beeping. Please give me advice! cheers


... Fisher and Paykel 24 in. DS603H I Built-In Dishwasher

I have a kenmore ultra wash quietguard deluxe & notice it has been connected to the hot water supply. As I am making some changes I would prefer to connect the cold water supply will this make any difference to the operation of the dishwasher. The unit is less than 2 years old. Thank you


Depends... some units heat the water for you in which case it would not matter and would infact save you money over time. If your unit does not heat the water your going to want to leave it alone for better cleaning performance. Check your owners man ... Kenmore Dishwashers

Can i use my candy aquaviva cd 622 dishwasher if i only have a cold water supply to connect to it - even though it has pipes to connect both hot and cold water supplies?


I strongly advice against it, because the pumps are gonna assume thier is water their and is gonna try to pump the water in, and u will burn them up if their is no water their.. how ever you could get a splitter and run water to both hoses. even thou ... Candy 24 in. CD622 Free-standing Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1095 seconds