Having problems with your Kenmore 15634 Built-in Dishwasher ?

My dishwasher type 280-2 is not cleaning as well as if was are there ways to clean it up, or filters that i am unable to find.


Answers :

Repair Help & Product Troubleshooting for Kenmore 15634 Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My dishwasher type 280-2 is not cleaning as well as if was are there ways to clean it up, or filters that i am unable to find.


... Kenmore 15634 Built-in Dishwasher

I have a Miele G892 SC dishwasher. When I start the cycle, it drains (except for a bit of water left below the triple filter). After that, the intake valve opens and water enters. It then does nothing for a period of time until the "intake/drain" indicator light starts flashing. When I open the unit, I find about 1/2in of water in the tub (above the tripe filter). I have 1. cleaned the intake valve filter (no blockage found) 2. Inspected the drain line at the base of the unit as well as t


The pump is running due to the float switch or the float itself either being stuck open or broken and showing a fault this is why you have water going in to a certain point but not the point required for washing the dishes and then due to the float s ... Miele Dishwashers

JENN-AIR Model number JD3B10AWX. Bottom of dishwasher is dirty, I want to clean it. I have removed six screws holding plate down, but cannot find any way to remove spinning blade. I think there's a filter underneath that I can clean or replace. Questions: 1. How to remove spinning blade? 2. Am I going about this correctly. Thank you


We have been having issues with our model where there is dirty sand deposited inside of glasses and dishes.You need a torque wrench for a triple square torque screw ... Jenn-Air Dishwashers

Whirlpool 8575637 dishwasher, My dishwasher will not drain all the way. I suspect there is a clogged filter somewhere I can't find. I have removed the round filter and cleaned it, but still have the problem. Any suggestions?


... Whirlpool GU2400XTP Built-in Dishwasher

We have a Sears Ultra Wash III dishwasher, model 665.1677993, bought in October, 1995. It is not filling with enough water to get the dishes clean. I took the water valve out and looked at it and it seems okay. It doesn't look like the valve is opening all the way - just my guess. A small stream of water comes out with good pressure, but it is a small stream. I can't find any screens or filters in the water line coming in. The fill cycle lasts only about a minute. Is that adequate? Steve


There should be another letter after the p in your model number. If it's just a B then there are no parts available for that model. Typically a dishwasher will fill for 90 seconds or more. One minute or less sounds like you have a control board is ... Whirlpool GU2400XTP Built-in Dishwasher

Hi, we have a Bosch Exxcel dishwasher which mid way through a cycle a button saying Check Water came on. we turned the machine off and opened the door and found loads of water in the bottom. my husband then scooped all the water out and cleaned filter in the bottom, where we did find some bits of plastic from the kids yoghurt pots, and took the water hose off the back and checked for blockages, which there was none. the water is certainly coming from the water pipe through the hose as we tested


Check your water level sensor. And also check to make sure that your pump is working correctly. It sounds like a couple of different things that need to be addressed. First check the water level sensor. It is a tube that is located from the back of t ... Bosch 24 in. SHU43 Built-in Dishwasher

My Kenmore 15632 is not cleaning well at all. The spinning "arm" thing broke off & I can't find my manual to see if there is a way to put the arm back on?


Hi, \012I have an older dishwasher also and recently mywife also complained about it not cleaning right... so me being the man I amtried in vain to clean the things... Bought new spray arms online and installedthem in minutes...now the thing works li ... Kenmore 15632 Built-in Dishwasher

Unit doesn't clean well. Is it normal to find water underneath the round unit at the bottom under the wire mesh filter?


Yes some water is normal.\015\012\015\012Replace the water supply valve under the sink and water supply line to dishwasher.\015\012Over time minerals deposit in the valve and restrict the water flow to the dishwasher.\015\012T ... KitchenAid 24 in. KUDI01FLSS Stainless Steel Built-in Dishwasher

Preventive maintenance? I have a kenmore elite dishwasher 665.13113100 for 1 1/2 yrs - It's working just fine. Should I be cleaning the filters yearly or doing some type of preventive maintenance? I don't find that info in my manuals.


You should buy some c.l.r. (calcium,lime,rust) remover.It's packaged in a grey bottle at any supermarket,drug store,ect.Pour a cup in and run a cycle once a month.This will prevent any lime build up from scaling the dishwasher due to hard water. ... Dishwashers

Have a Kenmore Elite Dishwasher (66513123K701). Was not cleaning dishes very well so we ran diagnostics on it and found a problem with the diverter motor (W10155344) so we replaced it. Now, the dishwasher is leaking from the diverter. There was a o-ring from the original diverter that we had to keep since the new motor did not come with it. Wondering if we should get a new o-ring/seal, but I cannot find mention of such a part anywhere. Is there a certain way to seat the o-ring? Is it ok to


I have experienced the same diverter motor leaking problems. I have the whirlpool gold with the diverter motor (w10155344). I bought the unit new 4 years ago. The fix is remove the the two screws that hold the diverter motor and pull the motor. ... Kenmore Elite Stainless Steel 24" BuiltIn Dishwasher with TurboZone Rotating Spray Jets 13103

I have a KUDS03CTWHO KitchenAid dishwasher. It started not cleaning the upper tray well a few weeks ago and now the lower one is not getting cleaned very well either. I have disassembled and cleaned the 3rd level , upper and lower spray/wash arm assemblies as well as the feed tube assemble. These were not blocked or glogged. There appears to be less spray coming out of the upper and 3rd level spray arms they before but as I said there is no blockage. I also cleaned the bottom filter. There has b


\015\012Hi\015\012\015\012The issue seems to be with the float switch\015\012assembly that is bad and should be replaced. Please check this ... KitchenAid Dishwashers

I have been negligent in not cleaning out the filters and after the unit more or less stopped, I pulled the two filters finding them full of what looked like soap scum. I cleaned them best I could (but noticed the inner filter still had most of the small holes blocked) Started the unit and it cleaned alright for a couple of days. Last night after running a load all the water did not empty from the bottom of the tub? Any suggestion on what wrong? Bought the unit on 1/19/05. Thanks


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks\015\012for using FixYa. Dishwasher not draining properly or not draining at all issues\015\012can arise due to different reasons ... Bosch 24 in. SHX46A02 / SHX46A06 Built-in Dishwasher

Ld-1416T I have an LG LD-1416T dishwasher and the lower spray arm does not turn. The top arm turns and the top rack is washed well. I pulled everyting out and cleaned all the filters (which weren't that dirty) but still no luck. I could only get so much stuff out to clean before it looked like to go any further, I would need to gain access through the bottom. Are there more filters in the motor area which might need cleaning? I read that it could be the vario motor. Can I test this? and if s


If you have one spray bar working then there is enough pressure. There is only one pump. So you should check the spray bar to see if it is plugged. Also check the seals to see if they are bad. ... LG Dishwashers

I've a Kenmore - Whirlpool dishwasher purchased in 7/2002(665.17574200), which seems clogged. T The ''Accumulator Assembly'' (8268429) filter is clean, and I've stripped the unit down to the plastic components. This has happened once before, and the repair person cleaned some kind of secondary filter, but I can't locate that filter on the parts diagram. I'm guessing it's below the ''Protector inlet'' (8268390). Either I buy a new dishwasher, which seems a waste, or I find out how to clear the


... Kenmore 24 in. 17572 Built-in Dishwasher

Like sand Not getting the dishes clean it seems like sand and other stuf in the glasses :( cant find any extra filters , have clean the regular ones in the bottom of the machine. Please can someone help me find a solution or find a manual online.


Clean out both top and bottom spray arms\015\012Deep Diver ... Bosch 24 in. SHU5305UC Built-in Dishwasher

After running our dishes through a wash cycle we noticed there was still a lot of food stuck on the plates & glasses etc. We cleaned out the trap but due to the murky water in the well, we also pulled out the racks & removed the bottom plate. The underside was greasy and had a lot of grim stuck to it as well as the bottom of the drawer itself. We washed the filter trap, swing arm and plate in the sink. We loaded it with the dishes that previously did not come clean and ran a full cycle. The


Hi,\012\012\012\012\012I\012have an older dishwasher also and recently my wife also complained\012about it not cleaning right... so me being the man I am tried in vain\012to clean the things... Bought new ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Hobart LX30 Thank you for your help earlier. I figured out a way to get the machine running on 220. Now my problem is finding the intake for the sanitizer and detergent. I have looked all over the machine and I cant find tubes anywhere. The guy I bought it off of tells me that when the water temp is over 170 you don't need any cleaning products. I just want a second opinion. I feel that our glassware is not as clean as we would like. Any thoughts?


I'm not sure I'm comfortable with the direction your seller is leading you. I assume this machine is installed in some type of place where you are serving food to the public. If this is the case, then the local health inspector will expect to see a w ... Hobart 24 in. LXIH-3 Built-in Dishwasher

It keeps tripping the fuse. Have tried cleaning the filters - well, have cleaned the filters that immediately accessible, I assume those are the only ones. Changed fuse in plug, too, but that didn't make any difference.


Hello , the fuse will blow because theres a dead short in the dishwasher. 1 check the element with a multimeter this may have shorted to ground also there a possibility that the motor may have a short.then check the circuit board for any burn't par ... Siemens 24 in. SE25A266 ExtraKlasse Free-standing Dishwasher

Our Kenmore dishwasher 665.1726 doesnt seem to be cleaning as well. LAst time this happened a serviceperson cleaned out a filter where food debris had clogged the water flow. We were able to take off the bottom wash arm but couldn't figure out how to get the filter off (there are 4 screws holding it in place and one is under the plastic arm that caries water to the sprayer.


I had the same problem!\015\012\015\012The arm WILL come off....you have to pull the screen off. ... Kenmore 24 in. 15689 Built-in Dishwasher

My Thermador dishwasher DWHD64EP/54 does not get the dishes clean. We checked all the usual things--water to the dishwasher is hot, filters clean, spray arms working and not clogged, detergent cups working, proper amts of detergent etc. We find that no steam is produced during the cycles, we find that the when choosing a cycle and power boost incorrect cycle times are now displayed compared to previous usage when the dishwasher ran normal. Some of the longer cycles now show only 24 min


... Thermador DWHD64EP Built-in Dishwasher

I have a GE Profile, GSD4930X73WW, dishwasher. The upper wash arm is not spraying well at all. I checked the water line from the pump to the upper arm and it's fine. I cleared the filters and cleaned the float. I also took the inlet valve off and cleaned the screen. Although the washer works better overall, the upper arm still does not work well. Nothing appears to be in the upper arm assy to clog water from spraying out. All seems clear from the turbid sensor (next to the pump) through t


... GE Dishwashers

Intake/Drain light is on. First flashed F13. Cleaned the water intake filter;cleaned the triple filter and drain pump.Light continues to stay on-it seems as if no water in coming in the dishwasher. Water supply is on all the way.


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks for using FixYa. F13 is a\015\012flow meter error; unfortunately there is no way to reset it so you’ll have to\015\012get ... Miele Dishwashers

Poor cleaning after cleaning, there is a gritty type residue on the cups and dishes. On the inside door i see dirt type particles as well. The unit is 3 years old and has been operating terrific till now. Can u suggest what i can do to resolve this problem. Thank you..Joe


I also have the same problem. My dishwasher is about the same age and there is a terrible film on everything. A vinegar rinse helps, but you can't do that everytime ... Whirlpool Gold 24 in. Built-In Dishwasher Dishwasher

I have a whirlpool dishwasher model adp 5550 condenser. The dishes do not get clean. I have had a repair man out twice and he replaced the soap dispenser on Friday but it still doesn't work. I went to the store today and bought every cleaning things I could find for dishwashers and also started to investigate online myself. I took the arms off and cleaned them, I took the filter out and cleaned it, and then I noticed that the plastic bar that runs from the top, along the back and into the bottom


... Dishwashers

GE quietcare 3 dishwasher doesn't clean dishes well. Is there a filter or something that needs to be cleaned? Dishes come out 1/2 clean, 1/2 not clean.


... GE Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1428 seconds