Having problems with your Kenmore 15762 Dishwasher ?

Kenmore Dishwasher 5871525 stops running after a few minutes

\015 The dishwasher fills up and after about 3-5 mins the unit stops working and the the normal wash (which is the cycle I select) and the washing indicator lights start to flash. This started last night and I opened the door and started the unit with it opened to see what was happening and the water started to shoot and then would stop and kept on repeating this every few seconds. Then it would start again for a few minutes, then stop again. Tried to use it today (after performing a hard reset by shutting it down in the circuit box) but after it filled up it once again stopped working but this time it did not start up again at all.\015

Answers :

Sounds like a stuck key pad since you said the normal wash button flashed.. the other thing is try holding the door shut while you run it.. to see of it is maybe not latching properly..
Repair Help & Product Troubleshooting for Kenmore 15762 Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

665.15824000 dishwasher Kenmore 665.15824000 dishwasher will NOT complete cycle. Conter stops @ 42 minutes and it runs and runs and runs.....


What is your water temp. This model has 4 automatic water heat cycles built in to it and it heats the water to 145 degrees and won't let advance till that temp. If the water coming in is lower than 120 degrees it will add about 2 hours to your normal ... Dishwashers

Kenmore Dishwasher 5871525 stops running after a few minutes


Sounds like a stuck key pad since you said the normal wash button flashed.. the other thing is try holding the door shut while you run it.. to see of it is maybe not latching properly.. ... Kenmore 15762 Dishwasher

My Bosch integrated dishwasher(model SGV56A03 GB/12) runs through the cycle but doesn't stop at the end of the cycle. It continues to heat water and it sounds like the motor is running even though the time indicator shows 0 minutes. I have to manually switch it off. Any ideas before I call out an engineer. I have checked all the filters etc included in the troubleshooter info anf there are no blockages.


... Bosch Dishwashers

Kenmore 15895 dishwasher, stopped running. There is an 18 in the display and after a day or so of sitting the pots and pans light comes on steady with 18 going out. The only reponse from the controls is that it sounds like it is doing something for a minute and stops.


Hi\015\012\015\012 \015\012\015\012Thanks for using FixYa. To resolve this you will have to reset the console. Do this\015\012by closing the door and press these buttons in sequence... ... Kenmore Dishwashers

Dishwasher keeps running I have a Bosche dishwasher and the water keeps running. As long as we run it and don't stop it, the pump will continue to drain about every 3 minutes. The water just keeps running though. If we open it to empty the dishes, the cycle will stop. But the water keeps running, filling the tub, and then overflows, flooding the kitchen and drains through our wood floors to the basement below. Our ASKO seems to have a similar problem. I started the dishwasher, and the water ke


Open up the door, get out the control unit. Pry open the unit's plastic case and look at the board. Burnt spot? If so, the heater circuit burnt out (happens a lot on Bosches) and the control is waiting for the water temp to rise, but of course it ... Bosch SHU43C05 Stainless Steel Built-in Dishwasher

My kenmore dishwasher, model 15822, just stopped working. The quick rinse light is blinking. The only other buttons that work are the pots & pans light which blinks when pushed, and the cancel button which will run through the 2 minute cancel cycle.


These are known to develop sticky switch contact pads. They stick in the contacted position and stifle the panel. Sometimes heat can be applied with a hair dryer to release them and make the unit function again. This is more than likely a temporary f ... Kenmore Dishwashers

I have a Kenmore dishwasher model #17519200. I loaded it last night as usual and closed the door. I pressed the wash cycle I wanted and pressed the start button. I heard it starting to fill with water as usual. After it filled with water it should have gone into the wash cycle mode but it just started making a buzzing noise for about a minute or two then just stopped. I pressed cancel to drain it and it drains fine. I have kept trying to re-run it but it just does the same thing I described.


... Dishwashers

8 years ago we bought a model 665 Kenmore Limited edition Stock #575-0 if you need that. A certified kenmore tech. has been out here 3 times with still no clear answer. The problem is when you run a standard cycle of 95 minutes it counts down to 78 minutes and stays at that time for about 45 minutes then stars counting down again till 42 minutes then stops at that time for about another 45 minutes then coutinues till it finishes the wash and drying cycle. It runs and sounds fine the entire time


Sounds like timer prob.would rec. replacing timer ... Dishwashers

My dishwasher has stopped mid cycle showing 1 minute left , when stopped and started again it now shows 28 minutes contantly, plus it continues to run (ie pump running) after the door is open. Any ideas ? many thanks Doug


Hey dcp667\015\012\015\012Dishwashers are incredibly durable machines. They can take years of daily use and in many cases, it's only a change in decor that brings about a replacement. Of course that doesn't mean things never go wrong with ... Dishwashers

Hi , i have westinghouse dishwasher model SB915SJ. when i put it to wash on eco normal, it stops a after about 20 minutes and i have to press the program button to start it working again. it's currently running now but it stops about every 4 minutes and the numebr 20 appears in the display screen. if i push the program button it will rung for another 4 minutes then stop, start beeping and the number 20 appears. how can i fix this?


Www.westinghouse.co.nz/...westinghouse/.../NZ_WH_Dishwashers_May06.pdf \015\012\015\012\015\012\015\012Above is your user manual, and below is your service and repair manual.\015\012 ... Westinghouse Dishwashers

I have a Kenmore Ultra Wash Dishwasher (Model Number 665.15634) that will not fill up properly. When I try to run a cycle (any cycle), the first thing the dishwasher should do is fill up with hot water. But in my case, my dishwasher fills for about 10 seconds, then stops. Then tries to fill again for about 7 seconds, then abruptly stops again. And this process goes on and on and on. The dishwasher never fully fills up nor starts the wash sequence properly. Once the dishwasher fills up, it


... Dishwashers

I have a Kenmore dishwasher model # 66513449K900 that will not stop running. I think it is stuck on the drain cycle. I can start the dishwasher on a cycle and it appears to clean the dishes, but after the cycle is complete, it continues running and running (on the drain cycle) until you open the door. What could this be?


It is possible that the machine does not move off the cycle because there are errors or back feedback from the inputs. For the program to end the main program controller must receive the feedback so as to switch off the circuit at the end o ... Dishwashers

When I press the start button, Bosch dishwasher (model SHY56A 05UC) just keep running the motor pumping the water out of dishwasher, irrespective of: 1) the wash cycle it is on, 2) whether the door is closed or open, 3) whether I cancel drain cycle, as told by Bosch Cust Svc in following steps: - "Cancel Drain" by pressing 'Quick Wash' and 'Regular Wash' buttons together for a minute until it shows 0* - Shut power off for a minute and wait for a minute - Restart on Quick Cycle. Paid


What is happenig i believe and has happened to me 2 times is that the water level float that is on the left side of dishwasher is stuck.\015\012\015\012Either remove side panel and flick lever or pull dishwasher out and tap lower portion ... Bosch SHY56A02 / SHY56A06 Built-in Dishwasher

Dishwasher issues hotpoint dishwasher model HDA1200 used for a year and put into storage for a year. reinstalled this weekend. dishwasher was fussy about the door latch for a minute...door latch did not want to engage all the way...but went into its cycle. we stopped it and added a few dishes for a test run it started right up and ran about 8 minutes and shut itself down. it will not restart. the power supply is ok. no leakage about the door once latch engaged. what can we do?


It can be the 10A fuse located in the back of the machine. but.... storage is kind of a problem with determining what is wrong with it.\015\012Mouse can have chewed the wires, moisture can have rusted or corroded some components.\015\012C ... Hotpoint 24 in. FDW60 Free-standing Dishwasher

The dishwasher starts, runs for a few minutes and stops. Wait about 10 to 15 minutes and it starts again only to stop once more. After a couple times of doing this it does not want to restart.


... Whirlpool DU930PWS Built-in Dishwasher

The dishwasher starts, runs for a few minutes and stops. Wait about 10 to 15 minutes and it starts again only to stop once more. After a couple times of doing this it does not want to restart.


... Whirlpool DU930PWS Built-in Dishwasher

Dishwasher stops running 15 to 20 minutes into the cycle


... KitchenAid Dishwashers

Bosch SHU43 My Bosch SHU43C dishwasher stopped washing, turns out the impella came free from the motor, I repairded impella and put it back together and now the dishwasher washes great however now it is stuck in a wash rinse drain cycle. Display counts down but the unit never stops running when it reaches 0. Also, the water level is higher than normal and I there is a kind of thumping sound repeatedly every 15 seconds " use to make that sound only once at the start of a cycle before the impella


Sounds like the control module is out -- cost about $100 (I am on my third). I got a "lifetime" warranty when buying my second one. If you are handy, you can replace it yourself. You can call Bosch to confirm this (I did). It mounts inside the door. ... Bosch 24 in. SHU53 Built-in Dishwasher

My dishwasher SL34A015UC / 29 does not complete it's cycle. The cycle will stop with 1 minute left in the rince cycle and continue to run for hours, showing just one minute left. The dishes are not geting clean and there is a unplesent odor inside. I can hear the water draining during the cycle. The drain line is clear and there is plenty of water in the dishwasher. Any thoughts?


... Siemens SL5A70UC 24 in. Built-in Dishwasher

Kenmore 665.15912001 DISHWASHER RUNS BUT DISPLAYS ERROR MESSAGE Instead of displaying the number of minutes in the cycle when I push the cycle selector button and then the start button, it starts as soon as I push the cycle selector, without waiting for me to push start; meanwhile, it displays "_J" instead of the number of minutes in the cycle. It washes the dishes but not well, lots of food debris. Some people in this forum have described running a diagnostic on this machine; how do you do that


... Kenmore 15912 Built-in Dishwasher

When I start the dishwasher, it sounds normal. A few minutes after it starts, it makes a loud, thumping noise that lasts for several minutes. After a while, it stops making noise, but about half way through the cycle, it starts making the loud, thumping noise again. It's loud, annoying, and does not get our dishes clean. We have to wash several dishes by hand AFTER we have run the dishwasher.


I have made the assumption that your d/w is a siemens machine, however if not pls repost with the make and model.\015\012There are a few possibities...check the spray arms are clear by removing any blockages in the holes, check that there ... Dishwashers

My dishwasher will not stop running. The timer gets to one minute and will not stop. When i open the door the water is full of suds. When i close the door the timer resets to 13 minutes and continues to wash.


Hi, this is timer failure. simply replacing the timer module(control) will fix this issue. ... Bosch SHU5307UC Built-in Dishwasher

Hi I have a DS605SS Fisher & Paykel Single Drawer dishwasher, I rent the house and the landlord says that it is quite new can you please confirm the year? Also when we turn it on it runs for like 20 minutes then stops then when you try to start the cycle up again it stops after a minute and wont start again.


Heeeyyy - these have been around for ages no one can tell you the age unless you bought it and know where it was bought from to trace the serial numbers...\012\012I fail to understand why this is your problem when you are renting the hous ... Fisher and Paykel DS605SS Built-in Dishwasher

Kenmore elite dishwasher model 665 15912001 runs but stops counting down at 76 on the normal cycle


... Kenmore 15912 Built-in Dishwasher

Dishwasher starts running for 2 minutes then stops


The first 2 minutes of the cycle is a pump out cycle followed by a brief pause then a water fill cycle.Make sure the water is getting to the water valve underneath. Check the water valve for power with a volt meter just after the pump out cycle. No p ... Whirlpool Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.2099 seconds