Having problems with your Kenmore 15762 Dishwasher ?

Kenwood KDW12ST3A Kenwood Dishwasher 18 months old intermittently shows E1 Thank you in advance


Answers :

E1 indicated long filling time. Perhaps the inlet filter has clogged. Check the inlet pipe and tap(faucet in usa).
Repair Help & Product Troubleshooting for Kenmore 15762 Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Kenwood KDW12ST3A Kenwood Dishwasher 18 months old intermittently shows E1 Thank you in advance


E1 indicated long filling time. Perhaps the inlet filter has clogged. Check the inlet pipe and tap(faucet in usa). ... Kenmore 15762 Dishwasher

Leaking dishwasher leaks intermittently. I removed the side panels and there is no sign of water in the base of machine. Door seal seams to be intact. What else can I check. Seal that needs replacing? Machine is 18 months old. seams to leak on the right side of the machine. Please advise. many thanks. My dishwasher showed the error code either OE or E1, I think it was more OE. I stuck my hand in the filter in the bottom of the machine and then it was okay but the next time it was used it leake


What sort of soap powder do you use\015\012some soap powders foam a lot in machine causing dishwasher to leak through seals\015\012also check that the machine is square that is the door is closing parallel with cabinet\015\012do no ... Dishwashers

I have a Kenwood KDW12ST3A that intermittently shows E1 Thank you in advance for your help.


Hi\015\012\015\012E1 means no inlet pressure. Sometimes fault code shows if machine takes too long to fill. Kindly check for blockage in inlet pipe. Also check if water inlet is not filling and check if the water outlet valve is ... Dishwashers

Hi I have a Zanussi ZDF501 dishwasher that stopped heating up intermittently. It got worse and I fitted a new heater and all was ok for a few months. Then the intermittent failure started again. Note that I tested the old heater and it is actually OK without a short circuit so I don't think it was the problem adn can be re-used. Could it be the thermostat or heat sensor? I am concerned it might be the PCB since the failure was intermittent. Thanks Dave


In my case, although the solder joints on the relay looked poor, improving them didn't help. I had to replace the relay. Fortunately, Maplin stock a compatible one, JM67X for 1.99. See ... Zanussi Dishwashers

I have Candy dishwasher A9010 SMART, 7 years old. Two minutes after pressing the start button, it stops and shows error code E4. Thanks in advance


... Candy Dishwashers

Hi my bosch dishwasher is washing but water is not draining. The check water light is comming on after the cycle. Dishwaher is only 3 months old. Have checked out all tapes and conections. Thanking you in advance Sarah


Hi Dishwasher not draining issue occurs due to kinked drain pipe, clogged drain filter or drain pump. Check the drain hose for any visible clogging, remove if present. If no visible lint is present then remove then turn off the dishwasher ... Dishwashers

Whirlpool dishwasher model DUB700XB has quit cycling. Fills with water but will not start wash cycle. Making intermittent humming noise unless the door is open to disengage the switch, even when on stop. No LEDs lighting when rotating the dial through the various cycles. Unit is old and wondering if it's better to buy a new one rather than fix this and have something else go wrong in the not to distant future. Thanks in advance


... Dishwashers

Leaking dishwasher leaks intermittently. I removed the side panels and there is no sign of water in the base of machine. Door seal seams to be intact. What else can I check. Seal that needs replacing? Machine is 18 months old. seams to leak on the right side of the machine. Please advise. many thanks.


There are screws on the inside of the door on a lot of those\015\012try to tighten them down a little sometimes that can cause a leak. ... LG 24 in. LD-12BW5 Free-standing Dishwasher

In my Kenmore elite manual {Dishwasher} Model 665-13109k901 it says to clean the ultra wash filter once a month. Where is it located in the dishwasher the manual doesn't show it. Please help me with an answer. My dishwasher is 6 months old.


... Kenmore Dishwashers

We are on the mainland but our dishwasher is on the island of Maui. We are told that the main control board is out. The dishwasher is only about 4 years old and is used only about 4 months out of the year. Is this a commmon problem with Bosch dishwashers? Is there only one "Main" control board? If so, do you know what the part number is? thank you.


... Bosch Evolution 800 SHE58C02UC 24 in. Built-in Dishwasher

I HAVE A WHIRLPOOL QUIET PARTNER 3 IT IS 38 MONTHS OLD IT IS USED 2-3 TIMES A WEEK BY WHEN I START THE WASHER, ONCE IT KICKS IN, IT DELIVERS THE LOUDEST SHRILL NOISE ONE CAN IMAGINE. IT IS GETTING LOUDER EVERY TIME I USE IT. IN FACT YOU CANNOT HEAR THE TV FOR THE LOUD ''SCHRILLY'' WHINE I AM OUT OF WORK AND HAVE NO MONEY FOR A REPAIRMAN I HAVE A 3 YR OLD HOME AND THIS REALLY BUMS ME OUT ANY IDEAS HOW I CAN SAVE MY WHIRLPOOL? THANKS IN ADVANCE MARTY


... Dishwashers

I have a KENWOOD KDW12ST3A dishwasher. There are no lights in the programme selection pane therefore I can't select a programme. There is power running through the dishwasher because it beeps when turned on. Do you have any idea what may be causing this? Thanks.


... Frigidaire 24 in. FDB1050REC Stainless Steel Built-in Dishwasher

We have a Haier DW12-PFE2-U dishwasher thats 2 years old. The cycle stopped yesterday leaving an amount of water in the bottom and all of the program lights are illuminated with a recurring beeping sound happening. It says in the booklet that the drain hose is too high or bended. But its not. The display does show the time when a cycle is selcted but nothing happens. The dishwasher turns on and off normally. Can this problem be rectified? thanks!


Refer userr guide on page 21. It reads...\015\012\015\012When all the programme indicators " J" blink.\015\012Have you checked whether:\015\012the door is closed properly.\015\012\015\012 ... Dishwashers

I have a credaplan integrated dishwasher with no manual it came with the house so is about 15-20 years old. I want to put salt in it. I have found a compartment with an 's' on it but just want to be sure that this is the right place. I have never owned a dishwasher before. Thanks in advance for your help.


... Creda 24 in. DWI34 Built-in Dishwasher

Where can I get the instruction manual for a Bosch Classixx Dishwasher SGS53C12UK? I have bought a second hand dishwasher that has only been used for 6 months. The programme works fine but when I go to use it again - check water shows on the display. I have to tilt the machine back as water is stored at the base of the machine, surely this is not normal? It there a simple solution to this or alot of cost involved with a new part? Any help would be much appreciated. Thank you.


... Bosch Dishwashers

My dishwasher adp 7570 is only four months old, but it do not clean the dishes properly. I tried to rinse it with sun rinse for dishwashers, but now it wont work. The start lamp blinks, and the display shows F2. The salt lamp lihts red.


... Dishwashers

Black specks There are black specks on my dishes (on the bottom of cups and glasses mostly) after the cycle is complete. My dishwasher is 12 years old. Dishes are otherwise clean. Thanks in advance.


Is that a glass? can't tell. is there water curculating to the top rack? if not you probably have a bad chopper ... Kenmore 15899 Built-in Dishwasher

Hello, Our 4 year old Siemens dishwasher is not starting. The standby light shows its getting power but no start. It is off warranty. thanks, Barry Lehr


This gennerally happens because the door closed sensor is not sending the correct info back to the main board. Try pushing a little harder on the latch when you close the door, you might just get lucky! Thanks, Dana ... Siemens Dishwashers

I have a Kenwood Dishwasher KDW12ST3A. P1 cycle stops after about 40 minutes and shows on the screen an error code of 'E3', Not sure what this means as I have mislaid manual. Can you help please?


... Kenmore 15762 Dishwasher

I have a F2 flashing on the top drawer. My dishwasher is only 2 years old. It started to bip on rinse and F2 was flashing. Also water does not drain when it get to rinse. I have this problem 4 months. I have no idea what's wrong. Will it be covered by the manufacture warranty? Please help. Many Thanks.


The motor has not\015\012been sensed rotating\015\012\003 Foreign object has jammed the rotor\015\012\003 The rotor has failed\015\012\003 The hall sensor has failed (small sensor on the underside of the motor)\015\012\0 ... Fisher and Paykel 24 in. DD603H W Built-in Dishwasher

Hi, We have a small CDI454-80 Candy Dishwasher. It is just 18 months old and has only been used around twenty to thirty times. It has recently started to leave a film on all the dishes after the wash is complete. We noticed it a few days ago and have tried different tablets but with no better results. We have also noticed that the cutlery is getting brown rust like marks on everything in the silver tray. PLEASE HELP! Thanks, Dave


The problem is hard water. Go to www.dishwasherfilter.com. They have a new product out that solves this problem once and for all. It filters the water entering your d ... Candy A8001 Dishwasher

I have a 13 month old (Thanks Sears warranty!) Kenmore Portable Dishwasher Model 665.17769. It drains poorly, taking 2-3 times after load is completed running thru the ''cancel/drain'' cycle to clean it out. It is not getting dishes clean either, presumambly because the dirty water isn't being flushed out at cycle end and instead of rinsing with fresh water, it's still screwing with the dirty water. Manual doesn't offer any advice except to see if the hose is kinked (it isn't). I made sure nothi


Hello Linda it sounds like you may have a piece of glass or some other hard material in your drain pump which is partially blocking the draining process. Remove the hose in the base of the machine, then unscrew the drain pump and physically examine ... Kenmore Dishwashers

The touchpad buttons no longer work to select a wash cycle. When I push "Start" the light above "Smart Wash" comes on and the dishwasher operates normally, but I cannot select any other cycles and the light only comes on after pressing "Start", not before. Also, the Options buttons seem to work normally but the delay button doesn't scroll through 2-4-6, it only toggles the light on and off above "4". The item is 15 months old. Thank you.


... Kenmore 13743 Staimless Steel Built-in Dishwasher

We have a Kenwood KDW8ST2A Dishwasher which is about a month old. The other day we had to pull it out from under the worktop because something rolled under it. When we put it back and went to use it later that day, we got an E1 error code appear and it's been like that since. We pulled it back out to make sure that we hadn't accidently pulled or loosened any of the pipes. We have the manual which does tell us what the error means but it doesn't tell us how to fix it. I'm sure it must be somethin


You can find a manual here ... Dishwashers

Hi. I have a 3 year old LG dishwasher. It will not drain. Display shows OE. I completely cleaned the drain assembly inside the DW. I checked the discharge line, it is completely clean. I disconnected the drain line from the air vent assembly at the sink and ran the DW, still will not drain. I disconnected the discharge pump wires and ran current directly, the pump works. I replaced the main control PCB, still will not drain. Please advise. Thanks


Measure the electric resistance of the Drain Motor. (Value should be 20-40 Ohms) If it is out of spec, replace it.\015\012\015\012Please reply with what worked best. Thanks! ... LG 24 in. LDF 7811 Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1875 seconds