Having problems with your Kenmore 15872 Dishwasher ?

The arms that spin both upper and lower do not appear to be spinning


Answers :

In case you do not have a user manual for your dishwasher you can load it form this site.
\015\012The actual model no. should be 665.15872.
\015\012
\015\012This diswasher uses the same pump to circulate water and drain water. There might be a blockage in the pump assembly which is preventing the water from entering the arms and spining them.
\015\012
\015\012I am assuming you do hear the pump running. You will have to open the pump and spray assembly to get inside and find out if the blockage is in the chopper. The parts should look like these on this website. You will have to open the side panels to access the base and bottom to get to the pump assembly.
\015\012
\015\012Hope this helps. Please rate the solution if helpful otherwise post a comment.
This is usually caused by either the arms are corroded or blocked and water can't flow through them or there is lack of water pressure. Lack of water pressure can be caused by either too many items demanding water atne the same time as the dishwasher. Like shower, wash machine, ect. Or the water valves on the dishwasher are not opening fully enough to allow sufficient water flow.
Repair Help & Product Troubleshooting for Kenmore 15872 Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

The upper and lower spinning arms in the washer do not appear to spin at all. Water comes out of the lower arm but not forcfully at all.Not cleasning dishes and leaving soap residue all over.


Hi,\012\012\012\012\012I\012have an older dishwasher also and recently my wife also complained\012about it not cleaning right... so me being the man I am tried in vain\012to clean the things... Bought new ... Asko D1876 Dishwasher

The arms that spin both upper and lower do not appear to be spinning


In case you do not have a user manual for your dishwasher you can load it form this site.\015\012The actual model no. should be 665.15872. ... Kenmore 15872 Dishwasher

The dishes in my dishwasher are not getting clean, particularly on the upper rack. It seems to be because the upper water arms are not spinning during the wash cycle. The bottom spin arm is working fine. I have cleaned out both upper arms as best as I could without removing them (above and attached below to the upper rack), as it does not appear that these arms are easily detachable. I am thinking maybe water is not making it up the line to the upper arms? I also have a lot of dirt in the b


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks for using FixYa. First of all please check the\015\012Water temperature by using a thermometer inside the dishwasher to measure ... GE Dishwashers

I have a frigidaire dishwasher - model number PLDB998AC1. There are two spray arms in this dishwasher - lower and upper. The lower works fine but the upper spray arms are not spinning. There is what I think adequate water pressure coming in from the top but no movement on the upper spray arm. Here is what I know: 1) The water pressure and spray arms alternate between top and bottom. 2) The upper spray arm moves freely when I push it gently. 3) I have removed the pump and cleaned out an


... Frigidaire 24 in. GLD2162RDC Stainless Steel Built-in Dishwasher

I have a KUDS03CTWHO KitchenAid dishwasher. It started not cleaning the upper tray well a few weeks ago and now the lower one is not getting cleaned very well either. I have disassembled and cleaned the 3rd level , upper and lower spray/wash arm assemblies as well as the feed tube assemble. These were not blocked or glogged. There appears to be less spray coming out of the upper and 3rd level spray arms they before but as I said there is no blockage. I also cleaned the bottom filter. There has b


\015\012Hi\015\012\015\012The issue seems to be with the float switch\015\012assembly that is bad and should be replaced. Please check this ... KitchenAid Dishwashers

Hello, Im trying to diagnose poor cleaning of glasses in the top rack of my Fridigaire FDB751SCB0. everything seems to work fine but while testing I noticed the upper arm isn't spinning. the lower arm is. i believe the pump is working as water is spayed everywhere inside but no matter which position I leave the upper arm in, I find it in the same place when I open the door. what could cause the upper arm to not get water preventing it from spining?


Hello; first thing to check, which you don't mention, is which side of the glasses aren't coming clean; the outside, which would be caused by the TOP spray not working properly, or the INSIDE, which would be caused by the spray BELOW the top rack not ... Dishwashers

Dishes are not getting cleaned after cycle. Glasses are smoky after cycle and I noticed that the upper spray arm appears not to spin. What would cause upper spray arm not to spin? Is this something I can fix or do I need to have a technician fix it?


Hello kharyespy,\015\012 First we have to address the obvious. Are you making sure that there aren't any large spoons sticking up from the silverware basket. Are there any objects hanging down from the top, or from any where ... Jenn-Air Dishwashers

I have a Frigidaire dishwasher, FDB-1100RHC, that is not cleaning dishes. My fiance cleaned the trap at the bottom of the washer, removing both the small basket and the larger mesh grid. After replacing both, the washer doesn't seem to have enough water pressure to spin the lower and/or upper arms. If I interrupt a cycle and open the door, water is dribbling out of the upper arms, but they are not rotating and do not move from whatever position you place them in. Both arms are completely uno


Hello :)don't feel bad, I run into this kind of problem at least once a week.\015\012It does sound like the pressure isn't there so you're not getting water to the upper spray arm. What you need to do is take the pump apart, which i ... Frigidaire Dishwashers

I have a Whirlpool GU2455.... dishwasher. Top spray arm is not spinning. Lower arm appears to be moving but slowly. Dishes on the top rack do not get cleaned. They are wetted, but the arm doesn't appear to be moving to allow all of the dishes to be cleaned.


Hi,\012\012\012\012\012I\012have an older dishwasher also and recently my wife also complained\012about it not cleaning right... so me being the man I am tried in vain\012to clean the things... Bought new ... Whirlpool GU2400XTP Built-in Dishwasher

No water delivered,or "spinning" of upper spray arm.Serviced @n year ago & worked very briefly. Spray arms & filter cleaned. Using a hose as water source to test.....spray arm isn't blocked. The problem appears to be water isn't being delivered to upper spray arms. What could cause this & how can I correct? Thanks for your time & response. Sincerely, Lee Ballard


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks for\015\012using FixYa. If the dishwasher is not filling then it is w ... Avanti DW18 Built-in Dishwasher

I have a whirlpool GU2700XTSQ1 dishwasher. I have the typical top rack not cleaning problem. I have removed the rear washer tube that leads to the top sprayer, no clogs. Upper arm is clear, lower arm is clear. I also removed the lower cover, checked the chopper screen and inlet, no clogs. There is a screen inside that I cannot get to. It appears to have some sort of paper or cloth sticking through the screen with a 50% block. Perhaps a sticker or label from a dish. I see this screen when looking


Hi, \012I have an older dishwasher also and recently mywife also complained about it not cleaning right... so me being the man I amtried in vain to clean the things... Bought new spray arms online and installedthem in minutes...now the thing works li ... Whirlpool GU2700XTSB / GU2700XTSQ / GU2700XTST Built-in Dishwasher

I have a Kenmore, Stock 15649, approximately 14 - 15 yrs old that worked fine until the past few days. The upper rack doesn't appear to be getting any water, as bowls and glasses are still dirty after being washed. It appears as though water would spray from the bottom, through a "nozzle" in the middle of the lower rack, then go to an arm located underneath the upper rack. I haven't noticed any obstructions in this path that would inhibit the water from spraying. Any suggestions (outsid


... Kenmore 16602 / 16604 / 16609 Built-in Dishwasher

Neff sd13j1f dishwasher lower arm not spinning


... Dishwashers

The dishwasher doesn't seem to have nearly enough water in it. The upper sprayer arm doesn't seem to be spinning when running (I open the door and look really quick) and the lower one looks like it barely spins and barely sprays water. The dishes are barely wet and the soap is just laying on the bottom. The water is on, there are no kinks in the supply line. It sounds like it is running, and pumps pumping, but being brand new I am not sure what it should sound like. It certainly doesn't sound li


I would lift the drain pipe higher. approx. 1/2 the height of the dishwasher . also rechack incomming water supply. Make sure no blockages and the like. Try again. ... Bosch Dishwashers

Have a dd603 with an issue...took off the arm and the metal silver disk (the ones with holes) to get to the wash impeller-(the thing with blue blades) the wash impeller will not spin-which I think is part of my problem, since i looked at the lower drawer and was able to spin the blue blades easily...was also able to pull it right out. Cant pull out the upper wash impeller!!!! Really want to get this fixed before my husband gets home and I get the lecture about how I purchased a cool looking d


Lol I don't know a lot about dishwashers, just do him good and tell him afterwards, and then hire a mechanic to look at it.Why would you want to pull the propellers off anyway? The top one doesn't pull off because it's screwed on, and the botto ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

The dishwasher is not cleaning the dishes at all, so far I have done the following: Checked both sprayer arms and they move freely and do not appear to be clogged (I ran stiff wire thru holes in each The float is not stuck and moves up/down easily The water leavel in bottom of tub does appear to be low - so I added water filiing tub to heating coil - however this did not help and the water did not spray on lower or upper racks - this is an older model Kenmore Ultra Wash WHAT DO I NEED TO CHECK N


Heating element may have burned out. Check water temp during wash--should read between 130 to 140 F.If not the heating element,you may have to replace pump-motor assembly or wash impeller.Hope this helps. ... Kenmore Dishwashers

I have an asko D3450 dishwasher. Washer makes buzzing/humming noise at start of cycle and then randomly through cycle. I checked the sump and pump appears to be clean and impeller spins freely. The cycle seems to work ok. Water is pumping out ok. If you open the door to stop the cycle, the buzzing will continue for a few minutes then stop. If the cycle is restart, the buzzing starts again. The vibrations seem to originate from under the lower spin arm.


If the sound is a bussing - it is the capacitor mounted to the pump. It is failing.Shown here (big white cylinder on right of pic).. ... Asko 24 in. D3450 Dishwasher

Upper sray arm is getting water,rotates slowly, very top sray head gets none, lower sray arm spins but is not sraying very high, bad pump?


... Kenmore 16583 Dishwasher

ADW650 has no water going to the upper arm.The lower arm is OK - it spins during the cycle,whereas upper one doesn't.


... Amana 24 in. DWA22A Built-in Dishwasher

Top level glasses, dishes, etc are covered in gritty substance after wash cycle. Lower level all dishes end cycle sparkling clean. I have removed and rinsed upper water spin arm. Am also using a rinse agent and still have this problem. Bosch model SHE45M06UC/50.


... Bosch 24 in. SHU5305UC Built-in Dishwasher

Dishes are cloudy and have soap residue. Have cleaned upper &lower spray arm often, as good as posible (find holes plugged). water level & temp. seems normal . Water intake screen appears clean


Clean the spray arm jet holes if they are blocked. Check whether you have filled the rinse-aid dispenser.Check whether arm turns freely when rotated by hand manually. ... Maytag MDB9600A Jetclean II Built-in Dishwasher

Hotpoint Aquarius dwf34 lower arm not spinning, There is water supply to top arm but none to lower? Lower arm is clean and can freely spin by hand.


... Hotpoint Dishwashers

I have an LG ldf7811st dishwasher. My bottom arm spins with water, my middle arm does not spin but does have water coming out, and my top arm doesn't spin or have water. I have just finished taking apart the arms, the supply to the upper arms, the filters and the impeller. I cleaned everything and nothing really seemed clogged. I have tested it since and it still has the same problem. I know that they aren't spinning because i placed them in a certain position before i ran the test run. They


I'm thinking like you're thinking, that it's something affecting the water pressure, but you've done everything in the upper section, so the problem must be from below, unless you have a leak somewhere you haven't noticed and are losing pressure beca ... LG 24 in. LDF 7811 Stainless Steel Built-in Dishwasher

Lower spray arm does not spin on my bosch dishwasher model number SHV55M03GB/40. However the top spray arm does spin. I have tried cleaning filters and the actual lower spray arm but found to blockages etc. many help will be greatly appreciated


S.Africa doesnt have same modles as you, but will try and help. Some washers give the operator a choice to run either the top spray arm or the bottom one independently, and/or both together.\015\012Almost certainly, there is a valve that is po ... Bosch 24 in. SHU66C02 / SHU66C06 Built-in Dishwasher

I have a GE Profile, GSD4930X73WW, dishwasher. The upper wash arm is not spraying well at all. I checked the water line from the pump to the upper arm and it's fine. I cleared the filters and cleaned the float. I also took the inlet valve off and cleaned the screen. Although the washer works better overall, the upper arm still does not work well. Nothing appears to be in the upper arm assy to clog water from spraying out. All seems clear from the turbid sensor (next to the pump) through t


... GE Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0443 seconds