Having problems with your Kenmore 16522 Built-in Dishwasher ?

GE Dishwasher fills with water but does not "spray water" on dish

\015 Hi, I have a GE Quiet Power Dishwasher, it is less than two years old.\015\012\015\012\015\012When I press start it fills with water norm, then it just stops. A few minutes later it drains the water and fills up again. It is skipping the part that it sprays the water on the dishes.\015\012\015\012Any help will be appreciated.\015\012\015\012Thank you\015

Answers :

Here are a few things that might help you out, first is you could have a bad heating element in your dish washer, when it fills with water it has to reach a certain temperature before continuing to the next cycle, next thing is you could have a bad thermostat, or your timer is defective.
Repair Help & Product Troubleshooting for Kenmore 16522 Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have a Kitchen Aid Superba KUDS24SEBS1. The inlet water pressure is good and the dishwasher fills and starts the wash cycle, however, after the initial spray of water, it seems that all of the water drains out and there is nothing left to continue the cycle and wash the dishes. It's like it's not able to fill up enough to wash the dishes.


When "full" of water, the normal height of level is about 1/2 below the heater assy(large blackish grey coil below he spray arm).. if theres enough water in the unit nad its still not "spraying",its quite possible that your filter/chopper assy is cl ... Dishwashers

GE Dishwasher fills with water but does not "spray water" on dish


Here are a few things that might help you out, first is you could have a bad heating element in your dish washer, when it fills with water it has to reach a certain temperature before continuing to the next cycle, next thing is you could have a bad t ... Kenmore 16522 Built-in Dishwasher

I have a GE Triton XL dishwasher that is not spraying water onto the dishes. I just reset the power, and that didn't help. Putting it on the rinse only or wash cycle fills the bottom with water, but it sounds like a trickle vs. the spray. The heating element comes on and the soap door opens, but there's not spraying. I made sure there was nothing clogging the water line or other parts. What do you think is wrong?


... GE Tritonr XL GSD6260JCC Dishwasher

Kenmore (Whirlpool) 655 1589910 Dishwasher. Fills with water, motor makes horrible noise (buzzing / loud hum). Dishes do not wash and there is no evidence that any water pumped up to the spray arms. Spray arms are not clogged. We have a fully functioning water softener so it is not a hard water issue. Unit does drain normally. Either filter is badly clogged or pump is bad. How do I get to these parts to check them out?


You need to clean/ check the chopper. sounds like you have a bad motor. about 2-300 dollars for the part ... Kenmore 15899 Built-in Dishwasher

Hi, When I turn on my dishwasher, it fills as normal with water but is not pumping into the upper spray arm. the spray arms are not clogged, I have checked them. Anyway, I always rinse the dishes under the tap before placing them in the dishwasher. I have to switch the machine on/off several times then the pump starts at full force.Occasionally it goes through a complete cycle without havig to switch on/off. It's a Siemens Lady model, E-NR SN53300GB/08, FD 7201 058479. The dishwasher is used


... Dishwashers

Ariston LS2020 I have a rental with the Ariston LS2020 dishwasher. It worked great for ages, but now it seems to fill with water than make a funny noise instead of spraying it all over my dishes...end results is dirty dishes and a cake of dishwashing detergent on the bottom of the dishwasher... Reckon there could be something screwing with the pump? How do I access the pump to check it out?


... Dishwashers

Dishes all cloudy and spotty. Maytag Intellisense plus 1996 dishwasher. I have real hard water that leave white calcium build up. I can remove and clean all of the lower spray arms and filter. How do I remove top spray arm to remand remove deposits? The motor sounds good, hot water, fill ok. On the inside top of center of arm where it meets the center input connection there is gunk to remove. How do I get to it? remove arm? thanks


The problem is hard water. Go to www.dishwasherfilter.com. They have a new product out that solves this problem once and for all. It filters the water entering your d ... Danby 22 in. DDW399 Free-standing Dishwasher

Whirlpool DU1101 Hello, My Whirlpool DU1100 is only 1 year old. The dishes are dirtu and the soap doesn't disolve completely My husband is convinvced it is low water pressure, primarily from a leak in the sprinkler system in the park behind our house. I think it is just a clog of some kind preventing the water from getting into the dishwasher fill and/or spray arms. The maunual says you need 20 120 PS to run the dishwasher I doubt it is below 20 PS because of a leak in the park. Is there anyway


Well you should have water up to the heating element. if there is more than likly your chopper is the culprate. do you make sure that there isn't big food particles on your dishes because that is a lot of stress on that chopper and that is what help ... Whirlpool 24 in. DU1100XTP Built-in Dishwasher

My dishwasher is not cleaning dishes... The cycles work but the dishes do not get clean an sometimes are more dirty if that is possible. I have tried adding jet dry and extra cleaning liquid but get no results. also there are times that the bottom of the washer fills with water unexpectedly and will even leak on to the floor. It doesn't leak when the dishwasher is running... I just don't know what to do other than clean out the spray arms. Please help.


Hi,Check your heating element.. Dishwasher ... Kenmore 15899 Built-in Dishwasher

My dishwasher is not cleaning dishes... The cycles work but the dishes do not get clean an sometimes are more dirty if that is possible. I have tried adding jet dry and extra cleaning liquid but get no results. Also there are times that the bottom of the washer fills with water unexpectedly and will even leak on to the floor. It doesn't leak when the dishwasher is running... I just don't know what to do other than clean out the spray arms. Please help.


Best off to call a certified repair company such as Sears. ... Kenmore 15899 Built-in Dishwasher

Whirlpool dishwasher doesn't seem to fill with enough water despite good water pressure. Therefore, pump sounds like it is cycling from pumping water for about 2 seconds to going dry for 2 seconds to pumping water for 2 seconds to going dry for 2 seconds, etc. Spray arms rotate only for the 2 seconds when pump is actually pumping water. Dishes do not get clean.


... Whirlpool 24 in. GU2548XTPS Built-in Dishwasher

When dishwasher is turned on to the cycle mode - it fills with water - heater heats water to the proper temp - pump starts - washer goes through it's complete cycle - even pumping out the wash water and the drying cycle,then shuts down. the problem is that it does not circulate the wash water thru. the spray heads-even though the circ,pump is running.Even though the unit is 8 yrs.old and hasn't run for 6 yrs,my wife&i do our dishes by hand. our unit is a GU1200XTKB0 Serial# FL4617501


The impeller on the wash pump is worn out or the disposer screen is obstructed. Disassemble as needed to investigate the cause. ... Whirlpool 24 in. GU1200XT Built-in Dishwasher

Dishwasher comes on, fills with water, water heats, no movement of the arms so no water spraying out, then the water drains, it goes through the dry cycle and no clean dishes.


What is the manufacturer and model number of your dishwasher?\015\012\015\012Depending on the model and design, the sprayer motor/pump has probably failed and the drain motor/pump is still working.\015\012\015\012Recommend you pull the sp ... Maytag 24 in. MDB5600A Jetclean II Built-in Dishwasher

I have the Siemens SL84A305UC Dishwasher. All of a sudden it stopped cleaning dishes, but everything sounds normal and it fills and drains water, and sounds like it is completing the cycle. In the past when I opened the door while it was actively washing the water would spray out aggressively. Now, when I opened it while it was supposed to be washing I see just a small amount of water coming from the bottom wash blade, and not even enough to turn the blade very far. I thought it was just a c


... Siemens 24 in. SL84A305UC Built-in Dishwasher

I have a whirlpool ADG 7550 dishwasher. The water is going in and it heats and appears to go through its cycle but the dishes are just the same as when they went in. I don't think it is spraying the water inside the machine it just seems to fill up at the bottom with water


Hi If you are noticing that the dishes are not clean, then there are a few things to check for. Check the soap powder if it's kept in a dry environment. Also try replacing the powder with something like a gel or liqu ... Whirlpool Dishwashers

I just moved into a condo and my GE quietpower 2 dishwasher will not spray water on the dishes just runs thru the entire cycle SOMETIMES otherwise just fills with water then drains water and shuts off. please help! :) Thanks!


... Kenmore 16522 Built-in Dishwasher

My kenmore washing machine fills with water but will not wash..it sounds like its doing something then it stops after a while i hear it drain and then stops again..water doesnt spray..I let the dishwasher run for a while but dishes werent even wet


Often these work by reversing the motor which has two pump impellers. One direction will pump the water out and the other will pump it through the spray bar. IF the one pump impeller has broken then that would explain your symptoms. \015\012 ... Kenmore 24 in. 16193 Stainless Steel Built-in Dishwasher

No spray Suddenly my dishwasher will fill up with water but doesn't spray the dishes


This sounds like the circulating pump motor is either defective or the linkage is broken. If it makes no noise when it should be washing. then it probably requires a new pump motor.\015\012\015\012It's normally located at the lower front ... Crosley 24 in. CDU600 Built-in Dishwasher

I have a KUDS40CVSS dishwasher. It is only 3 weeks old. It fills with water, lets out the soap, drains, heated dries, BUT it will not circulate the water and the spray arms do not work. So, I am back to washing dishes. I feel like i bought avery expensive "lemon". What's wrong ?


... KitchenAid KUDS40CVSS Builtin Dishwasher

My dishwasher will fill up with water and the sprayer will spray water, but will not spin like it should to clean the dishes, Help what do I need to do to fix it?


... Kenmore 24 in. 15149 Built-in Dishwasher

My Diplomat built in Dishwasher fills with water and heats it and empties, however the water does not get sprayed thru the arms and the dishes remain dirty. Any suggestions on what the fault is and what the fix is please?


The most common cause for no washing is a failed wash pump motor. Which is probably the single most expensive part to have replaced on a dishwasher. ... Dishwashers

Dishwasher Our dishwasher is not washing the dishes. The water go in and it goes through the complete cycle and dumps the powder in but the water never gets above the dishes or even to the soap holder. The powder is a dry pile below the dispenser. It seems that the spray arm doesn't extend or spray water over the dishes.


I have a kenmore dishwasher (about 10 year old) it won't turn on. It just buzzed when set to wash. What can I do? ... Dishwashers

Hi, I have an LG LDS4821 dishwasher and it appears to stop working properly. The dishes don't seem to be cleaned at all. It seems like the spray arms are not spraying the dishes as the dishes are still dry/dirty after a normal wash cycle. I did notice that the detergent was used during the wash, and a trail of white residue was at the bottom of the tub. I can hear water pumping into the dishwasher, but when I opened it during a wash cycle, there was a puddle of water at the bottom of the


Hi,\012\012\012\012\012I\012have an older dishwasher also and recently my wife also complained\012about it not cleaning right... so me being the man I am tried in vain\012to clean the things... Bought new ... LG LDS4821 24 in. Built-in Dishwasher

Dishwasher Repair I have a Frigidaire dishwasher that came with the house. The house and washer are probably about seven years old. It woked fine for the first few months but now, when I turn it on to wash it fills with water but then it will not go into wash cycle (i.e. there is no water sent into the dish compartment). It will go through every cycle by filling and emptying through wash and rinse but no water goes into the dish compartment. Is there a pump that is perhaps not working? How is th


Ebers, you have a seperate wash and drain motor on this model. When you remove the bottom panel the drain pump will be on the right and the circulation (wash) pump will be in the rear. You are going to have to verify that you have power getting to t ... Frigidaire 24 in. FDB421RF Built-in Dishwasher

Dishwasher fills with water but doesnt spray water around


... Frigidaire Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.2085 seconds