Having problems with your Kenmore 16522 Built-in Dishwasher ?

Kenmore dishwasher 665 7436 40 water overflowing out the door bottom the over flow float dos not float up with the waterthank you


Answers :

Repair Help & Product Troubleshooting for Kenmore 16522 Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Kenmore dishwasher 665 7436 40 water overflowing out the door bottom the over flow float dos not float up with the waterthank you


... Kenmore 16522 Built-in Dishwasher

Door leak I have a small leak between the bottom of the dishwasher door the lower service panel on the dishwashere. I did replace the seal on the inside bottom of the door along with the other parts that come with the door seal. Could there be a gasket leak around the detergent dispenser or the vent at the top of the inside of the door. I did not check the water lever as was mentioned in a previous question on water level, but the float does move up and down quite freely. Any suggestions as to w


I had my dishwasher leaking alot at the bottom of the doo,r and found out that the steam vent was very cloged with gunk. After taking the vent cover off on the inside of the door and cleaning, then putting the vent cover back on NO MORE leaking. Th ... KitchenAid 24 in. KUDS25 Built-in Dishwasher

Whirlpool dishwasher leaking from bottom of door between inner and outer door. Replaced door gasket. float and float switch working. Pump working, tub draining properly. leaks without adding soap or dishes too. Will a bad pump gasket cause water to get between inner and outer door?


... Whirlpool Gold 24 in. Built-In Dishwasher Dishwasher

Hello, I have a Frigidaire FDB510, after a few minutes of running water starts pouring out of the bottom of the door.I have replaced the wiper or sweep seal at the bottom of the door, the gasket does not seem to be bad, (it actually does not wrap around the bottom of the door anyway). Am I not draining correctly i.e. float,pump, etc. I sure could use some advice. Thanks


Ckd spray arm be sure it is not binding on something also ck for possible split in spray arm look close some are almost invisable ..when water is pushed through spray arm the seam will sometimes separate..also watch for oversuds ... Frigidaire Dishwashers

My dishwashing isn't filling properly. I think there is residue on the float "thingy" (located on the bottom right side close to the door) and it doesn't float like it should, so the dishwasher thinks the water level is correct when it isn't. How can I clean it and get rid of the gunk that is keeping the float from floating?.


It appears you already have someone providing solutions on this posting. Unfortunately I am not able to see the responses.\015\012\015\012It mgiht help if you can provide the full model number of the dishasher.\015\012The float shou ... Westinghouse Dishwashers

The diswasher will drain completely after the drain cycle is completed. It will then immediately begin to fill again despite no additional cycles being requested. I can hear the fill cycle begin. I can prevent the filling by opening the door slightly or by moving the float plunger up and away from the microswitch that signals to fill the bottom of the washer with water. Is there an adjustment on the float or on the length of the float plunger?


HI, The floater is not the issue here. Your problem will be with the main control assembly. The control assembly routes power to the inlet valve, and drain pump/motor. The floater is merely a regulatory ... Maytag MDB5100A Dishwasher

I have an Asko D1322, about 2 years old. All is good with the washing but the dishes when it finishes are still very wet. The fan appears to be running and I'm getting a small flow of air out the vent in the bottom left of the door. Does the fan need any maintenance? I was wondering if this might improve air flow and get rid of the condensation quicker.


... Asko D1876 Dishwasher

I have a model du1055xtsq2 Whirlpool dishwasher. When running, it leaks at the bottom of the door opening. This was recently installed by myself,Is this a door adjustment or is there a float that may be malfuntioning?


Hi,\012Check the float\012 \012 \012Here is a tip that I wrote about dishwashers and them leaking. ... Whirlpool DU1055XTSQ Built-in Dishwasher

Hotpoint dishwasher HDA467-02 AD leaks suds/some water at the bottom of the door ONLY during the wash cycle. There is no leaking during the rinse cycle. Have replaced the bottom flange gasket (Part WD8X5100). The leaking stopped for awhile then started again. Float switch moves freely. Any ideas?


Tilt dw back ... Hotpoint 24 in. HDA2000Z Built-in Dishwasher

Item: Whirlpool Ultra Dishwasher Age: 3 yrs Problem: Not enough water to effectively wash the dishes. State: When the dishwasher is started, the fill valve opens as normal. Only about 1/2 the amount of water is let in when the pump turns on and the washing cycle begins. Opening the door shows that the water level does not reach the bottom of the float. When I close the door, the wash cycle begins again but stops after a few seconds. This is when the water begins to fill again. This time, the wat


Larry,The float is generally for overflow conditions and will interrupt power to the fill valve solenoid. If you are not filling completely in the time allowed by the timer, it is most likely a flow restriction in the water ... Whirlpool GU2400XTP Built-in Dishwasher

My neff S5443X2 dishwasher pump keeps running - in addition, the operating lights on the top of the door do not illuminate. I checked the bottom tray and float switch but it was dry and the float switch seems to be down


When this happens usually it is a sensor.and/or the main unit Brain. One needs to troubleshoot to tell, as many, most? symptoms seem similar but have differing sources. One needs to troubleshoot.\015\012\015\012To have any chance at DIY repair ... Neff 24 in. S5443X2 Built-in Dishwasher

Our bosch dishwasher now and again leaks from bottom of door ,to stop it remove the silver filter plate then remove float chamber lid remove wated float and give it a good degrease and replace it this stop the flooding for one or two washes then leeks again has been doing this for some years yours mike


I have had the same problem and finally stumbled upon the answer today!\015\012\015\012If you are looking inside your dishwasher, look mid way up the right\015\012side wall and there is a valve/hole...if that hole is covered up (e.g.\015\ ... Bosch 24 in. SHU43 Built-in Dishwasher

Frigidaire dishwasher (Electrolux FDB750RCB0) does not move water through the hose to the upper wash/spray bar. The lower wash/spray bar has pressure enough to turn. With the dish washer out from under the counter I can see the water rise very slowly up the translucent hose. If I remove the check ball under the stem assembly in the motor in the bottom of the tub, water flows, but I'm not sure if the top bar turns then (with the door open I see water coming down from the top, but never saw


... Dishwashers

Doesn't appear to be washing the dishes like the spray arms are not working. I can hear water filling and it does drain but soap is still on the door and in the bottom of dishwasher itself. Ran diag on it and it came back clear (0). I have a Bosch SHU5315U6.


Sounds as if the pump motor has gone out in the machine. What happens is once the water reaches a certain level the machine goes into clean mode. This means the pump the forces the water into the machine isn't working. The timer actuates this pump ... Dishwashers

My Kitchenaid ModelKUDI01TJBL0 only leaks at initial start up. Just after the water fills, the first few seconds of the wash cycle. It pours out the front door for a couple seconds than no more for the rest of the wash. It is level, no cracked arms, or loose pumps.Splash guard is in place. The float seems to be working, not too much water in the bottom. I am stumped. Although I do feel that it has something to do with the level of the water being too high, when the arm starts turning, it makes a


Is the unit level or leaning back if leaning back it is morelikey filling too much if level make sure the float moves up/down easy if not clean ... KitchenAid 24 in. KUDS25 Built-in Dishwasher

Full model number is SGS45E08GB/56 Will pump out water if you pour it in manually. Takes in water - sometimes. Main pump runs but no water flowing out of arms. Float switch is not operated and is not defective (tested off the machine). Intake solenoid valve seems to work properly (tested off the machine). Pump continues to run even if door is opened.


... Bosch 24 in. SGS45E02 / SGS45E08 Exxcel Free-standing Dishwasher

Dishwasher leaking out of bottom of door, took the float off and cleaned seemed to help , but is still leaking


Hi,Here is a tip that I wrote about leaking dishwashers...There also is a link in there to another tip on how to buy parts online fo ... Dishwashers

Too much suds coming out of dishwasher, How do I open the bottom door to adjust flow. Fagor FI-48W


... Fagor Dishwashers

Middle and top spinners do not spin The pump is pushing water up the back delivery tube. There are no dishes in the unit and I was able to trick the door into thinking it was closed so I could watch what was happening. Or Not Happening The spinners are completely free of calcium or soap build up and both top and middle are easily spun with a finger. While the pump and bottom spinner were working, I pulled the top drawer out partially and there appeared to be a good flow of water coming out of


Hi,\015\012 Remove each spray arm and check it is clear of food particlesat the jets. The next problem may occour at the rotating joint . If the seal is not good, you can loose a lot of water out of this point.. If both of these seem reasonable ... Dishwashers

Water & soap was coming out of the dishwaster. Replaced the seal around the door. Ran again on a pots & pan cycle to clean & it worked fine. Ran a normal cycle with dishes & soap & water came flowing out of the bottom now. Any ideas?


That sounds like the float switch is acting up. It is a mushroom looking device on the bottom that has a movable (up and down) plastic cup over the top. With the machine off, take the lower tray out and lift up on the cup--you should hear a faint 'cl ... Kenmore 24 in. 17032 Built-in Dishwasher

Kithchenaid Dishwasher KUDP01FLSS3 Keep over flowing with water from front door. Tried jiggling float and will work for a while but then does it again!


... KitchenAid Dishwashers

My GE Nautilus DW doesn't fully drain. When it is drained as much as it will it leaves water in the sump at the rear right. If you run the pump at that point, it sucks water out of the sump, but when you open the door and the pump stops water flows back into it. It seems like there is a check valve that isn't working. I have cleaned the sump and the screen which runs accross the rear. I also have taken the plunger out and cleaned it. Then I took the housing for the plugner off the bottom. I don'


HI. check the following areas for fualts.1. Air gap / Drain hosesIf there is an air gap (located in the sink, near the faucet), check to see if it is clogged. Unscrew the top cap and see if there is anything blocking inside. Note: I ... Dishwashers

We have a Kenmore Elite Dishwasher #665.1646 - 5yrs old. On Friday nite, there were no problems but last nite the lights would not go on when cycles were pressed ( or Start). Checked the circuit breaker and it was OK. There is nothig caught in the bottom and the overfill float is functioning. I pressed Hi-temp and Air dry alternately and all the lights lit. I pressed Smart Wash, then Start and it did not go on. I can hear it draining but no water seems to flow and then it stops. All light t


The thermal fuse on the control panel. There isa couple of wires that lead up to a white box with the fuse in it. Thatis the problem. If you are good with a volt meter or light and youplace it across the fuse, if it is bad the light will light ... Kenmore Dishwashers

EDW5500DSS wont completely drain water Okay so now that my dishwasher runs, when it finishes a cycle it has a nice puddle of water at the bottom that never drains completely out. I am assuming its a relay or something because I looked for a floating switch (did not find), I can hear a pump sound as if it wants to pump the remaining water out, but, it doesn't. I really want to solve this problem soon so I can order the new door seal and needed part together. Checked the line out and of course i


The srainer over the pump could be clogged not letting the water drain quick enough. Be sure the screen is cleane out. I believe you would have already checked and cleaned this. I believe it is the impeller on the pump that pumps the water that is ei ... Dishwashers

Frigidaire model gldb756aq1 is leaking, more like overflowing. when door is opened water keeps flowing. float is free.


... Frigidaire 24 in. GLDB756A Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1082 seconds