Having problems with your Kenmore 16602 / 16604 / 16609 Built-in Dishwasher ?

I have a kenmore dishwasher mode 665.16032402

\015 Green clean light keeps flashing need to reset the unit tried heated dry and sani rinse buttons and all lights lit up i assume test mode now what\015

Answers :

I was able to reset it using this procedure:
\015\012
\015\0121. Crack the dook open
\015\012
\015\0122. Within 3 seconds, press these buttons in this squence: Hi Temp Wash, Heated dry, Hi Temp Wash, Heated Dry
\015\012
\015\0123. Close door
\015\012
\015\0124. Press Cancel
\015\012
\015\012That should clear the Blinking LED. It appears this is a common problem. The worst thing is they charge to come out for this.
I have the same problem. I have to go through the test mode at least three times just to wash one load of dishes. This dishwasher is a lemon. Sears she recall it. The techs say that they have at least 50 calls a week with the same problem. We need to hire a lemon law attorney and sue the pants off them. If you here anything email me please.
\015\012
\015\[email protected]
Repair Help & Product Troubleshooting for Kenmore 16602 / 16604 / 16609 Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Kenmore Elite My dishwasher occasionally goes to drain mode and will not do anything else, I've tied to push the buttons to reset it to diagnostic mode but that hasn't solved the issue. Last time it corrected itself after a few hours. Any suggestions?


About the only thing to try would be to remove the inner door panel to get to the control bd then you will see a mylar ribbon looks like a fat piece of scotch tape pull up on the plastic connector that holds it in and pull t ... Kenmore 24 in. 16032 Built-in Dishwasher

Broken dishwasher We recently had a plumbing problem that resulted in the kitchen sink overflowing and flooding the kitchen. The cabinets to the left of the sink were full of water and the dishwasher to the right of the sink will not work. It says it is washing and using two different washing modes, but I cannot get it to start over. What can I do? It is a Kenmore Quiet Guard 2.


If there is no water in the dishwasher - i.e. it had finished a cycle, but now it is just the indicator lights that are on, then the chances are some water has got into the control system. It will probably dry out, given time. (maybe a number of days ... Dishwashers

I have a kenmore dishwasher mode 665.16032402


I was able to reset it using this procedure:\015\012\015\0121. Crack the dook open\015\012\015\0122. Within 3 seconds, press these buttons in this squence: Hi Temp Wash, Heated dry, Hi Temp Wash, Heated Dry\015\012 ... Kenmore 16602 / 16604 / 16609 Built-in Dishwasher

Kenmore elite dishwasher model #665.13942k010 is 1 yr old and stuck in rinse mode..tried combo button pushing....no lights or beeps....tried the breaker in off position....blue light keeps flashing rinseing with 3 bars.....appreciate the help Thanks Steve


... Kenmore Dishwashers

Kenmore dishwasher 575 0


... Dishwashers

I have a Kenmore Type 575-0 Dishwasher, model number 665.16033401, Style 16033. It runs trough the cycle, once the cycle is complete the clean mode light is on but most dishes are still dirty. I had someone here to repair this about a year ago. All he did was press alternating two buttons, which I have tried, it resets and lets you start a new cycle. However, the problem remains. Last time there was only button pressing involved, no need to replace anything. So, I would hate to have to pay ag


You need an electronic control and heating element ... Dishwashers

When in wash mode leaks - Kenmore 24 in. 16039 Built-in Dishwasher


Generally in wash mode the water would be splashed around by the wash arms.\015\012\015\012it is likely the door seals are leaky and need to be replaced.\015\012\015\012Most likely part 3 in this ... Kenmore 24 in. 16039 Built-in Dishwasher

I have a Kenmore Elite Dishwasher, Model # 665.13119K701 that is just over a year old. It does not cycle through the washing/rinsing/heated dry cycles. It continually runs in the ''washing'' mode. It only drains if i press ''cancel/drain''.


Replace this: ... Kenmore Dishwashers

Kenmore Dishwasher Model 363.15171000 doesn't progress past the "Start" mode


... Kenmore Dishwashers

Kenmore ultra wash dishwasher stuck on water miser mode


... Dishwashers

I have a Kenmore dishwasher that seems to leave a bit of water inside. Model 3631435598. Is this normal finish mode? Seem the water would get stale. I have no manual can anyone help with either ?


Hi Doc! You know? If I had to postulate an educated guess, I'd wager that your dishwasher's (DW) drain hose isn't hooked up properly under the sink. When it's not hooked up right, water from the sink will siphon down into the DW making yo ... Kenmore 15762 Dishwasher

Kenmore elite ultra wash dishwasher mode 665.13972K014 door will not latch


... Kenmore Dishwashers

I have a Kenmore dishwasher model #17519200. I loaded it last night as usual and closed the door. I pressed the wash cycle I wanted and pressed the start button. I heard it starting to fill with water as usual. After it filled with water it should have gone into the wash cycle mode but it just started making a buzzing noise for about a minute or two then just stopped. I pressed cancel to drain it and it drains fine. I have kept trying to re-run it but it just does the same thing I described.


... Dishwashers

Kenmore Elite Dishwasher 0 Lock light on


Hold down the "air dry" button for 4 seconds ... Kenmore 24 in. 16983 Stainless Steel Built-in Dishwasher

Kenmore dishwasher 587 1523 not past wash mode, no dry or clean light


... Dishwashers

Kenmore dishwasher type 575 0


... Dishwashers

I have a Kenmore Elite Dishwasher about 7... Problem with the Kenmore Dishwashers I have a Kenmore Elite Dishwasher about 7 years old. The Model # is 665-16462300. It works beautifully, except that about every 2 months the spray flow intensity ( and the cleanliness of the dishes) drops significantly. The cause is the metal screen located just upstream from the sump is clogged with food particles. I have taken apart the dishwasher several times to remove, clean and replace the screen. This fix wo


Check the inlet hoses; if the catch screens have sediment build up, that will reduce the pressure of the rinse water. Also, look for missing plugs on the rinse arms... ... Kenmore 24 in. 16462 / 16464 / 16469 Built-in Dishwasher

Kenmore Dishwasher Will not start


... Kenmore 24 in. 16052 Built-in Dishwasher

665.13742K600 Kenmore Ultra Wash Dishwasher


... Kenmore Dishwashers

Kenmore classic dishwasher washing cyle doesn't start


It sounds as if you need to replace the timer. The reset motor is separate from the primary motor--that is why one type of "cycle"--diagnostic-- seems to work but the regular cycle(s) do not. ... Dishwashers

Reset code for sensor in Kenmore 17022 dishwasher


I've found conflicting information on this, so I'll post all three solutions - let me know if one of them works.\015\012\015\012One site told me to push Heated Wash and then Heated Dry alternately 5 times each, in quick succession.\015\012\015\012Ano ... Kenmore 24 in. 17022 Built-in Dishwasher

Cleaning Kenmore 665.17769K600 dishwasher filters


... Dishwashers

Kenmore dishwasher 665-1703 wont stop washing


Unfortunatly you are looking at the timer which is now built into the controller which would need to be replaced. If the relays are fused shut on the timer or the gears are missing some teeth then you will only get sofar I the cycle and the washer w ... Dishwashers

Kenmore Elite 665.15929001 Dishwasher, flashing Sani-Rinse light, won't start


Kenmore is **** with a double PP go buy a Maytag or GE and throw it threw the appliance dept like the Discount tire guy did on TV. I have asked the same question on 4 different blog's and no answer. The question to where they were actually built is u ... Dishwashers

K-more elite dishwasher stuck in sensing mode; won't move to wash


Where did you find the sequence to clear the flashing clean light? ... Kenmore Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1784 seconds