Having problems with your Kenmore 16602 / 16604 / 16609 Built-in Dishwasher ?
I have a Kenmore Ultra Wash Plus. Model # 110763691.
The light comes on each of the various modes but washer does not
turn on when I shut the door.
Repair Help & Product Troubleshooting for Kenmore 16602 / 16604 / 16609 Built-in Dishwasher
Tips for a great answer:- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.
Suggested Questions/Answers :
I have a Kenmore Ultra Wash Plus. Model # 110763691. The light comes on each of the various modes but washer does not turn on when I shut the door.
... Kenmore 16602 / 16604 / 16609 Built-in Dishwasher
When I pick a cycle with my washer the lites on the door come on for a short period of time then go out.We found sequence on line of selecting various functions repeating this to reset machine,this worked for awhile but know all it will do is fundtion lites will come on when you se;ect a cycle then go out nothing happens.
Remove the touch panel and un plug ribon . clean with alcohol wipe/ reinsert and try again. this some times will correct poor connections .if this does not work the panel may be bad. . mm fed back pls . ... Dishwashers
Kenwood Elite Dishwasher Mod#665.13779 K600 "Normal Wash " light blinks continuously with NO washer action. No other wash modes light up when pressed. Washer does not do anything. However, a couple of times I got it to make a noise as if it was draining, but then nothing happens. Push "Cancel" and it blinks in unison with Normal Wash light. Open door and close it, "Cancel" light goes out and Normal Wash light continues to blink. Have tried various combination of buttons to try to "Reset"
... Kenmore Dishwashers
I have a hiDefinition, Top button(Hidden when you close the door) with a stainless steel front cover. Drain pump continuously runs and won't shut off. This will not allow the washer to go into the next cycle or into the dry cycle. This I guess would be the shut down mode allowing the built up heat to dry off the plates and glasses.
Unfortunatley this is a error code to let you know the main computer board has failed & needs to be replaced.very common with electronic washer's just the part will cost around $300 add labour it will cost at least $400 to repair GOOD LUCK ... Siemens 24 in. SE55A560 Built-in Dishwasher
The door would not shut. We checked all around and nothing was blocking the door from shutting. We determined the latch on the door was not releasing. I forced the door shut. The touchpad works...lights come on but unit will not operate. The release handle on the front just wiggles back and forth without effect. Lowes says it is one of three parts...none returnable. Any thoughts on what part and whether this is something average consumer can self fix? Thanks.
Hi,\015\012 Lowes is right regarding the parts needed.\015\012\015\012First check the strike part is ok - that's on the body of the machine not the door.\015\012\015\012Unplug the machine.\015\012\015\012Remo ... Whirlpool DU1055XTS Built-in Dishwasher
I have a Maytag MDB7600AWB dish washer. I have a door leak, dripping from the right side. I can not see anything that would allow it. It seems like it could be coming from the inside of the door. Also, there is heat and condensation on at the top of the door, above the leak. It could be that steam is coming from the top right and dripping down the door. Could you give me some idea about fixing the problem.
HI,Check for the following troubleshooting steps:Some leaking around-under-from the door on dishwashers can be traced back to a split in the spray arm. If the lower spray arm develops a split in it, the spray arm can turn too ... Maytag 24 in. MDB7600A Jetclean® II Built-in Dishwasher
Asko 1585 Dishwasher. Lately the washer has not been completing it's cycle without going into the all lights flashing mode. Usually just opening the door, closing then pushing start gets it going again. Yesterday this happened and it was restarted as described, then it go stuck in what appeared to be a drain mode - all lights flashing, drain motor running. It was in this mode for several hours and could not be stopped by any means. Pushing buttons or opening the door had no effect. Even c
Hi\015\012\015\012\015\012\015\012Thanks for using FixYa. You are right it is related to a bad control board. The\015\012control board has gone faulty and needs a replacement. Please check this recall\015\012information--- ... Asko 24 in. 1585 Built-in Dishwasher
The dish washer ran its full cycle but won't shut off. the little pump motor in the very bottom keeps cycling water in the bottom. it won't shut off when you open the door, it won't shut off when you push the power button and the front switches won't respond. the little light on the front of the dish washer is blinking and it has never done that befor normally the lites are always on solid.....
The drain stuck cycle ( I presume you mean drain pump running constantly ) are directly related with overfill scenarios for Asko dishwashers of this ... Asko D3122XL 24 in Builtin Dishwasher
Our Bosch shu9925uc/12 when we push the "on" button before we shut the door, it sounds like it is running and after you shut the door no water comes out but continues to sound like it is running.
... Bosch SHU9925UC Built-in Dishwasher
Hobart Kitchen Aid dishwasher KDS-58. This washer is a champ. Recently it started leaking water from the lower left corner of the door, while the washer is in the wash mode. I replaced the lower seal, below the door, the seal is installed correctly. Not sure what to do next?
Maytag MDBH985AWS...control panel button to turn on the washer does not work...wash cycle and delay lights will light when pushed but washer will not come on. Have tried pushing normal wash and heated dry in sequence, flipped circuit breaker, open and close door, pushed buttons while door is closed
... Maytag MDBH985AWB / MDBH985AWS 24 in. Built-in Dishwasher
I own a KUDS01FLSS3 KitchenAid dishwasher. The lights on the control panel do not come on and a cycle can not be started. There is about an inch of water in the bottom of the dishwasher basin and it looks like the previous cycle did not complete. I have checked the wall outlet that the washer is plugged into and the washer is receiving power from the wall. And ideas? My next thought was to take the door off and check the power supply running to the door panel and control panel.
Servtek06 writes:\015\012check connections @ control board/module. May be Control Board/Module. ... KitchenAid 24 in. KUDI01FLSS Stainless Steel Built-in Dishwasher
Maytag Dishwasher Model MDB4100AWQ When I start the Light Wash Cycle: Washer fills with water, heater comes on (I checked it with a volt meter--120 volts), timer runs, motor never runs, before the timer gets to "rinse" the heating delay light on the door comes on and the timer stops. The heater is still on (120volts) nothing further happens it just boils away on the water in the washer. Note: If I manually forward the timer to "rinse" the motor will kick in and run but does not pump out w
Most common d/w power is 120 volts, check for 120 volts with a ... Dishwashers
Bosch shu8806 Hello, I aquired a shu8806 recently and it doesn't work. It has power and water. I push wash cycle, indicator light comes on, shut door and nothing happens. So the door switch seemed like a good place to start. Since I am an electrician I thought I would give it a shot. When plugged in, the wire from the motor is 120V but when jumpered to the neutral(common on the door switch), motor doesn't operate. Although, I have heard the motor turn over momentarialy when trying to run unit e
The pump may be clogged, or the motor start capacitor may be bad or some units have a fill switch wired inline with the motor so it won't start unless the unit is full ... Bosch 23 in. SHU 8805 Built-in Dishwasher
I have the above dishwasher shv57c03uc just less than 5 years old. The door latch does not engage solidly. when i pust start button left side lights on indicator right does not come on and i have to push on button twice for washer to come on. When it does come on the cycle is real short and it does not complete a full cycle. I an asuming the circuit board is defective!! does this sound right? if so how can i replace the board?where can i get troubleshoooting instructions?
Hi\015\012\015\012You are right it is the ... Bosch 24 in. SHV57C03UC Built-in Dishwasher
Kude48fxbl - brand new out-of-the-box. When put through a test cycle after installing it, water poured out of the bottom left edge of the door. This was not associated with either the water input or the discharge hose, but rather seemed to come from the interior of the washer and out under the door. The door seemed well latched, and running it with some dishes in the bottom tray (not blocking the soap dispenser) didn't help.
... KitchenAid Dishwashers
I have a bosch SHU8815UC dishwasher. It was already installed when i moved into my apartment - so I'm unsure of the age. The dishwasher isn't functioning. When I open the door, the "Clean" light and the PowerScrub button are red. When i close the door, the light go off but nothing happens. One time I closed the door, it started to rev up but would shut off and beep three times after about 1 min. No water comes out. Any ideas? Thanks! June
Light comes on but when shut the door nothing
... Indesit Dishwashers
Kenmore dishwasher model 363.1410691, approximately 18 yrs old... Wash cycle was on, unlocked and opened door to add silverware, shut and locked the door, but water did not (and will not) come back on. Appears heating element and timer still works...any ideas?
Check your water valve. if know water goes in normally that is the culprit. disconnect the wires and ohms it out with a ohms it out. if this works then you can help me by sending me a 4 thumbs up post thanks! ... Kenmore Dishwashers
The door hinge on my hotpoint dishwasher BF1620 has come unhooked and has jammed so i cant fully shut the door now. How would I find out which part is broken and is it fairly easy to fix a hinge yourself. Thanks
Moffat dishwasher The door has come repositioned on the left side and it will not shut properly and when the door is all the wway open, the bottom rack will not pull out smoothly without lifting it up slightly. Haven't tried it since the problem arose as I was afraid that it would leek. also I didn't want to force it back into position for fear that I ould break it. I bought it Aug., 2006. It is a Moffat Model #MHDD210LOOWW.
Frigidaire Dish Washer. no water is coming into it. Shut off valve under sink is open,float switch isnt stuck. should I shut water off and remove inlet valve?
Verify that water is getting to the valve and verify that 110 volts is getting to the valve. If either one is missing then you know what the problem is. If you have both then replace the valve. ... Dishwashers
Dishwasher stopped in mid cycle. door found open water in tub shut door and tried to re start. no lights come on. unit shows no signs of being on. circuit and switch checked OK connection in front behind kickboard checked OK
Check the main fuse box breaker ... Whirlpool Dishwashers
Bosch SHU4302 WITH REPAIRED PC BOARD has been working fine for several years now seems stuck in rinse/drain mode and is not quite pumping cabinet dry. I have removed the screens and located the small impeller at bottom below cover. The impeller rotates as though it has multiple spring loaded stop positions. When I turn on the unit and open the door water is trickling from the sprayer arms at low pressure. It seems stuck in rinse mode and will not advance cycles or reset when shut off.
... Bosch Dishwashers
Control panel buttons don't work. Seem to be stuck in the "Lock On" mode. Can't turn off, and dishwasher won't run. When you open the door all lights go off, but as soon as you relatch the door, the "Lock On" light comes on, although sometimes it can be another light. In any case, it won't run.
... Kenmore Dishwashers