Having problems with your Kenmore 16602 / 16604 / 16609 Built-in Dishwasher ?

Kenmore dishwasher Clean light flashes after reset goes through cycle but motor does not run then clean light comes on again.

\015 The dishwasher seems to go through the cycle to a point. It inputs water, heats it, dispenses the soap, and remains silent when it should be washing (the motor doesn't run?), drains and then just sits their until the Clean light starts flashing. Is the motor bad or maybe it doesn't get the signal to start?\015

Answers :

Repair Help & Product Troubleshooting for Kenmore 16602 / 16604 / 16609 Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

After a power outage, that occured while the dishwasher was running, the lights come on and there is a high pitched noise. Then all the lights go off and the motor sounds like it is starting. However there is no water and the heating elemant comes on. The lights on the front; china/crystal, normal wash, clean and heated dry, all come on as if the computer is confused and trying to run them all simultaneously.


Sounds like the board was fried from a power surge ... GE Tritonr XL GSD6260JCC Dishwasher

Kenmore dishwasher Clean light flashes after reset goes through cycle but motor does not run then clean light comes on again.


... Kenmore 16602 / 16604 / 16609 Built-in Dishwasher

My 1yo slimline hotpoint dishwasher LST216 has developed a fault when trying to run the 'normal wash': washing stops after a couple of mins, the lights start flashing and the alarm comes on as soon as the water is being drawn into the machine. When I open the door I can hear a whirling/grating motor noise coming from the bottom of the machine. I have cleaned all filters and have run other programmes to check overall functionality and they all work as expected most of the time. I cannot unders


... Hotpoint Dishwashers

Maytag Dishwasher Model MDB4100AWQ When I start the Light Wash Cycle: Washer fills with water, heater comes on (I checked it with a volt meter--120 volts), timer runs, motor never runs, before the timer gets to "rinse" the heating delay light on the door comes on and the timer stops. The heater is still on (120volts) nothing further happens it just boils away on the water in the washer. Note: If I manually forward the timer to "rinse" the motor will kick in and run but does not pump out w


Most common d/w power is 120 volts, check for 120 volts with a  ... Dishwashers

Miele g892 scu plus, about 5 years old. when on, all it does is run some motor (humming sound) and flash salt or intake/drain. No program lights on. Sometimes can be reset so rinse light comes on and nothing blinks, but humming motor still runs and salt eventually blinks. I removed toekick panel; there is water in pan. I disconnect drain hose, only a little water came out. Any ideas?


... Miele G892SC SS Dishwasher

Clean light Our diswasher runs fine and the clean light comes on, but will not go back off after the door is opened and closed. No buttons will work and the clean light will not go back off.


You have an issue with the door latch assy, something inside it snapped, and its not recognizing you opening the door.. it still thinks the door is shut and is waitin g for you to open it, a swtich must of gone bad, the console will reove with a few ... Frigidaire 24 in. FDB1050RE Built-in Dishwasher

My Frigidaire Dishwasher FDB1050RES2 gets stuck in a rinse cycle. The light on the front will be lit "clean" but the bottom of the washer is full of water. Opening the door does not turn off the "clean" light. For me to get it to run, I have to unplug it, plug it back in, push the start button until the ?washing? light comes on. I then push the start button once more and the dishwasher will begin to drain. I open the door as soon as I hear the water stop draining into the sink drain. This


By the descrition you are giving you will need to replace the main control board.Part number 154568401.you may also need to check the float switch.The part will run about 110.00 dollars from a local parts store ... Frigidaire 24 in. FDB1050RE Built-in Dishwasher

My electric pressure washer's motor will not start. the 110 plug has a test/reset fuse on it. when i plug it in the light comes on. i push test- it turns off but motor does not run. i push reset and the light stays on.


With the water faucet turned fully on and the power switch on squeeze and hold the trigger for at least 10 seconds to let the water flow push the air out and then it should start up. ... Campbell Hausfeld PW1750 Electric Pressure Washer

Green clean light wont stop blinking unable to use dishwasher . It is an energy saver. the drain button works ..and when you push start the light comes on but will not run for cleaning


HiThanks for using FixYa. If the clean light flashes, pauses, and then repeats. When the dishwasher doesn't sense a water temperature increase, it stops working and locks the functions (clean light fla ... Kenmore 16602 / 16604 / 16609 Built-in Dishwasher

Light is on but no motor running, no water coming


The switch is no good, by a new one ... ... Maytag 24 in. MDB6600A Jetclean II Built-in Dishwasher

Bosch shu8806 Hello, I aquired a shu8806 recently and it doesn't work. It has power and water. I push wash cycle, indicator light comes on, shut door and nothing happens.  So the door switch seemed like a good place to start. Since I am an electrician I thought I would give it a shot. When plugged in, the wire from the motor is 120V but when jumpered to the neutral(common on the door switch), motor doesn't operate. Although, I have heard the motor turn over momentarialy when trying to run unit e


The pump may be clogged, or the motor start capacitor may be bad or some units have a fill switch wired inline with the motor so it won't start unless the unit is full ... Bosch 23 in. SHU 8805 Built-in Dishwasher

My Viking dishwasher won't fill with water. The motor seems to be running but no water enters the chamber. It's Sunday morning so I'm not able to get a repair person here. I got a response that said ''The ventilators are blocked. Turn it off and have the motor checked'' i was hoping for instructions on how to unblock the ventilators or clean it out. I have a house full of people for the weekend and would love to get this thing back up before Monday when a repair person could come. Any suggestion


... Viking Dishwashers

DD602I USA v2. Runs approximately 10 min then beeps continuously and on the front panel the middle light is red and on the inside panel the "Del" "Fast" and "Rinse" lights are red. What is this fault code indicating? I have made sure spray arm, impeller assembly, are clean and not blocked. No kinks in drain line. Induction motor sounds a bit noisy. This is only a problem with lower drawer, top drawer works fine. Thanks, Keith


... Fisher and Paykel 24 in. DD-602 Built-in Dishwasher

Kenmore quietguard 7 dishwasher...clean light flashing, dishwasher won't run repair guy a few weeks ago couldn't come, but told my husband to push a couple of the buttons on the control panel, and it worked for a while... repair guy coming back on Monday, but I''d like to know the buttons to push to reset it so I can use it till then


... Kenmore 24 in. 15173 Stainless Steel Built-in Dishwasher

Asko 1375 unit will not wash drains and fills ok  motor at back of unit runs well. Suspect impeller   Does motor have to come off for impeller replacement?? My 1375 is leaking a bit, looks like the seal which was mentioned in the impeller repair case,may be the problem? The other problem I noted was a clogged screen at the bottom of the dishwasher which is on the suction side of the pump, the screen had calcium buildup etc. I cleaned it off with vinigar and reran the dishwasher seemed ot fix th


Do you mean to say that the washer does not go into the wash cycle at all, or washes poorly?An answer to both can be found HERE.This article ... Asko 1375 Dishwasher

Fagor Dishwasher My Fagor DW suddenly has no water coming in but the motor is running. The cycle starts for about 3 mins then sounds a bit painful followed by all the warning lights coming on and beeping. I live in Spain and am not good with the lingo so am worried about calling anyone out. I've checked the water in pipe which is OK. Help!!!!!!!!!!!! (Please)


Ok if you have a volt meter then remove the bottom kick-plate locate the water valve take the connector off the valve set the meter to ac volts plug the leads into the connector turn the timer to fill if y ... Frigidaire 24 in. FDB126RB Built-in Dishwasher

We have a Blomberg dishwasher. We came to a finished cycle to find water in the bottom. We have removed the water by hand, cleaned the filter and the hose. The lights come on, but it doesn't respond when trying to run a cycle. It will do it's ''finished cycle beep sequence'' at the end of the cycle that it didn't actually run. We have reset it by holding down the start button. Turned it off and on, etc.


I am curious what the repair guy found. We have the same problem. ... Dishwashers

My fridgidaire dishwasher model FBD1050REC4 will not run. When I depress the start button the washing light comes but nothing happens. The delay wash is not set. Last I turned the machine and this morning the clean light was on but the washer never ran.


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks\015\012for using FixYa. If the clean light flashes, pauses, and then repeats. When\015\012the dishwasher doesn't sense a water t ... Frigidaire 24 in. FDB1050REC Stainless Steel Built-in Dishwasher

Dishes not coming out clean, water is coming out of arms but doesn't appear to be rotating (either top or bottom). Trying to figure out the test cycle on the shu3302uc model (when I hold down pwr scrub and reg wash) the pwr scrub and rinse/hold light will keep blinking when complete, when I use pwr scrub and rinse and hold, both these will keep blinking after cycle is run.


There is a recall repair notice for this model (and several other models) on the Bosch website. There is a faulty controller which may cause a fire! They have an 800 number for setting up a recall repair appointment. Check it out! We just found o ... Bosch 23 in. SHU3302UC Built-in Dishwasher

Have SHU43C and have had no problems with it. We usually run it on the Quick Wash cycle, but ran it on the Regular Wash cycle yesterday because the glasses seemed to be coming out spotty. After it ran, there were no lights on the display like there usually are. The washer had run and the dishes were clean, but it has not drained completely. There is still about an inch of water in the bottom, despite removing and checking both the Large Object Trap and Fine Filter (neither which were clogged


The drain pump needs to be replaced or cleared of obstruction. ... Bosch 24 in. SHU43 Built-in Dishwasher

Kenmore 665.16529000 When we put the dial to pots and pans the diswasher fills up and cycles through, when the dials moves to normal wash, it fills up and cycles through again. When the dial gets to light wsh we can hear the motor running but nothing is happening, but the soap door opens soon after. The heating light comes on and the inside of the dishwasher gets so hot that it has melted our big plastic tumbler cups on the top rack and makes the counter top extremely hot to the touch. The dial


... Dishwashers

Motor runs but water doesnt come out. Intake drain light is NOT on


... Miele 24 in. Incognito G663 SCVi Built-in Dishwasher

Dishwasher won't run. Replaced door latch and timer/selector unit. Into this POS for over 200 bucks right now, with nil result. Any other ideas? Clean light comes on so power is getting through it.


If it's KitchenAid or Whirlpool or Kenmore, and your clean light BLINKS and the heating element inside is ROUND - there is a problem with your control board and the element. There is a kit containing both, for the price of the heating element alone. ... Dishwashers

Got a Frigidaire model FDB750RCS0. Now it was running for a couple of min then I hear a clicking sound. Thought it might be something hitting the propeller. I opened the door and nothing. Closed it and now it wont even work. Thought the breaker got tripped but not even that. Now when I had it set back to the cancel part, the Clean Light comes on very dim where as before it use to be bright. Any solutions?


... Frigidaire 24 in. FDB750RC Slim-Line Built-In Dishwasher

My Asko D3122 will not turn off. I have taken all the water out and checked for any blockages. The system is dry and clean. How do I get the red flashing cup light to stop and the motor to stop running.


... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1493 seconds