Having problems with your Kenmore 16602 / 16604 / 16609 Built-in Dishwasher ?

Kenmore Dishwasher No Power Model 665-16769000

\015 I have a Kenmore Dishwasher 665-16769000. We have replaced the circuit board 3 months ago and last night replace the touch pad. Since it had been sitting for 2 weeks I ran it empty. Today the dishwas will not start - - no lights nothing. Can you tell me what is the problem this time?\015

Answers :

Repair Help & Product Troubleshooting for Kenmore 16602 / 16604 / 16609 Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have a Kenmore Elite Dishwasher Model 665.13773K600. It seems to have no power to the touch pad (top) control panel. I have already checked the circuit breaker and the power to the dishwasher. A friend said that it may perhaps be the thermo fuse cut out that needs to be replaced. 1) Is this true? 2) How can I remove the 1" thick control panel touch pad after removing the six screws- it seems to be stuck, and I don't want to break the plastic touchpad.


... Kenmore Dishwashers

I have a Kenmore elite ultrawash HE dishwasher Model 665.13129K700 , serial # FU3801153 , Stock # 13129K , Type 586-0. My normal wash red light flashed constantly and will not allow me to reset the control panel. I disconnect power for 1 hour then it allowed me to run 1 cycle. Upon completion the normal wash red light started flashing again. I tried to toggle between high temp wash and heated dry but no other button will work since normal wash is flashing. I again disconnected power but this tim


Hi,Push push thishi temp wash / heated dry hi temp wash / heated dry hi temp wash / heated dryIf this does not reset the control then you will need to replace the control board.Let me know,if needed fur ... Dishwashers

When I press the start button, Bosch dishwasher (model SHY56A 05UC) just keep running the motor pumping the water out of dishwasher, irrespective of: 1) the wash cycle it is on, 2) whether the door is closed or open, 3) whether I cancel drain cycle, as told by Bosch Cust Svc in following steps: - "Cancel Drain" by pressing 'Quick Wash' and 'Regular Wash' buttons together for a minute until it shows 0* - Shut power off for a minute and wait for a minute - Restart on Quick Cycle. Paid


What is happenig i believe and has happened to me 2 times is that the water level float that is on the left side of dishwasher is stuck.\015\012\015\012Either remove side panel and flick lever or pull dishwasher out and tap lower portion ... Bosch SHY56A02 / SHY56A06 Built-in Dishwasher

My 1 yr old GE dishwasher model # GLD4900P00WW lost power during the drying cycle & blew the rest of the circuit. An electrician has fixed the rest of the circuit & rewired the dishwasher to it's own switch in the breaker box. The dishwasher still has no power. Is there a fuse somewhere in the dishwasher that could've blown? If so, how do I locate it?


... GE Dishwashers

Kenmore dishwasher I have a kenmore dishwasher and in the middle of a cycle all my front panel lights went off. I have checked the power going into the dishwasher it is fine. I also checked the door latch it is fine. Not sure what else to check? Same exact problem model number 665.15934 We have had nothing but problems with all of our sears products - highly suggest to SHOP SOME WHERE ELSE before you get stuck too.


Check the continuity of the thermal fuse (part # 8193762). It's clipped onto the electronic control inside the console.Let me know if you need more help. ... Kenmore Dishwashers

Kenmore dishwasher HI i saw your name on the website look like you know your stuff. My kenmore dishwasher model #587.1518 has a flashing washing light i've tried different button seq. but nothing.I 've turned off the power too that didn't help thank you so much for any advice you can give me


Lexi, sorry for not getting back with you, I had to fly to the other side of the country for a week. You may be right about the door switch. First do this, with the dial set to rinse, press and hold the heat dry and start/cancel buttons togeth ... Dishwashers

On my Kenmore Ultra Wash Dishwasher model 665 the Normal Wash light is blinking even though the previous cycle finished successfully. Also I can't start the dishwasher -- it doesn't respond to any of the buttons. I have powered it off and on and the Normal Wash light comes back on within 5 seconds of restoring power.


Http://appliancejunk.com/forums/index.php?topic=2933.0\015\012\015\012\015\012\015\012Hi. please find above your service and repair manual, bel ... Dishwashers

Hi kenmore model 587.15102800 dishwasher not getting any power breaker is fine . dishwasher is on its own circuit, is there a fuse in this model


If the breaker is fine then the next check will be the terminal box on dishwasher. usually that is where you would find your problem. let me know if this helps and if it did help me by sending a 4 thumbs up post Thanks! ... Kenmore Dishwashers

Kenmore dishwasher Model #66517464300 no power to main motor


... Kenmore Dishwashers

Dishwasher I bought a 2006 Kenmore dishwasher model #66516032400 and the water does not totally drain out from the dishwasher. There is always a small amount of water left at the bottom. Has done this from day 1.


Check whether the drain line was assembled exactly as per Kenmore's instructions.\015\012Good luck! ... Kenmore 24 in. 16032 Built-in Dishwasher

I am installing a Kenmore dishwasher model 13743. I have direct wired the washer?s terminal box wires to the wall power via a BX wire and the washer doesn?t respond. None of the panel buttons are active. With a multimeter, I find that there is voltage on the wall wires and on the dishwasher end of the BX cable wires that hard wired to the wall current. Even though, when I connect the dishwasher?s terminal box wires to the BX wires as directed in the Installation Instructions (white to white,


Next step to check the door switch...the door must close and the switches on the door must close to send power to the control...let me know ... Dishwashers

Dishwasher model: DU1100XTPQ1 The dishwasher started it's cycle and then just stopped. Now none of the lights come on in the front panel. I've tested: 1) Electrical power to the machine checked OK. 2) Two switches inside the door handle show contenuity when depressed.


HI. Your testing has confirmed that the main electronic control board has failed. This will cause an abrupt shutdown. There is a fuse located on the control board. it is mounted on the back side of the control board. test the fuse for continuity. if ... Whirlpool Dishwashers

My Kenmore Ultra Wash Dishwasher model 17731 stopped working mid wash I checked the power cord and it is fine but the unit doesn't seem to be getting power. Is there a fuse in this thing? Any advice would be welcome.


... Kenmore Dishwashers

Kenmore Elite Dishwasher, model 665.15914 , blinking lights Lost power yesterday... Dishwasher ran from No 99 to 76 and stopped I tried resetting on panel....didn't work Took out fuse and put back in ..didn't work hit Normal Wash and light just blinks


... Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher

Kenmore Dishwasher Model 665.11643300 Cycle will not run. Normal Wash light blinking Cancel light will also blink (but can be cancelled by holding button down) I tried shutting down the power and resetting at the breaker. I tried other buttons like Air Dry, etc to see if there was some sort of sequence Note* last cycle ran was rinse cycle many months ago - house has been vacant and dishwasher has not been in use.


I will look a bit further in detail about your dishwasher problem. I am assuming you have checked the inlet water tap to the dishwasher is turned on. ... Dishwashers

I have a Kenmore Elite dishwasher (model 665.1315), and the dishwasher will run through the wash cycle as expected, but when it gets to the heated dry cycle , it doesn't appear to dry. It will then flash a fault code 81 (8 short flashes of the 'clean' light, pause, and then 1 more short flash of the 'clean' light, longer pause, and repeat the code). The dishes seem to be somewhat dry, but there is certainly water on the dishes and on the tub (there is never any water standing in the tub, and t


Hi,Check your heating element.. \012A bad heating element causes many problems in dishwashers...Dishwasher Problems The ... Kenmore 24 in. 15932 Built-in Dishwasher

I have a Kenmore dishwasher am not sure of the model number it is a Kenmore Elite with stainless steel interior. i am using Cascade advanced power liquid detergent and am getting over a time a black mudlike residue left in the washer. What can be done to prevent this?


Hi,The scum, film and white\012residue problems have started since the reduction of\012phosphates in dishwasher detergents.Here is a tip that\012will help you to solve the problem of films, residue, and scu ... Kenmore 15899 Built-in Dishwasher

My kleenmaid dishwasher super silent model system DW5 doesnt appear to be heating the water on any cycle so it is not washing properly and leaving the powder etc on the glasses up the top particularly and also it does not go completely to the end of the cycle by itself(any cycle).Or completing the drying cycle. I have to switch to 0 cycle to make it complete the clicking to start again. What is the gauge on the inside of the dishwasher on the left that can be adjusted from 1-5 is this a heat


Http://frigidaireservicetips.com/pdfs/486_5.pdf\015\012\015\012\015\012\015\012Service manual, generic, use this to troubleshoot and repair.\015\012\015\012 ... Dishwashers

Kenmore dishwasher model #665.16039401 no lights, no power, breaker is not tripped? Any suggestions? There is some water in the bottom of the dishwasher, like it stopped mid cycle?


... Kenmore 24 in. 16039 Built-in Dishwasher

Hi i just got a second hand smeg stainless steel dishwasher it has 3 buttons on the left eco...1/2....and power it has a dial with the numbers 1-5 i have no idea the model number im wondering if u might know how i can find out which is my model out of the hundreds that smeg have


... Smeg Dishwashers

I have a Kenmore dishwasher, model 665.17019401 (serial number FS1002610). It goes through all cycles, drains out water, periodically, and dries the dishesat the end. But, when it ends, there is water at the bottom of the tub, at least 1 quart of water. I have to drain out the remaining water in the dishwasher. What is wrong?


Either the drain or screen is somewhat plugged, or a clog or jam in water pump. Many machines do leave just a little bit of water just so the sewer fumes don't come up. ... Kenmore Dishwashers

I have a Sears Kenmore Elite Ultra dishwasher 665.1315 model. For the last 3 weeks, it keeps having the clean light blinking 6 times pause then 1 blink and pause and repeats cycle again. I have turned off the breaker...I have reset by pressing the heated dry and normal wash until all lights are flashing. It then completes some type of cycle and looks ok. When I opened the door, steam came out and all was hot inside. However, once I try any new wash cycle, it seems to wash but after 1-2 hours and


Call sears service and tell them you need service there is a service flash and will be no charge ... Kenmore 24 in. 15932 Built-in Dishwasher

Bosch sgs6302gb I have this model dishwasher and did not use it for 1 year. I started it yesterday and found that after filling the water for 10 seconds the dishwasher suddenly stopped working. The power is there but the drain sounds which it normally makes in the begining is not happpening. Kindly help


The first thing that works is the drain pump at beginning of cycle check pump for blockage, if ok check voltage to pump , if you do not understand this answer leave well alone. ... Bosch 24 in. SGS45E02 / SGS45E08 Exxcel Free-standing Dishwasher

I have a maytag dishwasher model MDB8600AWQ that suddenly stoped working, no power lights on panel. I have had multiple problems with this unit with a complete service approxinamtely 1 year ago and had no problems until there just seems like there is no power to the unit. It is used infrequently and has been wwll maintained. Is there an easy solution or should I just give up on this unit.


Please refer to the diagrams on this site. \015\012\015\012If the ... Maytag Dishwashers

I have a GE Quiet Power 1, dishwasher. Model #GLD4200L00WW, Serial # TH837317B. It only has 1 soap dish with lid, no open dish for 1st wash?? Do I put only soap in the closed soap dish or do I put a scoop in the bottom of the washer and a scoop in the closed dish??? Thank you for your time.


... Maytag Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1753 seconds