Having problems with your Kenmore 17252 Free-standing Dishwasher ?

Vent cover removal from Kenmore 17252 dishwasher door, for cleaning

\015 Our particular dishwasher model has a circular vent on the inside of the dishwasher door. It was suggested I remove it in order to clean it out, as our dishwasher fails to dry our dishes. Do you know how it is to be removed, as it appears it wants to break when I try POPPING it out. Please advise.\015\012\015\012Kayzy\015

Answers :

Kayzy\015\012If you remove the bottom kick panel you'll find the pouch with technical data on the inside part of it. You will find a complete instruction how to remove the vent.\015\012Gendos...post back
Repair Help & Product Troubleshooting for Kenmore 17252 Free-standing Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Vent cover removal from Kenmore 17252 dishwasher door, for cleaning


Kayzy\015\012If you remove the bottom kick panel you'll find the pouch with technical data on the inside part of it. You will find a complete instruction how to remove the vent.\015\012Gendos...post back ... Kenmore 17252 Free-standing Dishwasher

Kenmore 17362 dishwasher was making a bad noise and now the motor seems to be locked up. I might have already un-jammed the motor by removing the cover on the bottom (inside), and turning the knife impeller on the outside of the screen, but I can see lint type material in the hole on the other side of the impeller. Hard to explain, but it is in the hole in the center of the unit and there is a screen like the knife impeller has behind it. I could clean this lint if I could get the door off. How


... Kenmore 24 in. 17362 / 17364 / 17369 Built-in Dishwasher

Remove door vent on kenmore elite dishwasher - Kenmore 15129 Built-in Dishwasher


... Kenmore 15129 Built-in Dishwasher

I have a Bosch Dishwasher, Model SHE46C06UC. No mater what cycle I start it in, it simply activates the drain and continues to run without ever starting. Within the last week prior to the dishwasher not working, I noticed a low hum/vibration emitting from the dishwasher. I've clean out the screen and drain filter, removed the pump cover to check for any debris. I've manually added water and it does drain. Additionally, the drain cycle continues to operate even with the door open.


First thing you may want to check is the door switch. You can pull it off and measure the resistance with an ohmmeter. If you get good reading while pushed in and none while switch button is released, then it is a good start. Next, you may want ... Dishwashers

Bosch dishwasher SHU3032 UC/14. The soap dispenser does not open. In the past I've used dishwasher magic or similar to clean the dishwasher of hardwater deposits and that solved the problem. The cover opens and closes manually. The springs seem fine. I removed the door skin and the linkages look good. I checked the resistance on the Wax motor and it is with in spec, approximately 2150ohms. I 've watched the cycle and the wax motor never seems to actuate. I put my meter on th


... Bosch Dishwashers

Whirlpool DU980QPDQ3: As per FixYa solution, I was successful in removing the inner panel of my dishwasher door in order to clean it. Since reinstalling the inner door panel, including the cover and drawbar for the detergent dispenser latch, the dispenser door will not open during the wash cycle. I have checked everything and cannot figure out what is wrong. I have only been able to locate disassembly instructions, but not the detailed assembly instructions that I need to get the dispenser do


Here are a few videos that may help\015\012Click on the link http://www.youtube.com/watch?v=MDideDjjuEU\015\012\015\012Click on the link ... Dishwashers

My kenmore elite - model 8525879 is not getting dishes clean even with pre-rinse by hand. It is also leaving soap scum on glasses that is so bad, I had to hand wash my glasses with a brillo pad to remove the scum. The inside of the dishwasher is also covered with a white scum. The dishwasher is new. Not even a year old. I am using liquid detergent and rinse aid.


Hi, \012I have an older dishwasher also and recently my wife alsocomplained about it not cleaning right... so me being the man I am tried invain to clean the things... Bought new spray arms online and installed them inminutes...now the thing works li ... Kenmore Dishwashers

Vent cover removal kuds301 vbl3 - Kenmore 17252 Free-standing Dishwasher


Do I need to remove the inside door to my KUNDS301-VBL, to change out \012the automatic soap dispenser? Its cover latch does not work. I need to \012reinstall a new latch cover. ... Kenmore 17252 Free-standing Dishwasher

Kenmore Model 1590 Dishwasher, 1985, sitting unused since about 1994. Takes water into tub but never goes through any washing/rinsing cycles; water stands in bottom (I stop it below door level). A click, like a solenoid activation from the timer area, but motor never does anything. Removed the shroud covering what I assume is the impeller, which was stuck, but freed it by turning several times...made no difference. Suggestions??


... Kenmore Dishwashers

Kenmore dishwasher leaking from upper vent in door


... Kenmore Dishwashers

I have a Kenmore Elite Dishwasher about 7... Problem with the Kenmore Dishwashers I have a Kenmore Elite Dishwasher about 7 years old. The Model # is 665-16462300. It works beautifully, except that about every 2 months the spray flow intensity ( and the cleanliness of the dishes) drops significantly. The cause is the metal screen located just upstream from the sump is clogged with food particles. I have taken apart the dishwasher several times to remove, clean and replace the screen. This fix wo


Check the inlet hoses; if the catch screens have sediment build up, that will reduce the pressure of the rinse water. Also, look for missing plugs on the rinse arms... ... Kenmore 24 in. 16462 / 16464 / 16469 Built-in Dishwasher

I have a GE dishwasher (GSD4020Y70BB) new in 1996. I replaced the whole motor assembly in 2007, seal was leaking. My dishes are not getting clean now, dried food left on plates, coffee stains in cups not being cleaned. I removed main spray arm, found nothing, turned washer on and plenty of water gushing out. I took the cover off sump all clean. I removed the filter screen in the back, there appears to be a valve with some soft rubber around it. Water gushes out of this, does stop during the cyc


Have you checked the drain pump impeller and drain hose? I am curious if there is a back siphon from the drain hose or the waste outlet at the garbage disposal might be blocked or plugged with food debris.\015\012I wou ... Dishwashers

We have a Kenmore portable Dishwasher one and a half years old. It ran fine for about 6 months then we saw a water leak from the lower right hand corner of the door. I cleaned the door gasket. It stop leaking for a while. It started leaking again. Cleaned and rest the door gasket again. It is still leaking. Unit drains fine and all other functions are correct. What is the fix?


... Kenmore Dishwashers

Maytag model mdbtt70aww. After the end cycle. open the door and found detergent tab on the bottom and the main wash cover is opened. Maytag diswasher model MDBTT70AWW. Put dishes and so forth in the dishwasher. Put detergent tab and jet-dry rinse agent in the pre-wash section. and close the cover. Start wash cycle after done over door and found the detergent tab on the bottom new the heater. The cover to the main wash is opened. Dishes are are clean. Wish someone would tell me


... Dishwashers

Hi. I have an LG LDF7810 dishwasher. I did a deep clean and ended up taking out a bunch of grease from the seal between the door-bottom and the tub. I even removed the door to get at the grease I thought was trapped back there. Since then it has been leaking water, sometimes a drip and a couple of times a few ounces have gushed out at the end of a fill cycle. Did I remove some factory grease designed to seal the door bottom? If so, what should I replace it with? If not, what else could the


It is possible that while you removed off the grease the water seal/oil seal was also damaged. Once the seal is taken out it can loose the sealing strength which can make it possible to leak.\015\012Hence it will be good to remove the seal and ... LG 24 in. LDF7810 Built-in Dishwasher

Dishwasher only faintly comes on. The detergent compartment opened but, there is a great deal of detergent residue on the inside of the door. Additionally, I removed the "mesh" drain grates from the base of the dishwasher and they are covered with chemical buildup. I was able to remove a good deal of chemical buildup. When the dishwasher would come on before, you could here the cycle start up, you could here the water, etc., now it is very faint, and you can barely hear any sound.


Hi, \012 \012I have an older dishwasher also and recently my wife also complained about it not cleaning right... so me being the man I am tried in vain to clean the things... Bought new spray arms onli ... Asko D3531XLHDSS Stainless Steel Built-in Dishwasher

I have a Whirlpool DU810SWLQ0 that will not drain. I've pulled the unit out, snaked the drain tube, pulled the motor/pump, and pipe assemblies, and cleaned the food trap, which I also removed. I've run the dishwasher with a bit of bleach, and the water will pump in, get processed by the agitator, and be heated. When the rinse cycle comes, dishes get covered in food, and are never clean. Waste water was being used for a clean rinse. I've run the dishwasher with the drain dangling in a bucket,


Refer the wash system assembly dwg. Check if the ball (item 21) is sitting correctly. If it is out of ali ... Dishwashers

Hi I have 4 yo sgs53e Bosch dishwasher which will not drain. I have removed and cleaned the filter, have undone the screw and removed the white cover, cleaned the tracks and ensured that the little propeller thing turns in both directions (requires a bit of a turn but does turn). I have run out of ideas as to what to do next.


Are you sure it is not draining ? \015\012what are thy symptoms ?\015\012mine (same model) stopped working yesterday.\015\012if you try to terminate the wash (follow instructions in manual), does it drain ?\015\012if it does ( ... Dishwashers

Dishwasher bubbles I have a kenmore elite mod- 16599201 stock # 16599 , recently there has been bubbles in the washer after the wash cycle ends . I thought that I might of put detergent in the jet dry hole so I removed the dispenser and rinsed the whole thing completely clean and reinstalled it. but the bubbles are still there . I think its the jet dry not completely rinsing away. I cleaned the dishwasher with vinegar and then glisten. My water temp is slightly low as I have my water heater set


... Dishwashers

Our Mieli Exclusive Plus Turbothermic Ultra has recently started to collect water in the ventilation unit positioned at the top left hand side of the door. I have removed the internal cover and cleaned the inside and replaced the cover but to no effect. At the end of the drying cycle there is obviously water in the unit and when the door is opened it spills onto the floor.


... Miele Dishwashers

Hi, I have a 10yr old Neff s5543 built-in dishwasher, it is has been working fine but recently has stopped fully draining. I have removed it from the housing and checked all pipe work is unblocked and not kinked, have also blown back down drain tube to free any blockages from drain pipe, have also removed pump cover and checked around impellor for any foreign bodies etc. Everything seems clean and free. I ran a complete heavy cycle (empty dishwasher) and allowed drain pipe to drain into a


Hello there and thank you for choosing fixyaOk there are acouple of things that can be checked on this along with what you have already checkedDrain solenoid\015\012 \015\012 \015\012 \015\ ... Neff 24 in. S5543X2 Built-in Dishwasher

The dishwasher will not drain. The motor hums. We have tried to remove the central unit inside the dishwasher, but cannot remove the inner black disk --it has a bolt, but we cannot get a good grip to twist it out. We suspect that under the mesh covering is a lot of gunk that needs to be cleaned out.


Hi,\012Here is a tip that I wrote that will help you with your dishwasher not drainingproblem...Dishwasher Problems - Waterwill not drain ... Dishwashers

Dishwasher model: se6 tie1 Fitted under kitchen work-top. Problem: After setting a program & switching on & closing door ? there is a normal sound from within but if door is opened there is no evidence of water being pumped in. I previously cleared food debris from the drainage pump area (including under the pump cover), checked the spray arms and checked the water supply was getting as far as the long in-take pipe. As it seems problematic to remove the (screwed in) dishwasher, I have not che


... Dishwashers

I'm trying to remove the disposal cover in the dishwasher (GE GSD3207P00WW) in order to clean it, but unlike previous models I've dealt with, this one has a filter thing that looks like a tilted plate, just under the main washer, and that has apparently a drainage tube (or some such) that goes down through the disposal cover, so I'm unable to remove it. How does one take that apart?


... Maytag Dishwasher

I have a Kenmore Elite Dishwasher about 7 years old. The Model # is 665-16462300. It works beautifully, except that about every 2 months the spray flow intensity ( and the cleanliness of the dishes) drops significantly. The cause is the metal screen located just upstream from the sump is clogged with food particles. I have taken apart the dishwasher several times to remove, clean and replace the screen. This fix works for about 2 months, then another cleaning is required, even though we h


... Kenmore Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.2222 seconds