Having problems with your Kenmore 24 in. 15173 Stainless Steel Built-in Dishwasher ?

I have kenmore dishwasher model 655' serial number 15639000 . It is leaking from the front. Almost in the middle. Checked door seal and it appears fine. What else could I check?


Answers :

Repair Help & Product Troubleshooting for Kenmore 24 in. 15173 Stainless Steel Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have kenmore dishwasher model 655' serial number 15639000 . It is leaking from the front. Almost in the middle. Checked door seal and it appears fine. What else could I check?


... Kenmore 24 in. 15173 Stainless Steel Built-in Dishwasher

Kenmore dishwasher I have a kenmore dishwasher and in the middle of a cycle all my front panel lights went off. I have checked the power going into the dishwasher it is fine. I also checked the door latch it is fine. Not sure what else to check? Same exact problem model number 665.15934 We have had nothing but problems with all of our sears products - highly suggest to SHOP SOME WHERE ELSE before you get stuck too.


Check the continuity of the thermal fuse (part # 8193762). It's clipped onto the electronic control inside the console.Let me know if you need more help. ... Kenmore Dishwashers

We have a leak around the door. It looks like it is around the bottom of the door. We can not find any reason for this. We have checked seals and everything else we can think off at no avaiel. Model 15919. We have found pieces of black stuff on the floor like maybe a protective cover that is deteriorateing . Other then that, everything else is fine. Thanks Dan


... Kenmore 15919 Built-in Dishwasher

Dishwasher is leaking water from the door somehow. I checked the seals on the door and they seem to be intact, what else could it be?


... Frigidaire 24 Built-In Dishwasher Black FFBD2409LB

My Kenmore dishwasher leaked out through the door and into the kitchen. It appears it is not draining and once the water reaches a certain level, pushes out the door. It did this before and we thought maybe the drain was clogged, but couldn't see anything. Ran it again and was fine but has now done it again. Could this be the control module or the overfill control, or something else?


\012\012Hi,\012Here\012is a tip that I wrote that will help you with your dishwasher not\012draining problem...Dishwasher Problems - ... Kenmore Dishwashers

I have an 8 year-old Kenmore 665.16912 dishwasher. Worked fine until two days ago. Then it stopped working altogether: nothing lights up on the front panel. I have checked the 120 in the electrical box, the door switch is working, the thermal fuse is working and there is 120 volts at the white and black connections to the timer control board. I bought a new timer control board for $120 and that did not fix the problem. What else could be causing the unit to completely stop working?


If all are really good then the only thing it con be is the display (8269205) $25.00 part, if it's bad dishwasher wont run ... Kenmore 16912 Built-in Dishwasher

Own a Kenmore 665 dishwasher. The clean light is flashing (7 times) and the machine won't run. Have pulled the control panel and checked the door latch switches and they appear fine. No obvious burned wires any where. Any ideas on what this could be? thanks


It sensed a problem in the heater circuit. try this sequence to reset the code. If it comes back again you will have to determine a cause.The reset sequence used was reported to be the following:\015\0121) Crack the door open. ... Kenmore Dishwashers

Model # PLD2850RDC2 has a leak at the bottom of the door. i have replaced the gasket in the vent. Had to remove door cover and seal at bottom of door. Had difficulty replacing bottom seal. How do I replace seal correctly? It is still leaking. Could it be something else?


The side baffels are bad. look on each side on the bottom in the corners and that is were their at just pull them out and get new ones ... Dishwashers

Door leak I have a small leak between the bottom of the dishwasher door the lower service panel on the dishwashere. I did replace the seal on the inside bottom of the door along with the other parts that come with the door seal. Could there be a gasket leak around the detergent dispenser or the vent at the top of the inside of the door. I did not check the water lever as was mentioned in a previous question on water level, but the float does move up and down quite freely. Any suggestions as to w


I had my dishwasher leaking alot at the bottom of the doo,r and found out that the steam vent was very cloged with gunk. After taking the vent cover off on the inside of the door and cleaning, then putting the vent cover back on NO MORE leaking. Th ... KitchenAid 24 in. KUDS25 Built-in Dishwasher

I have a Dishlex Global 450 dishwasher and have a faulty seal to replace. The original door seal had a foot on each side and the replacement I received has 45 degree cuts and no foot. Also the bottom seal replacement appears to be a screw-in type where the original was slipped behind a fold in the door. I have been assured by the supplier that I have received the correct replacement parts. Could you confirm the these parts are in fact correct and if they are which way should the seal lip an


Hello Tony. I am as concerned as you are that this is not the correct replacement part. The key to getting the right part is the model number which is on your machine, if you know where to look. Do this, go to this link to properly locate your mod ... Dishwashers

Hi. I have an LG LDF7810 dishwasher. I did a deep clean and ended up taking out a bunch of grease from the seal between the door-bottom and the tub. I even removed the door to get at the grease I thought was trapped back there. Since then it has been leaking water, sometimes a drip and a couple of times a few ounces have gushed out at the end of a fill cycle. Did I remove some factory grease designed to seal the door bottom? If so, what should I replace it with? If not, what else could the


It is possible that while you removed off the grease the water seal/oil seal was also damaged. Once the seal is taken out it can loose the sealing strength which can make it possible to leak.\015\012Hence it will be good to remove the seal and ... LG 24 in. LDF7810 Built-in Dishwasher

Electrolux ESL 63010 dishwasher. This worked fine until the door catch broke. I replaced the catch but could not remember which way round the two electrical leads went (red and black). I tried both ways with the same result. The lights come on the control panel and I can change the programme, but on closing the door the house fuses blow. I have checked the earth cable is fine. Any ideas?


Red - is active powerblack - ground or neutral ... Electrolux Dishwashers

Dishwasher leaking We bought our dishwasher in Sep/07, it was fine for a year, then started leaking out the bottom of the door on the left. We had the seal on the door replaced (didn't work) and then the door gasket replaced. That worked for less than a year, now it is leaking again in the same place. What could be going on? Have already put $400.00 repairs into this machine and am reluctant to put more money in to have it break again the same way. What do you suggest?


This sounds like a hinge problem to start with.\015\012\015\012Test the seal by dragging a strip of paper through it with door closed. Probably that left hinge isn't holding door close enough which was probably the original cause. As se ... KitchenAid Architect? II S SERIES KUDS03FT Stainless Steel Built-in Dishwasher

Leaking dishwasher leaks intermittently. I removed the side panels and there is no sign of water in the base of machine. Door seal seams to be intact. What else can I check. Seal that needs replacing? Machine is 18 months old. seams to leak on the right side of the machine. Please advise. many thanks. My dishwasher showed the error code either OE or E1, I think it was more OE. I stuck my hand in the filter in the bottom of the machine and then it was okay but the next time it was used it leake


What sort of soap powder do you use\015\012some soap powders foam a lot in machine causing dishwasher to leak through seals\015\012also check that the machine is square that is the door is closing parallel with cabinet\015\012do no ... Dishwashers

I have a G2500VH pressure washer that has started to pulse when the trigger is squeezed. This happens if I use the 0,25, and 40 degree nozzles BUT if I use the one for low pressure(detergent use) it will hold pressure fine. I have changed the unloader valve, checked all the valves and seals ad they seem to be fine. What could be the problem?


Do you mean pressure on and off with the hp tips and smooth and steady with chemical tip? ... Pressure Washers

Our Phillips SL2000 dishwasher (~20 years old?) has a leak from the door right hand bottom end when its splashing. The seals appear to be OK to touch and slightly pressing the door inwards does not reduce the leak. What could be the reason and is it worth repairing? The inside looks really good for its age and I am trying to extend its life at least a few years with minimal cost. Please advise.


When one of the sprayer arms develops a leak and sprays water in a downward direction toward the bottom of the door it can leak because it's not made to be sprayed on the seal in that direction. You might get wet but hold the arms still and watch for ... Dishwashers

My GE Profile dishwasher which may be 10 years old has worked perfectly until today. We push start and nothing happens. We have checked the breaker box and all appears fine. What else should I check?


Check for a blown fuse or ... Dishwashers

Middle and top spinners do not spin The pump is pushing water up the back delivery tube. There are no dishes in the unit and I was able to trick the door into thinking it was closed so I could watch what was happening. Or Not Happening The spinners are completely free of calcium or soap build up and both top and middle are easily spun with a finger. While the pump and bottom spinner were working, I pulled the top drawer out partially and there appeared to be a good flow of water coming out of


Hi,\015\012 Remove each spray arm and check it is clear of food particlesat the jets. The next problem may occour at the rotating joint . If the seal is not good, you can loose a lot of water out of this point.. If both of these seem reasonable ... Dishwashers

We are having water leak from the bottom of our Roper Dishwasher door. THe model # is RUD5750DG3. I have taken the inside door frame off and found a small white rubber seal had dislodged inside. i placed it back in the only sopt it fits but water is still leaking. I have checked to make sure the water is not leaking from any where else on the dishasher. This occurs when the water inside is spraying and eventually fills up on the bottom. We no longer have our manual as the dishwasher cam


Try to fix the rubber seal which has come out by fixing it through super glue or apoxy seal which will stop the water spill and leakage.\015\012Please give more details of you dwasher ..... the Make and model so that i can send you the manual f ... Dishwashers

Leaking dishwasher leaks intermittently. I removed the side panels and there is no sign of water in the base of machine. Door seal seams to be intact. What else can I check. Seal that needs replacing? Machine is 18 months old. seams to leak on the right side of the machine. Please advise. many thanks.


There are screws on the inside of the door on a lot of those\015\012try to tighten them down a little sometimes that can cause a leak. ... LG 24 in. LD-12BW5 Free-standing Dishwasher

The dishwasher stop during the wash cycle. It did finish draining the water from the tub. The machine is not showing a power signs, I check the circuit breaker and the fuse is not tripped. I open and closed the door and the door latch seems to be working fine. There is just no power to the washer. Usually when a machine breaks down, there still is power or buttons that light up on the front of the machine. I looked on the internet and many say that the fuse could be tripped. No where can I find


... Whirlpool DU912 Dishwasher

Kitchen circut was accidently turned off. Now whirlpool gold disher will not work(unit was not running and the door was not closed all the way when circuit was turned off, All circuit breakers are on) There are no lights on display when door is closed completely, and it appears to have no power. Worked fine prior, what could it be? The unit has not been removed from under the counter yet. Is there a fuse or circuit breaker on the unit? If so where is it located? Other troubleshooting ideas


Hello- Turn power off. Remove kick panel and cover for power wires. Check connections. If these are ok, most likely suspect is a fuse at the control. This is a little harder to get to. Remove inside door panel screws. Unplug wires and remove panel. F ... Whirlpool Gold 24 in. Built-In Dishwasher Dishwasher

My dishwasher is a Smeg model STA 6143, and the door won't close. It seems fine until the last few centimeters, then it jams and won't close easily. If you press hard, it'll shut but not latch. Nothing appears to be stuck anywhere. We've tried jiggling the door but it seems somehow to be misaligned, although there's no reason why it should all of a sudden appear to be so. The electronics work fine, the racks fit fine (we also removed them, and the door still won't close), and nothing appear


... Dishwashers

ENGINE STARTS FINE BUT ALMOST IMMEDIATELY DIES, CLEAN PLUG & NEW GAS APPEARS THAT IT'S NOT GETTING ANY GAS BUT CHECKS OUT OK


You may have some condensation trapped in your carburator. I don't know about your make and model, but small engine 101, gas and spark ought to make something happen. If you have good gas and good spark, there's something denying the gas access to th ... Pressure Washers

My Hotpoint LFT04 has always had some water/steam escaping from the top (1 yr old) which has ruined our door front. Now it has steam shooting out the top and bottom! The seal looks to be fine, so what could this be? Thank you


... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1593 seconds