Having problems with your Kenmore 24 in. 15252 / 15254 / 15259 Built-in Dishwasher ?

Kenmore dishwasher mod# 665.16362300 spinner falls off.

\015 There is a spinner, part #8193768 located at the top of a Kenmore mod# 665.16362300 dishwasher. It falls off along with the retaining hub. I replaced the spinner and hub. I did not replace the top pin because the replacement parts didn't describe how to get to it.The replacement worked for about two month but it has fallen off again\015

Answers :

Repair Help & Product Troubleshooting for Kenmore 24 in. 15252 / 15254 / 15259 Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Kenmore dishwasher mod# 665.16362300 spinner falls off.


... Kenmore 24 in. 15252 / 15254 / 15259 Built-in Dishwasher

Small Burn spots on interior tub below heating element. These spots have small cracks in center of them, and leak right through the bottom of the tub, dripping water all over under the dishwasher. Nothing has falling into the bottom of the tub, and nothing has touched the heating element. What in the world could be causing this to happen? Kenmore Ultra Wash Quiet Guard 4 Mod.# 665.1603* Purchased new from Sears 2006


Hi,\015\012\015\012The heat from the element when the dishwasher is in the "drying" mode has caused the bottom to stress crack and become open so it leaks...\015\012Ultimately this will cause you to have to replace the dishwasher... ... Kenmore Dishwashers

Kenmore dishwasher mod 13742K604 parts list - Kenmore Dishwashers


... Kenmore Dishwashers

I have a 7 year old Kenmore 24" (mod. 16532201) built-in dishwasher. For the past several months now I have noticed a dark almost greasy film covering the inside of the dishwasher after doing a load of dishes. It can also be found around the soap dispenser door, basically everywhere. I'm wondering if the black rubber around the inside front of the dishwasher is deteriorating. It doesn't appear to be damaged or cracked. I have tried "Finish" dishwashing cleaner several times, but to no avail


There are several items apart from the door seal in the dishwasher that comes in contact with the wash water that circulates inside the dishwasher.\015\012\015\012One will have to eliminate one by one - the most likely cause is the washer ... Kenmore 24 in. 16352 / 16354 / 16359 Built-in Dishwasher

Dishwasher how do i fix a broken roller. the rollers are fixed to the wall of the dishwasher. how do i get the wheel hub off the wall. the machine is a kenmore elite dishwasher mod# 665-16469300 ser# fp4803075


... Kenmore 24 in. 16462 / 16464 / 16469 Built-in Dishwasher

Hi, I have a Kenmore 15879 that is basically working except the bottom water spinner...lol (don't know technical name). The dishwasher pumps the water into the bottom of the dishwasher, will heat the water, but not disperse the water in the spinning sprinkler manner it's suposed to. I've opened the dishwasher in time to see that water is spurting out of the holes about 2" high, but it's just not spinning. The water also drains just fine after the whole cycle.


This is caused by the impeller being clogged or the pump is failing, When the pump is woring properly the water will shoot out with force. ... Kenmore 15879 Built-in Dishwasher

Top spinner arm of dishwasher keeps falling off


Did you solve this. we have the same problem. the piece that the arm is connected to is slightly broken. I don't want to pay for a service call. let me know what you did. ... Dishwashers

I have a Kenmore Ultra Wash Dishwasher model 665.16379301. The spinner from the top of the dishwasher has come off. I have a replacement part but need to know what is required to replace it. Do I need to remove the feed tube assembly in order to replace it?


... Kenmore Dishwashers

Kenmore Ultrawash Dishwasher #665 - The drain is clogged and water leaks out when the dishwasher runs. How do you lift up the spinner so you can clear the drain?


... Kenmore Dishwashers

Kenmore Dishwwasher My Kenmore mod. 363.15555993 dishwasher is not working because no water is going through the system


Test this steps and fix it. God bless youPower Supply\012\012\012\012The main power supply is the first thing to check. Also remove the toe \012kick and the cover on the power box and check the connections. Also check 120 volts at ... Dishwashers

I have a kenmore ultra wash mod# 665.13492k600 dishwasher that in the last couple of days will not drain the last cycle . If you push the cancel /Drain button after the cycle is finished it will then drain but all the dishes have soap spots on them and are very wet .I have checked for clogs but cant find any I have also run a lot of water throug our waste disposla because the dishwasher drains into it help ??


... Kenmore Dishwashers

Kenmore Ultra wash III will no longer stay connected to faucet after filling...what part should I replace the hose or the faucet adaptor? When we turn the faucet on to start up the dishwasher it falls off...when we finally get it to stay connected with water on...it will fill but then falls off again...get it to stay on, it empties, but then after it has completed filling up again it disconnects from the faucet.


If your adapter that hooks up to the faucet has 4 little white plastic jaws inside it then it can be rebuilt. there is a kit that replaces those 4 jaws, the spring, the attaching clip and the internal seal.. usually runs around 10 buks or so. if i wa ... Kenmore Dishwashers

Dishwasher bubbles I have a kenmore elite mod- 16599201 stock # 16599 , recently there has been bubbles in the washer after the wash cycle ends . I thought that I might of put detergent in the jet dry hole so I removed the dispenser and rinsed the whole thing completely clean and reinstalled it. but the bubbles are still there . I think its the jet dry not completely rinsing away. I cleaned the dishwasher with vinegar and then glisten. My water temp is slightly low as I have my water heater set


... Dishwashers

Kenmore Drawer Dishwasher - inlet/outlet bezels fall off during wash causing leaking. Bezels break/disintegrate. Kenmore needs to make the bezel out of a different type of plastic, or offer a refund.


... Kenmore Dishwashers

Kenmore dishwasher Mod.#66516039403 stop running thru cycles,clean light blinking


... Kenmore Dishwashers

Kenmore Elite dishwasher model 665 touchpad buttons falling off


WE HAVE THE SAME PROBLEM. DID YOU FIND A FIX FOR YOURS? ... Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher

I have a Kenmore Ultra Wash Dishwasher and the 3rd level spinner broke off. I have a new one and now need to know how to replace it.


You don't have to remove the top dish rack, but it might be easier unless you're flexible. To remove the dish rack, remove the "stop" clips from the front end of the tracks and pull the dish rack out.Remove the screw holding the water supply fe ... Dishwashers

My dishwasher Kenmore Elite mod 665.16283402 does not clean dishes seems like cycle is running, but everything comes dirty lower impeller moves but two upper ones does not change their position at all all the sprinklers are not plugged, inside no food pieces what possibly could be the problem thanks Greg


... Kenmore Dishwashers

Kenmore dishwasher keeps flashing clean, it wont run please help mod #665.17019401


This may help in your situation. The following link explains how you may be able to clear the blinking clean light problem:http://www.f ... Dishwashers

I have a broken motor of the timer control. where can i buy one? Kenmore dishwasher mod:360.15677000


Try a sears appliance parts store they carry all parts for any kenmore it is their brand name ... Dishwashers

Require a parts manual for a Kenmore Dishwasher 18" Mod. Nu. 587.14249991


Purchase a new dishwasher. ... Kenmore Dishwashers

Kenmore dishwasher mod # 363.14375791 hums, wont fill or run


Are you sure the valve is what is humming? If so, it may have went bad again. Its not unusual for that to happen. You could possibly have a timer going bad, or a ground issue. If it is the valve humming, check your water supply, and be sure you d ... GE Dishwashers

Kenmore dishwasher mod. #665.16912001


... Kenmore Dishwashers

My water spinner burnt to the heater coil - Kenmore Dishwashers


It was the piece at the top of the tub wasnt it?it fell off and got hung under the element didnt it? mine did the same thing. well it burned a spot on the tub sears has that piece pretty cheap. I didnt worry but later the tub material cracked at that ... Kenmore Dishwashers

Sears kenmore dishwasher mod. #665.17269402 when i opened the door the clean light never went off. now it seems like it wants to start or drain but doesn't do anything.


... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1830 seconds