Having problems with your Kenmore 24 in. 15689 Built-in Dishwasher ?

My dishwasher wont start after the power outage. all the lights are working fuse box is checked also.


Answers :

Please follow this steps and fix it. God bless you

1. No power to the dishwasher
\012\011\011\011\011\011\011Make sure there's power getting to the dishwasher. Check for a \012tripped circuit breaker or a blown fuse. Check the wall socket for \012power. Sometimes the power cord disconnects at the dishwasher (inside \012the junction box, behind the bottom kick panel), if this is the case, \012the wiring must be repaired or replaced.
\012\011\011\011\011\011\011
\012\011\011\011\011\011\0112. Door switch
\012\011\011\011\011\011\011Replace if defective.
\012\011\011\011\011\011\011
\012\011\011\011\011\011\0113. Timer or Control Electronic
\012\011\011\011\011\011\011Replace if defective (note: uncommon problem).
\012\011\011\011\011\011\011
\012\011\011\011\011\011\0114. Selector switch
\012\011\011\011\011\011\011Replace if defective (note: uncommon problem).
Repair Help & Product Troubleshooting for Kenmore 24 in. 15689 Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My dishwasher wont start after the power outage. all the lights are working fuse box is checked also.


Please follow this steps and fix it. God bless you1. No power to the dishwasher\012\011\011\011\011\011\011Make sure there's power getting to the dishwasher. Check for a \012tripped circuit breaker or a blown fuse. Check the wall s ... Kenmore 24 in. 15689 Built-in Dishwasher

Dishwasher will not start, no lights come on. There is also standing water at the bottom. Can you help point me in the right direction? Went to start the dishwasher and none of the controls on the panel are working or lighting up. I checked the fuse box and all fuses are good.


... Frigidaire 24 in. GLD2350RC Energy Star® Built-in Dishwasher

Hello, Our kitchenaid DW has stopped working. Non of the buttons cause a any of the lights to turn on. Of course, it will not start. On its last working cycle, it had a very strange washing cycle. It almost sounds like the water was not splashing around (even though I opened it while it was working and noticed water at the bottom). I checked the circuit breaker, and it is not tripped. For a couple of weeks, the DW had started making a kind of metallic noise while in the washing cycle. Also,


It is nice to see a problem described with such a depth of observations. It helps in closing on to the possible causes of the problem.\015\012\015\012For the moment let us make sure there are no remnants of the glass left in the dishwashe ... KitchenAid 24 in. KUDI01FLSS Stainless Steel Built-in Dishwasher

White knight dishwasher dw1260WA will not power up. The light doesn't come on either. Machine was in the middle of a programme but stopped with water left in it. at that time the light was working but even the light doesn't come on now. I also removed all the excess water out of the machine...I've also checked the fuse and it is fine. Any suggestions?


... Dishwashers

My Whirlpool Quiet Partner IV dishwasher model number GU3600XTRY1 has stopped working. The normal light on the top panel is flashing and one lighted bar is showing in the start touch circle. Upon throwing the breaker in fuse box panel seems cleared but when you try to press any buttons it makes a starting noise for a few seconds then goes quiet and returns to the state above.. My buttons on top are Accusense, pots&pans, normal, light, glass express, rinse only Soak and scour Hi temp wash


I think I just responded to this problem. Please accept both if you are happy with the solution. ... Dishwashers

Kenmore dishwasher... filled up with water and its lights went off.. no buttons work acts like no power. check the house fuse box - ok ... check the 2 door switch - ok .. checked the thermal fuse - ok ... so, i picked up a new board and changed it out. still wouldn't run.


Did you check power to the unit? Double check the common and grounds. When servicing I will disconect(unplug from wall) power to the unit. Is it pluged in? Use another outlet(the outlet under the sink may be wired thru a switch for a disposer)even ... Kenmore 24 in. 16032 Built-in Dishwasher

My Whirlpool Quiet Partner IV dishwasher model number GU3600XTRY1 has stopped working. The normal light on the top panel is flashing and one lighted bar is showing in the start touch circle. Upon throwing the breaker in fuse box panel seems cleared but when you try to press any buttons it makes a starting noise for a few seconds then goes quiet and returns to the state above.. Thanks


... Whirlpool 24 in. GU3600XTRY Stainless Steel Built-in Dishwasher

I have an 8 year-old Kenmore 665.16912 dishwasher. Worked fine until two days ago. Then it stopped working altogether: nothing lights up on the front panel. I have checked the 120 in the electrical box, the door switch is working, the thermal fuse is working and there is 120 volts at the white and black connections to the timer control board. I bought a new timer control board for $120 and that did not fix the problem. What else could be causing the unit to completely stop working?


If all are really good then the only thing it con be is the display (8269205) $25.00 part, if it's bad dishwasher wont run ... Kenmore 16912 Built-in Dishwasher

Built in model MDB5601AWB- about 3 years old. The touch panel stopped working..no lights would come on when touched. Tried it a couple of days later. Lights came on..finished a cycle. after satying in the wash mode for a few hours. Then lights started flashing on and off. At that point I shut it off at fuse box since I couldn't get lights to stop blinking and haven't trusted to use since


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks\015\012for using FixYa. From what you have described it seems to be the ... Maytag Dishwashers

Wont start I've had the washer for many years with minimal problem. Yesterday when I closed the door no light went on and the washer would not start.  After 20 minutes or so it suddenly went on and worked fine.  I thought that it might have not completed its last cycle. Today, however, I had the same problem and it's been over an hour and still hasn't started. (I checked the circuit breaker and it's fine)


Give it a firm push over the door latch once you've closed the door..it might be the door switch not activating. oops.... first and formost isolate from power for 5-10mins and try ... Bosch 24 in. SHU43 Built-in Dishwasher

Cycle interrruption Recently, about 20 minutes into the wash cycle, the unit shuts down and the lights start blinking - usually "Pots & Pans" & "Quick Rinse" simultaneously. No other buttons respond and I cannot get it to finish the cycle. Only shutting down the unit at the fuse box eliminates the lights. I've checked for blockages and nothing found. Manual does not offer any help or suggestions. Any ideas??


Relace control board. ... Kenmore 24 in. 16032 Built-in Dishwasher

I can't get the igniter to start on north start pressure washer #157224. Fuses ok, indicator light in heat switch does not illuminate. Blower works, fuel dripping out. Cleaned fuel tank and pump and filter too! Tried jumpering past the thermostat didn't help either. Also, swapped pump and heat switches on main panel. No help!


... Pressure Washers

Wont start..light wash lights up and delay wash lights up but start button wont work. replaced handle and it worked one time


There are two micro-switches just inside the handle mechanism that apply power when the door latches. You need to remove the interior panel to access. Hope this helps! ... Maytag Dishwashers

Wont start Won"t start. Some program lights work, then shut off within a few minutes. Example: The SmartWash, Heated Dry, and Start lights will work, then go out. The NormalWash light will not work


We walked away from it for about an hour, came back, reset it, and it started. Thank you. ... Kenmore 24 in. 16022 Built-in Dishwasher

I set my dishwasher to wash last night (delay 2 hrs.) and I checked it this morning and it never washed. Yesterday, I had to turn off the dishwasher at the breaker box because it wouldn't reset. Now, the normal wash and heated dry lights are on, but it won't start. Also, it usually beeps when I close the dishwasher door, and now it won't even do that. We bought the dishwasher about a week ago. It a GE Profile dishwasher. Thanks, Chris


\015\012\015\012\015\012First off all try to close the door tightly with your hand till you hear a beep.dont force very much.\015\012as you mentioned that unit normally gives a beep when door is closed.but not it is not giving that beep w ... GE Dishwashers

We had a new heat pump put in yesterday. now our maytag jetclean wont start...no noise..no lights..nothing...is there a fuse we can check?


... Maytag 24 in. MDB3700 Built-in Dishwasher

See below This is a post that I just copied to this space "I have a whirlpool Quiet Partner II, Model GU2400XTB1, that just suddenly will not start, as if the power was cut. Circuit breaker is fine. from the little Internet research I've done it looks as thou it could be a thermal fuse problem. How easy are these to replace, assuming that's what it is?" Mine is quiet partner III ... there is power to the connection box at the dishwasher it self (checked w/ light tester) ... but there is no power


Have you tryed leaving the power cord out of the socket for an hour or so sometimes they don't lose the memory until they have been left disconnected for a while ... Whirlpool GU2400XTP Built-in Dishwasher

Dishwasher wont start, no lights on, checked fuse.


... Bosch 24 in. SGV53E03 Built-In Dishwasher

I push start and my dishwaher wont turn on. I have checked the other buttons and they work. I also turned off my breaker to see if that will help and it still doesn't turn on,


Either:\015\012\015\012something blocks the door from latching or closing. Check, if anything is stuck behind a dishrack. try reversing lower rack. check if the door aligns properly and dishwasher is installed correctly ... Magic Chef CDB1500AW 24 in Builtin Dishwasher

Dishwasher does not wash simply beeps continously and wont start the rinse cycle with green flashing pre rinse light. Have tried turning off at power and have checked all connecting pipes. Have emptied dishawasher also all to no avail.


If your dishwasher is a whirlpool or IKEA then maybe the answer given by emmanuelr in "Whirlpool dishwasher ADP5962 F7 error code" may do the trick. It certainly worked for me. Bit technical but if you are happy taking the sidepanels off the thing th ... Whirlpool 24 in. GU2500 XTP Built-in Dishwasher

The water inlet valve dose not work, therefor the machin can not start. The inlet water signal light is off, however I checked the water pressure that was ok, also there is a noise in the valve. Is the valve is damaged???


Hello,Welcome to FixYa. ... Bosch 24 in. SHE44C02UC / SHE44C06UC / SHE44C07UC Built-in Dishwasher

Dishwasher lights work but wont start


... Frigidaire Dishwashers

DU1145XTP The buttons don't all work--for a while the normal wash and heated dry were the only functions that worked--now the start button doesn't work. I took the panel off and clicked the door switch and held it and got all the cycle buttons to light up except rinse only and only heated dry in the cycles would light up. The delay buttons don't work and neither does start. Also the panel seems hot.


You need to replace the circuit board inside the machine, technically it is possible for you to do it, how long have you had the machine, if it is under warranty you can have it serviced without any cost or less cost to you contact Whirlpool ... Whirlpool 24 in. DU1100XTP Built-in Dishwasher

The touchpad buttons no longer work to select a wash cycle. When I push "Start" the light above "Smart Wash" comes on and the dishwasher operates normally, but I cannot select any other cycles and the light only comes on after pressing "Start", not before. Also, the Options buttons seem to work normally but the delay button doesn't scroll through 2-4-6, it only toggles the light on and off above "4". The item is 15 months old. Thank you.


... Kenmore 13743 Staimless Steel Built-in Dishwasher

Dishwasher is not starting. The detergent lid is closed. Door is secure and locked. Tried all three wash settings, i.e. heavy, normal, light. Tried with and w/o heat dry. I also checked the breaker bo


I can't say for sure but it sounds like you lost house power to dishwasher. Being that the breaker is OK remove the dishwasher from cabinet and check power at the dishwasher. Its quite possible that mice may have ate through the wiring ether in the w ... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1731 seconds