Having problems with your Kenmore 24 in. 16029 Built-in Dishwasher ?

Normal wash light blinks, machine will not run. No reset key code exists on the kick plate or inside the washer door panel. I have cleaned to drain hose and hot water supply is ample. Thanks Model 16029


Answers :

Repair Help & Product Troubleshooting for Kenmore 24 in. 16029 Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Normal wash light blinks, machine will not run. No reset key code exists on the kick plate or inside the washer door panel. I have cleaned to drain hose and hot water supply is ample. Thanks Model 16029


... Kenmore 24 in. 16029 Built-in Dishwasher

Hi there, I have a Whirlpool Quite Partner 1 dishwasher. It was working fine until today the water would not drain. I detached the drain hose and it was clean as a whistle. When I had the drain hose off I ran hot water and it was draining through clean. What else could it be? I have no idea how to fix this. Thanks.


Hi,Here is a tip that I wrote that will help you with your dishwasher ... Whirlpool 24 in. DU900PCD Built-in Dishwasher

Front panel My dishwasher wouldn't drain. I read I had to remove the front panel under the door and get to the hose to look for a blockage. I screwed out two screws on the side of the dishwasher and removed the white front panel just under the door. But then there is another metal panel and I can't loosen it. Is it just stuck or is there soem way of doing this? Elmi


Did you knock out the plug on the disposal before you hooked up the drain hose ? ... Bosch 24 in. SHE44C02UC / SHE44C06UC / SHE44C07UC Built-in Dishwasher

Removed rear toe-plate to detect leak. Leak caused by broken drain hose. Hose replaced. To do this the unit was tipped forward onto its front door to allow access to the base area. Water allowed to drain out the front base area. Unit re-assembled but now does not switch on. Water connected. Base-plate dry. No water was detected at upper-front control panel. Power is connected and reaching unit ( multi-meter test ). Tipping the unit forward seems to be the cause. Is there any fuse,


The micro switches are frequently replaced on the door handle and they don't need to ever get wet. A lot of amp draw burns those switches up while they are dry. If they were wet and power was applied then they got fried my friend. The good news is th ... Dishwashers

I am having issues with my dishwasher where it appears to be working but does not clean. Hot water does enter the unit and drains properly but is not cleaning. Muck is still on the door, the arms are wet. Also, normal cycle with no extra features selected (i.e. High Heat, etc.) takes over 1 hour and 20 minutes. Sounds appear to be normal, draining, filling, etc. Thanks!


No\015\012 you need not wash the dishes but just cleaning of the debris and then \015\012putting it in the dishwasher for proper cleaning will help you to \015\012prevent the drain from getting blocked.\015\012\015\012 ... Dishwashers

My Kenmore Elite suddenly stopped filling with water. I pushed start but when I checked it hours later the soap dispenser door had opened, the soap is just lying in a puddle, and nothing is clean but the clean light on the front panel is blinking. I tried again to no avail. Any ideas? I've had the machine since it first came on the market and have had other issues with it--it never drains completely, it makes sounds like someone revving a sports car engine when the drain pump is engaged, my dish


Https://secured.whirlpool.com/Service/SrvTechAdm.nsf/2cd44500d572193285256a4 ... Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher

I have a Bosch SGE63E05UC dishwasher that keeps intermittently showing an "E:25" error code. Occasionally it will get all the way through a cycle without going into error, but more often than not it will error and stop. So far the main control module in the front panel and drain pump have been replaced and the problem persists. All hoses have been checked and are clean (unit is only 1 year old) and drains well, when it does drain. Any suggestions?


... Bosch SGE63E05UC 24 in Builtin Dishwasher

We have water leaking out of bottem of door when my MDB4000AWB is draining on last cycle.I took drain hose off under unit and is clean.Hose is also clean at air gap.What should i check next? Thanks, norcalstevo


Hi,\012Here is a tip that I wrote about dishwashers and them leaking.Leaking Dishwasherheatman101\012\012sthyushg ... Maytag 24 in. MDB4000 Built-in Dishwasher

My Bosch dishwasher SGS46E26GB/90 makes a knocking noise when started. the timer does not advance and the check water light comes on.There is water in the bottom (up to the bottom of the door) . If I reset the DW the water drains ok. If I mess with the buttons E3 shows on the display the 'quick' light stays on and the eco light flashes. I've checked the filter where the water hose is fastens to the rear. I've cleaned the filters at the bottom of the DW and cleaned out the pump area under them.


... Dishwashers

Have a whirlpool gold dishwasher.The problem is that the clean lite on the control panel flashes not allowing the unit to work.I installed a new disposal and forgot to remove the plug for the dishwasher drain hose.When the flood happened I opened the door in order to stop the dishwasher.Now the unit will not work.The lite flashes 7 time ,then it pauses and flashes 7 times etc.Is there a reset procedure to run in order to get the unit to work or do I need to buy a new control panel?


HI,Can you please give the make and the model no. so that i can give you the manual.Waiting for your reply ... Dishwashers

My Frigidaire 4000 Dishwasher panel board is lighting up with almost all lights on/flashing. When the door is closed the pump engages and ther is no water in the machine. If we put water in it drains successfully. The following is flashing on the control panel: washing, drying ER, clean and s. Up top lighted up is china crystal and rinse only. What is going on?


... Frigidaire 24 in. FDB1050REC Stainless Steel Built-in Dishwasher

My GE dishwasher will fill then it stops. The wash cycle never happens. After a while the heating element gets extremely hot, it drains, then says it is clean. The soap is still all over the door. It's a GE Quietpower2 # GLD5500L00BB and it's about 5 years old.


The pump/motor combination is stuck.Disconnect power to the unit.Remove the toe-kick panel at the bottom front.You will see fan fins at the back of the motor.Turn the fan fins counter-clockwise.Turn to the left and hold the po ... GE Dishwashers

- the dishes and glassware on the top rack are not coming out clean - I checked the course strainer to see if it is being blocked but don't see any thing there - I also took out the spray arm that sprays up into the top rack and ran water through it with a hose - it also appears to be free of clogs. - I don't see the spray arm spinning when I open the door during the wash cycle - - lastly, it may be unrelated, but the dishes are not coming out of the washer as hot as they used to be any i


... KitchenAid 24 in. KUDI01DL - Multiple Color Built-in Dishwasher

E6 I have been getting E6 error message over and over again. I have had the machine to pieces, cleaned out the pump and hoses, and still the same problem. Occasionally, the error message changes to E8 or E1, but no matter what, I can't get it to work. Any ideas? When I start the machine, select any program and close the door after a short while the machine does not complete the wash cycle and I get the following message either: E1 or E2 will appear in the control panel Any suggestions Dave M


I had this problem and fixed it tonight. When selecting a program water pumps into the machine, but with no drain i ended up with too much water and error code E6.\015\012\015\012I traced the fault to a broken wire between the electronic ... Smeg DWI614 Built-in Dishwasher

My whirlpool dishwasher is ocasionally filling back up with water, whether the door is open or closed, and regardless of of control panel being lit. It happens, then leaks out the front. If i run the cancel drain, it will pump out the water just fine. All the other cycles are working just fine, and it leaves no water at the end of of the cleaning cycle. I have found no common occurance for this


Greetings,\012\012 in most instances the water inlet valve is leaking..this is the water valve that brings water into the dishwasher...its possible, the drain water is running back into the d/w from the drain hose not installed prope ... Dishwashers

Dishes don't get clean. soap still on inside of door. . . water coming up to fill line and hot enough and dishwasher drains after cycle, spray arms are clear. . . help!


Water from the wash arms must be able to reach the detergent cup during the wash. It sounds as though the machine may be over-loaded during the wash and water does not cause the detergent to mix with the wash tank water. Try washing a cycle with noth ... Dishwashers

Dishwasher problem Hi We have a Whirlpool GU 2300, the machine has stopped and is the clean LED on the control panel is showing a 7 pulse sequence which I guess is a fault alarm. I have tried resetting, checked the door switch and looked at the pressure sensor at the drain pump outlet. I changed the heating element and fitted an uprated control card earlier this year. Any ideas?


I solved the reset by pressing the air dry and reset buttons 6 times in sequence, the whole panel array lit and I was then able to reset. I have had no problems since and have used it 6 times. I initially thought that the chipset had a volatile memor ... Dishwashers

Westinghouse Dishwasher SB921SE---Water flowing out of door---suspect could be solenoid not turning water off-I have cleaned all filters and checked drain hose for kinks and blockage


... Westinghouse Dishwashers

My Frigidaire Dishwasher FDB1050RES2 gets stuck in a rinse cycle. The light on the front will be lit "clean" but the bottom of the washer is full of water. Opening the door does not turn off the "clean" light. For me to get it to run, I have to unplug it, plug it back in, push the start button until the ?washing? light comes on. I then push the start button once more and the dishwasher will begin to drain. I open the door as soon as I hear the water stop draining into the sink drain. This


By the descrition you are giving you will need to replace the main control board.Part number 154568401.you may also need to check the float switch.The part will run about 110.00 dollars from a local parts store ... Frigidaire 24 in. FDB1050RE Built-in Dishwasher

Kitchen Aid dishwasher Model# KUDP01FLSS. 2 problems #1 Won't run unless you press in on the door and hold it for a few minutes then it runs through cycle normally. Problem #2 It won't drain water out at the end of the cycle when I open the door there is water laying in the bottom of the tub. I have checked the drain hose for clogging and it appears normal. I am able to remove the hose from the disposal and suck the water out of the tub using a shop vac this indicates to me that the drain is ope


... Dishwashers

Do4esnt clean My Bosch SHX33a05 dishwasher has a problem. It fills and drains well but nothing gets clean. It appears as if the arms are not rotating but the inside is wet when I look inside. I have put a bit on catsup on the inside door and even that is on at the end of the cycle. I have opend and clodes the door multiple times during the cycle and bot arms appear to not be rotating. Nothing is blocking them. I have clean the microfilter, the drain screen and open up the impeller to make sure t


... Integra SHX33 Dishwasher

Brown scum accumulates under the large circular aluminum plates on the bottom of the drawers. Has to be cleaned out every 1-2 weeks. We have never had a dishwasher that required so much maintenance. We think it is the size of the drain. Can this be fixed by installing a larger drain hose. We have cleaned out the drain hose and it doesn't stop the problem.


... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

My dish washer isn't cleaning the dishes well. There are little particals inside of every cup and on dishes after it is done. I just emptied and and now I'm running it with bleach. But before I started it I looked at the drain hose under the sink. The drain hose had water in it. The drain hose is going uphill from the dishwasher to the sink so I don't know if this is normal to have some water in the drain hose when the washer completes since it's not would have to pump uphill to get to the garba


Hi, \012I have an older dishwasher also and recently mywife also complained about it not cleaning right... so me being the man I amtried in vain to clean the things... Bought new spray arms online and installedthem in minutes...now the thing works li ... GE 24 in. GLD5560LSS Stainless Steel Built-in Dishwasher

My GE Monogram ZBD4500 dishwasher does not drain completely at the end of the cycle. If I run a couple of manual cycles afterwards it eill eventually drain completely. Drain hose is clean, pump suction sump looks clean, drain pump impeller appears OK, discharge check valve assembly is easy to blow through in direction of drain. Do I have a sequence switch problem?


I bloody lostt you! are you still there? ... GE 24 in. Profile PDW9880JSS Built-in Dishwasher

There is gum stuck somewhere in my dishwasher drain line. The water won't go down. I took the inside apart and can see the hole where the drain water goes. I disconnected the drain hose under the sink. I got the water to drain out when there was alot in there, but now it won't drain again. I blew compressed air from a compressor backwards through the hose and it makes a big splash and bubbles inside the dishwasher, but the water still won't go down. I put Boiling hot water and vinager in there t


Ther e is noo easy fix, short of replacing the drain line( if indeed thats where the clog is)although you checked the hose from the under the sink, did you check with in the hole where the sink conection is made??and try disconnecting the drain hose ... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1872 seconds