Having problems with your Kenmore 24 in. 16039 Built-in Dishwasher ?

I HAVE NOT HAD AN ON LINE CHAT YET AND YOU ARE SENDING A NOTICE THAT MY CHAT TIME HAS EXPIRED.THIS HAS NOW HAPPENED TWICE!


Answers :

What kind of issue are you having with your dishwasher?
Repair Help & Product Troubleshooting for Kenmore 24 in. 16039 Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I HAVE NOT HAD AN ON LINE CHAT YET AND YOU ARE SENDING A NOTICE THAT MY CHAT TIME HAS EXPIRED.THIS HAS NOW HAPPENED TWICE!


What kind of issue are you having with your dishwasher? ... Kenmore 24 in. 16039 Built-in Dishwasher

I have a mi-t-m pressure washer in the ca-series.The problem is the motor shuts down at times with out any reason. The first time I used it was on a house with a well supplied water. It worked fine,brought it home where I used it with no problem. It was used twice that first year. I then winterized it.The second year brought it out to the same house,I was using it for about a half hour when it just shut off with out any notice. I noticed there was back pressure in the engine when I tried to rest


Mi-t-m pressure washers have a Low Oil shutdown feature that turns off the motor, this is often causing similar problems on this kind of appliance.Have oil checked, if oil is fine , then the sensor that controls oil pressure and activate ... Pressure Washers

I wanted to heat up a cup of tea. As I've done many times before, I pressed Time, then 1:20 seconds, then I pressed Auto Start, but fear I may have touched the button below it, which says Start in small red print. The oven wouldn't switch on, and I noticed a small green u-shaped mark had appeared at the base of the 1: I pressed Clear, and repeated my movements, making sure this time that I pressed Auto Start. Again, nothing happened. I've cleared the touchpad several times, but the oven won't


... Danby 22 in. DDW399 Free-standing Dishwasher

I have a dish washing machine bauknecht model gsx 7988, when closing the frontdoor, the pump starts to run and a beeping sound is noticed, this beeping sound and automatic running of the waterpump happens on any selected program, when opening the door, the grren startligt is flashing two times fast,then a halve a second out and then flashing again two times fast etc.etc filter is clean, waterpressure is ok, eno other program can be started.pls help.


... Dishwashers

Dishwasher problems Hi. I have been having issues with my dishwasher the last month or so. There is a white powder-like residue left on dishes. I noticed it most on my silverware. At first I thought the detergent didn't rinse off completely so I did a ran it again without any detergent a couple of times. Still there. I bought some stuff that is supposed to remove build up from hard water. did that twice. Increased the amount in the rinse aid dispenser. Now I have noticed that the drying coil? is


I've been reading a lot lately about cleaning your dishwasher on a tight budget if indeed you want it working properly as well as clean properly. It is suggested to use ONE Kool-Aid Packet, Lemonade ONLY, and insert that into your wash dispenser to l ... Dishwashers

I have a Kenmore Ultra Dishwasher. The bottom arm spins, the top doesn't, although water drips out. The water fills up under the heating element. The top dishes aren't getting clean and the bottom aren't as clean as they used to be. I also noticed that the soap dispenser is open, some of the soap is gone, but there's still some soap in left in the dispenser. This never happened before and it happens all the time now. Thanks for any help you can give me!


Hi, \012I have an older dishwasher also and recently my wife alsocomplained about it not cleaning right... so me being the man I am tried invain to clean the things... Bought new spray arms online and installed them inminutes...now the thing works li ... Dishwashers

I have a Kenmore dishwasher (model 363.14478791). I hadn't used the dishwasher in a month. I turned on the dishwasher tonight and noticed nothing was happening, but I was getting a clicking sound. I moved the dial to the right to off. As I moved the dial to the right, there were lots of clicks and clunks. I started over and turned the dial to the start position. Some water went in, but then nothing happened again. I clicked forward one click at a time. Sometimes water came in. Then water star


... Kenmore Dishwashers

Elite 665.13933K010 The touch panel is inactive. There appears to be no power to it. It has done this before twice...the first time I bumped the top of the door and the lights came on and it worked. Second time, I took it out of the cabinet, turned it upside down and examined everything looking for a loose wire or blown fuse. When I put it back together it worked. Any idea what is happening?


... Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher

First time it happen I notice that it started before it should with the timer, so started it without timer and it worked. Now its not going though circle again. Changing the program, and trying again, which did work first time but now it is not working.


1) you must test the timer is stuck with the contacts, you can try to clean it, tight loose wires, test wires open or break. Or doesnot replace complete TIMER. The timer contacts if you see the diagram is determinant control all operation machine of ... Hotpoint-Ariston LFT 228A 23 in Builtin Dishwasher

We have a Bosch dishwasher. The manual says for models SHV46C13, SHX43C0 so I guess it is one of those. It stopped working and when I opened it there was a bunch of cloudy soapy water on the bottom. The power was not coming on at that point. I have noticed that lately when I go to push the on button, the light will go on and when I shut it it doesn't start. After a couple times of turning it off and on it will run normally. This has only happened a couple times though....


... Bosch Dishwashers

I turned on the dishwasher tonight and noticed nothing was happening, but I was getting a clicking sound. I moved the dial back to off and started over. Some water went in, but then nothing happened again. I clicked forward one click at a time. Sometimes water came in. THEN WATER STARTED LEAKING OUT. I clicked back to off. After water stopped leaking, I opened the door. There is still water in the bottom. What do I do???


Hi \015\012\015\012Thanks for using FixYa. As the water is not draining and clicking is\015\012coming from the bottom so the issue seems to be with the drain pump solenoid. Usually, these issues are related\015\012to ... Kenmore Dishwashers

Noticed dishes on top shelf not entirely clean. Ran machine empty and opened many times during wash. Noticed that Lower Spray Arm works as expected, but Middle Spray Arm turns only 1/8 or less, then Lower Arm spins again. Schematic with Use and Care manual just says pump motor switches from one to the other in certain cycles, but I don't see this happening. Looked for obstructions to water flow and pressure seems normal. Is control for this function part of the pump, or in the control panel?


Something could be in that checkball, see page 5 ... Frigidaire 24 in. GLDB653A Built-in Dishwasher

Our dishwasher beeps twice when the start button is pressed but then doesn't do anything and there is no other noise from anywhere (eg, motor/pump). There are no error codes displayed and the display appears normal (ie lights up and shows time for program completion etc). When the problem first occurred the machine was full of dirty water. We have turned the dishwasher off and on at the wall, checked/cleaned all filters, drained the dirty water and still nothing happens (it doesn't even fill


... LG 24 in. LD-12BS6 Stainless Steel Free-standing Dishwasher

Our smeg dishwasher beeps twice when i set it running, but nothing happens. when i open the door it beeps 10 times at me... any ideas on the error?


... Smeg 24 in. STX2 Built-in Dishwasher

Dish washer is seldom used , maybe twice a year. Notice during a drain cycle that the pump makes a squaling noise.This happens only after the load of the water has pass through the pump. The dishwasher is a boush,is there impeller style pump? Maybe dry rot ?


The pump impeller is probably plastic -- if so, dry rot is out.\015\012\015\012Most likely the pump shaft is just dry from lack of use. More use will probably wet it enough to stop the squeal.\015\012\015\012Charlie ... Bosch 24 in. SHU66C05 Stainless Steel Built-in Dishwasher

My Kenwood dishwasher KDW24FI/B has worked fine for approx 2 years. But now when I put my dishwasher on, the cycle never seems to end. After a few hours of running I opened the door to find the tablet hadn't dissolved but lots of steam coming out. I tried 2 more times and the same thing happened. The pump is working and everything seems ok. After reading the manual I have noticed the salt and rinse aid lights are iluminated. I have never put salt or rinse aid in since I had the dishwasher so thi


Lol is it a stereo or a kenmore, dishwashers dont use salt, but water softeners do ... Dishwashers

The green light flashes consistently after stopping. I have noticed during the cycle that-: The rinse/wash/dry/end lights flicker, occasionally the wash cycle will run for 2 hrs before completing or malfunctioning, will sometimes make a unusual noise (growning)and then malfunction, and will try and click the soap dispenser door a number of times and then malfunction. All the above symptoms will happen intermittently and have been progressively getting worse and are now at a point where the dish


HiThanks for using FixYa. If the green/clean light flashes, pauses, and then repeats. When the dishwasher doesn't sense a water temperature increase, it stops working and locks the functions (clean lig ... Dishwashers

Follow-up I've removed the lower arm, I'll spend some time and see whether I can get the pobem sorted out. My wife noticed the the detergent was smeared all over the door and repeated tries didn't get it out. Therefore, the water is not spraying. I can confirm the water is filling on the bottom and draining. The heater is working well. I am thinking there is no pressure to send the water through the tubing to the upper and lower arms. The motor is hot to touch (118 degrees with my temp probe). I


... Kenmore 24 in. 15199 / 15194 / 15192 Built-in Dishwasher

My karcher hds 745 has started blowing fuses. it switches on the power light comes on and it makes a buzzing noise for about five seconds and then blows the mains 13amp fuse. i have replaced it twice but the same happens every time. the power lead is fine


You have an electrical short in the motor windings. you'll have to either replace the motor or buy another washer. also check to see if the motor isn't locked up with a piece of trash. to do that you'll have to dissassemble housing until you get to t ... Karcher 2500 PSI Pressure Washer

My karcher hds 745 has started blowing fuses. it switches on the power light comes on and it makes a buzzing noise for about five seconds and then blows the mains 13amp fuse. i have replaced it twice but the same happens every time. the power lead is fine


Dear dumbelldaveb,\015\012Having a 13A fuse I am concluding that the machine is single phase. Most probably you have a faulty capacitor. Check the capacitor and if you find it expanded and leaking...then you must change it with a new one. If y ... Karcher Pressure Washers

The water is pumped out after the rinse cycle then it continues to run and make an unusual noise but nothing happens. The noise is almost a grinding sound. There is also a smell like some part may be hot or the wiring may be hot. I can reset the dishwasher and re-run the cycle up until that same point and it does the same thing again. I have had a repairman out twice in the last six months. The first time he could find nothing wrong because the problem was intermittent and he couldn't see anythi


Timer \015\012\015\012or\015\012\015\012 ... Bosch Dishwashers

Dishwasher is less than a year old. Once in a while it will stop about 10 minutes into the cycle, then the display lights will blink. Sometimes it will stop and the lights wont blink so we will come back later thinking it is done only to open it up and there is water sitting in the bottom. Doesnt happen all the time but sometimes and yesterday happened about 10 times finally gave up. I can cancel and restart the cycle but the same thing happens.


I would most likely guess a faulty latch....it will cancel the cycle, thinking that the door has opened, and the lights will flash. After a certain amount of time, it might "time out" and reset and the lights would stop flashing. Unfortunately it's ... Frigidaire 24 in. PLD2850 Built-in Dishwasher

Maytag mdb6601aww push normal wash button-- nothing happens. push other wash cycles, the lights flash about 30 times then stop-- then nothing happens. tried clearing codes. hi temp wash then heated dry , hi temp wash then heated dry. same problem. also tried normal wash then heated dry 3 times in 6 seconds--- same thing. also tried unplugging unit waiting 10 minutes with no luck. thanks


... Maytag 24 in. MDB6100A Built-in Dishwasher

Dishwasher FDB4315LFC0 Error code ER uo Second time it has happened. First time, a repairman came and said I needed a new "vent assembly", but I asked if he could "un stick it," so he took it apart and fiddled with it, and it worked for about a month. Now the error code is back, and he warned that if it came back, I should have it replaced. I've only had this NEW machine 10 months -- this shouldn't happen, right? Any suggestions? Thanks.


Who's to say what should or shouldn't happen?Sounds like you need a new vent assembly. ... Frigidaire Dishwashers

Control panel inoperable - 2nd time this has happened. First time repairman said "it was fried" because the panel is just under the countertop - of course this is how it is designed to be. Now it has happened again. My dishwasher is GE PRofile and is now 4 yrs. old. I have tried shutting off power and the controls still do not respond to touch.


Is it operable when the door is close? I'm having a similar problem. The console panel on the top of the door appears to be not working. No lights. No buttons will respond. However when the door is shut, I can squeeze a finger to the start button and ... GE 24 in. Profile PDW9280JSS Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0758 seconds