Having problems with your Kenmore 24 in. 16222 Built-in Dishwasher ?

Not draining before I spend alot on a service call- any suggestions?


Answers :

Repair Help & Product Troubleshooting for Kenmore 24 in. 16222 Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Not draining before I spend alot on a service call- any suggestions?


... Kenmore 24 in. 16222 Built-in Dishwasher

Our Asko 3530 dishwasher is giving us a 'water inlet fault' code. The machine goes through the pre-drain at cycle start then begins to fill, continues until it's full then kicks out the fault code. I have changed the inlet valve, reset the system to factory default and taken off the lower front panel, finding the overflow area to be dry. Is it time to call for service or is there something else to try before spending the big bucks?


Hi,This sounds like either the overflow sensor or the water control valve is stuck.Usually the valve is a solenoid valve that controls the entrance and fill of the water. If the overflow sensor is underneath, there may be wate ... Asko 24 in. D3530FI Built-in Dishwasher

I have bosch shv57c03uc/40 built in and the water is not draining on the bottom I already took the spout in the center out to see if anything was stuck but I did not see anything would you kindly suggest something else before I call someone to service it?


Hi,Here is a tip that I wrote that will help you with your dishwasher not draining problem...Dishwasher ... Bosch 24 in. SHV57C03UC Built-in Dishwasher

My dishwasher will not turn on and the Start/Resume light will not stop blinking. Is there any thing you can suggest to fix this without my calling and paying for a service call? We have stopped, restarted and reset the unit as well as cleaned out the soap tray. We have also switched off the electric to the washer as well to no avail. Really cannot afford another service call again so please help us out. Thanks. Chris


Reset the control again. Then change out your heating element.\012\012That should fix it good.\012\012Have a great day! ... KitchenAid 24 in. KUDP02CR Built-in Dishwasher

Hobart LXi Dr Op will not turn OFF? Any suggestions before calling Hobart Service??


... Hobart Dishwashers LXIH-4 Undercounter Dishwasher Lxih4

I have a jenair and it is not draining. I saw your advise below to check the bottom of the dishwasher as well as make sure the drain line is clear all the way thru? Can I do that with out calling in for service? If so, how?


Maybe. Check for your normal clogs near the drain (you have probably done that already).\015\012Can you hear the pump running and water flowing inside when you run a wash cycle? The same pump that circulates the water empties the machine too. I ... Jenn-Air 24 in. JDB2150AWP Built-in Dishwasher

How can you clean the drain receptacle ? I have a piece of broken glass. When you run it it never stops at the last minute and run forever after reaching that point. Can you tell me what to do, we call service man and is to busy to service it, no washer since. Last Saturday. Thank you


Hello, welcome to FixYa. \015\012\015\012**What I`m about to share applies to All B/S/H/ dishwashers. That includes Bosch, Thermador, Gaggenau and Siemens.**I know what the problem is, though yo ... Gaggenau Dishwashers

LG LDF6810ST had OE error. Disassembled found no obstructions blew air through and vacuumed hoses to air gap and to disposer, no obstructions. Never heard pump run when starting cycle, so replaced drain pump. Still doesn't run. Looked at the service manual, and the only other suggestion is repair circuit? Is this the circuit on the bottom right of unit or the pcb up top? Wires and connections all look fine. What else could it be. Any suggestions appreciated!


Hi,Usually my First Response to this Common Error is :-Most likely pump trap is clogged up. Access it behind small door at front. Drain water out through small hose that is there otherwise water will be all over the floor when ... LG LDF6810ST Stainless Steel Built-in Dishwasher

My Kenmore Elite UtraWash Dishwasher won't drain completely. We have checked the hoses (water supply and drain connected to the disposal) - both are free of obstructions. We have taken the whole thing apart but can't get the plastic cover off to access the motor or "garbage disposal thingy" inside the dishwasher. All of the bolts were taken out, but it was still firmly attached. Didn't want to force it and potentially make the problem worse. Any suggestions before I call Sears Repair people


I have the same problem. The part you're talking about can be released from under the dishwasher to clean it. www.searspartsdirect.com has useful diagrams. I cleaned everyt ... Dishwashers

Dishwasher does not drain all water after wash, code C=drain hose,coase or fine strainer or sink blocked.(all checked & are ok) then towards end of wash code H= Call AEG service force ,comes up. but if i put machine on pre-rinse it driains ok, so pump is working. only seem's to be end of wash programe fault accurs


... AEG 22 in. Favorit 55750IM Built-in Dishwasher

Frigidaire dishwasher Mod# GLD4050RHS overheats, melting plasic contents, and venting steam upon opening door hot enough to burn my face. Did so when new, numerous service calls eventually leading to part# 5304467317, 154642901, 154467702, 5304467317 154543602 replaced. Satisfactory service 13 months and now melted another load. Suggestions? Fear fire hazard.


... Frigidaire GLD4050RHS Builtin Dishwasher

I had a service tech at my house to repair my refrigerator. He also took a look at my Maytag WU504 dishwaser, which was not cleaning the dishes anymore. He was less familiar with dishwasher diagnosis, but found that the lower spray arm was pumping out water through the jets properly in the cycles, but that the spray arm was not rotating. He seemed stumped and called his supervisor, who suggested it might be the wash impeller. I have looked at the parts diagram on partselectdotcom and taken t


You are absolutely correct!!\015\012\015\012The support retaining nut allows the arm to spin without falling off.\015\012\015\012And it would definately cause dishes not to clean if the arm didnt rotate.\015\012\01 ... Dishwashers

Describe your whirlpool du948pwpq Problem: I have a whirlpool du948pwpq dishwasher in a tenant's unit. They said the delay start button is no longer working. Also, they cannot "de-select" the heated dry option. It seems to be an issue with the electronics of the control panel. I've already tried to "unlock" the buttons - no change. I also powered off the unit in hopes of re-setting - no change. Does anyone have any other suggestions? I am hesitant to call a service person (it's out of warrant


... Whirlpool 24 in. DU948PWPQ Built-in Dishwasher

My Bosch Dishwasher das not drain water after washing is completed. The water level stays below door sealer. I did check it out filter on the bottom and everything simce ok but still dosn't work. Is there enything I can do before calling service??? Bogdan e-mail: [email protected]


Sorry to read about your problem, I hope this helps you out.you have done it allI tried to help you. Please help me and Rate/Vote on my response, thanks and good luck ... Bosch SHU9950 Dishwasher

My Bosch dishwasher has had a problem since we had it installed. It smells like garbage after sitting for a few hours. This problem is there whether it has been run or not. Water is always standing in the large drain tube under the "filter" and it doesn't look clean. I contacted Bosch by phone as soon as this was discovered - in a matter of days after purchase - and was told by a rather haughty service person to leave the dishwasher door open. Not a practical suggestion even if it didn't sm


Was the drain tube that hooks into the sink drain passed over the partition between the sink area and washer area or through a low-level hole. If through a low-level hole, try rerouting the tube over the partition. This forms a 'trap area' to isolate ... Bosch 24 in. SHU43 Built-in Dishwasher

Error 03 -"Wash pump not operating" and sometimes Error 12 "drain valve is running when it should be off". About one third of time runs normally. Other times only E03 or E 12 after E03 and restart attempts(pwr off/on). Pwr off 1 min before restart attemps. Last 45 uses eventually does run to finish. Local tech unable to replicate problem in one $100 service call.


... Electrolux Dishwashers

I have a Frigidaire dishwasher Model #that GLD2445RF alw ays leaves grit on the dishes. The heating element in the bottom of the unit is grey with a powdery substance flaking off of it. Does it need to be replaced? Can a novice do this, or is it time to spend the $50 for a service call? I've had it 13 months.


Figures just outta warr. if you have a meter you can remove the lower panel of d/w and depend on the model the heater wire connections are right there either on the left or right , you can see them from within the tub which end they wil ... Dishwashers

The electronic panel on the top of the door doesnt light up anymore and is unresponsive, when the power is turned on, the machine makes a sound like its running or draining or something, but nothing is happening. This all started after a potential electrical disruption following a power outage. Perhaps there is a fuse or some relatively easy way to fix this? or am I screwed and should just call a repair man. Thanks for your suggestions, Brodie


... Bosch 24 in. SHX56B05 Stainless Steel Built-in Dishwasher

Flood switch This DW is a Kitchen Aid version of a Fisher & Paykel. Both drawer rinse lights stay on, the drain pump stays on. Book says the flood switch is activated. Is this somthing that a homeowner can fix or am I required to call for service?


I had the same problem and I fixed mine. It wasn't hard at all. First, make sure power is off either unplug or shut off breaker. Next, open the lower drawer and on the sides toward the bottom you will see a circular recessed pin with a flat slot. Wit ... KitchenAid 23 in. KUDD01DPPA Stainless Steel Dishwasher

I just finished a service call for my 5312UC/UC12. The tecnician says he saw water leaking under neath the machine but hoses were secure and no visible crack to the motor housing, The machines pump works but very little water is actually put into the tub, hence no dishwashing. This technician says that this is a repair that most technicians avoid because it takes a long time and costs alot and violated some sort of warranty. He recommend replacement after only 7 years!


This leekage may come from thermostads water isolation ring, just under rezistance leads. There must be a ceramic holder to fix it to rezistance. İf it is broken, thermostad may go down, or rezistance leads isolation (lastic washer) may leak wat ... Bosch 24 in. SHU66C05 Stainless Steel Built-in Dishwasher

My GE triton is not draining the water in the bottom - what to check before calling service


You posted under a model GLD5860LSS, so it that is correct fine, if not, this may be slightly off.\015\012First, and easiest, is to disconnect the drain hose at the very end where it connects to the drain or disposer and make sure there is not ... GE 24 in. GLD5860LSS Stainless Still Built-in Dishwasher

Kenmore Dishwasher model # 665.16012401 Year 2005. Clean light flashing indicating malfunction. Manual suggests calling to service heater circuit. How can I repair this myself?


... Kenmore Dishwashers

Kenmore Model 665.15979992 (Elite) dishwasher: lock light blinks and none of the reset suggestions on your website that I've tried appear to work. Any thing else before a service call?


The blinking "clean light" is a common problem with some of the Kenmore and Whirlpool models dishwashers. The problem is usually attributed to water supply temperatures being too low when filling. Apparently, there are some issues w ... Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher

Hello, We have a Fisher Paykel DD603 dishwasher. I have spent $400 on parts and service call and still have same problem: U1 fault code. I have changed water inlet valve and electronic controller. I'm exasperated. Anyone with suggestions ? Jeff G.


... Dishwashers

I have a Miele g664 and it goes through the cycle, however doesn't drain any water throughout the entire cycle. Is there anything I can do before calling service.


Take apart the filter etc inside and clean, check and drain holes for foreign objects. ... Miele 24 in. G656SCi Plus SS Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1114 seconds