Having problems with your Kenmore 24 in. 16352 / 16354 / 16359 Built-in Dishwasher ?
The clean light is blinking and the dishwasher does not run???
Close the dishwasher door. Push the "normal wash" button, then push the "heated dry" button. Push the "normal wash" button again, and push the "heated dry" button again.Try out his and see what happens.It must reset the memory and your dishwasher must work.
Repair Help & Product Troubleshooting for Kenmore 24 in. 16352 / 16354 / 16359 Built-in Dishwasher
Tips for a great answer:- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.
Suggested Questions/Answers :
Clean light blinks 7 times pauses 1 second and repeats. will not work. the light above the clean cycle indicator blinks 7 times. I can not run the dishwasher, When I press start the light above the start button blinks and will not start
Hi there,\012Well first of all you reset this by pressing - High Temp Wash, Heated Dry, High Temp Wash, Heated Dry, High Temp Wash.If you don't have a heated dry then use "air dry"This sequence help you to reseting the e ... Whirlpool GU2400XTP Built-in Dishwasher
Hi...my dishwasher 'clean' light continues to blink. I can hit cancel and it sounds like the cancel cycle is running. After that the light keeps blinking and I can not start the machine. If you hit start the light goes on, then stops, and the clean light flashes again. Any clues? Thanks!
Sounds like the control board or panel is shot. What is the model number of the unit, and serial number? ... Dishwashers
Maytag dishwasher I have a Maytag dishwasher 2001 Mod# MD85100AWB - Ser# 25257529ZD. I can not get it to run again after the last wash. The lights (clean, rince only, light wash, heavy wash, heated dry) continue to blink and won't clear. I tried to power it down and that did nothing. Do you have a suggestion to what I can do to run my dishwasher again?. Thx, Richard
My whirlpool dishwasher GU2400XTPB won't turn on but will drain. the clean light keeps blinking. After I have turned the breaker off and on again. Still won't get the clean light on without being able to run the dishwasher
... Whirlpool GU2400XTP Built-in Dishwasher
I have the Whirlpool DU 1100 dishwasher and the clean light kept blinking. I did the heated dry, normal combination and got it to run through the diagnostic check and sure enough it cleared the lights and appeared ready to run. When I would start it up again it would run the water and then get to the soad wash cycle and stop. No more lights it just stopped. I have been through the diagnostic process 3 times and still same problem. HELP
... Whirlpool Dishwashers
I have GLD2250RDS2 Gallery Series dishwasher and the 4 lights (sensing, washing, clean and sanitized) are blinking. I can clear and restart, but th unit will only run a few minutes and then stop and the lights blink. Dishes are not being washed.
... Frigidaire Dishwashers
Green clean light wont stop blinking unable to use dishwasher . It is an energy saver. the drain button works ..and when you push start the light comes on but will not run for cleaning
HiThanks for using FixYa. If the clean light flashes, pauses, and then repeats. When the dishwasher doesn't sense a water temperature increase, it stops working and locks the functions (clean light fla ... Kenmore 16602 / 16604 / 16609 Built-in Dishwasher
Kenmore dishwasher Mod.#66516039403 stop running thru cycles,clean light blinking
... Kenmore Dishwashers
Clean light blinks and beeps and dishwasher wont run
... GE 24 in. GLD5560LSS Stainless Steel Built-in Dishwasher
Kitchenaid dishwasher KUD1021RWH4 clean light is blinking and the machine won't run. How can I clear this?
Kitchenaid dishwasher model KUDC021R clean light blinks and dishwasher won't run.
... KitchenAid Dishwashers
My Kenmore elite dishwasher in not running. The power light turns on when pressed. When I push the start button it blinks and shuts off. the green clean button in also blinking. Model number 6651726
Hi,Close the door and to cancel that just press high temp and heater dry again high temp and heater dry and all the lights is going to light up, its getting into test mode.After that press cancel and now you need to replace the ther ... Dishwashers
Maytag dishwasher model MDB7609AWW2 has a blinking clean light. I followed the advice on fixya (thankya!) and by alternating the normal and heated wash buttons I was able to return the lights to normal. However, once I tried to run a normal cycle, it didn't do anything other than fill and drain. I then ran the hot water faucet in the sink until hot and tried another new cycle, but no luck. Any advice is MUCH appreciated!
I have an Ariston LS245 dishwasher, have just had the pump replaced, as it had shorted out, due to water in the bottom tray where the water detection float is, also a new drain hose fitted. Have just run a wash and after running a while, presumably to the end of the rinse, wash and dry cycle, then one of the cycle phase lights, the one for 'soak' blinks constantly. I switched the machine off and had a look to see if a wash had been done, the dishes look clean. In the book it says that if one
... Ariston Technologies Dishwashers
Greetings, My KitchenAid dishwasher is on the blink...actually, the 'clean' light is blinking and I can't get it to run a regular cycle. Help!
Hi,This is a common problem on Kitchenaid. There is already a service pointer for the same.You could read :-https://secured.whirlpool.com/Service/SrvTechAdm.nsf/d12cd4888abce86285256a42005ea985/3976dc6fea92e1c385256fc4006611c9 ... KitchenAid Dishwashers
I have a Whirlpool GU2700XTSB1 dushwasher. It stopped one day and cleanning light was blinking. I was able to reset the dishwasher by pressing two of the button 3 times. Now when I run the dishwasher it fills the bottom with water, heats the water and then buzzes. The wash motor does not spin. Any help?
... Whirlpool GU2700XTSB / GU2700XTSQ / GU2700XTST Built-in Dishwasher
Jenn air quiet series II dishwasher has blinking light on clean and light wash after it runs...it only goes away when we push the off button...it didn't used to do this
Couple of things to check: there's a float that needs to more freely, make sure it does. There's dishwasher cleaning instructions in the operation manual. You may need to take the lower rack out, take off the spray arm to get at a filter, which yo ... Jenn-Air Dishwashers
Model no. MDB6100AWW. Just unloaded the dishwasher. Shut the door and immediately heard clicking (regular cadence). All indicator lights (arrow-shaped) for clean, dry, wash and heating delay were blinking. Opened the door, waited a few minutes, closed the door. Now, just the "Clean" and "6 Hour" arrow indicator lights and "Heated Dry" button light indicator are still blinking continuously. Cannot override. What's going on? Dishwasher came with the house when we purchased it 6 years ago. Proba
Hi Thanks for using FixYa. To resolve this you will have to reset the console. Do this by closing the door and press these buttons in sequence...-high temp wash-heated dry ... Maytag 24 in. MDB6100A Built-in Dishwasher
I own 2 model KUDS01FLSS1 KitchenAid Superba Dishwashers. The first unit had the clean light blinking so I read the post below and reset it. I thought everything was fine but half way during the cyc
... KitchenAid 24 in. KUDS01FLSS Built-In Dishwasher
Kitchenaid dishwasher - green light blinking on clean cycle.
... KitchenAid Dishwashers
I have the kitchenaid dishwasher model #kudv03ctss0.the clean light stay blinking and when i hit the start it just blinks and then stops but the clean light stay blinking constantly.if i hit the cancel button i hear a um noise as if it going to turn on but nothing happens and the light stays blinking. what do you think might be the issue .
Dear friend,\015\012ngfam at you service! happy to assist!\015\012It's an electronic problem!The lights are called codes and need to be diagnoed by a factory service person!!We sell appliances for 65 years an ... Dishwashers
Whirlpool dishwasher green clean light is blinking and won't run any other mode. tried shutting electric off to the washer for 5 min. no change.
Is it blikning 7 times and then repeating??? If so its a water heating fault. look in my solved solutions for more info on how to clear this fault. ... Whirlpool GU2400XTP Built-in Dishwasher
I have a Kitchenaid dishwasher #KUDK01LBS6.The unit will not run. The ''Clean Light'' indicator on the display panel blinks off and on. I have read that a ''Fault Code'' is needed to solve this problem, can you provide me with one? Thanks! e-mail [email protected]
... KitchenAid Dishwashers
Clean light blinking, will not run at all - Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher
If the clean light flashes 7 times, pauses, then repeats...\015\012\015\012When\015\012the dishwasher doesn't sense a water temperature increase, it will\015\012stop working and lock the functions (clean light flashes 7 times, all\015\012 ... Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher
I have a DU1100XTP83 dishwasher and does not run. The clean light flashes 7 times, stops for about a second and then blinks 7 times, etc... Before all this started to happen, and I don't know if it was related, there was an odd odor I couldn't identify in the kitchen.
... Whirlpool Dishwashers