Having problems with your Kenmore 24 in. 16992 Built-in Dishwasher ?

Part came off

\015 I looked in the dishwasher yesterday and there was a slim cone shaped piece at the bottom of the dishwasher. I can't figure out where it is supposed to go. It is about 6 inches long with fins on the bottom flange. Any ideas\015

Answers :

Repair Help & Product Troubleshooting for Kenmore 24 in. 16992 Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

A part came flying out when I tried to use the handle to open my dishwasher.I now cannot open it without a screwdriver. How can I fix it? What part do I need to fix it.


If the handle is off then you only have to take off the outer door panel. then replace the screws. ... Dishwashers

Spray arm, 3rd level, fell off. Flower-like looking ring is still attached to top of dishwasher and arm itself is no longer attached. How can I reattach the spray arm to the flower-looking like ring?I have Frigidaire model number PLD4555FRC0; part # of spray arm, 3rd level, grey is 154478202. I called help line and got someone whose accent I could not understand. I think his name was Victor. He left the line and never came back but, before he left, he said he was looking for the part...why he, t


Unscrew the flower looking piece, there is a white plastic retaining clip inside- press it back together. ... Frigidaire PLD4555RFC Dishwasher

Hello, we have a Frigidaire dishwasher Model# FDB1250REC2. There was all kinds of junk down in the lower filter area and when I tried to remove the parts they all came out together and then fell apart. I need to see how the parts go back together, because I thought I had them in there correctly, but when I opened up the dishwasher after running it the water sprayer was laying on the heating element. Could you please help me get it back together right? Thank you


I am having the same problem...were you able to fix it? ... Frigidaire Dishwashers

I have a KitchenAid but model # KUDI24SEWH1. Can not find it on your list although another model without the last letters 'WH1' is on it. Anyway, my nephew ordered the parts he said needed to be replaced. One was the top water feed tube and bearing which he had no problem replacing when the part came in. But, he is having a very difficult time opening up the front door to replace the soap dispenser. Removed the 6 screw (three on each side) and the two at the top of the door but that is as far


You don't Use the WH2 just the first 6 letters and numbers.\015\012Jim ... KitchenAid KUDI24SE Built-in Dishwasher

Lower spray arm came off, part broken which holds it on, not sure what that part is called so we can order it... is it a spindle, bearing or axle? can't find manual for schematic thx


Hello, welcome to FixYa.I believe the part y ... Viking VDB450 Dishwasher

When the door is closed tight, the plate warmer cycle comes on and repeats over and over. a technician came out and said he had to order a part that costs over $100. Can we fix this ourself or get the part cheaper?


Did the tech tell you what the part was called? ... Haier ESD311 24 in. Built-in Dishwasher

The maytag dishwasher model mdb7130AWB stoped cleaning correctly so we went from the arm assembly in bottom of dishwasher down to the cutter disc and we found a crack in the housing so i ordered that piece. the new part was designed a little different but we put it all back together the way it came off. but it started and ran maybe 1 minute and stopped. so i have pulled up the diagram and see some problems. in the current diagram. original there was no part 37, 17 19 and 3, alos the crew d


... Maytag MDB7130 Dishwasher

Maytag MDB8859AWS, cover latch that's a part of the detergent dispenser came entirely out of the hole that the long spindle on the end of the cover latch fits into it. Does this mean the part's broken? Now the detergent dispenser won't open automatically. I can TRY and close the cover after I put the cover latch's long spindle back in the hole, but something doesn't seem right. Only three months old!


... Maytag MDB8859AWS Stainless Steel Dishwasher

I have a component in the bottom front part of the Miele G542 dishwasher that is leaking water. Its connected to the water IN line. Plumber came out, showed me that I need a dishwasher repair guy to replace the part. Who can I get to make a service call and repair this in San Jose CA.


\015\012Advantage Appliance Repair\015\012\015\012(408) 266-9560\015\012Highly recommended. ... Miele Dishwashers

Water is running in and draining right back out. Leaving the dishes completely dry and dirty. I found a part laying on the floor when I took the cover off. I put it back where it came off of and now this problem. Yesterday it was the water not draining at all, now after putting that part back on it drains and doesnt wash.


Was it the float? try this empty machine put 1cup of vinegar or CLR and let it run through machine and clean jets and spray arm as well as soap dispenecer,You may want to try cascade they have rechanged it .Try this and let me know thanks ... Crosley 24 in. CDU600 Built-in Dishwasher

Hi I run a restaurant and have just purchased a used Hobart Hi-Temp Dishwasher but it came without a manual and I want to hook it up. the model # I can make out is AM-12 it also came with a booster, could you give me a parts list of hook up and also is this a 3 phase or 1 phase and what is the amp load what conductor cable to use, sort of info I need Dale


Since your question requires a lot of typing i.e. complete manual which is not feasible over here. Hence, I am offering few links from where you can get your owners manual. Hope this will solve your problem.\015\012 ... Hobart Dishwashers

Glasses are blasted with grime. We no longer have the manual (apartment came with dishwasher) so don't know how to clean parts, or what parts to clean. Also, not sure what the second trap door is for. Where to put the rinse, the ''salt''? Thanks in advance for any insight into how to operate effectively this somewhat ancient appliance! (Commercial code found on inside of door: ADP 456 DW)


... Dishwashers

Model#lds5811bb--started making noise coming from the water inlet area(bottom left). 3/4's of the way through the cycle, noise became louder and then an error code "le" came on. We tried turning breaker off, then we tried in the rinse only cycle, but 5 minutes into it the "le" code error came on again. I'm fairly handy, so I'm not sure what part I can replace to maybe solve the problem. I can't afford to spend a couple of hundred dollars for a repair man to fix it. I'll appreciate any suggestion


The LE code is a locked motor code. Something may have gotten into the pump impeller. I would take the screens and filters off and clean the and check the pump for something stuck in it. It could also be the motor going bad but I would check the obvi ... LG Dishwashers

Kitchenaid MOD KUDK031TBS3 bottom rack part came off


... KitchenAid Dishwashers

Whirlpool dishwasher door falls open fast when opening. plastic part came off, but don't know where it is from


Remove the bottom access covers on the bottom of dishwasher. turn on the dishwasher with water valve in off position so you can here the motor running,while its on, find the breaker and turn off power.you will here motor stop. disconnect power wires ... Whirlpool Gold GU2275XTV Builtin Dishwasher

Miele Dishwasher Model G1040, Type HG03, NR: 32/65143704 The machine is three years old. The cycle reaches almost to the end, then all three LEDs merge together, and the pump runs continuously, even with the master switch off. I have taken the machine out and removed the base plate. When I first took the machine out of its position, I tipped it backwards and water came out of the bottom. All hoses and parts in the bottom section seem perfect in every way but the inside of the bottom plate indica


... Dishwashers

Bosch dishwasher Model SHU 4302 UC Bracket holding upper spray arm came off when upper rack was removed (had never happened before). Cannot figure out how to reattach bracket. No "parts" or loose pieces on the bottom so doesn't seem like anything broke. Thanks.


Hello. Here is a diagram of the upper rack\015\012http://ww ... Dishwashers

The detergent dispenser door won't stay closed. A 2 inch long part came loose. How do I repair


... Kenmore 13743 Staimless Steel Built-in Dishwasher

This part is different that the one that came with the dishwasher. Need instructions on how to install it


Not sure which part you are talking about - do you need instructions on how to install the LG LDS5811 dishwasher.\015\012\015\012The user manual is available at ... LG 24 in. LDS 5811 Built-in Dishwasher

Kenmore 17369 Dishwasher overflowed water came of lower part of door during filling


... Kenmore 24 in. 17362 / 17364 / 17369 Built-in Dishwasher

Stops part way through programme water still in machine. Now no power to machine. Problem happened yesterday - cleaned filter and pump - power came back. Programme started but then stopped. No power - nothing happens.


Either there is a bad capacitor in the control panel, or the power supply has a faulty capacitor. You will have to get a multi-tester and test each component for resistance and current ... Dishwashers

Silverware container Flap that opens silverware container came off. Does it just snap on? Can't get it to stay. It doesn't seem to have any broken parts.


If we are talking about the quiet partner 3 the silverware container can actual hang more effectively on the lower dish rack itself as opposed to on the door. The flap also does just snap on. Hold the back side of the metal with your thumb while pusi ... Whirlpool GU2400XTP Built-in Dishwasher

Hi, We have a Frigidaire dishwasher machine 1500 series with fully electronic control. It is a new unit, has been installed nearly 4 months ago. The other day, when I went to take the dishes out of it, I notice that the rubber gasket that seals the door had come off somehow. Along with it I saw, sitting on the bottom, two pieces that looked like part of the seal, but I didn't know where they came from. I put the rubber gasket back on, but now the pieces and now the dishwasher will leak when runn


... Frigidaire Dishwashers

The lower spray arm came off during a dishwasher cycle and melted. The dishwasher is okay but I need a replacement spray arm for a Sears Galaxy dishwasher model number 587.15139400 I have searched google for replacement parts for this model and have not found a place where I can get a lower spray arm. Any help would be appreciated.


Sears parts dept ... Sears 24 in. 14181 Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0326 seconds