Having problems with your Kenmore 24 in. 17032 Built-in Dishwasher ?

Kenmore 655.13222 k601 bought 5 months ago after

\015 Kenmore 655.13222 k601 bought 5 months ago after insalation machine stops and clean light comes on flashing. had a repair man in changed circut board. month later of same issues told us the drain was not connected properly. today had a service man in and a wire was off to the element. now it runs a full cycle. what i would like to know is how long should all the cycles be if set to normal or fast etc. and when heated dry is selected should dished be fully dry . cause on normal - with heated dry turned on - everything is still wet like machine just turned off nore do the modes on the dishwasher change ie light stays on for normal clean but never lights up at rinse or drying just normal to clean? any one any ideas?\015

Answers :

Repair Help & Product Troubleshooting for Kenmore 24 in. 17032 Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have a Kenmore model 665. It is having an intermittent problem. It goes through the fill cycle, and then stops. Timer does not progress either. Then, at some random moment, it will come back on and finish the entire cycle. This could even be a day or two later. Sometimes it seems a nearby thump will set it off, other times no one is anywhere near it when it comes back on. This happened for a month or so off and on 6 months ago, and then it worked fine for 6 months. Now it's back to it.


Its possible its a door switch thats causing this or the main wire is loose..be careful as you do have 115 volts. i'd turn off power and check where power comes into d/.w and make sure the wire nuts are tight.. the next step is a little more difficul ... Dishwashers

Kenmore 655.13222 k601 bought 5 months ago after


... Kenmore 24 in. 17032 Built-in Dishwasher

Our Kenmore Ultrawash dishwasher leaks rinse aid. There is always a thin blue line coming from the rinse dispense, even after a wash, but more so between washes. We are usually careful not to overfill, but may have done this once about three months ago, shortly before this trouble started. Could this be related weeks and months later?


... Kenmore Dishwashers

I have a Kenmore Elite dishwasher with electronic controls. When I set the controls press the start pad and close the door it will not start. The light on the start pad just continues to blink. This happened about six months ago and the Sears serviceman pressed two of the control pads simultaneously and this reset the controls. Everything worked after he did this. What are the two control pads that you press to reset the controls?


This is difficult to find out. Try different combinations. Otherwise get the information from the SEARS serviceman. ... Dishwashers

Kenmore Dishwasher Model 665.11643300 Cycle will not run. Normal Wash light blinking Cancel light will also blink (but can be cancelled by holding button down) I tried shutting down the power and resetting at the breaker. I tried other buttons like Air Dry, etc to see if there was some sort of sequence Note* last cycle ran was rinse cycle many months ago - house has been vacant and dishwasher has not been in use.


I will look a bit further in detail about your dishwasher problem. I am assuming you have checked the inlet water tap to the dishwasher is turned on. ... Dishwashers

My Kenmore 13743 is 3 years old and was washing perfectly until a couple of months ago. It has become so bad that it won't clean anything on the top rack and barely anything on the bottom rack. In fact, I just pulled a butter knife out of the rack that still had butter on it! Not normal... I do not know how to remove the bottom washer arm to get at the chopper, filter, etc. Please help


Hello,\015\012\015\012Welcome to FixYa,\015\012\015\012You are likely right on, this is very common with these unfortunately. Hopefully this will help.\015\012\015\012**Unplug the unit or turn off the powe ... Kenmore 13743 Staimless Steel Built-in Dishwasher

Kenmore 17012 dishwasher is making a very loud noise when motor is running. Started about two months ago, recently got louder.


... Kenmore 24 in. 17012 Built-in Dishwasher

Dishwasher won't drain. (Kenmore 3380957Rev A) It's been not draining that well for a couple of months, but then a couple of weeks ago, it just won't let the last inch of water out. --I can't see in the center area under the plastic to see if something is clogging it. --I tried running it on three different cycles to see if that changed anything (Pots and Pans, Normal, and Water Miser). No difference. It never seems to overflow, but when the cycle is over, it has a couple of inches of


The problem could be the pump, the drain hose or the timer. It will not drain if left to sit. The thing to try first is to put a cup of white vinegar in the machine and let it wash. This may remove sludge or scale blocking the strainer. 2nd take the ... Dishwashers

I see that you have advised on the dishwasher soap residue problem in the past. I was just wondering if you have learned anything new since the last time you posted. I have this dw residue problem, too. I DON"T seem to have it with the gel packs. But my 3-level Kenmore did the job great up until about 6 months ago. Then, I bought a different dw soap and had trouble. So I changed brands. It STILL left a residue. SO bad that I phoned the company. They were completely noncommittal about the reason


Hi, \012I have an older dishwasher also and recently my wife alsocomplained about it not cleaning right... so me being the man I am tried invain to clean the things... Bought new spray arms online and installed them inminutes...now the thing works li ... Dishwashers

Kenmore ultra washer II 1993 two months ago white chalky film on all dishes. cleaned out used vinegar running hot water first, gel pacs, what's wrong


Sounds like too much rinse agent (jet dry) ... Kenmore 24 in. 15932 Built-in Dishwasher

Kenmore ultrawash dishwasher is humming, and not as quiet as 2 months ago?


Bearing is going out in the pump motor. ... Kenmore 24 in. 16363 Built-in Dishwasher

My Kenmore Diswasher (Mod # 665.17842400) has crapped out again. Towards the end of a cycle, the power seems to have been lost. There is now water in the bottom, and the user interface won't come on. 2 months ago I replaced the user interface and the magical board it connects to to solve a start button problem. I checked the power coming to the washer and it is live.


There is a thermal fuse on the control board. It protects in a overheating problem or sometimes when there are to many appliances on the same circuit that creates a high amp draw, that melts the fuse not actually blowing it like a short. Check your d ... Kenmore Dishwashers

Throttle problems Homelite pressure washer model UT80709A. bought it 10 months ago with no problems and stored it for last 9 months. Before doing so, drained gas, oil. Brought out of storage a few days ago, filled with fresh gas, oil, cleaned air filter. Starts great first try but after about 30 seconds the throttle starts visibly revving the motor a litlle at first then gradually faster and faster until it seems to flood and die. Then you cant start for about an hour and its the same story. Hav


... Homelite Pressure Washers

I have a Frigidaire dishwasher, Model FDB15000LFCO. Serial No. TH74135326 purchased 10-19-07 from Lowes. The washer stopped working almost immediately. On December 5, 2007 the computer brain for the washer was replaced by Able Appliance Service, LLC, Swannanoa, NC (828) 296-1017. Four months ago my electric bill for three months was almost twice my average use for the time period. We stopped using the dishwasher for one month, and the bill returned to normal. Was one part in the dishwasher in


I think you have one 0 too many in the model no. should have been FDB1500LFCO. The user manual is available here.\015\012 ... Frigidaire Professional Series 24 in. Built-In Dishwasher Dishwasher

I have a Miele G868 dishwasher. It is 15 yrs old. 8 months ago the soap dispenser wouldn't close, so I got another dispenser from Miele and replaced it myself. Everything worked fine until 3 months later, when the soap dispenser did not open. After 3 restarts, it began to function as it should. Now 5 months later, the soap dispenser is not opening at all. Here are my observations: 1. Economy wash cycle should run 35 minutes but only runs 13 now. 2. Water in machine is not hot, even though I run


... Miele Dishwashers

I have a Kenmore Elite Dishwasher about 7... Problem with the Kenmore Dishwashers I have a Kenmore Elite Dishwasher about 7 years old. The Model # is 665-16462300. It works beautifully, except that about every 2 months the spray flow intensity ( and the cleanliness of the dishes) drops significantly. The cause is the metal screen located just upstream from the sump is clogged with food particles. I have taken apart the dishwasher several times to remove, clean and replace the screen. This fix wo


Check the inlet hoses; if the catch screens have sediment build up, that will reduce the pressure of the rinse water. Also, look for missing plugs on the rinse arms... ... Kenmore 24 in. 16462 / 16464 / 16469 Built-in Dishwasher

I have a KUDIO1ILBS6 diswasher. Couple months ago


... KitchenAid 24 in. KUDI01IL - Multiple Color Free-Standing Dishwasher

In my Kenmore elite manual {Dishwasher} Model 665-13109k901 it says to clean the ultra wash filter once a month. Where is it located in the dishwasher the manual doesn't show it. Please help me with an answer. My dishwasher is 6 months old.


... Kenmore Dishwashers

I have a 7 yr old GE Tritron XL dishwasher that I rarely use. Last time I used it was almost 2 months ago. A week ago I noticed a horrible rotting stench coming from the inside. I poured 1 cup of vinegar in the base and let it sit overnight. Next morning I ran the dishwasher with detergent but no dishes. Odor still there. Checked bottom of dishwasher for food - nothing there (I prewash dishes before putting them into dishwasher). Added 2 cups of vinegar, ran dishwasher on hottest setting. Sti


... Tappan MDB531RF Dishwasher

I have a JennAire jdb1090aws dishwasher. It's about 4 years old. The symptom is no water flowing through dishwasher. Approx 3 months after installation, the same symptom occurred. Tech resolved with float switch adjustment (no charge). Has run fine every since. I have not checked water supply, but doubt this is the problem (new water heater 3 months ago, sediment gone). I suspect the float switch is bad or out of adjustment. How do I trouble shoot float switch in dishwasher? Connect ohm mete


Hi,The procedure to test the float switch :-http://www.partselect.com/dishwasher+test-float-switch+repair.htmMost for no water entering the dishwasher, there are 2 main causes. One is the float switch and the other ... Jenn-Air 24 in. JDB1100AW Built-in Dishwasher

I have a Kenmore Elite Dishwasher about 7 years old. The Model # is 665-16462300. It works beautifully, except that about every 2 months the spray flow intensity ( and the cleanliness of the dishes) drops significantly. The cause is the metal screen located just upstream from the sump is clogged with food particles. I have taken apart the dishwasher several times to remove, clean and replace the screen. This fix works for about 2 months, then another cleaning is required, even though we h


... Kenmore Dishwashers

8 years ago we bought a model 665 Kenmore Limited edition Stock #575-0 if you need that. A certified kenmore tech. has been out here 3 times with still no clear answer. The problem is when you run a standard cycle of 95 minutes it counts down to 78 minutes and stays at that time for about 45 minutes then stars counting down again till 42 minutes then stops at that time for about another 45 minutes then coutinues till it finishes the wash and drying cycle. It runs and sounds fine the entire time


Sounds like timer prob.would rec. replacing timer ... Dishwashers

Kenmore Elite I replaced most of my appliances 3 years ago with Kenmore Elite and I've had problems intermittently while the appliances were under warranty, but when the repair person arrives, no problem is detected. Once the appliance is no longer under warranty, the problem becomes persistent. At one point when I explained the difficulty, the technical support person said something to the effect of, "Oh that's an easy one to fix. All you need to do is...Oh wait, the warranty expired on the 3rd


Hmm, I'll start at the top :->. Well, first thing is that Kenmore doesn't manufacture any appliances. The only thing Sears has is the name recognition, therefore, they have GE, LG, Whirlpool, and others to make appliances for them and Kenmore s ... Kenmore 24 in. 15173 Stainless Steel Built-in Dishwasher

I purchased a Bosch dishwasher and had it installed into my new kitchen. It is plumbed and it does not work, a reapair man said it needs a new motherboard. My issue is that Bosch can't seem to supply central Wi. with this part. The repair place put the order in two and onehalf months ago and still cannot give me a date about when the part will be in. I have owned this dishwasher for five months and have not been able to use it once!


... Bosch Dishwashers

It is 3 years old and 2 months ago I had to have a new motor fitted. 2nights ago I put it on and in the morning it was still going. I have tried again and it just keeps going. The water is slushing round but it is cold. Also the soap dispenser didn't open. It doesn't drain or dry.


The control circuits of the unit is malfunctioning. It is probably a bad capacitor in the unit that has to be replaced. The control unit is the brain of the system. It will have to be replaced.Before doing so, check to see if you have any ... Siemens Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0734 seconds