Having problems with your Kenmore 24 in. 17032 Built-in Dishwasher ?

Light flashes 7 times then pauses and blinks 7 times again, and keeps repeating


Answers :

Temperature problem with water. Incoming water when filled should be no less then 1/2 inch below heater. If not, possible water valve. Incoming water temp. min after fill. 120 degrees. Missaligned door. One of door switches not activating. Bad circulation motor. Not throwing water over heater. Tech.sheet behind bottom panel. Will tell you. Shorted heater. When bottom panel is removed. Look for signs of water leaks. Hard water deposits on floor.
Repair Help & Product Troubleshooting for Kenmore 24 in. 17032 Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have a Sears Kenmore Elite Ultra dishwasher 665.1315 model. For the last 3 weeks, it keeps having the clean light blinking 6 times pause then 1 blink and pause and repeats cycle again. I have turned off the breaker...I have reset by pressing the heated dry and normal wash until all lights are flashing. It then completes some type of cycle and looks ok. When I opened the door, steam came out and all was hot inside. However, once I try any new wash cycle, it seems to wash but after 1-2 hours and


Call sears service and tell them you need service there is a service flash and will be no charge ... Kenmore 24 in. 15932 Built-in Dishwasher

Light flashes 7 times then pauses and blinks 7 times again, and keeps repeating


Temperature problem with water. Incoming water when filled should be no less then 1/2 inch below heater. If not, possible water valve. Incoming water temp. min after fill. 120 degrees. Missaligned door. One of door switches not activating. Bad circul ... Kenmore 24 in. 17032 Built-in Dishwasher

Clean light blinks 7 times pauses 1 second and repeats. will not work. the light above the clean cycle indicator blinks 7 times. I can not run the dishwasher, When I press start the light above the start button blinks and will not start


Hi there,\012Well first of all you reset this by pressing - High Temp Wash, Heated Dry, High Temp Wash, Heated Dry, High Temp Wash.If you don't have a heated dry then use "air dry"This sequence help you to reseting the e ... Whirlpool GU2400XTP Built-in Dishwasher

Dishwasher Fault Hi, My dishwasher is a Diplomat ADP8322 (which i think is a rebadged whirlpool unit) & has been playing up recently. When you start a cycle it is fine for a minute or so then it starts beeping, the rinse light comes on & the light next to the start button flashes 11 times, pauses then repeats. I have read online that this flashing relates to what the fault is, but i cannot find out what fault the 11 flashes relate to. The first time this happened i cleaned out all of the filters


... Dishwashers

Clean button light blinks 7 times, pauses and blinks 7 times. This repeats over and over. Dishwasher will not work. Model is DU1055XTPS4


The blinking clean light is an interruption in the dishwasher program that either indicates a malfunction, or a simple program glitch. The light blinking 7 times can commonly attributed to a thermostat problem. However, before assuming you have a co ... Whirlpool 24 in. DU1055XTPS Stainless Steel Built-in Dishwasher

Kitchen aid dishwashers model kudi1o1ilbl6 won't function. Cancel light flashes 7 times pauses and flashes 7 times repeat for ever. killing the power did not reset. Advice?


Open door, press in rapid sequence the following keys: hi temp scrub, energy saver dry, hi temp scrub, energy saver dry. Close the door until it latches, then open it and depress the cancel key. The lght should clear. It's a beautiful thing. ... KitchenAid 24 in. KUDS25 Built-in Dishwasher

Kenmore Dishwasher:665.13222K601, S/N FU2603549 purchased Oct 2007. Clean Light flashing seven times then a short pause and flashes seven times, repeating.


... Kenmore Dishwashers

I'm working with a kitchenaid D/W model N0. KUDS01FKSS1: I repired a broken wire that shorted out near the main board, after repairing the wire the cycle selector board "light wash cycle" was not working, after the customer used the D/W the "clean light starting flashing 7 times then pauses repeately, after instaling the selector board, I entered the diagnoptics code all lights came on and then I cancelled, the D/W started working, when the cycle finish the light will come back and D/W will no


... KitchenAid Dishwashers

My Kenmore Ultra Wash QuietGuard4 flashes the Clean light 7 times then pauses,then repeats the flashing sequence. Help.


You have a problem with your heating circuit . It could be the ( heater control board , wiring , or the door latch . ) do a visual inspection on the heater most of the time you can feel the problem . trace wires from heater to control to make sure ... Kenmore Dishwashers

I have a kenmore dishwasher model 58715199400. the clean light keeps blinking. ive seen posts that say to press heated dry, normal wash buttons repeatedly until all lights flash. my model doesnt have a normal wash button, it has a rotating knob instead. any tips?


... Kenmore 24 in. 15199 / 15194 / 15192 Built-in Dishwasher

Kenmore dishwasher 665.13422k701, the clean light is flashing 6 times, pause, 1 time, long pause. What does this mean?


... Kenmore Dishwashers

I have a Whirlpool Quiet Partner 3 GU2200XTSB3 dishwasher that starts but wont complete a full wash cycle. I went to diag mode and the follow light sequence appeared: Normal light and washing light came on, then switched to Rinse only and drying then back to normal light washing this sequence repeated 3 times then no lights then Light and heated dry followed by the normal light flashing repeatedly for an long period of time then switched to Light and heated dry then all lights went out I was t


... Whirlpool GU2200XTSB GU2200XTSQ 24 in Builtin Dishwasher

I HAVE A WHIRLPOOL DISHWASHER AND THE LED LIGHT FOR CLEAN KEEPS FLASHING AND IF I PUSH THE CANCEL BUTTON IT PUTS IT IN TO A DRAIN CYCLE THEN THE LIGHT KEEPS FLASHING I CAN SELECT ANY CYLCE I WANT BUT WHEN I PUSH THE START BUTTON ITS LED FLASHES SEVERAL TIMES AND THEN STOPS AND THE CLEAN LED LIGHT STARTS FLASHING AGAIN


Check out it there is a water leak to the bottom housing. Usually this happens when there is a leak activated the flood sensor causing LED light turned on. Dry out the leak then leave it unplug for 24 hours so the sensor dry out by itself. Make sure ... Whirlpool Dishwashers

I have a Whirlpool ADP4530 and recently the light above the start button flashes 4 times, pauses and repeats this. The machine won't start unless switched off and then after a while when switched on it will run a program. Any help appreciated.


... Whirlpool 18 in. ADP530 Free-standing Dishwasher

Miele dishwasher inlet/drain light flashes 5 times then stays on, this keeps repeating and no water is going in. Any ideas?


... Miele Dishwashers

Our dishwasher does not complete a cycle. Regardless of what cylce it is on, part way through the the clean light blinks 7 seven times in a row and then a pause, and that repeats until the dishwasher is rebooted. What does this mean?


... KitchenAid Architect® Series II KUDT03ST Built-in Dishwasher

Rheem classic quiet 80 it has two green light. one is indicate power on. and other is blinking 5 times and 2 second pause. then repeating this cylce like it forever. I have take the pcb out from the furnace , for seeing if there any electronic parts are burning or some cracking, but I don't see any thing unusual. this problem occured when the water heater is leacking water from the pipe then the water was spraying over the funace. because the funace is locate just one foot away from the water


... Maytag 24 in. MDB5600A Jetclean II Built-in Dishwasher

My dishwasher light keeps flashing 7 times then pauses, and does it all over again. I think I have tried every sequence of pressing certain buttons on the panel with no luck. I always turn the hot water from my kitchen tap on before I turn on the dishwasher. Any other suggestions?


... Kenmore 24 in. 16032 Built-in Dishwasher

Clean light flashing 7 times, then a pause, and repeats...


May I get the make and model # to help you more ... Dishwashers

My kudpo1ilbt6 kitchenaid dishwasher clean light flashes 7 times, then pauses, then repeats. Cannot break out of this mode and get dishwasher to start. Reset circuit breaker also. Is this a diagnostic code? How to put controller into diagnotic mode?


... KitchenAid Dishwashers

Kenmore 665 17033400 Elite dishwasher clean light flashes 7 times and it wont run. i used the reset combination, all lights lit and stayed lit until i pressed reset. Then it started a wash. now the wash seems to be finished, though i am not sure and the clean light is flashing 7 times, pause, 7 times, etc.


That signals an issue with a faulty heater &/or heater drive circuit.(that info comes from their troubleshooting guide)I ran into it this weekend and discovered that the heater coil in the bottom of the washer was broken. ... Kenmore 24 in. 17032 Built-in Dishwasher

Kitchenaid does not do the program, I can start the program, but about 15 minutes into the program the program stops and the light jumps to clean light which it 7 times blinks pauses and 7 times b


Clean all the buttons , one must be stuck , push all the buttons and un stuck them.... ... KitchenAid Dishwashers

Hello my Kenmore built-in dishwasher (model: 17352) has a flashing light as of yesterday. The "clean" light flashes 7 times then pauses then flashes 7 times continuously. I don't have the troubleshooting manual. What does this indicate?john Racette


... Kenmore 24 in. 17352 / 17354 / 17359 Built-in Dishwasher

I have a Kenmore Elite dishwasher (model 665.1315), and the dishwasher will run through the wash cycle as expected, but when it gets to the heated dry cycle , it doesn't appear to dry. It will then flash a fault code 81 (8 short flashes of the 'clean' light, pause, and then 1 more short flash of the 'clean' light, longer pause, and repeat the code). The dishes seem to be somewhat dry, but there is certainly water on the dishes and on the tub (there is never any water standing in the tub, and t


Hi,Check your heating element.. \012A bad heating element causes many problems in dishwashers...Dishwasher Problems The ... Kenmore 24 in. 15932 Built-in Dishwasher

I have a kenmore dishwasher mo. no.665.17039401 the clean green light flashes 7 times and it keeps doing that if i try to start the dishwasher on the start button a red light flashs three times what do how do i fix it .i made shure the door was locked


... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1228 seconds