Having problems with your Kenmore 24 in. 17052 / 17054 / 17059 Built-in Dishwasher ?

I just bought this house with this dishwasher built in. I have pushed the door shut, pressed the heat dry button to lock the door and pressed the start button. Nothing happens. Now I can't even get the lights on front to turn off. The lock button flashes as though the door is open, but its not as far as I can tell. I have to press the latch in to open the door. I'd like to use it... any ideas. Its a Kenmore Elite model # 665 17052 402. Thank You


Answers :

Repair Help & Product Troubleshooting for Kenmore 24 in. 17052 / 17054 / 17059 Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I just bought this house with this dishwasher built in. I have pushed the door shut, pressed the heat dry button to lock the door and pressed the start button. Nothing happens. Now I can't even get the lights on front to turn off. The lock button flashes as though the door is open, but its not as far as I can tell. I have to press the latch in to open the door. I'd like to use it... any ideas. Its a Kenmore Elite model # 665 17052 402. Thank You


... Kenmore 24 in. 17052 / 17054 / 17059 Built-in Dishwasher

I opened the door before the drying cycle finished. I pressed the cancel button, then I pressed "normal wash" and the "start" button and it didn;t start. Then did "cancel" again . I pressed the "heat" button for five seconds to lock the door so I wouldn;t make the same mistake again. It still won't start. Now the "cancel" button won't work and the start button flashes. What do I do now?


HI. The unit will need to be reset. This is achieved by unplugging the unit for five minutes. If unplugging is not an option, simply,shut down the appropriate circuit breaker for five minutes. This action will, essentially, reset the logic sector. On ... Dishwashers

I have a Jenn Air dishwasher and the door latch mechanism has been "locked" but teh door is in the open position, how do I unlock the mechanism. I have pushed the het button three seconds but this me


This happened to me. After replacing the board for $100, still happened. I messed with it myself...\012Reach under the counter to where the "catch" is. Mine is white plastic. Mine had a bit of movement side to side (like 3mm). Try sliding it to ... Jenn-Air 24 in. JDB1100AWS Built-in Dishwasher

I've had an LG LDF6810ST dishwasher for about three years with no problems. All of a sudden it won't close. It finished the wash, I emptied it, and when I went to close the door it wouldn't close all the way. It was as if something was getting caught not allowing the door to close completely. I searched and found nothing blocking, then I looked at the door latch and it looks as if the child lock feature is engaged. So the door is locked while open. I turned the child lock on and off through the


If all else fails.... kick it! at least you will feel better! ... LG LDF6810ST Stainless Steel Built-in Dishwasher

I have a 2005 GE profile. There was been an off and on issue with the door latching. Usually a few tries and the interlock beeps. But now, it will not latch. i can manually press the white "button" on the door-side latch female and it beeps. I removed the bottom rack and top one is empty. it seems the longue of the top latch is aligned with the door slot. Any ideas Greg Miller


... GE Dishwashers

The contol lock LED is illuminated on the front panel of my Maytag dishwasher. (Neither my wife nor I pressed the control lock for 3 seconds!) We've tried to extinguish it by pressing it for 3 to 5 seconds, but it remains ON. We've turned off the breaker to the dishwasher overnight, but when we turn the breaker back On, the contol lock LED comes on. We simply can't unlock the control panel. We can tell that all of the other buttons work just fine because pressing any of them causes the 3 Sec LED


If by pressing the control lock button for 3 seconds does not solves the problem.then there are 3 possibilities due to which this problem may occur\015\0121)the door is not closing properly. the dishwasher door latch is either cracked internally or t ... Maytag Dishwashers

Indesit d63 dishwasher, door locked shut. took top off+got to latch, the plastic catch wouldn't pull out of the latch. undid it all, all seems unbroken but cannot seem to arrange the latch so that it will allow the plastic catch to come out when levered. also not sure if the handle is supposed to click the switch to another position, or just tweak the switch as it opens the door. is a new latch supplied with the switch ?


Check with whoever you order the latch from, usually parts are individual for electrical parts and never assume that the screw or washer will come with new one, save every piece. ... Indesit 24 in. D63 Free-standing Dishwasher

Dishwasher Kenmore Ultra Wash model #1777990 the 2 hour delay light is on and when I try to cancel the door lock button starts flashing I hit cancel and open the door and shut it and the 2 hour delaay button cmes on and will not go off. Is there a reset button anywhere.


... Dishwashers

My GE dishwasher's door is stuck shut ~ I'm assuming a broken latch. I was told to fix the latch, the dishwasher has to be taken out from under the counter top (in order to get the door open). My problem is: with the dishwasher door stuck shut, it's impossible to unscrew the dishwasher from the countertop... Any helpful hints? Pleeeeeeeease (all of my silverware is stuck INSIDE the locked dishwasher - LOL!)


Well I'll try to help you get this opened. I don't know how much space you have at the top side edge of the dishwasher. You need a long stiff rod like a metal clothes hanger straightened so it can reach from the side to a little past the dishwasher m ... GE Profile PDW9880NSS Stainless Steel Dishwasher

Top drawer would not open. I got it open unplugged unit and now it opens and closes fine but the lock indicator is on and the drawer will not turn on. When i press the Lock button nothing happens.


The child lock has engaged. Press the lock button for 4-5 secs and hopefully it should disengage.\015\012\015\012Please post a comment to say if this helped.\015\012It would also be helpful to know under what conditions the drawer l ... Fisher and Paykel 23 in. DD-603 Built-in Dishwasher

I have a Kenmore dishwasher model 66574362K2. It has worked fine until tonight. I opened the door before the end of a cycle, closed the door, and pushed the cancel drain button. There was still water in the bottom but the dishes were basicly finished. Now I can not seem to get the dishwasher to come back on. The lock button seems to be on and it usually is not on. The manual says to push and hold the button for 4 seconds to turn it off. I did that. But now it is flashing between the Heate


Can you press the drain button to drain the water, then shut the unit off and restart??? I have exhausted all my resources to help, thought this may work. ... Kenmore Dishwashers

Control panel buttons don't work. Seem to be stuck in the "Lock On" mode. Can't turn off, and dishwasher won't run. When you open the door all lights go off, but as soon as you relatch the door, the "Lock On" light comes on, although sometimes it can be another light. In any case, it won't run.


... Kenmore Dishwashers

Viking dishwasher, after pressing normal cycle button, then the start button, the dishwasher begins to run (doesn't seem like there's water enters), then it runs for about 5' and shuts off by itself, the entire cycle is about 5-10min. When I open the dishwasher, it seems dry and the dish detergent door didn't open at all. What should I do to correct this or where do I troubleshoot?


... KitchenAid 24 in. KUDI01TJ - Multiple Color Built-in Dishwasher

When I press the start button, Bosch dishwasher (model SHY56A 05UC) just keep running the motor pumping the water out of dishwasher, irrespective of: 1) the wash cycle it is on, 2) whether the door is closed or open, 3) whether I cancel drain cycle, as told by Bosch Cust Svc in following steps: - "Cancel Drain" by pressing 'Quick Wash' and 'Regular Wash' buttons together for a minute until it shows 0* - Shut power off for a minute and wait for a minute - Restart on Quick Cycle. Paid


What is happenig i believe and has happened to me 2 times is that the water level float that is on the left side of dishwasher is stuck.\015\012\015\012Either remove side panel and flick lever or pull dishwasher out and tap lower portion ... Bosch SHY56A02 / SHY56A06 Built-in Dishwasher

GU1500XTLS3 Periodically won't start. Dishwasher has power because pressing cancel causes dishwasher to start draining (even though there is no water). Door switch works because opening door prevents starting drain cycle. No other button on control panel will work except for the 'air dry' / 'lockout' button. Turning off circuit breaker for 15-30 minutes and then turning circuit breaker back on seems to fix the problems but only for a couple uses and then it stops working again. Need ad


This could be the 'fill switch', which is the level sensor. Could be a plastic tube that exerts air pressure into the tube as it fills, make sure it's clear and open. The dishwasher has a sensor that monitors the door being closed too. Some use a hig ... Dishwashers

Is there a way to have this dishwasher continue the wash cycle automatically after the door is opened? The kids always forget to press the start/resume button after opening the door during a wash cycle. This is for a KitchenAid KUDT03ST model dishwasher.


... KitchenAid Architect® Series II KUDT03ST Built-in Dishwasher

Have a GE Quiet Power 3 Dishwasher. Went to reun it and when I closed the door no lights came on to pick a wash cycle. Nothing like it lost power. No buttons work, nothing. Opened door and removed inside door panel. Have power at door latch switch. Actually have power at all 4 connections and doesn't change when engaging switch as if door was closed. Switch does click but no power at front control panel. Whats up. I have my own Handyman/Home Remodeling business and I'm very good at fixing things


If your dishwasher is not running check the following \015\012\015\012You have already taken care of the 1st item.Power Supply The main power supply is the first thing to check. Also remove the toe ki ... Dishwashers

I have a fisher and paykel single door dishwasher model dw918 td. The other day its door spring collapsed and the door had a free fall. The dishwasher operated fine. But we have accidentally opened the door and let it free fall under its weight a few times. Last night the dishwasher began its cycle and stopped after 10 minutes - no beep, no alarm, display was fine. it just stopped. I opned and closed door a few times. Pressing the start/stop button only resulted in a beep but no action. I let


... Fisher and Paykel Dishwashers

Start Button doesn't light. Tried to get it lit by opening and closing door and pushing all other button options. All other buttons light and seem to depress or click when pressed - the start button doesn't.


Does the dishwasher work as normal? If so, most likely that LED burnt out. ... Dishwashers

Hi, I have a KitchenAid Superba diswasher model #KUDSO1FLSS2 that has quit working. All the buttons seem to work and the lights light up as they should but when you hit the 'start' button the light that you selected for whichever cycle would flash once, then close the front door and dishwasher would start. The 'start' button was acting up and would have to press a few times before light would flash and then the dishwasher would work. Now everything lights up but start button does not work. Opene


Hi.Test the start button switch.The switch is tested by disconnecting power and reading Ohms, this will tell you if it does open and close the circuit.If the start button is part of the control assembly, then this kind o ... Dishwashers

Start button flashes 2hr, but will not start the dishwasher, when touched. Also, lights on top of the door are not always functioning. I phoned Maytag and customer service had me turn off the circuit breaker for 5 minutes. This did not change the dishwasher. I think that the door latch is not snapping into position, when I open the door.


... Maytag 24 in. MDB7601A Free-Standing Dishwasher

I have an ADB 1200 (or possibly an ADB 2200) according to the installation instructions. I lost the manual. Anyway, the door was becoming more difficult to open. Now it won't open at all no matter how hard I press on the latch. Any suggestions before I try to pry it open and probably break something? Bill


... Amana 24 in. ADB1200AW Built-In Dishwasher

I have power to the unit but there are no lights on door when closed. Unit will not respond to any buttons and lock not on.I have opened up the door panel and have power to the door switch and then to the board.What is my next thing to check?


Ok so you have power going to the unit at the bottom if the unit is not under warranty? first are any LEDs operating at all when door is opened? if not you most likely have a control issue to test this you would remove the screws along both sides of ... KitchenAid 24 in. KUDI02IR Built-in Dishwasher

Prima lpr601 problem- filled dishwasher up sa normal set the wash pressed button on far right (dont know what it is but needs to be done), closed door and loud raattling so i opened door to make sure all spray arms were clear which they were, closed the door , again the rattling . now the green light has gone out on far right and cant get it back on so program wont start at all. Any advice?? please help


... Dishwashers

We removed the dishwaser 3 months ago for renovations. It has been reinstalled (everything looks ok). However, app. 2 min. into the cycle the door pops open. Eventually the cycle completes but only by pressing the door closed and hitting restart button 2 or 3 times per cycle. With the constant door popping there is considerable condensation on the new cabintry. What can we look for to fix this proble. thank you.


... KitchenAid 24 in. KUDI02CRBS stainless Steel Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1330 seconds