Having problems with your Kenmore 24 in. 17052 / 17054 / 17059 Built-in Dishwasher ?

Kenmore Ultra Wash - repeats cycles

\015 Our dishwasher starts filling and repeats the cycles over again after running through them all once.\015

Answers :

Sounds like a control board / timer problem.
Repair Help & Product Troubleshooting for Kenmore 24 in. 17052 / 17054 / 17059 Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have a Sears Kenmore Elite Ultra dishwasher 665.1315 model. For the last 3 weeks, it keeps having the clean light blinking 6 times pause then 1 blink and pause and repeats cycle again. I have turned off the breaker...I have reset by pressing the heated dry and normal wash until all lights are flashing. It then completes some type of cycle and looks ok. When I opened the door, steam came out and all was hot inside. However, once I try any new wash cycle, it seems to wash but after 1-2 hours and


Call sears service and tell them you need service there is a service flash and will be no charge ... Kenmore 24 in. 15932 Built-in Dishwasher

I have a kenmore ultra wash dishwasher and it doesn't seem to get to the dry cycle. Left on it will wash and drain and repeat over and over. I have to manually press the drain/reset cycle to drain the water.


... Kenmore 24 in. 16182 / 16189 Built-in Dishwasher

Using Smart Wash cycle for Kenmore Elite Ultra Wash Dishwasher, machine runs for 3 seconds, cuts off for 10 seconds repeatedly. Is this normal?


... Kenmore Dishwashers

Kenmore Ultra Wash - repeats cycles


Sounds like a control board / timer problem. ... Kenmore 24 in. 17052 / 17054 / 17059 Built-in Dishwasher

Kenmore Ultra Wash model #665.1374* purchased 1/26/08 electronic control pad doesn't work properly - one wash cycle works (no matter which cycle is selected, it defaults to same one - light wash) - "washing" and "drying" cycle lights don't work -


... Kenmore Dishwashers

Kenmore Ultra Wash Quiet Guard - will not drain at end of cycle. After cycle is complete, water (not clean) sits at the bottom of the washer but I still unload the dishes and then turn the cycle dial around again - going past all the water heating and filling and washing - and land on the drain cycle, it will drain. Any ideas why it will not drain when I let a cycle run, but will drain once I cycle it through to the drain option?


... Frigidaire 24 in. PLD2850 Built-in Dishwasher

Kenmore Elite Ultra Wash QuietGuard 7 skipping washing cycle.


... Kenmore Dishwashers

I have an kenmore elite "ultra wash" model 665. not sure the rest.. about 7/8 years old, making loud buzzing sound during wash cycles,starts about 5 minutes into the normal wash cycle. i removed the inlet protector and the chopper area and all was clear.clean...it's running now and seems to be pumping the water, but can live with this buzzing noise,,, any idea, is the pump on it's way out ? just stopped as it kicked into another cycle, at 42 minutes...but it will be back, any ideas ? (back alrea


Buzzing sound may be coming from a solenoid that is mounted under the dishwasher, below the tub ... Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher

I have a Kenmore Elite Ultra Wash HE. Model #66513122K701. Serial #FY0310281. Purchased New 1/31/09. It only works for a full wash cycle on on 1 hour wash. Super Wash and Normal wash both stop mid cycle and leave dishes sopping, dipping wet and with green light blinking. Been doing this almost its entire life...has ahd control panel replaced once under warranty...but if it is a factory defect...they probably just repaced it with another defective part...what to do? What should I do.


... Kenmore Dishwashers

Dishwasher hums I have a 2003 Kenmore Elite Ultra Wash Dishwasher model #665.17469300. I started the wash today. The water came in the unit and started washing then I heard it stop and it just started making a humming noise. I was afraid it was going to overheat or something so I cancelled the washed and it drained out. I started the unit up on a different cycle and the water came in the unit but did not wash it just hummed so I cancelled and drained it again. I did that on all cycles and the sa


... Kenmore Dishwashers

Kenmore Ultra Wash 3 (6651694193) stuck in wash cycle


Hi,\015\012 There should be 2 thermostatic switches in the heater area. They are just simple bi-metallic "button" switches.\015\012One will trip at the correct temperature - and tell the programmer to advance now the water is hot enough. ... Dishwashers

I have a Kenmore Ultra 15895 or 15891. It fills with water then doesn't run. It will continue through it's cycles, but stays full of water. If I hit cancel before it completes the cycle, the number 2 shows in the display and nothing happens. If I let it complete the wash cycle, it will sometimes start and wash properly.


HI. The culprit will be the main control sector. This control fault may possibly be corrected by initiating a hard reset. the logic chips are scrambled, and this damage may be correctable by simply unplugging, or shutting off the appropriate circuit ... Dishwashers

Kenmore ultra wash Normal cycle runs,runs, does not switch to next cycle?


... Kenmore 24 in. 15932 Built-in Dishwasher

My Kenmore ultra wash quiet guard doesn't seem to be doing a very good job washing dishes, especially anything on the top shelf such as glasses. Sometimes after a whole cycle, their are still fingerprints on the glasses and scum on the bottom of coffee cups. Also it doesn't seem to use much of the detergent. I fll the dispenser about half full with liqid Cascade Complete and most of it is still there after the cycle is done. The inside of the door is also stained and dirty. I have looked at the


... Kenmore Dishwashers

My dishwasher so my dishwasher seemed to have quitworking during a cycle. like breaker triped or something. i checked the breaker and thats fine. it seams like its hard wired in though. Would that be right? and is there a fuse or something that could/would blow during a wash? I dont know what model it is or anything it was in the house when i got it. The dishwasher is built in and it seems decently old its a kenmore ultra wash and it has like 10 buttons for the differend cycles on the left and a


Sounds like the fuse on the control blew. you can replace the fuse for\015\012around $20 or you can cut and splice the wires for free. If that doesnt\015\012work then you may have a loose conection in your junction box under the\015\012dishwasher. ... Kenmore 24 in. 15932 Built-in Dishwasher

I have a Kenmore 665.1373 Ultra Wash dishwasher that will not work. In the past few weeks, it stopped mid-cycle, the the clean light began to flash. Sears sent out a technician who told us that the latch was not catching. He adjusted it, did something with a computer and the dishwasher worked for a couple of days. This time, it would not start a cycle, it would only show heated dry if you pushed the smart wash button and nothing if you press start. It looks like some of the lights are continuous


... Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher

I have a Kenmore Ultra Wash Dishwasher (Model Number 665.15634) that will not fill up properly. When I try to run a cycle (any cycle), the first thing the dishwasher should do is fill up with hot water. But in my case, my dishwasher fills for about 10 seconds, then stops. Then tries to fill again for about 7 seconds, then abruptly stops again. And this process goes on and on and on. The dishwasher never fully fills up nor starts the wash sequence properly. Once the dishwasher fills up, it


... Dishwashers

My Kenmore Ultra Wash Diswasher is stuck on the wash cycle.


Sir,Here is the link for some basic tips to how to maintained the diswasher. check out may be u solved ur problemthanksg ... Dishwashers

Dishwasher: Kenmore ultra wash sensor quiet guard plus. I'm in a rental so I don't have the manual or model number. A few days ago it just wouldn't start the wash cycle. When you press normal wash then start the no heat dry and lock lights flash every other second or so but nothing happens. I can hit the cancel button and it will make sounds like its trying to drain, and after about 5 minutes stops. I've done the heated wash/ no heat dry sequence to try to reset but no luck. Also tried turn


... Kenmore Dishwashers

My Kenmore ultra wash dishwasher model 665.1374 will only work if I press the restart button. When I do it goes to pots and pans with the drying cycle light lit. I cannot get the smart wash, normal wash, or quick wash buttons to work.


... Kenmore Dishwashers

Kenmore Ultra Wash Diswasher - wont move past initial cycle


Motor trying to start. blockage in pump, or bad motor! ... Kenmore 24 in. 15932 Built-in Dishwasher

Kenmore ultra wash dishwashers model 665 red light is on when running wash cycle


... Dishwashers

My Kenmore Ultra Wash III has a 66 min. normal cycle. Now it freezes at the 37 minute mark and just continues to wash without stopping.


... Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher

Kenmore Ultra Wash Model stuck on wash cycle


... Dishwashers

Kenmore ultra wash 6651346 k900, The washer


... Kenmore Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1337 seconds