Having problems with your Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher ?

Kenmore elite, no power, tried circuit box

\015 I stood on my head, twirled three times, ate spiders...no help....Where is the plug in on this thing? Not under the sink....take the unit out?\015

Answers :

The unit is hard wired (no plug). with the kick plate removed, you will see a wiring box. With the power off, open the wiring box and disconnect the supply wiring then disconnect the incoming wire from the unit. turn off the water and disconnect the water line under the unit. disconnect the drain line under the sink and pass the slack through behind the dishwasher. Open the door and remove the mounting screws holding the unit in place. slide the unit out.

Please take the time to give this solution a fix ya rating

clarkco
Repair Help & Product Troubleshooting for Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Kenmore elite, no power, tried circuit box


The unit is hard wired (no plug). with the kick plate removed, you will see a wiring box. With the power off, open the wiring box and disconnect the supply wiring then disconnect the incoming wire from the unit. turn off the water and disconnect th ... Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher

I have a Kenmore Elite 665 Dishwasher. The front control display has been partially working but the dishwasher still worked. Today when we tried to start it it will do nothing & it is getting the correct power. Would this be the control circuit board or something else?


It appears your timer/main controller/CCU has failed in this instance.For replacement parts - head on over to PartSelect.com or RepairClinic.com and enter in your full model number for a full parts listing.I recommend both sites bec ... Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher

I have a Kenmore Elite Ultra Dishwasher and the cleaning light is flashing. I have tried pressing the start/resume button and closing the door within 3 seconds. I am not able to turn on my dishwasher. I have tried turning off the power for 20 minutes but when power was restored the green light continues to flash and the dishwasher will not work. This machine was installed in May 2008. Help!


If the clean light flashes 7 times, pauses, then repeats...When\015\012the dishwasher doesn't sense a water temperature increase, it will\015\012stop working and lock the functions (clean light flashes 7 times, all\015\012buttons are non ... Dishwashers

I have a Kenmore elite ultrawash HE dishwasher Model 665.13129K700 , serial # FU3801153 , Stock # 13129K , Type 586-0. My normal wash red light flashed constantly and will not allow me to reset the control panel. I disconnect power for 1 hour then it allowed me to run 1 cycle. Upon completion the normal wash red light started flashing again. I tried to toggle between high temp wash and heated dry but no other button will work since normal wash is flashing. I again disconnected power but this tim


Hi,Push push thishi temp wash / heated dry hi temp wash / heated dry hi temp wash / heated dryIf this does not reset the control then you will need to replace the control board.Let me know,if needed fur ... Dishwashers

Kenmore elite 1393 worked fine for a week or two then began to stop in mid cycle,we could drain the water and try again but would shut off almost immediately. sometimes trying to restart it there would be NO power to any buttons, after waiting for awhile the buttons/lights would work again but the washer would not run a full cycle.blue light would light then go out within a minute or so.


... Dishwashers

I have a Kenmore Elite Dishwasher Model 665.13773K600. It seems to have no power to the touch pad (top) control panel. I have already checked the circuit breaker and the power to the dishwasher. A friend said that it may perhaps be the thermo fuse cut out that needs to be replaced. 1) Is this true? 2) How can I remove the 1" thick control panel touch pad after removing the six screws- it seems to be stuck, and I don't want to break the plastic touchpad.


... Kenmore Dishwashers

Kenmore Elite Drawer Dishwasher model 465.13329600 Normal Wash and High Temp Wash buttons stay lit, as does green Lock button. The Start/Resume button and the red button on the front of the drawer keep flashing. I've tried key combos suggested above, but nothing seems to work. Even tried shutting it off at the circuit breaker to reset it, and that didn't work either. This ****** was purchased in 2006 or 2007, and hasn't been used very much. WTF?


... Kenmore Dishwashers

Kenmore 665.1389 No power, lights won't come on. Tried circuit breaker didn't help. Is there a fuse or probably the control panel?


... Dishwashers

My kenmore elite model # 253.4448370 keeps beeping and won't stop. We try to press reset button because high temp and power failure lights are flashing but when we press reset button it doesn't seem like the button works..it doesn't reset like it use to...does anyone know how to make this beeping stop? It appears that the temps are right for both frig and feezer but beeping won't stop...HELP!!


... Kenmore Dishwashers

Model 665.15919001 Kenmore Elite dish washer suffered blown fuse last week, and after running two more loads, it appears to have the same problem-no power. The unit is plugged in and the breaker to the circuit is on.


... Kenmore Dishwashers

I have a kenmore elite dishwasher that no lights will come on.I have checked for power all the way to the motor.I have tried the buttons that you push to reset but nothing happens.Any ideas?


It appears your timer/main controller/CCU has failed in this instance.For replacement parts - head on over to PartSelect.com or RepairClinic.com and enter in your full model number for a full parts listing.I recommend both sites bec ... Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher

My kenmore Elite stopped working after my daughter open the door during a cycle. There seems to be no power. Circuit breaker is fine. Any thoughts? Thanks


Check the wall socket for \015\012\011\011\011power. Sometimes the power cord disconnects at the dishwasher \015\012\011\011\011(inside the junction box, behind the bottom kick panel), if this is \015\012\011\011\011the case, the wiring must be repai ... Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher

Hello, My Kenmore elite dishwasher model 665.17282.400 seems to have a problem. The CLEAN light is flashing and can't do anything else with it. Do you know what thew problem is, or how to reset it. I tried cotting off the power to the unit but to no avail. Please help ASAP


Try pressing the heated wash then heated dry one after the other about 5 times. this should reset the unit.\015\012\015\012\015\012--------\015\012in some machines there is "Hi temp scrub " and "air dry" so press this ... Kenmore 24 in. 17282 Built-in Dishwasher

Kenmore Elite 665.17053400. Powers up ok, fills up with water ok, but wash cycle won't start. I can hear the motor trying to turn but sounds like its seized up. If I cancel the wash, the machine drains out the water ok. Does this sound like the moter is shot and if so, what should I expect to pay to have it replaced?


This dishwasher has a very sophisticated wash system. In order to improve the wash efficiency it uses a chopper and a soil sensor. It is very likely the chopper assembly is clogged which is blocking the water from circulation and straining the wash m ... Kenmore Dishwashers

My kenmore Elite stopped working after my daughter open the door during a cycle. There seems to be no power. Circuit breaker is fine. Any thoughts? Thanks


It appears your timer/main controller/CCU has failed in this instance.For replacement parts - head on over to PartSelect.com or RepairClinic.com and enter in your full model number for a full parts listing.I recommend both sites bec ... Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher

Kenmore Elite Dishwasher, model 665.15914 , blinking lights Lost power yesterday... Dishwasher ran from No 99 to 76 and stopped I tried resetting on panel....didn't work Took out fuse and put back in ..didn't work hit Normal Wash and light just blinks


... Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher

I need to reset my Kenmore Elite dishwasher 665 16919 front panel. Drain tube was blocked and the dishwasher shut down. Now there is no power to the front panel. No circuit breakers were tripped.


... Kenmore 16919 Built-in Dishwasher

Kenmore Elited Ultra Wash dishwasher Model No. 665.13859K601 The normal wash button is flashing. I pushed the cancel/drain button and it stayed on. I've turned off the circuit breaker and tried pushing some button sequences as recommended on the internet. I can't access the tech sheet because of they way the dishwasher was installed.


... Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher

Hotpoint Dishwasher BF1620 blew the main fuse circuit in fuse box during mid cycle wash? Re-set main power fuse circuit but now as soon as Dishwasher switched on immediately blows main kitchen power fuse in fuse box? What is problem?


This is happening because you have a very bad fault, a Phase to Earth short, problem. Leave machine UNPLUGGED, Breaker/Fuses OUT. do NOT use it, nor Touch it, It is possible to get severe electric shock. PLEASE get a registered serviceman to inspec ... Hotpoint 23 in. BFI62 Built-in Dishwasher

Kenmore Elite Model 665.16499300 will not operate as though it has no electrical power. No lights.


... Dishwashers

Kenmore elite dishwasher no power


1) Test the fuses blown or c.breaker reset.2) See for any wires broken, burn, or loose wires repair.3) test the switch door, if are open the starting relais will not move the motor see the diagram.4)see the test that you can make ... Kenmore Dishwashers

Have an electrical circuit that has stopped working. Romex circa 1930. The breaker is fine. There are 4 ceiling lights and 3 outlets on the circuit. There is power through the hot wire leaving the breaker. Tried wiring to a different breaker to be sure. Still no power


If there is power leaving the box, you have a broken/damaged wire somewhere.If all the lights and outlets do not work - the problem is with the common (return) (white) or a broken/damaged wire before the first item in the circuit.If the b ... Dishwashers

My 1 yr old GE dishwasher model # GLD4900P00WW lost power during the drying cycle & blew the rest of the circuit. An electrician has fixed the rest of the circuit & rewired the dishwasher to it's own switch in the breaker box. The dishwasher still has no power. Is there a fuse somewhere in the dishwasher that could've blown? If so, how do I locate it?


... GE Dishwashers

My DD 603 has burnt out the power board marked 34740453-G. It tripped the circuit breaker at the power box. It is burnt out on the board where the loom connects for the upper washer. It is burnt vertually in the centre of where the loom joins to the power board and the centre of the loom. I am wondering if something else has gone wrong with the washer causing the power board to burn out, or can i just replace the power board?


... Fisher and Paykel 23 in. DD-603 Built-in Dishwasher

I have no power to the dishwasher. I tried the circuit breaker, flipped it. No lights on, nothing. It must have been running when the power might have gone off, may be the power surged or something and it wasn't able to finish running the cycle. I have taken out all my dishes and washed them by hand but I still have water standing in the bottom of the dishwasher. I am a mechanically challenged mom and my husband won't be getting home for two more weeks. The dishwasher is a WhirlPool Gold Quiet


First check and make sure that the units not on a switched receptacle(and is wired into this circuit(i know the dishwasher is "hard-wired",as in the unit doesn't have a plug on it,but it could have been wired into this switched circuit by mistake) un ... Whirlpool Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1215 seconds