Having problems with your Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher ?

Does not wash properly, does not drain

\015 While washing the dishwasher was making a heavy clunky noise. When done there was some water left in the bottom of the drain. The dishes were not rinse thouroughly.\015

Answers :

Pull your spray arms and make sure the holes are clean. Next with the spray arm off check your impellors and make sure they are not broken or worn. Last but not least check your drain and make sure it flows smoothly. One of these is causing you problems.
Repair Help & Product Troubleshooting for Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Indesit idl 535, washing on usual cycle but not heating and dishes not being cleand properly? Disolves tablet and goes through full wash cycle as usual but doesnt wash dishes properly and the dryer isn't working as it normally is hot when you open the door, but it is just cold. water draining as normal too.


Your problem is very clear, you need to replace the wash tank heating element. ... Indesit 24 in. IDL500 Built-In Dishwasher

Hello, I had a problem with my Bosch dishwasher not washing properly. I have fixed burnt out wires, replaced the water inlet valve, AND tested with a new control module. Nothing is helping. When I start the cycle, it completes the initial drain and water does flow into the unit for about a minute, maybe a minute and a half. I can hear the clicking of cycle changes but it is not washing. Eventually it will drain the inch or so of water in the bottom, but it never washes. Any help???


Hi,\015\012\015\012Welcome to Fixya.\015\012\015\012Can you hear the wash motor humming ? I`ve got a "pdf" I can send you regarding this if you want to contact me at ... Bosch SHU9925UC Built-in Dishwasher

This thing has never drained properly. You have to hit the cancel/drain button a few times for it to finally drain. I don't think it drains completely after wash and before rinse because everything comes out covered in particles that weren't there going in. We've checked the hose, and for stuck food with no luck. There aren't many dishwasher repairmen in my area and I'm at the point it's just a giant drying rack while I hand wash. Any advice would be welcome!


... Haier ESD210 / ESD211 Built-in Dishwasher

The dishwasher did not drain properly a couple of washes ago. Then the next washing cycle is did drain. Now the machine does not work on any cylce and there appears to be a leak from the bottom of the machine. Can you help?


Hi \015\012\015\012 \015\012\015\012Thanks\015\012for using FixYa. Dishwasher not draining properly or not draining at all issues\015\012can arise due to different reasons. Usually, th ... Bosch 24 in. SGS47E02 Exxcel Free-standing Dishwasher

Wont dry Hello, I have the Asko D3112 dishwasher. It washes great, but does not dry completely. After a wash everything is still drenched as if i splashed in a bucked full of water. I know it drains properly (i hear it draining down the sink), and it attempts to dry (hot air). I also am using the rinse aid as specified in the manual. Any tips would help. thank you Andrew


Make sure you select a high temp wash and the heated dry as well Also, dont put too many plastic items in there at once, they dont dry very well in anything. Check the amount of soap you are using, it shouldent be more than 2 tablespoons (way less th ... Asko 24 in. D3112 Free-Standing Dishwasher

Hi experts - My dishwasher won't drain properly. There's several inches of standing water in the bottom of the unit. During the drain phases of the wash, the motor underneath doesn't spin and a buzzing is coming out of the motor relay. During the wash and rinse phases, the motor runs fine and all appears well. Any thoughts? Thanks!


Either the water outtake or the pump are clogged - you will have to remove it to see where's the problem. ... Frigidaire 24 in. FDB679GF Built-in Dishwasher

I have a Bosch SHE55C05UC dishwasher and it just started to not wash properly and leave water in the pan below (first time it did not drain at all.. I tried the rinse/hold cycle and got the unit to drain and tried again and it is not working properly and keeps water in the pan. I am on a well and have great water pressure about 70 psi.


I am assuming you have checked the filter and drain sump and there are no obstructions. Have you tried taking the drain pipe out of the sink downpipe and checking if it drains directly into the sink?\015\012\015\012I am also assuming the ... Bosch SHE55C05UC Dishwasher

The dishwasher isn't draining properly. Not a blocked drain problem as the washing maching draining via the same drains is OK. The bottom of the dishwasher is half full of water that isn't draining on its own.


Sounds like you have a bad drain solonoid very common problem and easy fix. ... Neff Dishwashers

Start button pressed - Water loads and "Wash Cycle" lights are on but does not start wash. If "stop/reset" is pressed then all water is properly drained. Tried different wash cycles like "Speed Wash", etc and same problem persists. Have checked interior to make sure no blockage and that washer arm moves freely.


... GE 24 in. GSD6600G Built-In Dishwasher

Edgestar DWP60ES prematurely ending wash cycle, will not drain properly, beeps alot


Most likely the dishwasher has a minor leak in the base under the wash sump. this could be tripping the flood switch which causes the pump to run continuously. when the leak dries up you are able to start normally until the leak trips the flood switc ... Dishwashers

My dishwasher doesn't seem to be cleaning properly. I have cleaned the screen and all sprayers and they are working properly, but not sure the autoclean cycle is working properly. Is the water supposed to drain and refill before the washing cycle begins?


Hi \015\012\015\012 \015\012\015\012Thanks for using FixYa. First of all please check the\015\012Water temperature by using a thermometer inside the dishwasher to measure the\015\012wa ... Maytag Dishwashers

Kenmore Ultra Wash III Dishwasher will not drain properly


Fixerfailure, is the knock-out plug still inside if the garbage disposal inlet?\015\012\015\012Stick a screwdriver in there to make sure.\015\012\015\012spazmo1969, could be the rubber flapper is broken off in the pump dischar ... Kenmore 24 in. 15932 Built-in Dishwasher

The wash ('arms' twirling and washing) part of my hotpoint 71340 dishwasher cycle is not working properly - little water soming through - The motor sounds as though it is working although at a higher pitch Draining OK


It sounds like you either need to clean the debris out of the filters and wash arms or the machine isn't filling with enough water. ... Dishwashers

The dishwasher does not appear to be draining properly any more. There is soap residue on the door after it runs. Also ther s a small pool of water by the food drain after the cycle ends. The glasses all have a residue on them after the washing cycle ends


Hi,The scum, film and white\012residue problems have started since the reduction of\012phosphates in dishwasher detergents.Here is a tip that\012will help you to solve the problem of films, residue, and scu ... Asko 24 in. D3121XL Free-standing Dishwasher

Our haier, hdw101wh dishwasher is not washing properly. Water does not seem to be coming into the machine when it should and the water has not drained properly from the bottom. When we opened the dishwasher up mid cycle to see what was wrong the element was on, even though there was no water.


... Haier Dishwashers

De3861fw Hi, the machine stays on the same cycle time(cycle wash 5-84min; cycle wash 6-93min) The machine is on and sounds like it is running, but no water is entering, have checked the obviuos of water being turned on and also draining properly, but to no availe. Please help! Cheers


... Beko Dishwashers

My Bosch SRS5602GB/05 isn't draining properly. After the wash the drain filter tray retains water and food residual is lining the bottom of the washer


... Bosch Dishwashers

My kitchenaid KUDI01DL dishwasher began making a lot of noise while running, then subsequently decided not to circulate the water around to wash the dishes. It sounds like the motor is running (maybe) but there is no washing action going on. The machine will fill, drain and heat the water but nothing else. Is it likely that the pump/motor assembly has ceased to function properly? thanks...


The problem is very likely in the chopper and/or somewhat possible in the impeller. The chopper is replaceable from the front. Disassemble the pump, the chopper will be on its left side under a cover. That cover is kinda tricky to remove (remove all ... KitchenAid 24 in. KUDI01DL - Multiple Color Built-in Dishwasher

Kenmore Ultra Wash III Dishwasher will not drain properly


From the sound of things, your dishwasher drains faster than your sink drain ( via the garbage disposal) can drain it off.. You may have a problem with the way your sink drain/trap is vented and there is too much back pressure to drain down quickly.. ... Dishwashers

Indesit Dishwasher not washing properly or draining


Could be a few problems here. The main one may be the timer. Generally the timer will tell each part to do what it needs to do and when, if it is not closing relays then you get a dishwasher full of dirty dishes. I would also check the pump to mak ... Dishwashers

Does not wash properly, does not drain


Pull your spray arms and make sure the holes are clean. Next with the spray arm off check your impellors and make sure they are not broken or worn. Last but not least check your drain and make sure it flows smoothly. One of these is causing you probl ... Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher

Dishwasher will not drain and wash properly


Check airgap on sink (chrome cap) remove cap , and remove top of plastic cap and check for clog . ... Kenmore 24 in. 16032 Built-in Dishwasher

Dishwahser not washing and draining properly - Dishwashers


Need more info. Model # Properly? ... Dishwashers

IDL 700 Our dishwasher starts the program and just after it goes into the proper wash mode it stops, drains and lights 2 & 4 flash. Any clues?


A10 2 & 4 Heating element Open circuit heater\015\012\015\012info from idl service manuall\015\012 \015\012 ... Indesit 24 in. IDL700 Built-In Dishwasher

I have an SHU 4322. It displays "2H" in the countdown window. It will drain-cancel properly, but all of the programs display "2H" instead of the normal # of minutes for each cycle. How do I get the wash cycle to start normally?


Just reset the unit by unplugging the cord from the wall for 4 hours. The purposed for this is to drained the current stored in memory IC . So it will works normal again. Plug it again after 4 hours to see the result..Good luck: ... Bosch 24 in. SHU43 Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1082 seconds