Having problems with your Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher ?

Ice maker water will not shut off ,an l replace inlet val twenice.


Answers :

Valve runs on a time cycle. in most units. the ice maker may need to be replaced. you might inspect unit by removing it and checking for obvious defects, such as loose wires or evidence that timer is malfunctioning. the valve is probably solenoid type, and is native to off mode, which means that with current from the timer, it opens against a spring to let water in for a period of time. you can see if your unit has a replaceable timer.
mark
Repair Help & Product Troubleshooting for Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Ice maker water will not shut off ,an l replace inlet val twenice.


Valve runs on a time cycle. in most units. the ice maker may need to be replaced. you might inspect unit by removing it and checking for obvious defects, such as loose wires or evidence that timer is malfunctioning. the valve is probably solenoid typ ... Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher

Ice maker not making ice - KitchenAid Icemaker Replacement Water Inlet Valve fits Kitchen Aid Ref


... KitchenAid Icemaker Replacement Water Inlet Valve fits Kitchen Aid Ref

My Karcher 330 M has blown two water inlet ( Garden hose inlet ) elbows. Replaced one and then after about 5 min operation shut off the valve on the wand and immediately the new elbow split the same as the first. The garden hose I was using has a shut off valve could this caude the problem?


I have a larger gas powered karcher, just make sure the water going to your karcher is not obstructed from its path. on mine i bought a goodyear hose that can be purchased at northern tools or any hardware store. and use it just for pressure washing. ... Karcher PSI Electric Pressure Washer

GE Dishwasher model PDW8200J03BB stopped draining. Removed the drain pump, checked with Voltmeter and there is resistance on ohms X10 of about 3. The flap is in place so water isn't shooting back into the sump inlet. Replaced the sump inlet about 6 months ago because it was deteriorated due to hard water. Pump worked fine after that. Checked drain hoses and air gap. Was able to blow water through. Pump only trickles water out at air gap. Does the pump need replaced?


Clear the line from the air gap to the drain,, if the rest is clear the only thing it can be is the propellers on the pump, i which case you will need to change the pump ... GE 25 in. Profile PDW8200J Built-in Dishwasher

Samsung dmt800 dishwasher error code 4e. Water valve is open, pressure and temp correct, flex water hose not kinked, water inlet valve is free of debris. next steps? replace water inlet valve?


... Samsung DMT800RHW Built In Dishwashers

ASKO D3432 At start up, drain pump works fine to remove water. Inlet valve kicks in and it fills with water, then it shuts off and gives a fault message. "Water Inlet Fault". There are no "kinks" in the water hose and I can see water fill the side "reservoir".


... Asko 24 in. D3432XL Dishwasher

Miele 646 sc plus inlet tank solonoid valve on water tank leaking. We moved the machine from one room to another and now this valve is squirting out water. We replaced both door seals thinking that was the problem, then started the machine with a side pannel removed, and saw the jet of water coming from the solonoid valve on the water inlet tank. Any ideas.


... Miele Dishwashers

This a message for phil. The aquastop valve was not under the dishwasher. On my model, it was fitted directly onto the water inlet pipe. I replaced the valve as you suggested. After removing the old valve you could see through the clear plastic housing that water was leaking inside the valve. Anyway replaced valve but had to split wires and reconnect with connections supplied with the valve and according to instructions. Water leak has now stopped but when 'on' button is depresse


Please provide dishwasher make and model. Looks like you are retrofitting the valve to your dishwasher which may not be getting the correct supply voltage from the dishwasher control. Will need to understand part no. of the replacement valve you ha ... Dishwashers

No ice just replaced the ice maker itself - Amana Ice Maker S 106 626640 626639 -


Did you check to make sure there is water going to the fridge? It's possible the waterline may be clogged at the saddle valve. does the ice maker cycle? make sure the plug is in correctly and all the way. ... Amana Ice Maker S 106 626640 626639 -

Water inlet valve the machine wont fill with water. checked all hoses, but water inlet valve ma;y be sensitive how much are they to replace. could this be the problem?


A water valve is anywhere from 15$ to 43$ depending on make and model ... Dishwashers

Inlet Valve keeps stopping and starting, takes a bit of water then stops take a bit more then stops, on off on off for about 10 mins until its taken enough water to srta the cycle , have replaced the Inlet Valve still happening and water flow meter with pcb still happening Any suggestions? It a DWLT65


What about the overflow valve? It could be sticking ... Beko Dishwashers

GE model#vrb4119vw129 My water inlet valve wont stop pumping water after the tub is full. I have replace the water inlet valve and the float switch.


... Dishwashers

The dishwasher won't fill with water. We took the water inlet valve off and cleaned the filter screen. The dishwasher worked about 2 times and started doing the same thing. We then replaced the water inlet valve and again, the dishwasher worked a couple of times and now we're back to it not filling again. What could the problem be?


Check the float assembly, that will trip and stop water from coming in. May have soap or grime holding it up. ... GE 24 in. GLD6260LSS Stainless Steel Built-in Dishwasher

Zanussi dw927 not filling inlet valve changed,supply to machine ok, calls for water solinoid activates for about 30secs shuts off and machine does no more. cleaned out two blue plastic pipes situated under a plastic cover which were both blocked, and put a hose jet wash thru where they were situated to clean housing out, put blue channels back still not filling up and now the inlet solinoid wont switch off when when it should and programme advances heater now comes on with no water in.manually


... Dishwashers

Bosch dishwasher (SXH55MO6UC/46): The power comes on and runs normal, but no water is coming into the unit. I was told that it was a water inlet valve that needs to be replaced (part #263833). I need to know if this is what needs to be replaced and if so, is this something that I can do or do I need an expert repair service to do it? If it is something that I can do, I need instructions. I am handy, but this is something that I have not done before, Thank you, Craig Covey


Hi Craig,Yes it may be the fill valve...but first take off the pipe or hose and check the screen just inside the fill valve...some do not have it but most do...also check that water comes out of the hose or pipe at the valve....THEN ... Bosch Integra® 500 SHX55M05UC Built-in Dishwasher

Frigidaire Dish Washer. no water is coming into it. Shut off valve under sink is open,float switch isnt stuck. should I shut water off and remove inlet valve?


Verify that water is getting to the valve and verify that 110 volts is getting to the valve. If either one is missing then you know what the problem is. If you have both then replace the valve. ... Dishwashers

No water Thanks for the try, but I have already replaced the inlet valve. Still no water. I also checked and confirmed that I am not getting 120v to the inlet valve and/or float switch.


Check your heat dry options I have seen them short out a lot and that will prevent the water valve from getting 120v. ... Frigidaire 24 in. FDB126RB Built-in Dishwasher

My maytag dishwasher will run for about 5mins. then shut off. if you open it after it stops it has water in it. then you shut it back, it drains the water and stops. I have replaced the board in it and it still does it.


Hi\015\012\015\012The issue can be with the drain pump assembly not cleaned,\015\012you can clean the drain pump assembly by taking the bottom access panel out and\015\012then clean it completely. Check this video:\015\012\015\012 ... Maytag Dishwasher

Asko Dishwasher DW20.1 d3120 Water not coming through inlet valve. I have replaced the inlet valve - solenoid only releases when on/off switch and start button are pressed and released simultaneously. A burst of water comes out at that point and stops. What could be wrong?


Hi, Welcome to FixYa.\015\012\015\012I'll start by saying your description sounds exactly like a symptom of a faulty control board on Asko dishwasher's...specifically the relay responsible for energizing the fill valve. It sounds to me like the relay ... Dishwashers

Water leaking from bottom of Water inlet. How does the inlet come apart? Is there a replacement seal?


You are right, the seal has probably gone bad and needs to be replaced. Can you post the make and model of the washer in question so that I can help you find a replacement gasket and give you the right information.Benjamin ... Dishwashers

Danby ice maker keeps flashing it is out of water but there is water in it


I finally found the manual and did what the manual trouble shoot section said to do. Nothing fixed the problem so I called the customer service number listed in the manal. Because there is no Danby service people in my area, they suggested I return ... Danby DDW1805W Designer Series Free-Standing Dishwasher

Maytag HDB8600AWW Dishwasher had been making noise (thought might be water valve, like previous DW), eventually stopped draining water, water now in bottom, I've let sit for couple weeks, looked inside, water was gone, I tried running again, it filled with water, but heard humming control panel noises for first time, then shuts itself off. Also, my handle needs replaced. Please let me know as soon as possible. Thanks in advance. David Weaver


Hi David\015\012\015\012The hum and all the noise that you have mentioned in your post states that the issue is with the pump and motor assembly. Please check the drain hose and try to clean the drain pump filter for any clogs, obstructions. Af ... Dishwashers

Tricity Bendix DH090 water valve closes too early. Insufficient water causes program to stop before first heating cycle. If I switch off, open the machine & pour an extra pint of water in, shut the door & switch on again the wash takes place and completes perfectly to specification. OK so the problem seems to be that level detector No 1 switches off the water inlet valve early and level detector No 2 (apparently) halts the cycle since it detects insufficient water in the machine. I cannot see t


... Tricity Bendix 18 in. DH090 Free-standing Dishwasher

Kskarcher k 320 ,replaced the elbow inlet and after that it does not work . with water connected the stream of water comes when the trigger is pressed but no pressure or the pump does not start . Any


... Karcher Pressure Washers

I have a Bosch SHU9915UC/U11 dishwasher, installed in 2002. Recently, our hot water heater had to be replaced, and we were without hot water for five days. Air got into the hot water pipes, and dried out all the debri in the lines. When we got the new hot water heater going, all of the sediment in the pipes ended up in the in-line screen filters in various appliances (clothes washer, etc.). I have cleaned these out, and these appliances are fine. Since then, the dishwasher has been shutting


All inlet valves have a screen built into the valve itself,shut off the water remove the entire valve and you will be able to see built in screen,if you flush out the debris from it and re-install the valve it should work fine.  ... Bosch 24 in. SHU66C02 / SHU66C06 Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1154 seconds