Having problems with your Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher ?

Kenmore 665 no lights on panel water in bottom

\015 Water in bottom of dishwasher, no lights are lit up on control panel. I checked and reset fuse. Not the problem Kenmore 665 model\015

Answers :

This is commen with these. you need to take the door and remove the screws around it. You need to gain access to the controller. on the controller you will see a white peice with 2 balck wires going to it that is your fuse. replace this and that will solve your problem.
Repair Help & Product Troubleshooting for Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Kenmore 665 no lights on panel water in bottom


This is commen with these. you need to take the door and remove the screws around it. You need to gain access to the controller. on the controller you will see a white peice with 2 balck wires going to it that is your fuse. replace this and that will ... Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher

|Can't seem to get any response or panel lights from my built in Kenmore Ultra Wash Quietguard 4. I stopped the machine mid cycle, started it again, I do believe it started but when I checked a bit later no indicator lights at all, and still has water in bottom of dishwasher???


Hi \015\012\015\012Thanks for using FixYa. The issue seems to be with water not draining. To\015\012start with check all\015\012the hoses for blockages, after you have checked the drain hose and can't locate\015\012t ... Kenmore Dishwashers

Kenmore Dishwasher, 66517029401. Lights on control panel will not light up & water remains at bottom from recent load just completed.


Are you sure the breaker that runs it didn't trip? ... Kenmore Dishwashers

Kenmore elite dishwasher...seems to have shut down mid-cycle...no clean light this morning...inch of water in the bottom...panel not responding....have power to one side of the start button


... Kenmore 24 in. 16032 Built-in Dishwasher

I have a Kenmore UltraWash QuietGuard Model # 16632. Yesterday after 8+ years of problem free operations, it stopped working. When I went to unload it, the dishes were completely dry, the inside of the unit was still warm but there was about 1.5" of water in the bottom of the machine. None of the front panel light or buttons work any longer and I have verified that there is power to the unit. Help?


... Kenmore 16632 Built-in Dishwasher

KitchenAid KUDIO1FL DW control panel is not responsive (ie indicator lights do not light when buttons are pressed). There is water on the bottom of the DW. Like it just died, in cycle. The circuit bre


First see the fuse it it is dead replace it\015\012nor take out the plug from the switch it is connected ... KitchenAid Dishwashers

Electrolux Model EIDW6105GB1 All lights across panel flash. Error light on bottom of dishwasher for drain valve is lit. Tub has water in bottom


... Dishwashers

I have a Frigidaire Dishwasher (PLDB998AC1). The wash selector panel will light up correctly, but when you press start it doesn't turn on and within about 5 seconds the lights on the selector panel go out. In addition there is some water in the bottom that doesn't appear to be draining. Do you have any suggestions?


... Frigidaire PLDB998A Built-in Dishwasher

After installing the new Kenmore model 665.13293k I tried to run a short cycle. Nothing happened and the selector lights timed out. Checked water supply and filter screen - OK. Panel lights so power is on. I don't hear any sound from the electronic water valve when door is first closed.


... Dishwashers

Kenmore dishwasher. The upper rack is not getting clean. Even very light residue remains. And, detergent is left in door at end of cycle. The bottom is filling up, so I don't think it's the intake valve. Also, all the blade openings appear clear. I am noticing that hot water is not filling the dishwasher when I first run the cycle. Even if I have hot water running in the sink, the dishwasher fills with cold or warm water. So, I think this is the problem. What should I do? Thank you in advance!


I find it odd that the dishwasher is filling with cold water if the water is hot at the sink. It sounds like the dishwasher is connected to the cold water line rather than the hot. Check under your sink; if you've got standard plumbing, the dishwas ... Dishwashers

I own a KUDS01FLSS3 KitchenAid dishwasher. The lights on the control panel do not come on and a cycle can not be started. There is about an inch of water in the bottom of the dishwasher basin and it looks like the previous cycle did not complete. I have checked the wall outlet that the washer is plugged into and the washer is receiving power from the wall. And ideas? My next thought was to take the door off and check the power supply running to the door panel and control panel.


Servtek06 writes:\015\012check connections @ control board/module. May be Control Board/Module. ... KitchenAid 24 in. KUDI01FLSS Stainless Steel Built-in Dishwasher

We have a Kenmore Elite Dishwasher #665.1646 - 5yrs old. On Friday nite, there were no problems but last nite the lights would not go on when cycles were pressed ( or Start). Checked the circuit breaker and it was OK. There is nothig caught in the bottom and the overfill float is functioning. I pressed Hi-temp and Air dry alternately and all the lights lit. I pressed Smart Wash, then Start and it did not go on. I can hear it draining but no water seems to flow and then it stops. All light t


The thermal fuse on the control panel. There isa couple of wires that lead up to a white box with the fuse in it. Thatis the problem. If you are good with a volt meter or light and youplace it across the fuse, if it is bad the light will light ... Kenmore Dishwashers

I have a GE monogram zbd5900 that continues to drain, won't shut off. The drain pump just runs. None of the lights on the control panel will come on, tried pressing and holding buttons to clear, nothing. Turned off and on circuit breaker (even left it off overnight) and did not change. Drain is not blocked, pulled the unit out and put water in the bottom and it pumped the water out just fine. any thoughts?


See if you can access the tech sheet, should be on the right side of the underside of the unit after you remove the toe panel, or perhaps in the console. Almost sounds like a stuck key pad but the tech sheet might shed more information on this malf ... Dishwashers

I have a kenmore 665-15684. I have clear standing water in the dishwasher and doesn't seem to drain. No lights are on (or blinking) on the control panel and none of the buttons seem to work on the control panel.


It is very likely the computer has failed. \015\012\015\012Try to empty the dishwasher with a small container and try it on a short cycle to see if it starts the cycle.\015\012\015\012If there is no action then it is time to d ... Kenmore Dishwashers

AFTER RUNNING MY DISH WASHER I OPENED THE DOOR THERE WAS ST HALF IN OF WATER IN THE BOTTOM SO I WAS GOING TO WASH AGAIN BUT HAD NO LIGHTS ON CONTROL PANEL HAD POWER TO THE DISH WASHER BUT NOTHING WOULD LIGHT UP? DONT HAVE 10 WASHES WITH THIS UNIT .? MODEL #655-13443K900


Hi Bennie, Try http://www.manualowl.com for free PDF for troubleshooting the issue you are having. I hope this helps. ... Kenmore Dishwashers

We have a kenmore ultra wash dishwasher. i am unsure of the model number. i believe it was bought in 2001. the NO HEAT DRY button was blinking, so we replace some panel under the door. now the QUICK RINCE light is blinking. i tried the sequesce of WATER HEAT, NO HEAT DR, WATER HEAT, NO HEAT DRY, but that did not help. any other suggestions?? we have a family of 4, and it STINKS not having a dishwasher! litterally sometimes : )


... Kenmore 15129 Built-in Dishwasher

Dishwasher will not start, no lights come on. There is also standing water at the bottom. Can you help point me in the right direction? Went to start the dishwasher and none of the controls on the panel are working or lighting up. I checked the fuse box and all fuses are good.


... Frigidaire 24 in. GLD2350RC Energy Star® Built-in Dishwasher

Dishwasher appears not to have power. No lights come on panel display and water was collected on bottom of washer that I manually removed. What could be the problem with panel?


There may be a problem with your panel yes.\015\012however the first thing to check is the main power supplied to the unit under the right front side and make sure that all the wires are connected properly\015\012as well as you circuit br ... Dishwashers

Dishwasher front panel lights are all blinking in unison. Pump has removed all water from bottom including sump. Pump and lights will not shut off or reset with dishwasher door closed or OPEN. I have shut the circuit breaker off to keep from burning up the pump. Problem continues if I reset circuit breaker.


It would help to know what the make and model of the dishwasher is.\015\012\015\012Most likely the flood switch at the base has been activated. ... Dishwashers

Kenmore quietgurad dishwasher won't come on (no lights), water in bottom, cancel/drain button not working/not lighting up


Check main fuse panel ..... ... Kenmore 16602 / 16604 / 16609 Built-in Dishwasher

Maytag MDB6759AW; Light panel will not light up, control buttons will not respond, dishwasher will not run. Moved round object lower right front corner of tub bottom, up and down (possibly water depth switch?) yesterday and it ran and completed all cycles. Today it will not run.


IF light ( touch control panel does not light ) then you have lose power to maching ) moving the float didn't corect problem but it may have seemed that it did . This is what i want your to do! in the right bottom corne ... Maytag MDB6759AW Dishwasher

I have a kenmore Ultra Wash Dishwasher, Model 15825691. We were recently hit by lighting. Once hit, the dishwasher started up. Since then, all cycles work, however, at the end of any cycle, the dishwasher continues to run and fill the bottom of the washer up to about two inches and then cuts off, so when we open the washer, there is approx 2 inches of water inside no matter what. I have pressed the "Cancel/Drain" button, in which drains the water after two minutes, but when that is finished, the


There must be a problem wit the fill valve. Check which valve the water enters. Check first the wiring to the valve of the water inlet or where the water comes out to fill the washer. Check for physical evidence of damage on the solenoid (or contr ... Kenmore 24 in. 16539 Built-in Dishwasher

When pressing any front button on the control panel nothing will light up or start up in any manner,does look like it did not finish draining,have water sitting in the bottom. Pulled off front access panels no signof burned wires or anything becoming disconnected? do have small childern in the house pressing buttons? power is good going to unit.??


1)check any fuse blown in board.\015\0122)check supply to the board. ... Kenmore Dishwashers

Dishwasher won't start and it is plugged to working outlet. Control panel lights do light up. When I turn the setting dial to start, nothing happens. It looks like the last cycle never finished as there is water on the bottom. Any thoughts what might be wrong?


... Whirlpool DU912 Dishwasher

My Bosch dishwasher SGS46E26GB/90 makes a knocking noise when started. the timer does not advance and the check water light comes on.There is water in the bottom (up to the bottom of the door) . If I reset the DW the water drains ok. If I mess with the buttons E3 shows on the display the 'quick' light stays on and the eco light flashes. I've checked the filter where the water hose is fastens to the rear. I've cleaned the filters at the bottom of the DW and cleaned out the pump area under them.


... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1340 seconds