Having problems with your Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher ?

The diswasher cycles will not change. It will

\015 The diswasher cycles will not change. It will only do one cycle...\015

Answers :

This is a bad controller. It will need to be replaced.
\015\012
\015\012If this was helpful, please select YES to the first two RATINGS questions. Good Luck!
Repair Help & Product Troubleshooting for Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My fisher and paykel 605 diswasher seems to have a problem... the timer stop at around 58 minutes on normal cycle or 25 minutes on fast cycle? Can you tell me what I can do for this situation? The botton diswasher works fine...but not the top one? Thanks for your help. Marc


... Fisher and Paykel DD605SS Stainless Steel Dishwasher

Bosch Diswasher Have Bocsh SMU 2046 UC diswasher. Aprox. 11 years old Has always worked well. Recwntly is not cleaning at 100% as before. Seems to run through cycle as normal and sort of cleans but leaves stains in coffee cups and flatware seems filmy, sometimes a little guk left on dishes, all uncharacteristic of past performance. Tried a thermometer during cycle and water temp is around 151 F during wash, 136 F at rince. and 154 F at dry time. Have checked arms for cloging and are free w


Remove the drain hose and check if you have any residual into it. After 11 years your appliance may need a thourought cleaning.Check also if the pump has enough pressure. ... Dishwashers

Kenmore diswasher model 587 15423100A My new brand (1.5 year) diswasher Start cycle to fill in , wash/Heat cycle bypass, drain out fine ? I ran the Diagnostic test and same result ?


... Dishwashers

Our Smeg Diswasher, model STA 9452 18" built in is not advancing past the wash cycle. Water does not pump out for rince cycle. I can stop the cycle by opening the door, cancelling the program and restarting on the rince only program. Do we need a new timer?


... Smeg Dishwashers

The diswasher will drain completely after the drain cycle is completed. It will then immediately begin to fill again despite no additional cycles being requested. I can hear the fill cycle begin. I can prevent the filling by opening the door slightly or by moving the float plunger up and away from the microswitch that signals to fill the bottom of the washer with water. Is there an adjustment on the float or on the length of the float plunger?


HI, The floater is not the issue here. Your problem will be with the main control assembly. The control assembly routes power to the inlet valve, and drain pump/motor. The floater is merely a regulatory ... Maytag MDB5100A Dishwasher

Kenmore Dishwasher My dishwasher fills with water and then stops. I hear the cycle timer continue all the way through the cycle. I pulled the screen off the bottom inside of the dishwaher and stuck my hand in the diswasher drain. Originally I felt and cleared what appeared to be a torn up rubber band. I feel a thin straight metal pin that I can rotate and I believe it causes the pump to rotate as well. Once I do that the dishwasher will run normally thorough a complete cycle...BUT I have to


If you have either dry bearings in the motor or sticky grease buildup in the pump bearing/seal, it can cause the motor to stick rather than rotate on startup. More likely to be greasy crud buildup. \015\012\015\012The best you can do without disasse ... Kenmore 24 in. 15149 Built-in Dishwasher

My Whirlpool diswasher model GU1200XTKQ0, runs through the cycle fine, but the sanitized light flashes continuously after the cycle is finished. I know that this will happen if the dry cycle is interrupted by opening the door, but thats not the case here.


... Whirlpool 24 in. GU1200XT Built-in Dishwasher

My Bosch diswasher is hanging up in the cycle (at 102 mins. in normal cycle and 38 mins in quick cycle). I hear what sounds like a one second pumping of water into the sink area, a pause, and then another one second pumping of water, on and on, but there's no progression beyond this point. One possible cause: a few weeks ago someone turned off the hot water at the heater and another person tried to run the dishwasher. The dishwasher did not function because it could not get hot water. Perhaps


Hi\015\012\015\012 \015\012\015\012Thanks\015\012for using FixYa. To start with check the water inlet valve which is located\015\012behind the lower access panel on the left or right side of the Di ... Bosch 24 in. SHU66C02 / SHU66C06 Built-in Dishwasher

I have a Kenmore diswasher model 587 1525. I can hear the water filling and rinsing, but during the wash cycle I do not hear the motor. At the end of the wash cycle and when I open the door I see the detergent tablet is sitting on the floor. The dishes are not cleaned. Does this mean that the motor has failed or is it the control card. I can hear some clicking noise while the motor should be running. Maybe solenoids cycling.


... Kenmore 24 in. 15252 / 15254 / 15259 Built-in Dishwasher

I have a new Frigidaire FDB1050RE diswasher. I ran it for the first time set on normal wash and pressing both the Hi-temp wash and heat dry button. This cycle is supposed to take a total of 89 minutes to complete including the drying cycle. After 89 minutes it was still in the wash cycle so I cancelled it to preserve sanity. In the instruction manual it states that the water temperature must be above 120°F. Our building's water heating unit is set at 110°F. Why there is a lower temperature


It should still work pretty well but you probably can't use the high temp wash because it will take too long for the dishwasher to heat up the water enough to satisfy the high temp washer thermostat. If the thermostat's calibrated closing temperature ... Frigidaire Dishwashers

Diswasher motor making noise during wash cycle


It could be the impeller on the motor. The impeller fits over the shaft of the motor and might have split/broken up. That funny noise is probably the shaft spinning inside the damage impeller. Fortunately the impeler is fairly inexpensive and easy ... Maytag 24 in. MDB8600AW Jetclean II Built-in Dishwasher

Hi I have a Whirlpool dishwasher Model #DU912PFG01 Or DU912PF001 or DU912PFGG1 cannot tell the last 3. Serial # FK194309. My son noticed the dishes didn't look clean, he added DISHSOAP which then produce a huge amount of suds. Anyway hav run the cycle thru with vinegar and it doesn't seem like water is moving throughout the diswasher, just on the bottom. DO you have any ideas, it runs thru all the cycles.


Slog builds up in the drain pipe right before the garbage disposer. I had to replace mine when I replaced my old dishwasher. If you put vinegar in the dishwasher to unplug the pipe, the vinegar could have loosen all the slog and clog the drain ... Zanussi 24 in. DE6965 Built-in Dishwasher

HOTPOINT BF1680 DISWASHER STARTS CYCLE THEN DRAINS AFTER TWO MINUTES SHOWING FAULT ON 1 3 CYCLE LED,S


... Hotpoint Dishwashers

My Bosch diswasher water inlet work fine, when the wash motor or cycle need to start nothing happens. The timer is advancing normal. Water outlet(drain pump) is also working fine. There is no woosh sound (start of wash cycle) and arms is not rotating.


Hi,\015\012\015\012it sound's like the wash motor is either seized or just stuck, let's hope it's the later. Bosch had issued a service tip about this problem several years ago titled "Loosening Frozen Impellers" strange choice of word's considering ... Bosch 24 in. SHE44C02UC / SHE44C06UC / SHE44C07UC Built-in Dishwasher

My dishwasher goes through each cycle until the rinse cycle. at that point the water will not drain out of the diswasher.


\015\012Most likely your line is stopped up. Take off water line under sink and rub it into a bucket, If water runs out it is stopped up in the line. If it does not run out, it's the solenoid that lets the water run out you have to replace. ... Kenmore 24 in. 15689 Built-in Dishwasher

The diswasher seems to be stuck in the rinse cycle and it basicly isnt going through the entire cycle


... Jackson 25 in. TempStar 328 Free-standing Dishwasher

Bosch diswasher ( SHU 3035 UC) stops at every cycle. Moving foward the dial just a tiny bit and it will jump to the next cycle. Have to do this for five time during the whole washing time.


Best to replace the timer module which looks like this.\015\012\015\012You can find the details of the assembly in ... Bosch Dishwashers

Water won't drain after cycle is done. Leaves 1-2 inches of water in bottom. Checked hose and its clear. Put hose going to disposal in bucket and water comes out when diswasher is cycling


It is easy track this path of water from bottom of m/c it will b afilter then small hoses to drain pump thenouter hoses <\015\012 thanks ... Dishwashers

My Bosch diswasher SHU9925UC makes loud squeaking noises during times of the cycle. If I turn the dishwasher off during water cycle the noise will continue. Do you think it is my pump? Should I clean out some hoses? Help I am a stay at home Mom who has to do all the fixing myself!


Hello jlerms,\015\012\015\012I won`t say this is something you can`t fix yourself, but I will say what it sound`s like based on your description and my experience with Bosch...and it is quite a repair.\015\ ... Dishwashers

I WAS LOOKING FOR A SHORT DISWASHER TO REPLACE MY 32" HIGH DISWASHER WHICH LEAVES WATER AT THE BOTTOM AFTE R THE CYCLE HAS FINISHED. IT DOES NOT LEAK. OTHER INTERNET SITES HAVE CONFIRMED THAT A 24" WIDTH WASHER IS IMPOSSISBLE TO REPLACE AT 32" HEIGHT. DOES THIS DISHWASHER SOUND LIKE IT WOULD BE WORTHWHILE TO FIX AND WHAT WOULD BE INVOLVED?


... Hotpoint 22 in. 7892 Built-in Dishwasher

Intermittent Dishwasher fault Zanussi 23 in. ZDT6252 diswasher only partially drains in some of the wash cycles. I suspect it's a faulty float valve & sometimes too much water is taken in at the start of the cycle. Anyone else come accross this??


Fixed the problem by replacing the ELECTRIC ANTI-OVERFLOW VALVE. Simple enough installation - bit fiddly.\015\012\015\012\015\012 ... Zanussi 23 in. ZDT6252 Built-in Dishwasher

Diswasher I am needing information on a GE diswasher, model GsD2600G00BB. The dishwasher will not drain after a cycle is finished. There are no obstacles obstructing the drain upon examination. Upon manual operation of the solenoid, the water drained properly. I would appreciate your input as to what the problem is and how to repair. Sincerely, Sonny Thacker


You will have to test the solonoid electrically now its probably getting juice and the solonoid may have failed. You can get just the solonoid ot the entire pump assy for a little more. ... Dishwashers

Kenmore 665.16529000 When we put the dial to pots and pans the diswasher fills up and cycles through, when the dials moves to normal wash, it fills up and cycles through again. When the dial gets to light wsh we can hear the motor running but nothing is happening, but the soap door opens soon after. The heating light comes on and the inside of the dishwasher gets so hot that it has melted our big plastic tumbler cups on the top rack and makes the counter top extremely hot to the touch. The dial


... Dishwashers

Bosch SHX46A02Uc/21 My bosch diswasher runs continuously (stuck in some cycle). Not sure which cycle it is, but it does fill with water. Can you help me torubleshoot?


It is likely a control module issue. I will take mine apart this weekend to verify what others have said: solder joint on circuitboard burns out from possible overheating, and DW doesnt go into rinse cycle. Try rinse and hold cycle to see if it sto ... Dishwashers

My miele diswasher seems to be stuck on rinse cycle and will not advance...keeps draining and refilling. Can't figure out how to reset and restart new cycle, to clear the snag. What's going on? I have cleaned all the filters in bottom of unit per operating manual. Wish I still had my GE, where you could reset the unit...no button to do that on this overpriced unit.


Sounds like a broken timer. If it's a rotary dial, they're not too bad to change.... ... Miele Slimline G832SCi Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0959 seconds