Having problems with your Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher ?
I need the soap door replaced on the Sear Kenmore Elite Dishwasher 665.15954000. Does someone have this replacement parts?
Go to www.repairclinic.com they have everything and cheap. just give the model number and it will show you pictures of every part you will want. they sell individual pieces or whole rebuild kits . Done it myself on a GE it was so simple had the part the next day Fed ex ground and done in 1 hour.
Repair Help & Product Troubleshooting for Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher
Tips for a great answer:- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.
Suggested Questions/Answers :
I need the soap door replaced on the Sear Kenmore Elite Dishwasher 665.15954000. Does someone have this replacement parts?
Go to www.repairclinic.com they have everything and cheap. just give the model number and it will show you pictures of every part you will want. they sell individual pieces or ... Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher
When I first contacted you, I couldn't get the soap door to close in my dishwasher. As suggested I got the part. I now have the door apart. When I work the soap latch I can't see what closes the door. The part I was going to replace seems to be working correctly. over
Well IF the piece, the latch, seems to be working OK, then the only other thing it can be, is the Electronic "Drive" from the controller board, or a disconnection between the Controller and the Latch, Sometimes it can be a "Sensor" not allowing the ... Dishwashers
I have two problems with my GUI1500 dishwasher. The 1st is that when water starts entering the dishwasher I hear a loud hammering/vibrating sound. It's strange, but the sound will stop if I turn on a faucet in the house. The other problem I have is that the soap dispensor will no longer stay closed. The Plastic tab that holds it shut has basically disintegrated. Will this cause the dishes to not come clean? Can this part be replaced? I don't see any visable screws holding it onto the door.
Hi - welcome to FixYa,\015\012\015\012The first problem isn't a fault with the washer, it's a plumbing problem called "water hammer", which is a resonating vibration through your pipes. It's usually caused by a toilet flush valve, but can ... Whirlpool 24 in. GU1500XTLS Stainless Steel Built-in Dishwasher
We have a Kenmore Elite dishwasher. Recently when opening the door we heard something snap and the door fell open all the way. It appears some type of counter balance broke free. We would like to know what parts are needed to be replaced and how to do it.
The door is holded by the hinges.the hinges are connected to the machine as well as to the door.\015\012if the hinges are bent or get cracked or loose then it will not hold the door.\015\012\015\012To repair the door hinge as ... Dishwashers
I have a Bosch dishwasher, model SHU9915UC/U11. The spring mechanism on the detergent door cracked, and I bought the part to replace it. I took the front cover off of the dishwasher to determine how to replace it. Two white plastic "things", maybe spacers, fell out. I need 2 things: a) how to gain access to the spring on the detergent door so that I can replace it, and b) how to put the door spacers back on. An exploded parts view would probably help a great deal. Michael J. Orr
Hello! This is Guru...Saailer...I have your information...Due to size limitations I'll need your e-mail address in order to send it to you...Send an e-mail to me and I'll send an exploded view diagram and parts list...Guru...saailer... ... Bosch SHU9915UC Dishwasher
Ge dishwasher model num.GSD2400G01.soap dispenser not opening during cycle.took it apart to replace broken handle.now i have a hard time opening and closing door.when door is closed,it wont let the soap out.dont know if gear-like parts are lineing up or not.please how can i fix this problem.
Hi\015\012If the soap dispenser door doesn't closes on your GE dishwasher then disconnet the dishwasher from power and check the spring & plastic tab under the timer. Check the plastic tab, it breaks often and will not let the soap door t ... Dishwashers
I have a Dishlex Global 450 dishwasher and have a faulty seal to replace. The original door seal had a foot on each side and the replacement I received has 45 degree cuts and no foot. Also the bottom seal replacement appears to be a screw-in type where the original was slipped behind a fold in the door. I have been assured by the supplier that I have received the correct replacement parts. Could you confirm the these parts are in fact correct and if they are which way should the seal lip an
Hello Tony. I am as concerned as you are that this is not the correct replacement part. The key to getting the right part is the model number which is on your machine, if you know where to look. Do this, go to this link to properly locate your mod ... Dishwashers
I have a KitchenAid but model # KUDI24SEWH1. Can not find it on your list although another model without the last letters 'WH1' is on it. Anyway, my nephew ordered the parts he said needed to be replaced. One was the top water feed tube and bearing which he had no problem replacing when the part came in. But, he is having a very difficult time opening up the front door to replace the soap dispenser. Removed the 6 screw (three on each side) and the two at the top of the door but that is as far
You don't Use the WH2 just the first 6 letters and numbers.\015\012Jim ... KitchenAid KUDI24SE Built-in Dishwasher
Replacing diswasher soap door on Bosch dishwasher
... Bosch 24 in. SHU66C02 / SHU66C06 Built-in Dishwasher
My dishwasher, a Whirlpool DWF B10, is not cleaning properly. When the cycle has finished, there is always a block of undissolved dishwasher tablet/powder left behind. My guess is that the seal to the powder door has gone and allowing the tablet to get wet too early and part dissolve before the door opens - is this likely to be right? If so, can I get a replacement seal or do I have to replace the whole powder & rinse aid containers ??
... Whirlpool Dishwashers
I have a Necht dishwasher. The dishwasher door does not close therefore I can not get it to operate. Someone came to have a look at it and they said that it needs a replacement for the door latch. The problem is I do not know where I can find this replacement for this brand ( Necht). Can you tell me where I can burchase or order it from? a website or a shop.
Depends where you are located. Try google .com and search for Necht. ... Dishwashers
Whirlpool DU927QWDG1 Hi, The problem I'm having with my dishwasher pertains to the door cover for the area I place the soap. There is a small spring which helps the door pop open to release the soap when washing. I cant figure out how to place the spring so that the pops open.....right now when I run the unit the door stays latched and the soap doesn't get dispensed. Any ideas on how to repair this or where I could maybe get a parts manual??? Your expertise will be greatly appreciated!!!!
... Whirlpool GU2400XTP Built-in Dishwasher
KitchenAid Dishwasher KUDP01FL: Called repairman to replace balance link kit. Then door extremely stiff to open & heard loud pop when one of the ropes came off the roller. Repairman came back & put rope back on & replaced door seal, then the door won't close & he claims need a new door latch. When he left, door again extremely stiff to open & heard same loud pop when one of the ropes came off the roller. Now he says he can't fix it and to call someone else. I now have three problems: (1) The doo
May have bent door hinges,, need to check all alignment of door, hinges and latches... ... KitchenAid 24 in. KUDI01FLSS Stainless Steel Built-in Dishwasher
When dishwasher drains the water not all the water is drained. Some stays standing at the bottom and starts getting an odor after awhile. This is a replacement dishwasher in a 35 year old house. How important is the air release part in the draining situation? I was told by someone that the newer dishwashers have the air release part which was not hooked up on this dishwasher when installed last year. Are there some other possibilities of things that can be checked. Model Number is DU
... Whirlpool DU1055XTS Built-in Dishwasher
I have Whirlpool ADP 962 dishwasher. The front door is leaking when washer is running. I can feel a rubber seal at the bottom of the door, when I open the door, which seal is wavy and corrugated. How do I replace the seal, and what is replacement part number. Thanks Trevor H
Hi,\012Here is a tip that I wrote about dishwashers and them leaking.Leaking Dishwasherheatman101\012\012\012\012q4w5ifgf ... Whirlpool 24 in. ADP5966 Free-standing Dishwasher
We have a 6 year old Jenn Air dishwasher model JDB2150AWP We had a cracked door close unit which we replaced but got a short while restoring connections I am wondering if there is an internal circuit breaker, relay or fuse on these machines that we need to check and possibly replace since we cannot get it to run at all. No power or lights at all. I believe all connections are secure and we replaced the door close unit with new parts.
... Jenn-Air 24 in. JDB2150AWP Built-in Dishwasher
Water leak have the Ge triton dishwasher (Model # GSD5320D02BB, bought it n 2001) and currently have very small amount of water leaking out of the door during a run cycle. I did check levels when running and that seems to be fine......meaning the dishwasher is level and not an over-flow problem. My next thought is maybe it is a faulty door gasket. So my question is, where is the door gasket located and how do I replace it? (and where do I order this part from?). Looked for diagrams to follow and
They are in the bottom left and right of the door opening. GE likes to use L-shaped, molded and ribbed seals on most of their models - hopefully also on yours. Typically these can be removed by hand and easily replaced without taking anything apart. ... GE Tritonr XL GSD6260JCC Dishwasher
My repairman replaced the soap dispenser and the next time I used the dishwasher I noticed a few drops of water on the floor under the dishwasher door. I felt under the door and the insulation was soaking wet. Did the repairman not reinstall the door correctly and what is possible causing the leak?
... Whirlpool GU1100XTLB / GU1100XTLQ / GU1100XTLT Built-in Dishwasher
My Viking DFUD042 dishwasher soap dispenser release is broken. The soap dispenser does not close. Can I replace only the latch or do I have to replace the entire soap dispenser? Where can I get the parts? Thanks, Robbie
You will need to replace the entire soap disp. You can find it at marcone.com w/ your model # ... Viking DFUD042 Built-in Dishwasher
How do I replace myself the detergent/rince aid assembly on a Maytag Jetclean dishwasher EQ plus model #MDB9150WB? I only need to replace the door, but I don't see a part for that, just the entire assembly. Please advise how to replace myself the entire assembly or can I just purchase a door from the detergent/rince assembly? Thanks, Carol
Carol,\015\012\015\012This is a simple repair. Remove the screws around the outer door edge and separate the door. The dispenser is clipped into position with several screws. Remove the screws and push the dispenser through the door.You can pur ... Dishwashers
How to replace the door seal on a Simpson Silencio 850 Dishwasher Model No. 82B850WH. The part No. that I have for the door seal is 0208400158G & is Electrolux part number
The around the tank seal just pushes into the groove. make sure that you copy the way the old one comes out. The bottom of the door seal is a bit awkward. Thsi has some screws that are difficult to access. Take the door liner off and possibly two of ... Dishwashers
Fisher and paykel Nemo dishwasher,door spring replacement instructions.Can you help ? I haven't stripped the door down yet or aquired a replacement. Thought I'd get some info' first. Can I download a parts and schematic diagram ?
... Fisher and Paykel Dishwashers
I need to replace the heating element and electronic control board on my Kitchenaid KUDS01DL Dishwasher. I have the parts. I have been able to find directions on how to replace the heating element, but am not finding anything on the electronic control board. I don't even know where this part goes. I am guessing somewhere in the door, but can't find any instructions. Help...
... KitchenAid 24 in. KUDS01DLSS Built-in Dishwasher
I have a dishwasher and the lid to the soap won't release and my dishes aren't getting clean if I just pour the soap in. It's a whirpool Model #DU810SWPQ0 Type 280-0. Can I just buy a replacement part or do I need a whole new dishwasher?
Hi,\015\012\015\012Yes you should be able to purchase a new combi dispenser and not a new dishwasher. you should be able to find a local whirlpool supplier through the internet. This is provided the unit is not too old for spare parts. ... Dishwashers
We have a Bosch dishwasher supplied with softened water - does a great job. However, on the most recent run, the soap door didn't open properly and the soap puck (we use those two part liquid/powder that dissolve) was only partially dissolved. Our stainless steel cutlery now has a hazy film all over it, something that handwashing and a subsequent successfully-executed dishwasher run didn't remove. It's expensive cutlery, less than a year old, and a wedding gift from my mother who lives next d
Sounds like the you need to see if your using a proper rinses / drying aget like turbo dry. Fill it up and you should be good for 40 washes. If it continues you may have a bad control unit. ... Dishwashers