Having problems with your Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher ?

How can I take the unlock the dishwasher? The locked light is on, and the washer will not operate. Help, please.


Answers :

Try unplugging it for a few hours. In the meantime of it being unplugged, press and hold start cycle button for 5 long full seconds. Then wait half hour more, plug back in and see if it resets itself.
Repair Help & Product Troubleshooting for Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

How can I take the unlock the dishwasher? The locked light is on, and the washer will not operate. Help, please.


Try unplugging it for a few hours. In the meantime of it being unplugged, press and hold start cycle button for 5 long full seconds. Then wait half hour more, plug back in and see if it resets itself. ... Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher

We have a 10 yr Kenmore Elite Dishwasher in our winter home so in reality has only about 5 yrs worth of wear that all of a sudden the lock on light comes on and it will not operate we have tried holding the switch in for 4 seconds but does not help we turned the breaker off and back on washer worked for a few minutes but then shut off...Please advise


The most common type of door interlock is a heater operated delay \015\012lock, which\015\012is why some machines take a time for the door to release. So make sure \015\012you have\015\012waited a minimum of 2 minutes before you open these or conclud ... Kenmore Dishwashers

Dishwasher Problem My Kenmore Ultra Wash Dishwasher has a light which state "lock" on and I can't cut it off or start the washer..Does anyone know what is locked and how it got locked and how to unlock it and start the washer?


According to my ultra wash dishwasher you have to hold the no heat dry button for 4 seconds and that is how you lock and unlock the control panel ... Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher

I have a Maytag dishwasher MDBM601AWW. The control lock on the control pad will not unlock. I replaced the electronic control board and it worked for one wash. Control lock engaged again. I shut down the power and pressed the control lock for 3 seconds as directed by the owners manual. No luck. Please help Rich.


You have to power the unit back up and then holld the lock in for three seconds, if ths does not reset it then the console not the control bord needs to be replaced it comes with a new touch pad ... Dishwashers

Re; Smeg DWD612CSS dishwasher. Please help. On setting our dishwasher to operate overnight, we were awoken by a loud bang only to find a strong rubber burning smell and the trip had blown. After investigating we found that the part no DWF 409 interface filter required replacing which we have done. Now however the dishwasher runs to the middle of its cycle and stops. The troubleshooting page of the manual tells us code E3 applies i.e.first 2 phase lights are lit and states "The appliance is not


I would first look for anything that may be stuck anywhere in the machine that may be causing it to come up with an error. Possibly something that was in the dishwasher is making it think it can pump out the water even though it is draining.\01 ... Dishwashers

Fagor 6kg dishwasher FUS-3611 IT problem.Select the wash option, but fails to start wash and door lock light fails to light. please help


... Fagor Dishwashers

To have somrthing that doesnt work is a pain plaese help . my dishwashers light keeps on blinking it is green. the water is open but does not take in water all pipes has been checked. please help!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!11


Check the water strainer on the inlet hose then hold the on button for 4 to 5 seconds and see what happens ... Whirlpool GU2400XTP Built-in Dishwasher

The kitchenaid dishwasher (model KUDC25CHSS1) appears to have the 'child lock' engaged on the led display panel. The 'energy saver dry' light is flashing red and when I attempt to push 'cancel' it only flashes and never goes away. When I attempt to press a 'wash selection' the 'child lock' then flashes. Please help.


On my unit, I had the same problem (child lock LED on, or flashing.The cancel process of pushing anything was not possible, as a bad/stuck switch prevented any input from the control panel buttons.The underlying cause of the problem turne ... KitchenAid Dishwashers

I have a Whirlpool Energy Star dishwasher (no clue what the model is). Door will not latch. Inside of door says to press and hold ''Heated Dry'' 5 seconds to lock control and repeat to unlock. This is not helping. We rent and do not have a manual. Please help.


Happened to me today. After much head scratching I found that the screw attaching the unit to the underside of the kitchen counter had loosened and was preventing the door from closing all the way. I tightened the screw and was back in business. ... Dishwashers

My Whirlpool Quiet Partner IV has alternating flashing lights across the front panel where I make selections for the type of cycle. When these lights are flashing, the dishwasher will not operate. We have already replaced the circuit panel and the problem persists. We have shut off power at the circuit box several times with no success. Please help!


Here is the tech sheet\015\012http://www.servicematters.com/docs/w...%208530866.pdf\015\012\015\012Here is a manu ... Whirlpool Dishwashers

Dishwasher wont let u select a cycle...all buttons seem locked...ive unplugged it for 5 seconds or so and then plugged it back in and the normal wash button light comes on and the heated dry button light comes on, but it wont start and it doesnt respond when buttons are pushed...please help. thanks


... GE GLD4560NSS Stainless Steel Built-in Dishwasher

KUDG25SHBT1 Kitchen Aid dishwasher child lock is on and cant get it off. Pressed and held the start button and now the child lock light is blinking but dont know what to do next?? Please help!! Lexi


... KitchenAid 24 in. KUDS25 Built-in Dishwasher

Danby portable dishwasher ddw1899wp starts taking in water and then stops working with pre-rinse light blinking. Please help me on this issue. Any answer would be much appreciated.


If the water level sensor does not electrically shut off when the level needed is reached, the pre-rinse cycle will error out thinking that the level has not been reached. That sensor is a float device and probably needs to be replaced... ... Danby DDW1899WP Portable Dishwasher

Bosch Classixx dishwasher: Initially no water feed and 'water check' light came on. Removed side panel, emptied water from base. Ran OK for a week or so. The problem then repeated so side panel removed, float switch operation checked (OK) drained water from sump below polystyrene float. Ran OK but contents came out dirty and cold - no heat. Side panels off again, water in base but no obvious leak when watched during cycle - still no heat. Help please.


Http://www.repairclinic.com/Dishwasher-Repair-Help\015\012\015\012\015\012\015\012 ... Dishwashers

Dishwasher not taking in water and then huming sound and bleeping sound but it wont work. have switched water on /off in case of air lock and have replaced fuse in wall. was working and went through last cycle ok but left little water in the base of machine. soaked this uo and tried all of above. Please help!


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks\015\012for using FixYa. To start with check the water inlet valve which is located\015\012behind the lower access panel on the l ... Dishwashers

My dishwasher will not turn on and the Start/Resume light will not stop blinking. Is there any thing you can suggest to fix this without my calling and paying for a service call? We have stopped, restarted and reset the unit as well as cleaned out the soap tray. We have also switched off the electric to the washer as well to no avail. Really cannot afford another service call again so please help us out. Thanks. Chris


Reset the control again. Then change out your heating element.\012\012That should fix it good.\012\012Have a great day! ... KitchenAid 24 in. KUDP02CR Built-in Dishwasher

Kenmore elite dishwasher cancel drain,and lock light wont turn off or clear. please help !!!!!!!!!!!!!!!


... Kenmore Dishwashers

Overfill Hi Mark ,my Hotpoint BFI 62 at very first use ,takes water but in few minutes later water come out from floor and after that you can hear water drains out,Heavy Duty cycle light flashing rapidly,after some advice looked exactly source of water is from pipe connected to overflow system. That mean it is filling more than required,how it possible new Dishwasher never used before? Please help me to repair because we never try when I bought now is to late for company warranty. [email protected]


... Hotpoint 23 in. BFI62 Built-in Dishwasher

I have a KUDS25 dishwasher and the child lock is flashing. I have held down the "Energy Saver" button for the 4+ seconds and it still flashes. I have tripped the breaker for minutes, only to have it restart flashing. It ran perfectly until this issue yesterday. HELP!! It will not operate with this light flashing.


... KitchenAid 24 in. KUDS25 Built-in Dishwasher

My Kenmore Dishwasher Model #16769000 says its a Kenmore 665 will not unlock to restart the washer. The air dry light will not go off and we held it for four seconds and still it did not work. Help


Unplug the machine for at least ten mins or so, replug with cycle at start, try restarting cycle, if it still get locked on dry, then probably the control panel must be replaced. ... Kenmore Dishwashers

I managed to 'lock' the control panel on my maytag dishwasher and i can't get anything to operate. The lights just keep flashing at me. What or where can i find the unlock code?


Hello. No problem. Press the START/STOP button to stop the machine. Then check your watch as it takes up to two minutes to unlock the door. Next pull the door indentation opposite the hinges. \015\012\015\012If the door still won't open, c ... Dishwashers

My Fisher and paykel dishwasher drawers are showing a F1 fault on the top drawer screen, But it was the bottom drawer that was in use at the time of the fault occured. The top drawer will open but the bottom drawer is locked. I need to unlock this drawer to get my cooking equpiment out. Please Help. I know that the F1 fault is a flood fault but how do fix it.


... Fisher and Paykel Dishwashers

Kenmore Ultra Wash Dishwasher Model 665.15779 LOCK ON light blinking on control panel, unable to use washer. If buttons were locked, LOCK ON light should be lit continually not flashing. If you press and hold NO HEAT DRY button to disengage lock, nothing happens. If you press the CANCEL button it begins to blink in unison with the LOCK ON light. How can I stop the light from blinking to allow button function again?


... Kenmore Dishwashers

Ariston dishwasher i have an ariston built in dishwasher. It wont start washing cycle, and has 2 flashing lights from the left (total 4 lights)...can anyone help. i cant find the model number on the machine. The lights looking like sprinkiling water..i have filled the salt, and rise etc but still it wont come on please help


I have a brand new ariston ll-64 and the wash cycle won't start and two flashing lights ... Ariston Technologies L63 Free-Standing Dishwasher

I have a Kitchen aide dishwasher Model KUDI01ILWH6 that will not turn on..there is a control lock light on and I have tried pushing the cancel button but all that happens is the control lock light flashes 3 times and the dishwasher still wont turn on....Please , how to I disengage the control lock


... KitchenAid Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.2102 seconds