Having problems with your Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher ?

Water standing in bottom of dishwasher

\015 What would cause this and how can i fix it\015

Answers :

Alot of water in botom?? its normal to have alittle maybe just ot about the filter cover. not enought fill bottom of tub though. if htat shte case, try removing clamp hook up under the sink and look for possible clooged drainline
Repair Help & Product Troubleshooting for Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Leaking dishwasher The dishwasher leaks a stream of water at the base -bottom left corner whenever it goes into the final rinse cycle. It does not leak when it is in the wash mode. This leak just seemed to develop suddenly. There was no build up -ie a small stream of water. I just noticed a big puddle on the floor one day after dishwasher had completed its cycle water leak in the left side ,bottom ,husband states a small drip,drip and we do not know what to do or replace. No water standing


I just had this same problem and it was caused by a small plastic seal on the bottom of the door. My friend owns an appliance store and he said this is a common problem for this model of dishwasher. The part was $68 and the labor was $60. I could ... Frigidaire 24 in. PLD2850 Built-in Dishwasher

Model No. DU850SWPU3 AND SER. FT 4101406 TYPE 280-0. When cycle is complete and in off position the dishwasher fills with water. I find the bottom of the dishwasher standing full of water when I get ready to fill with next load of dishes. When I remember to turn off the wall switch this does not happen, however once in a while I forget to turn off the wall switch. The next day I find the bottom of the dishwasher full of water again. I then have to go through the cycles manually a couple of tim


If by turning the wall switch off, and only then it stops comming in, it means the board is faulty. There is a leak in the electronic system allowing to solonoid to stay partially open. Strangs that it doesnt flow onto the floor. ... Whirlpool GU2400XTP Built-in Dishwasher

After I run the dishwasher, water stands at the bottom and it smells. I have had the dishwasher for five years. The washer seems to be working properly it's just that water stands at the base of the washer. Is it normal for water to always stand there?


No it's not normal, you are probably having some cloge in the drain pipe, you could try with a pice of wire to pick it up or hose it down, or use some comercial unplaguners like mr. muscle or something like that, i think that this would do the trick ... GE Nautilus 24" Built-in Dishwasher

GE GHDA485N 10CS Dishwasher that has standing water in the bottom after the cycle completes. I pulled it out and reconnected power and ran a rinse cycle. I could see that water was pumping out the clear drain pipe but there was still about an inch of standing water in the bottom. Any thoughts as to what part has failed. Does the system use a water level switch or a timed drain cycle to determine when the water has pumped out. If it is a timed cycle could a slow drain cause the problem. Thank you


... GE Dishwashers

I have a brand new whirlpool DU1055XTV5 dishwasher, installed two days ago. After the cycle completes there is about 1/2" clean standing water left in the bottom. It is not just down in the well area, the whole bottom is covered with water. This is after running a normal cycle with no other options such as sanitize or heat dry. I called Lowes, the store that sold/installed it, and they said this is normal in new dishwashers to keep the parts wet. They said as long as the water does reach th


... Whirlpool DU1055XTS Built-in Dishwasher

My Kenmore Elite dishwasher did not drain the water out of the bottom after the dishes were washed last night. Could I possibly have pushed a wrong button to keep it from draining, or do I have a problem? All the dishes were clean. Should I run it through another wash cycle? I've got water standing in the bottom of my dishwasher.


Yes , If the program controller has hung it would have skipped the drain cycle. So try to redo the cycle and see if the drain works, is not check the program controller and the drain valve/pump.- if there is food particles that have clogged and block ... Kenmore Dishwashers

After cleaning alot of crud out of the bottom, the dishwasher wont drain! I took all the parts out that I could and cleaned them with bleach water, put it all back together and ran a load of dishes.........Now there is orangish water standing in the bottom of the dishwasher!


Hi,\015\012\015\012\015\012You have blockage inside, in the drain line, or if it connects to the disposal side of the sink. I would first check at the disposal, if it does indeed connect there. Usually gunk from the disposal will cl ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

When dishwasher drains the water not all the water is drained. Some stays standing at the bottom and starts getting an odor after awhile. This is a replacement dishwasher in a 35 year old house. How important is the air release part in the draining situation? I was told by someone that the newer dishwashers have the air release part which was not hooked up on this dishwasher when installed last year. Are there some other possibilities of things that can be checked. Model Number is DU


... Whirlpool DU1055XTS Built-in Dishwasher

The dishwasher seems to work ok, except for excessive water in the bottom. It does pump water out during the wash process, but leaves standing water in the bottom when wash is complete.


Hi,\012Here\012is a tip that I wrote that will help you with your dishwasher not\012draining problem...Dishwasher Problems - ... Dishwashers

Hello we are having a problem with our Maytag stand up dishwasher. The water is not pumping out all the way and the water that is pumping out is pumping out slow. There is about an inch of water that is laying in the bottom of the dishwasher.


... Maytag 24 in. MSE760FAKS Free-standing Dishwasher

I stopped using my dishwaser because it left crusted on food particals even tho I rinced them well(so I thought) before loading. It was as if they were just being dried crusty. After a couple month I noticed a bad smell. I looked in the dishwasher to find standing water in the bottom. I ran a little CLR through and it cleared out. But a couple weeks later again there was water in the bottom. It seems as if the water from the sink is draining into the washer. If I run it it runs thru just fine, n


Hi, \012I have an older dishwasher also and recently my wife alsocomplained about it not cleaning right... so me being the man I am tried invain to clean the things... Bought new spray arms online and installed them inminutes...now the thing works li ... Estate 24 in. TUD4700KQ / TUD4700KB Built-in Dishwasher

We have a GE profile dishwasher and we have standing water in the bottom of the diswasher after going through the complete cycle and the water is leaking through the bottom on the floor. Any suggestions on how to fix this.


I would suggest to open up the panel first to see if the leak is from the link of the water lines, from the valve or from openings either from the tray or the hoses. If it is not clearly visible I suggest to clean the unit and let the water fill it ... Dishwashers

When the cycle was done I had water standing in the bottom of the dishwasher. I checked the drain line and it is not clogged or crimped anywhere. I pushed the button to drain it out and it is still in the bottom of the dishwasher.


Can you here the drain pump coming on there may be a small piece of glass or something in the pump not allowing to flow out of the dishwasher ... Dishwashers

Water does not completely drain? Garbage disposal is functioning properly and hose from Kitchen Aid dishwasher to Garbage disposal is good. I ran the dishwasher a couple of times start to finish for rinse cycle and approximately 1/2 inch of standing water on the bottom. Any ideas? Please help. Thank you.


\012Hi,\012Here is a tip that I wrote that will help you with your dishwasher not draining problem...Dishwasher Problems - ... KitchenAid 24 in. KUDI01ILBS Stainless Steel Built-in Dishwasher

All of a sudden, my Kenmore dishwasher (Model 363.1411691) will not cycle. When I lock it shut and try to set it to wash, all I hear is a click--no motor running, no water sounds. As I advance the timer knob, I just get clicks where each cycle should begin. There is standing water in the bottom of the dishwasher which does not drain out. Any advice would be much appreciated, for sure.


Hi.The clicks are simply the relays in the timer board that try switching on. The control module is likely working.The cycle does not start because of a different problem.If no light is coming on, then ensure that wall socket ... Dishwashers

Standing Water There is an abundance of standing water in the bottom of my dishwasher. Is this normal???


Hi,Here is a tip that I wrote that will help you with your problem...Dishwasher Problems - Water will not drain outhttp: ... Dishwashers

I have a GE PDW 8200 Dishwasher and there is standing water in the bottom of the tube. Why is there standing water after a complete cycle?


If it is older, the pump may not be draining the machine completely. The impellers, which is what acually moves the water could be clogged with yuck and could be cleaned if you can take the machine apart. If you call the repairman, he will likely rep ... GE 24 in. Profile PDW7800 Built-in Dishwasher

Dishwasher won't drain. Pushed the drain button and water stil is at bottom of tub. Sink is not clogged, drain hose is not clogged and can't see what is in bottom of tub due to standing water? What are suggestions for repair?


... Kenmore 15639 Built-in Dishwasher

I just installed my kitchen aid dishwasher model kudco03fvss and it won't drain. There is standing water in the bottom of the dishwasher. It is a brand new appliance. There is no water going through the drain hose that I can tell. Is the pump faulty?


Hi, my name is Audrey. I am a KitchenAid employee and thought the following link might help address the draining issue you're having with your dishwasher:\015\012 \015\012 ... KitchenAid KUDC03FVSS 23 in Builtin Dishwasher

Help! My Whirlpool Quiet Partner II isn't working at all. Water was standing in bottom at end of last 2 cycles, but on the last cycle, I came home to clean looking dishes, standing water, and a machine that won't turn on at all- no lights on any buttons- nothing works. I've tried the reset codes published here and elsewhere, but there are no lights on any buttons at all. The circuit breaker is fine. I have 3 young kids and can't function long without my dishwasher!


There is a fuse in the control panel what your model# i can get you the part number its easy to replace it. ... Dishwashers

My Miele Platnum dishwasher is not working. It is flashing "intake/drain" When it begins instead of the normal hearing of water moving around you just hear a humming. My husband and father took out all the filters/baskets etc and made sure everything was cleaned out. They checked the hoses. After that it seemed like it was going to work because it started to cycle normally but now it is flashing again and this time there was water standing in the bottom of the dishwasher. Any thoughts?


Most common faults with dishwashers is a drain fault. Check for any kinked hoses and check the drain spigot under the sink where the drain hose connects into the u bend. Usually this is where food gets trapped due to the spigot not being drille ... Miele 23 in. Novotronic G841 Built-In Dishwasher

Standing Water After running our dishwasher we have standing water in the bottom, it won't completely drain out. Thanks, ---Joe


Are you leaving it long enough to finish it's programme or are you opening it when the drying light is on as some dishwashers leave a bit of water in the bottom to help with the drying programme ... Dishwashers

Got standing water in bottom of dishwasher model #GSD5500GWW/CC/BB. We found some plastic cake decorating tips in the standing water, and hear crunching like more tips when we turn the machine on. How do we take remove the spinning thing in the middle, or anything else, that would allow us to clean out all th plastic tips?


... GE Dishwashers

I have a JennAir dishwasher (E71195), and all the water does not drain out. The sink is not backing up, but there is water standing in the bottom of the dishwasher.


... Dishwashers

Brand new dishwasher, installed last week. When it is done there is quite a lot of water standing in the bottom of the tub. It has only been run 2 times since installed and both times several inches of water were left standing. Is this something we could check or do I need to have the installer come back, which will probably take a week at least. Oh-KitchenAid #KUDC031VWH


First was a new garbage disposal also installed? There is a knockout on the garbage disposal where the drain hose connects to.\015\012If that is not the problem make sure it has the correct high loop or also called air gap. If that is not right ... KitchenAid KUDC03IVWH Builtin Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1626 seconds