Having problems with your Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher ?

There is an element at the bottom of the dishwasher which is broken. What does it do and can it be replaced?


Answers :

Hi,

Here is a tip that will help you replace your dishwasher heating element.

\012How to Replace the Dishwasher Heating Element
heatman101
Repair Help & Product Troubleshooting for Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

There is an element at the bottom of the dishwasher which is broken. What does it do and can it be replaced?


Hi,Here is a tip that will help you replace your dishwasher heating element.\012How to Replace the Dishwasher Heating Element ... Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher

Maytag dishwasher MDBTT50AWS Door Latch broken. Screws hold the top. The bottom appears to fit into ''plastic teeth'' . Are the teeth supposed to have top and bottom or just bottom teeth. It appears mine has broken teeth on bottom. Is so, do I need to replace control panel to hold latch at bottom.


... Dishwashers

Dishwasher is model DWD1SSE type11045 Initially the dishwasher leaked water on the floor On investigation the bottom tray under the dishwasher was wet The motor was wet Tested the motor which was fine although the capacitor on the motor impellor was dead. Replaced capacitor, now no water going around the spray heads so found the impellor inside broken. Replaced that. No hoses are leaking. Machine now works fine heats up etc etc but over fills and the E5 fault shows


... Smeg 24 in. DWD1SSE-1 Built-in Dishwasher

Hello,I hope you can answer the question below for me. My dishwasher is a Hotpoint model BFI680 - integrated. I want to replace the old interlocking assembly with a new one as the spring has broken and I can not close the dishwasher door. I have trouble removing the old interlocking assembly though. I can not see any screws that keep it into place as with other models. Instead, it looks like that it is "clipped" to the dishwasher door via the two inner side round holes at the bottom. Tried to re


... Hotpoint 23 in. BFI68 Built-in Dishwasher

I have a Salton SDW12 Dishwasher and I'm looking for a replacement filter (at bottom of dishwasher) as mine has gone brittle and pieces have broken off. Please let me know? Thank you


Timers ... Dishwashers

I have a haier dishwasher model WQP12 AFM, I've replaced the wash pump motor and drain pump (they had been damaged with water after last repair person didn't put widget around drain hose which split and water accumulated on bottom). It well for about two weeks, then it would not go through it's cycle and I noted water not heating up. Have checked element with meter, thats fine, I replaced timersince it wasn't going through its cycle and that has not changed anything. Any suggustions?? Cheers


... Haier Dishwashers

My magic chef dishwasher door springs broke. I need to know how to access the bottom of the dishwasher to replace the broken parts.


Open the back door and see whether the hooking points visible.Look from the front end also to get an idea! ... Dishwashers

We discovered broken glass dish in bottom of dishwasher with some pieces below the bottom pump area. Shortly after the washer is making a louder noise during operation time. The water pump is quite when filling but after fill the noise comes during the wash time. The heat element works fine. What can be done to quite the wash cycle????


Sounds like you have broken glass in the wash pump you will have to remove pump from sump and clear also check the drain pump.good luck let me know how it goes ... KitchenAid KUDK03ITBK Built-in Dishwasher

Leaking at the bottom left side onto throw rug - not sure where it's coming from. Dishwasher works just fine. Is this repairable or has a seal broken and dishwasher needs to be replaced? It's about 8 years old.


May be pump leaking ... Frigidaire Dishwashers

Dishwasher won't drain. Water in bottom of tub. Washer hooked up through disposal, which was broken and just replaced. Currently, sink and disposal work fine but now tub of dishwasher won't drain. 24" stainless built in Model GLD6360L00SS


Hi\015\012\015\012\015\012Thanks for using FixYa. Hope you\015\012know that new disposals ... GE 24 in. GLD6360LSS Stainless Steel Built-in Dishwasher

The water doesn't heat up in the dishwasher. is that the element in the bottom that needs to be replaced? thanks, Kevin


... GE Nautilus 24" Built-in Dishwasher

I need to remove a broken heating element from my Whirlpool dishwasher and install the replacement part. I was hoping it would just "pop" out and the new piece would push in, however, it seems that it is not that simple. I need instructions.


Depend on how the heating element goes through the tub you do have to go underneath (if it goes down through the tub in the front) or even remove the dishwasher from the cabinet (if it does it on the back of the dishwasher). The tub is made of ... Whirlpool GU1200XTLS Stainless Steel Dishwasher

I have a Frigidaire Dishwasher, model #FDB635rfs It is not that old, but appears to have quit working. It sounds like it runs the water gets pushed in by the tube on the side but goes straight to the bottom of the washer. It looks like the spray arms are not spinning. Water is not circulating. Element still heats up. Detergent just runs down the inside of the door and doesn't dissolve since water is not circulating through arms. I have just replaced the water inlet valve and it did not hel


Don't know about yours but many of the rotating spray-heads are turned only by waterpressure, not a separate motor.\015\012The rotator is normally pretty loose and should turn willingly by hand; if it seems stiff and your water pressure is normally l ... LG LDF6810 Built-in Dishwasher

I have a Frigidaire dishwasher Model #that GLD2445RF alw ays leaves grit on the dishes. The heating element in the bottom of the unit is grey with a powdery substance flaking off of it. Does it need to be replaced? Can a novice do this, or is it time to spend the $50 for a service call? I've had it 13 months.


Figures just outta warr. if you have a meter you can remove the lower panel of d/w and depend on the model the heater wire connections are right there either on the left or right , you can see them from within the tub which end they wil ... Dishwashers

How do I replace Hoover Nextra HND 325 Dishwasher Element


... Hoover Dishwashers

Nasty dishwasher there is nasty wet grunge at the bottom of the door, around the place the heating unit in the bottom of the dishwasher. half the time the dishes are clean in the bottom of the dishwasher. half the heating element is melted..for some reason...what do i do. the dishwasher still works, if we make sure the dishes are clean before they go in. using more for a sanitation thing than a dishwasher. can ya'll help me?


Sounds like your heating element is broken and you should replace it to prevent a possible fire hazard. \015\012You can replace the element easily for not alot of cash. You'll need to pick up a new one at an appliance parts store, just bring them the ... Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher

We need to replace the locking ring in the bottom of our Asko 1716 dishwasher.(It's cracked) I can only find one kind of replacement ring for that,but it looks like the right size. I need to know if Asko uses one ring for more than one model of dishwasher?It's a 5" locking ring for the bottom well of the tub. Thanks for your help!


Only 1 size ... Asko D1716 Built-in Dishwasher

Items not drying like they should. I replace bottom heating element already. What's my next move? Is it the electronic control unit?


The control unit is not letting the element stay on as long as it needs to in order to dry the top rack. ... Dishwashers

I have a whirlpool dishwasher DU915WKSO: when I turn the dishwasher on, the heating element comes on but no water comes into the unit. I recently replaced the garbage disposal and th dishwasher worked fine for a time or two. Since then I have only been able to get water in it once. Like I said, the heating element works but no water in the dishwasher. Thanks for any help.


... Whirlpool DU1055XTS Built-in Dishwasher

I have Frigidaire model FDB130RGS3. This seems like a pretty cheap dishwasher that is provided by my management company. This is third dishwasher I've had in this apartment. The others have all broken. Now this one, which is less than 6 months old, seems to have broken. It does not clean the dishes. I removed the round plastic cover in the base of the dishwasher and the bottom of the dishwasher (sorry don't know how else to describe this) is filled with dirty water. I drained the water and tried


Hi,\015\012\015\012the round plastic cover in the base should just push back on, but you need to make sure it is correctly rotated before doing so. It should look like this:\015\012\015\012\015\012 ... Frigidaire FDB130 Built-in Dishwasher

Leaking dishwasher The dishwasher leaks a stream of water at the base -bottom left corner whenever it goes into the final rinse cycle. It does not leak when it is in the wash mode. This leak just seemed to develop suddenly. There was no build up -ie a small stream of water. I just noticed a big puddle on the floor one day after dishwasher had completed its cycle water leak in the left side ,bottom ,husband states a small drip,drip and we do not know what to do or replace. No water standing


I just had this same problem and it was caused by a small plastic seal on the bottom of the door. My friend owns an appliance store and he said this is a common problem for this model of dishwasher. The part was $68 and the labor was $60. I could ... Frigidaire 24 in. PLD2850 Built-in Dishwasher

Smeg Dishwasher DWD 63.1 SS, not heating; I have Smeg dishwasher that is sticking in its cycle (wash phase), water was cold, so I assumed the element had failed (or tank termostat), so I have replaced both element and tank thermostat in turn. No change, water still cold and dishwasher sticks in the wash cycle. Any ideas? (Note, no diagnostic leds on this model)


... Dishwashers

Hey Everyone! Ok try this one! I have been working on a KUDS25 Kitchenaid Dishwasher. It was leaking like a siv from the bottom. I replaced both top and bottom plastic bearings and also tightend all the screws at the bottom. Leak Gone, I thought. It now has small leaks down both sides. I have since been told by the owner that he took the door apart himself. I pulled out the dishwasher from the cabinet and ran it. I could see the leaks at the top on both sides of the door latch. I cou


Hello davidgalb. You can install a new gasket to seal the door again. That old seal is not flexible any more. That said, for my time and money I recommend a replacement dishwasher, this one has definitely seen better days. Joe ... Dishwashers

Can I replace just the heating element in my LG LDF6920WW dishwasher?


... LG LDF6920WW - Dishwasher with FulIntegrated Controls

We have a Maytag dishwasher, MDC4000AWX. Both dish racks are rusted, broken and falling apart in places. How much is it for replacements of these dish racks. Also, so you have any used dish racks in excellent condition. We do not want to replace the dishwasher because it works perfectly. We are just VERY disappointed this this rust problem. What can we do?


The only way to get new racks is to buy them here at link below. Parts #1 and #3\015\012\015\012 ... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1399 seconds