Having problems with your Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher ?

Have a model 665.17602301

\015 Dishwasher starts with normal wash light on and sening light on. It just fills and runs and runs and doesnt stop washing. cked to see if heater was working and it didnt heat. it will pump out if u put it on short rinse. ran diagnostic and all the lights came on and ran through, should i replace board?\015

Answers :

Hi,
\015\012On my own dishwasher the cycles are controlled by the temperature - the machine washes until the water reaches a certain temp and then it pumps out and goes on to the next bit of the program. If yours is based on the same principle and isn't heating the water that would explain things.
\015\012I wouldn't replace the board yet - I would first try to find out why it isn't heating. It could be the heating element, the relay or the temp sensor (if fitted) at fault.
\015\012
\015\012If you are technically inclined and know enough to delve into the machine safely you could check the heater connections, resistance voltage etc and hope to spot the fault. Let me know what you or the engineer find. D
Repair Help & Product Troubleshooting for Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Bosch D/W model # SHU9955UC. The drain motor will not stop running. Ran the reset sequence on the panel. Display reset to "0" minutes. Power cycled the D/W and when powered back on the drain motor started up again. What do I do ?


Hi ....This is a common problem. Remove the kick plate you will see the white base which also is a tray to collect leaks or backups. Reach your fingers over the top of tray and feel for water/wetness,if so safety switch has been activated and pump wi ... Bosch SHU9955UC Built-in Dishwasher

Model IGV 659.1 Dishwasher When switched on the 'time display' takes longer than 2 minutes to display the planned wash duration. The display works fine to set a delayed start. After cycling the start delay round to 0, or after RESET (buttons A and C pressed) the unit is then 'nudged' into displaying a time. After, at last, a time is displayed the unit works fine.


... Kuppersbusch Dishwashers

I have a Bosch dish washer model SHX 43 M 0 ZUC / 48 FD 8709 00169 The dish washer is about 1 1/4 years old and was installed by a plumber as part of a Home Depot kitchen remodel. The problem is draining. The quick wash does not drain at the end of the wash. The regular wash sometimes drain and sometimes does not. The auto wash does drain. The lack of draining does not cause problems with the regular wash cycle. I checked the drain hose re the instruction manual and it is correctly installed.


Usually a brush with a flexible shaft will do the trick...\015\012\015\012Like this venturi tube cleaner (available where gas grills are sold)\015\012\015\012 ... Bosch Dishwashers

We have Bosch model SHE44C02Uc. The motor seems to run for more than 10 hours, even though the indicator is on "0" minutes. Our dishes are cloudy, there is food always on the bottom, the filters have been cleaned -as much as we can get them clean of calcified dishwashing detergent.


Can you tell me how you can allow this to run for 10 hours ????? Are your sure you mean ten (10) hours?\015\012What in the world are you thinking while this is going almost half the day ? And then you say everything is still dirty.... somethi ... Bosch 24 in. SHE44C02UC / SHE44C06UC / SHE44C07UC Built-in Dishwasher

My Bosch integrated dishwasher(model SGV56A03 GB/12) runs through the cycle but doesn't stop at the end of the cycle. It continues to heat water and it sounds like the motor is running even though the time indicator shows 0 minutes. I have to manually switch it off. Any ideas before I call out an engineer. I have checked all the filters etc included in the troubleshooter info anf there are no blockages.


... Bosch Dishwashers

When I try to start the dishwasher, I can get the light to show I want it do do a normal load. Then when I hit the start button, it lights up but the machine will not sstart. Then in a few minutes the lights on the control panel at the top of the door go out. What can I do to fix this? The model # is KUDS011JBS0 tHE 0'S HAVE A SLASH ACROSS THEM THE TYPE IS 577-0 SUPERBA


Hi,\015\012\015\012Your control board has gone bad... you will need to replace it.\015\012The replacement is not very hard, just make sure that you mark where all of the wires go before removing them.\015\012\015\012Here ... KitchenAid Dishwashers

How do you reset a quiet partner I whirlpool dishwasher with a model number of du1014xtxq 0


... Whirlpool Dishwashers

When I press the start button, Bosch dishwasher (model SHY56A 05UC) just keep running the motor pumping the water out of dishwasher, irrespective of: 1) the wash cycle it is on, 2) whether the door is closed or open, 3) whether I cancel drain cycle, as told by Bosch Cust Svc in following steps: - "Cancel Drain" by pressing 'Quick Wash' and 'Regular Wash' buttons together for a minute until it shows 0* - Shut power off for a minute and wait for a minute - Restart on Quick Cycle. Paid


What is happenig i believe and has happened to me 2 times is that the water level float that is on the left side of dishwasher is stuck.\015\012\015\012Either remove side panel and flick lever or pull dishwasher out and tap lower portion ... Bosch SHY56A02 / SHY56A06 Built-in Dishwasher

Honda pressure washer model # exhp3640-1 3600psi 0=13hp has low water pressure out of triggers motor does not engage for higher pressure


... Pressure Washers

Honda 3600 psi 0-13hp model # exhp3640-1 has low water pressure


... Honda Pressure Washers

Dead spot? We just moved into a house and the built-in frigidaire oven, model no: CFEB27S2AS1 bakes on only the low heats, 0 - 250 and high heats, 450 - max but does not heat (red indicater light not come on nor any heat) at mid-range. Is there something I am not doing, or does it need to be "rebooted", and if so how do I get to the power plug/switch as it is embedded in the wall?


Hello\015\012\015\012You said, We just moved into a house and the built-in frigidaire oven, model no:\015\012CFEB27S2AS1 bakes on only the low heats, 0 - 250 and high heats, 450 -\015\012max but does not heat (red indicator light not come ... Frigidaire 24 in. FDB1050REC Stainless Steel Built-in Dishwasher

My kleenmaid dishwasher super silent model system DW5 doesnt appear to be heating the water on any cycle so it is not washing properly and leaving the powder etc on the glasses up the top particularly and also it does not go completely to the end of the cycle by itself(any cycle).Or completing the drying cycle. I have to switch to 0 cycle to make it complete the clicking to start again. What is the gauge on the inside of the dishwasher on the left that can be adjusted from 1-5 is this a heat


Http://frigidaireservicetips.com/pdfs/486_5.pdf\015\012\015\012\015\012\015\012Service manual, generic, use this to troubleshoot and repair.\015\012\015\012 ... Dishwashers

I have a power washer, craftsman &.0 horsepower, 2900 psi, 2.3 GPM model number 580.752410. i was starter to wash my car, and stops? i change the spark plug, andput new oil in there. still do not working. some one helme in this problem.


... Craftsman 3000 PSI 27 GPM Briggs Stratton Powered Pressure Washer

Hi I have a LG LD-2052 dishwasher. It gives me an E 0 error - the water does not pump out when I open the machine after a few minutes when started to wash and message of E 0 appears? Have cleaned an


... LG Dishwashers

Can't find model number.


... KitchenAid Dishwashers

Replaced control board 447325 in bosch SHU66C05UC/23; FD860300407. What code to select 0,1,2,3,4?


... Dishwashers

I am not able to get a siemens front loading washing machine at the right price. first they told me that the model was not available now the price of the model in india is too high for the features that are in it. I doubt whether it is a siemens model itself. kindly call me on 8975764416 immediately please. i tried to contact the england phone number also but it was wrongly given in the website of siemens. please help me to get WM14S79BUK or WM14S794ME model of washing machine at the right


... Siemens 24 in. SE25A266 ExtraKlasse Free-standing Dishwasher

Water from my disposal backs up into my hotpoint ($300-model) dishwasher. The dishwasher works fine otherwise. Is there a one way valve in the diswasher that is suppose to prevent reverse flow and/or is there other dishwasher motor problems which could cause this. Actually the Hotpoint Model number is HDA3600N00BB but this website did not recognize that model number so I put in the closest model number closest to mine.


If it's what I think, it's a simple fix. Does your dishwasher drain run along the floor of the cabinet, then up to the disposal? (my guess is yes). There should be an "air gap" between the disposal and dishwasher, this means when it comes out of th ... Hotpoint 24 in. HDA3400G Built-in Dishwasher

Hi, I have a Dishlex dishwasher. It's an electronic model, from about 92 I think. The model I thought was B8557WW. It is very hard to see the model number because it's almost washed away. Is the model number maybe located anywhere else on the machine? Could there be a manual or circuit diagram hidden somewhere on (in) the machine? The fault is that it wont start. It reacts to some of the front buttons, and beeps, but not all, and not the start button. Before it stopped working completely, some o


... Dishwashers

Where do I find the model number on my Frigidaire Dishwasher. It is a built-in model ''Ultra Quiet I'' I do not remember how long ago I bought it and had it installed. The model number entered was picked from a drop-down menu so I could get submit my question. I doubt it is the correct model number.


It should be located on the inside perimeter of the door on a metal plate. If not there, and there is a bottom panel, try and remove it to see if they put it there. You shouldn't have to pull it out I am sure. Just look real well with a light inside ... Frigidaire 24 in. GLD2350RC Energy Star® Built-in Dishwasher

Customer bought house with a Viking Dishwasher already there. He has no user manuals or documentation with the model number listed. None of the stickers on the side of the door have a Viking model number. This unit is a Quiet Clean System with Auto Water Heating and is (he thinks) about two years old. How can I find out what the model # might be or better yet how do I find out the part # to fix the main control board / interface. It just keeps blinking.


Check the back of the unit for a tag.... otherwise - removing the clock... it should have a part number on it.\015\012\015\012Thanks! ... Dishwashers

I need to replace a whirlpool dishwasher model du810swkq0 do they still make this model if not what model would fit in the same spot


... Whirlpool Dishwashers

I would like to purchase a Moyer Diebel U/C dishwasher for residential use. I have the option of purchasing a used dishwasher - it could be one of three models. Which one is the model he is trying to sell to me? 1. 501 HT 2. 501 HTN 3. 501 LT the owner states the voltage is 120/208-240 and heats between 150 f and 180f.He notes there is a 4 ft. cord at the back without a plug on the end of it but the model is rubbed off of the serial number tag.There are three switches on the lower right hand co


The way you mentioned the unit have a 4 ft. cord at the back seem like a 50l LT the best way to determent is open up the bottom plate and see whether there is a booster tank in the right hand side. \015\012Hope this can help you. ... Moyer Diebel 24 in. 501HT Built-in Dishwasher

How to find problem and repair my Bosch dishwasher, European model?SKT5002/02 is model number. One site suggested trying to manually turn the impeller on the motor as it might be stuck from not being used since last fall. But how do I get to the motor? This is a European model used in Europe.


... Bosch Dishwashers

I have a kitchen aid dishwasher model # KUDM01TJWHO The clean light has a 7 code. Your link to diagnostic mode/reset didn't work for this model. The tech sheet isn't behind the kick plate nor door panel. Need more suggestions do you have a tech sheet for this model?


You need to see if your getting power from the control all the way to the heating element something in the heating system is not working. some times the element burnes out and takes out the other stuff with it, so check for continuity at the element ... KitchenAid Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0504 seconds