Having problems with your Kenmore Dishwashers ?

Very noisy in rinse motor is very noisy, i stopped arm from rotating and figured out that wasn't problem, sounds like motor


Answers :

You may have something lodged in the pump that is causing it to rattle a bit.. Depending on the model, you may need to remove or disable power, then gain access to the pump by removing the toekick panel from the front.. You may also be able to zero in on the specific cause of that rattle by removing that toekick and cysling the dishwasher while listening for the source of that rattle.. A flashlight may help spot that source.. Hope that at least gets you headed in the right direction... Re-post if you still have an issue..
\015\012Regards,
\015\012Rick
Repair Help & Product Troubleshooting for Kenmore Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Very noisy in rinse motor is very noisy, i stopped arm from rotating and figured out that wasn't problem, sounds like motor


You may have something lodged in the pump that is causing it to rattle a bit.. Depending on the model, you may need to remove or disable power, then gain access to the pump by removing the toekick panel from the front.. You may also be able to zero ... Kenmore Dishwashers

Our 2470scvi has caused all of our glassware to turn white. we use very little soap and we always use rinse aid. It seems to me that it is not rinsing properly. It actually has a sound for about 10 seconds that sounds like a motor is stuck.. This sound occurs twice in each cycle. It seems to wash ok but not great of which I would expect for a supposedly top of the line machine. This problem has always happened and the machine is 3 years old.Is this normal for a miele? If so its not the machine w


Hello macit. I do not blame you one bit for being disgusted about this machine. Let's do this. Empty it out and pour in 2 fulll cups of white cider vinegar. Close the door. Let the hot water run into the kitchen sink until it is as hot as it wil ... Dishwashers

Our Asko D1716 dishwasher functions to fill and empty but the pump which causes the sprayers to rotate and distribute the water does not function. The local appliance repairman diagnosed the problem as a bad pump (he called it a motor). Since the pump is a $400 part plus labor, is it possible that the problem is something else like a bad motor capacitor or relay? When the cycle calls for the pump to come on, there is no sound except for a very soft hum.


Hi ! \015\012\015\012Got a D1706 ( in 2002 ) paid $1000 and as os April 2010...same problem as yours, I will trow it away ( dishwasher ) and will never buy at such cost. I'll get a GE or LG. \015\012\015\012Stupid Sweden dish ... Asko D1716 Built-in Dishwasher

Have Fisher-Paykel DD603 double-drawer dishwasher. Top drawer motor making loud noise. )Bottom drawer fine.) Still seems to wash and definitely pumps water but sounds like a "motor with a broken belt." Checked filter and rotating spray arm - no problems. (Found a little broken glass in filter; could be very old.) Suggestions?


If glass has gotten past the screen and into the pump, you may have a pcs. logged in the pump housing.\015\012Best way to correct this, is to remove the pump inlet and outlet lines and flush out with a water hose.\015\012Keep ... Dishwashers

DD602I USA v2. Runs approximately 10 min then beeps continuously and on the front panel the middle light is red and on the inside panel the "Del" "Fast" and "Rinse" lights are red. What is this fault code indicating? I have made sure spray arm, impeller assembly, are clean and not blocked. No kinks in drain line. Induction motor sounds a bit noisy. This is only a problem with lower drawer, top drawer works fine. Thanks, Keith


... Fisher and Paykel 24 in. DD-602 Built-in Dishwasher

Both spray arms of my DU943PWKQ0 do not turn or spray. The motor is moving and the it drains without problem. During the wash and rinse cycle I can hear the sound of water, however it doesn't clean at all and the sprays arms stay where they were. It seems the motor only creates no spray, but wave. I powered cycled the dishwasher, the problem remains the same. Anyone know what's wrong with it? Thanks James


Try rotating the spray arms by hand. It should rotate freely. If possible clean the arm rotating place by removing them.Arms rotate by by pump pressure only. finally check the water pump also. ... Whirlpool DU943PWK - Multiple Color Built-in Dishwasher

I recently bought a different type of dishwashing detergent for my Frigidare dishwasher and my dishes look as if they have not been rinsed. They cycled all the way through the drying cycle so the detergent dried on and was difficult to remove. I would like some advice on whether this sounds like a detergent problem or mechanical problem before I try another load. This washer is not new. It was in the house I bought and I've only been using it for about 2 months. (I usually use Casade Liquid and


The best way to use your dishwasher is the way it was designed.\015\012if your unit has a compartment for jet dry or rinse agent then you should add and fill that compartment with rinse aid. try not to buy soap with any extra like soap with jet ... Dishwashers

This problem is intermitten. Kenmore 665 16765690. starting the dishwasher, I hear a motor running. I think it is trying to empty water, however there isn't any water. I will turn the time rotor around to the start again. Sometimes, when I do this the motor running sound has stopped and I hear gurgling sound of water entering. Once this happens, the cycle is good and does well. However, there are times, rotation the timer back to the beginning may take several times, up to about 20 times.


Hiclean water filterthe presure is to lowPls vote me to keep us alive ... Kenmore Dishwashers

I have a new Ariston LKF720 dishwasher. In part of its wash cycle it is very noisy - not water noise, but a grating motor-like noise. Is there anything I can do? Is there anywhere I can watch a dishwasher do a run and listen to its noise, Ariston or other brand? We bought the present one off the floor and did not expect any problem, having had other dishwashers for years, they being quiet. The poor technician already changed the motor, but it is still just as noisy. I am even considering sellin


... Ariston Technologies L63 Free-Standing Dishwasher

My dishwasher blades do not turn. I have replaced the water valve so water is getting into the unit. I have not however, cleaned out the area below the lower blade. Could this be the problem or does it sound like a motor problem? There was a bit of a burning smell up to this problem. Thanks.


... Dishwashers

Dishwasher Dilema Hi, Can someone help me solve this problem. Last time I had a problem with my dishwashers I was pretty successful in solving it on this site. I was running a reg wash on the top drawer of my Fisher&Paykel when I suddendly had to stop it in the middle of a wash to add more dishes (something I do all the time) suddenly both screens started beeping with an F1 along with a wrench. It sounds like both motors top and bottom are running full blast. I tried shutting the power for a few


You need to remove the bottom drawer and dry out the water with towels and a hair dryer when this is done it should operate normally. most likely when you pulled out the drawer the water sloshed back and out of the drawer making the dishdrawer think ... Fisher and Paykel 24 in. DD603H W Built-in Dishwasher

I have an older Maytag model #WU482. For some reason it will not drain and will only run using the economy mode. I can hear the timer ticking at all other cycles and it does click between cycles. I recently replaced the drain float and the machine had been working fine after. The motor is working and the belt is good. I think the kids were playing with the timer knob. Could this cause a problem with the timer motor? Or does this sound more like a pump out issue, impeller? I'm thinking its


First,inspect the drain float. Make sure it rides on the micro switch correctly or it will not take on water.Check the float micro switch for continuity. Check for power at the water valve when it calls for water. Remove the wire harness from the tim ... Maytag 24 in. PDB1420 Built-in Dishwasher

Sounds like a have simular problem to one I read on the site with a stuck dishwasher motor. Mine is a Kenmoore 363.16229100 can This motor can be released and if not what opptions do I have Thanks


... GE Profile PDW8060GSS Built-in Dishwasher

Motor makes noise shortly after starting, makes normal sound level during main body of wash, then makes noise again during what I'm guessing is the rinse cycle. Not sure if it is a pump or motor problem. Slight electrical smell noticed after finishing the ''cancel/drain''. Water does not seem to be sprayed around washer during normal cycle, even though water has been in the washer.


Make sure the sprayer arm is turning freely, check for something stuck in the base of the sprayer arm (food or utinsel) preventing it from turning. ... Dishwashers

For my Kudi01dl model dishwasher, the rinse light is on, but the unit will not respond to any buttons being pressed and won't turn on. When I press any buttons, two horizontal lines show in the front, but go off as soon as I let go of the button. Is there a ways to reset the unit? Everything was functioning fine the last time I used it. I use it about once a day. The problem started when I heard sounds coming from the unit, very loud motor sounds. The door was closed but I had not turned


... KitchenAid 24 in. KUDI01DL - Multiple Color Built-in Dishwasher

My GE Profile dishwasher has a clicking noise in the motor. It sounds like a BB is rotating in it when the motor kicks in. What can I do?


Sounds like something is caught in the drain pump (if it occurs when you begin the cycle) or wash pump (if 3 minutes or so after the cycle begins) You can check the wash pump by removing the screen in the back. ... GE 24 in. Profile PDW7800 Built-in Dishwasher

Aqua Surge dishwasher sounds like the motor is straining during it's very long washing cycle. Water pumps in and out without a problem and dishes get cleaned but the sound it makes is loud.


... Frigidaire Dishwashers

Loud grinding noise sounds like something small and hard is getting caught in some kind of rotary. The sound comes from underneath the dishwasher at or near the motor. I screwed the big circular plastic filter on the bottom of the inside of the dishwasher, but found no significant debrie. It did not resolve the problem.


... Jenn-Air 24 in. JDB1090AWS Stainless Steel Built-in Dishwasher

Dishwasher motor sounds like its struggeling to run. oR LIKE it's bogging down during washing cycles any and all cycles. there is water going into the washer but when washing it sounds like there is no water moving around creating the motor to work harder ........sounding like its gonna stop at any second. frigidaire d/w model#= FDB510LCS3 SERIAL==TH74378818


Try pouring water from the front. The pump has got air traps inside. This will ease your problem.Also check whether the spray arm turns freely without any obstacles. ... Frigidaire 24 in. FDB510LC Free-standing Dishwasher

Dirty dishes Dishes come out dirty. Soap not all disolved. You can tell they are washing but looks like the problem is in the rinse. SOunds normal. Took water valve ant it opens but not very much but not sure how much its suppose to open.


It would help to know the manufacturer and model number.\015\012\015\012Generally the most common problem when a dishwasher is not cleaning properly is:\015\012\015\0121. You switched to a different/cheaper detergent. Go buy a box of ... Dishwashers

I have a GU1500XTLB1, type-575-0 Whirlpool Gold dishwasher. For the last couple of weeks I've been getting the control lock on. I got the manual out, I hold the air dry button and it clears. My problem is now when I turn the machine on dosen't matter which cycle I hit (pots and pans, normal, or quick wash) it runs for about 5 minutes and it goes into a mode with the timer having lines going horizontal with the air dry button lit up and rinse button lit up. It sounds like it starts the cycle


Hi,There are Few Tricks to Reset this. Follow the below Tricks :-1. Try holding down heated dry key for 5 secs. I believe that is the control lock/unlock button on your model. IF not, look for the lock symbol and follow same i ... Whirlpool Dishwashers

After 3 years it just started making a loud noise, I am no expert but it sounds like a fan in a motor. I have only heard it today, but I am betting it will still happen next load too. I didn't change any of the settings, have been running the same way forever. When I did hear this noise I started pushing buttons to see if I could get it to stop, no good, no change. The cycle has completed and everything looks ok, waiting on the dishes to dry. Drainage has never been a problem for me either.


I would say this is a build up of lime.try changing your tablets and checking your salt levels.there is no fan .try what i say and see what happens.have you found a glass broken it could be as simple as that but i dont think its serious.adrian,,,, ... GE Nautilus 24" Built-in Dishwasher

Water does not enter into machine . it sounds like its running. it shuts off in 10 minutes. There are 3 rotating blades . the middle, or biggest one, is missing . is that a problem? bob [email protected]


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks\015\012for using FixYa. To start with check the water inlet valve which is located\015\012behind the lower access panel on the l ... Miele 24 in. G643Vi Plus Built-In Dishwasher

Hotpoint aquarius water is going in, making all the right sounds, water is heating up, but not washing, spray arms do not rotate around. is this a motor or pump problem?


It could be your circulation pump is not pushing the water round the system . to replace this part if that is the problem is quite expensive , ... Hotpoint 24 in. HDA2000Z Built-in Dishwasher

My dishwasher is making a loud motor noise when pumping water for rinse. This is not happening when draining. I've opened it up, cleared any dishes and the drain. It sounds like it's coming from underneath the unit.


... Frigidaire 24 in. FDB750RCC Stainless Steel Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0991 seconds