Having problems with your Kenmore Dishwashers ?

Kenmore dishwasher model 363.1410691, approximately 18 yrs old... Wash cycle was on, unlocked and opened door to add silverware, shut and locked the door, but water did not (and will not) come back on. Appears heating element and timer still works...any ideas?


Answers :

Check your water valve. if know water goes in normally that is the culprit. disconnect the wires and ohms it out with a ohms it out. if this works then you can help me by sending me a 4 thumbs up post thanks!
Repair Help & Product Troubleshooting for Kenmore Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Kenmore dishwasher model 363.1410691, approximately 18 yrs old... Wash cycle was on, unlocked and opened door to add silverware, shut and locked the door, but water did not (and will not) come back on. Appears heating element and timer still works...any ideas?


Check your water valve. if know water goes in normally that is the culprit. disconnect the wires and ohms it out with a ohms it out. if this works then you can help me by sending me a 4 thumbs up post thanks! ... Kenmore Dishwashers

Middle and top spinners do not spin The pump is pushing water up the back delivery tube. There are no dishes in the unit and I was able to trick the door into thinking it was closed so I could watch what was happening. Or Not Happening The spinners are completely free of calcium or soap build up and both top and middle are easily spun with a finger. While the pump and bottom spinner were working, I pulled the top drawer out partially and there appeared to be a good flow of water coming out of


Hi,\015\012 Remove each spray arm and check it is clear of food particlesat the jets. The next problem may occour at the rotating joint . If the seal is not good, you can loose a lot of water out of this point.. If both of these seem reasonable ... Dishwashers

Miele G 841 dishwasher -power appears and disappears mysteriously (green light off). Closing and reclosing the door doesn't help. Have checked the water supply (both entrance and exit). It will just come back on by its own accord.


Well..sounds to me like the power is uncertain..check the plug and socket in wall, and maybe spread the tines a bit to get a better connection. Failing that, move it to another plug, and see if same thing happens(ok for temporary testing, but not for ... Dishwashers

Flashing light The 3rd light to the right keeps flashing. I cannot cancel the programme or move the indicator light to any other setting. When I close the door the machine does not come on, just the light keeps flashing. Any idea what the problem can be? There is no water in the machine and doesnt appear to be any blockage in the outlet pipe.


... Smeg 24 in. DWI612 Built-in Dishwasher

Hi my L G dish washer is coming up with E1 . It comes on after about 2 min it takes water into the washer then it hummes for about 30 seconds then comes up with E1 and pumps water back out. I have checked the hoses which don't appear to be leaking -I read somewhere in your answers about this problem that it could be the Water Level in Drum lowering, this means there is a leak on one of the pipes. More likely it is the Circulation Pump, which is responsible for pushing the water to the Spray


Hello aderry -\015\012\015\012\015\012I'm a bit short of time as I'm on my way out to a service call, but I've uploaded the service manual to Rapidshare for you to download. \015\012\015\012\015\012Rapidshare download inst ... LG Dishwashers

I have a mod. GSD2200G00WW . It has low water level and not enough pressure to turn the spray arm. When first starting i see water coming in but not enough. I added water in manually with a container and turned on and the spray arm rotated fine. I closed the door and turned back on and the water drained out of it instantly back to a low level. What now?


... GE Dishwashers

I have a smeg dishwasher and E7 comes up, water is not draining, i have checked for blocks and cant find one? I empty all the water added salt etc.... but the water comes back and E7 returns, any ideas of what else i can do? thanks


... Smeg 18 in. DWF410SS Slim-Line Free-standing Dishwasher

My Frigidaire Dishwasher FDB1050RES2 gets stuck in a rinse cycle. The light on the front will be lit "clean" but the bottom of the washer is full of water. Opening the door does not turn off the "clean" light. For me to get it to run, I have to unplug it, plug it back in, push the start button until the ?washing? light comes on. I then push the start button once more and the dishwasher will begin to drain. I open the door as soon as I hear the water stop draining into the sink drain. This


By the descrition you are giving you will need to replace the main control board.Part number 154568401.you may also need to check the float switch.The part will run about 110.00 dollars from a local parts store ... Frigidaire 24 in. FDB1050RE Built-in Dishwasher

My dishwasher emits a dead animal smell immediately after filling. I have a 20-year-old KitchenAid KUDS220T3 dishwasher. The racks are a little corroded, but it still cleans dishes just fine. About two months ago, it started smelling like a dead animal immediately after the dishwasher fills with hot water, during the time the water is being heated, but before agitation begins. The smell appears to be coming from around the door. If I open the door, everything inside the dishwasher smells fine.


This vent that you are describing is to allow air to flow in for the heat/dry cycle. Some times little creatures want to "mark" their territory by "spraying". Spray some type of cleaner like ammonia into it and **** it out with vacuum a few times. Mo ... KitchenAid Dishwashers

Hi, we have a Bosch Exxcel dishwasher which mid way through a cycle a button saying Check Water came on. we turned the machine off and opened the door and found loads of water in the bottom. my husband then scooped all the water out and cleaned filter in the bottom, where we did find some bits of plastic from the kids yoghurt pots, and took the water hose off the back and checked for blockages, which there was none. the water is certainly coming from the water pipe through the hose as we tested


Check your water level sensor. And also check to make sure that your pump is working correctly. It sounds like a couple of different things that need to be addressed. First check the water level sensor. It is a tube that is located from the back of t ... Bosch 24 in. SHU43 Built-in Dishwasher

Karcher 3100 pressure washer, motor runs fine but when I squeeze the trigger on handle, high pressure pump won't come on unless I remove tip and water is coming out of wand without restriction. Help anyone have any ideas? It did come on once but when I let go of trigger it wouldn't come back on.


... Alfred Karcher Quick Connect Nozzles 2600 3100 Psi 5 Pack

Miele 646 sc plus inlet tank solonoid valve on water tank leaking. We moved the machine from one room to another and now this valve is squirting out water. We replaced both door seals thinking that was the problem, then started the machine with a side pannel removed, and saw the jet of water coming from the solonoid valve on the water inlet tank. Any ideas.


... Miele Dishwashers

It appears that the dishwasher is not getting enough water. I have made sure that there is nothing blocking the door area so that the soap can dispense and I have reduced the amount of detergent to maybe a 1/2 Tablespoon. Have tried both powder and liquid detergents. Ran a sani clean cycle with the Jet Dry product for dishwasher used in the rural. I also run the hot water in the sink prior to starting the dishwasher to ensure the water is hot when it comes into the dishwasher. The detergent


Hello,Welcome to FixYa.Based on your description you`re experiencing the ... KitchenAid 24 in. KUDP01IL - Multiple Color Built-In Dishwasher

I have a LG Dishwasher LD 14AW3 it fills and runs for about 30 min. It then appears that when it tries to rinse it cannot get water and flashes "1E". I disconnected the unit and when I moved it out of its position water was leaking from the bottom of the unit. after cleaning out the inside filter & the hard water filter I re-connected and found it worked. I ran a dishwasher cleaner through it at high temp. After a few loads the problem has come back. It is now located in MY garage waiting for me


Found a leaking component that was causing the foam float located and attached to the inlet valve to shut down the water inlet and the water inlet Solenoid was also sticking. I found out this simply by tapping it while it was trying to get water for ... LG Dishwashers

I have a bosch SHU8815UC dishwasher. It was already installed when i moved into my apartment - so I'm unsure of the age. The dishwasher isn't functioning. When I open the door, the "Clean" light and the PowerScrub button are red. When i close the door, the light go off but nothing happens. One time I closed the door, it started to rev up but would shut off and beep three times after about 1 min. No water comes out. Any ideas? Thanks! June


... Dishwashers

Mod #: MDB6600AWB Ser #: 16505148CG No water comes out of spray arms, checked and cleaned filter-OK. Wash impeller is cracked where it slides onto the hexagon rod but it you take the filter flow plate off and put the impeller back on, when you put the unit on rinse only and quickly open the door you can see it is still turning and moving the water. The unit still fills and drains. it just does not have enough force with the impeller to force the water into the spray arms.


Hi,\015\012 \015\012Please check the bellow link regarding your query....\015\012 \015\012 ... Maytag 24 in. MDB6600A Jetclean II Built-in Dishwasher

KitchenAid dishwasher; insulation in door is wet, door seals appear okay. Where is this water coming from?


... Dishwashers

Leaking This is a problem that I have when the dishwasher is in drying mode. I will find a 5X5 and sometimes smaller, size water spot under the dishwasher after the dishwasher has stopped. I was told it was the vent were the steam comes out and I had that replaced. It still leaks, then they told me to replace the rubber around the door, still leaks now they order a whole new plastic interior door. Please if you have any ideas what could be causing the problem, please let me know. Thank you


\015\012open the bottom panel 2-4 screw\015\012take a flashlight and turn the machine on\015\012see where it come from\015\012if you need take the unit out a bit f ... Jenn-Air JDB4000AWS Stainless Steel Dishwasher

D63 continually empties. is there a bypass valve on the pump, as although water is coming in, (and being pumped out the drain hose), there is also a jet coming back into the filter housing, so the arms don't have enough pressure to spin above about 6 rpm! The time switch appears to be operating correctly.


Flame sensor is dirty or faulty ... Indesit 24 in. D63S Free-standing Dishwasher

Have the Kenmore Limited Edition dishwasher, model # 665.15892100. When dishwasher is running, you can hear the soap container flip open. However, @ end of washer's completion, and main door is opened, the soap is still in the container. Some has leaked out, but the majority is still in the container. Dishes are still dirty, so it appears that either there is no water to disperse the soap, or does the door really open? Any ideas?


Check the wash arms to see if food has not cloged the holes stopping water getting through\015\012if these are clean the machine may not have enough water entering machine\015\012also check how you stack machine ... Dishwashers

I just bought a Whirlpool quiet partner II and it's leaking. It appears to be coming from a dome shaped thing at the front of the basin. It only leaks when the dishwasher stops and there is water in the basin. It appears to be a valve of some sort but i can't tell. Nothing in the manual even mentions what this thing is. Any ideas?


I think what your looking at is the fill switch float there should be a switch located under it on the bottom of the tub it might have came loses or not hitting it properly ... Dishwashers

I own a KUDS01FLSS3 KitchenAid dishwasher. The lights on the control panel do not come on and a cycle can not be started. There is about an inch of water in the bottom of the dishwasher basin and it looks like the previous cycle did not complete. I have checked the wall outlet that the washer is plugged into and the washer is receiving power from the wall. And ideas? My next thought was to take the door off and check the power supply running to the door panel and control panel.


Servtek06 writes:\015\012check connections @ control board/module. May be Control Board/Module. ... KitchenAid 24 in. KUDI01FLSS Stainless Steel Built-in Dishwasher

I have an LG LDF6810ST dishwasher that has a leak on the bottom right hand side of the door. It appears to be leaking from inside the door itself. The dishwasher is 2 years old. I checked the inlet water to make sure connections were not leaking and they were not. I live in a rural part of Alaska so after talking with the LG help desk I'm pretty much on my own. Any ideas?


Hi,\012Here is a tip that I wrote about dishwashers and them leaking.Leaking Dishwasherheatman101 ... LG LDF6810ST Stainless Steel Built-in Dishwasher

I have a kenmore model 665.17779990 dishwasher that is leaking. I am collecting about one gallon of water coming from directly under the door during a normal wash cycle. The door seal does not appear to be the problem.


Hi,Follow the below troubleshooting points :-\015\012\015\012Inspect the seals for the main tub, float, heating element and blower diffuser\015\012Check for ... Kenmore Dishwashers

Water & soap was coming out of the dishwaster. Replaced the seal around the door. Ran again on a pots & pan cycle to clean & it worked fine. Ran a normal cycle with dishes & soap & water came flowing out of the bottom now. Any ideas?


That sounds like the float switch is acting up. It is a mushroom looking device on the bottom that has a movable (up and down) plastic cup over the top. With the machine off, take the lower tray out and lift up on the cup--you should hear a faint 'cl ... Kenmore 24 in. 17032 Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1775 seconds