Having problems with your Kenmore Dishwashers ?

Middle spray arm dripping but not spraying - Kenmore Dishwashers


Answers :

Hello,

Welcome to FixYa,

Based on your description I`d suspect a plugged wash pump.

The place to start for that is to pull the pump filter, spray arm and check for food deposit, broken glass, undesolved detergent and general water deposit built up in the sump well.

The key is to get in there and clean it all out, I`ve attached a link at the bottom that will show you how to go about it. It is not really referring to the heating issue, or maybe even your model, ( Most Whirlpool, Inglis, Kenmore, Kitchen-Aid, Jenn-Air ) but it is the same procedure.

When you`re finished run it through a test cycle and see how it goes.

Let me know how you make out and what you find.

macmarkus :)

http://www.youtube.com/watch?v=iRCCrEwrst8&NR=1
Repair Help & Product Troubleshooting for Kenmore Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Middle spray arm dripping but not spraying - Kenmore Dishwashers


Hello,Welcome to FixYa,Based on your description I`d suspect a plugged wash pump.The place to start for that is to pull the pump filter, spray arm and check for food deposit, broken glass, undesolved detergent and ... Kenmore Dishwashers

I followed 'Mindcell's' advice on fixing my Kenmore QuietGuard 4 dishwasher, and I managed to clear out all the food particles that have accumulated. I suspect that is probably why the middle spray arm has not been very effective. However, in my repair, as I was screwing in the star screw that holds the cover of the foodscreen (the lower most star screw), I managed to overturn it and break it. Thus, the food screen is only held by a plastic clip, and from what I can gather, pressure from a


Hello Lily - You could use the machine this way, afterall all that could happen is for the cover to come loose and end up in the bottom of the machine.\015\012\015\012That said, why not remove that broken screw with a small pair of vise g ... Kenmore 24 in. 15689 Built-in Dishwasher

My LG LDF7810ST dishwasher does not spray water from the middle or upper spray arms, therefore the dishes don't wash properly. Even when I ask for a top load only, the bottom spray arm is the only one moving (which I would expect that it shouldn't move at all since I've requested a top load only) I checked the spray arms as best I can to make sure that they're not clogged.


... LG 24 in. LDF7810 Built-in Dishwasher

Kenmore BuiltIn Dishwasher Stock 17512 Model 17512200 Type 575-0 Serail FM3309375 Probelm: Water sprays out of lower arm weakly, and not out of upper arm at all. Action taken: Unscrewed the 4 screws holding down the item underneath the lower spray arm, and then the small item under that. Found major refuse from years gone by, removed, cleaned. Reassembled, same issue. I suspect I have to get 1 more level down, to the intake for the pump? found 2 screws to remove, but was not suc


... Dishwashers

Dishwasher Problem... Hey, I'm sorry I can't seem to find this information anywhere else. I'm having a similar problem with my dishwasher (also a kenmore quiet guard) and I wanted to try to clean the filter. I'm not sure how to remove the lower arm of the dishwasher. There is a kind of plastic-screw in the middle of the lower arm, is that what holds it on? I'm afraid to try twisting it because I don't want to break it. How did you get it off of yours? I hope I'm not bothering you! Thank you, Je


You are right. The plastic screw needs to be removed. I have a Quiet Guard 4. My procedure is as follows:\015\0121. Remove baskets. Need to pop off the 'keepers' at the ends of the top slidding shelf supports.\015\0122. Remove bott ... Dishwashers

I have a maytag MDB600AWW dishwasher. the top spray arm doesn't turn. it wouldn't even turn if i removed the to middle trays. I took the accumulator out and cleaned it. the fine mesh filters were clogged. unfortunately, birthday candles found their way into the machine sometime back. i cleared as much as i could. when i put it back together, the top arm would spin only when i had the 2 middle arms disconnected. It seemed there was an increase in pressure. i ran a diagnostics test and there were


First check to see if the washarm itself is clogged, if so clean it out.\015\012\015\012If the arm has a bearing it may be shot.\015\012\015\012You may have a clogged manifold on the output side of the pump. I sometimes run a ... Dishwashers

Broken upper spray arm for a Kenmore 665 16689 dishwasher. need the par number for the post part that inserts into the spray arm.


... Kenmore Dishwashers

Kenmore dishwasher lower spray arm loose - Kenmore Dishwashers


... Kenmore Dishwashers

My Kenmore Elite dishwasher 630.1630 9400 (possibly made by Bosch) has a bottom rack spray arm a top rack spray arm and a missing sprinkler on the outlet at top of unit (ceiling it the cavity was a room). What part number is it? Can I post a picture? thank you


... Dishwashers

SPRAY ARM ASSEMBLEY NOT TURNING ON MY BOSCH DISHWASHER, ALSO WATER JUST DRIPPING THROUGH SPRAY ARM


\015\012\015\012\015\012\015\012If your dishwasher leaks, check these:Main tub seal ... Whirlpool 24 in. ADG7540 Built-in Dishwasher

Kenmore dishwasher model 665.16033401 doesn't drain well. Drain pump comes on but drain water only trickels out slowly. Obstruction somewhere ? Removed rotating spray arm inside to try & get at the place where the drain water enters pump. Can't remove any parts beyond spray arm. Home: 330-865-4813 Cell: 330-608-3022


... Dishwashers

Kenmore (Whirlpool) 655 1589910 Dishwasher. Fills with water, motor makes horrible noise (buzzing / loud hum). Dishes do not wash and there is no evidence that any water pumped up to the spray arms. Spray arms are not clogged. We have a fully functioning water softener so it is not a hard water issue. Unit does drain normally. Either filter is badly clogged or pump is bad. How do I get to these parts to check them out?


You need to clean/ check the chopper. sounds like you have a bad motor. about 2-300 dollars for the part ... Kenmore 15899 Built-in Dishwasher

Frigidaire dishwasher top spray arm only drips the water out. top spray arm doesnt spin


Hi, \012I have an older dishwasher also and recently my wife alsocomplained about it not cleaning right... so me being the man I am tried invain to clean the things... Bought new spray arms online and installed them inminutes...now the thing works li ... Dishwashers

Dishwasher spray arms don't spin & spray water


Go here www.partselect.com/repair.aspx?appliance=dishwasher&part=dishes-not-clean - ... Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher

Kenmore dishwasher spray arm too low, hits heat element bracket


There is a picture of the inside of what I believe is your dishwasher. It is not great but might give you some idea of what might be missing. http://www.bobgolds.com/dishwasher/home.htm ... Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher

Middle spray arm not spraying


Unlikely that 2 dishwashers would have the same fault but is of course possible\015\012could it be to do with how you are loading? quite common is for a knife or similiar to stick down thro the rack and jam the arm ... Dishwashers

GE PWD7980 dishwasher middle spray arm not spinning when in wash or rinse cycle.


... GE Dishwashers

Middle spray arm of GE Triton XL Dishwasher is not spinning


... GE Tritonr XL GSD6260JCC Dishwasher

Kenmore dishwasher spray arms do not spin


... Kenmore 18 in. 14432 / 14439 Built-in Dishwasher

Middle spray arm does not spin Frigidaire dishwasher


... Frigidaire Dishwashers

Kenmore dishwasher spray arm removal


... Jet Tech Systems STEALTH Dishwasher

Kenmore dishwasher spray arms not functioning


... Kenmore 16879 Built-in Dishwasher

Hello, Please help. I follow recommendations for cleaning: sewer pump, cleaning arms, screens of the dishwasher. However, still machine is not working. water is not going through arms: lower, middle or top. Also, I get water into dishwater when it starts, and when I open i hear noise for water dripping into hot elements,but no water is running throughout. PLEASE HELP


... KitchenAid 24 in. KUDP01IL Stainless Steel Free-standing Dishwasher

I have a Kenmore, Stock 15649, approximately 14 - 15 yrs old that worked fine until the past few days. The upper rack doesn't appear to be getting any water, as bowls and glasses are still dirty after being washed. It appears as though water would spray from the bottom, through a "nozzle" in the middle of the lower rack, then go to an arm located underneath the upper rack. I haven't noticed any obstructions in this path that would inhibit the water from spraying. Any suggestions (outsid


... Kenmore 16602 / 16604 / 16609 Built-in Dishwasher

Hello, Hope you call help. I have a kenmore 13793K. Middle spray arm (attached to the bottom of the upper tray) is not rotating. It is, however, spraying water. Any ideas on what is preventing the rotation?


... Kenmore 13793 Stainless Steel Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1787 seconds