Having problems with your Kenmore Dishwashers ?

How to replace a soap dispenser in a kenmore dishwasher, model #587.16193400


Answers :

Repair Help & Product Troubleshooting for Kenmore Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have a kenmore dishwasher model#665.17014400. the soap dispenser does not open in cycle. I replaced dispenser because of high ohm's reading ,but it still does not open. which is the next place to look?


... Kenmore 24 in. 17032 Built-in Dishwasher

How to replace a soap dispenser in a kenmore dishwasher, model #587.16193400


... Kenmore Dishwashers

Kenmore dishwasher My Kenmore dishwasher model 630.16302401 is not successfully completing wash cycle. When I hit "normal" and turn it on, water enters the d/w, and the sprayers (both top and bottom), spray water. Approx. 10 mins. later, the water is drained. At that point, it appears that water never again enters the d/w to complete the wash cycle. In fact, the soap in the dispenser does get released, and the door opens. However, the soap will just run down the inside of the door and pool on th


... Maytag Dishwashers

I have a 12 year old Kenmore Ultrwash Model #665.15951790. I recently replenished the rinse aid dispenser and am experiencing an oversuding problem. It was oversuding to the point that suds were coming out the bottom of the door. Did notice that the blue rinse aid seemed to have leaked into the dishwasher due to a puddle of blue rinse aid at the bottom of the dishwasher. Have run a "quick rinse" cycle 4 times with no dishwasher soap added and still have sudsing. Can the rinse aid cause oversudin


... Kenmore 15129 Built-in Dishwasher

The soap dispenser won't open during the cycle on my 15782 model Kenmore Dishwasher. I am using gel pack soap...so I do not have old soap caked in the receptical. Any thoughts?


Hi\015\012Dishwashers use Bi-Metal strip to allow the dispenser to open/close. This strip when heat up causes the soap door spring to open up the dispenser. If this strip is not heated doesn't allow the door to open. Th ... Kenmore 24 in. 15782 / 15784 / 15789 Built-in Dishwasher

Kenmore Tumble Action Washer, Model 417,44152400 LEAK! Leaky Door got progressively worse over a month. I replaced the boot and about 10 minutes into the first test wash there was a massive leak under the soap dispenser and down the hinge side of the door during a fill cycle that seemed to be going through the dispenser. This happened again during another fill through the dispenser. No leaks during subsequent fill through the boot hose, before the spin cycle and no leaks around the door


Any of those could be the problem. Theres no other way to diagnose and fix unless/until you open it back up. ... Dishwashers

Kenmore dishwasher model 665 soap dispenser locked


... Dishwashers

My Kenmore model 665.16022401 has the problem w/ the clean light flashing. I tried the bottom combo of hi temp wash, heated dry, high temp wash, heated dry and it re-set my dishwasher but then after I tried to run a new load it doesn't seem like it finishes all the way through because there is still soap left in the soap dispenser and the dishes arn't all clean, plus the green clean light begins flashing again. Don't know what to do.


... Kenmore 24 in. 16022 Built-in Dishwasher

Hello! I have a Kenmore Dishwasher Model # 665.15805890. The dishwasher came with the house and I'm guessing it is around 10 years old. My toddler was having a great time flipping the door to the soap dispenser back and forth until he pulled the door off of the pin. Now, I can't seem to position the spring in a way so that the door will spring back. I never looked closely at the hinge before, so I don't know if that is the only reason the door will not release the detergent, or if something


Hi.Please see if the diagram here can help you. Check if the spring is that indicated with nr ten in diagram. ... Kenmore Dishwashers

Leaking dishwasher I have replaced the rubber grommet around the soap dispenser latch and have double checked it for leaks.It is not leaking and I suspect that was never my problem.The water is coming from the lower right hinge area.I do not qualify for the maytag recall.I have never used the rinse aid dispenser but find it peculiar that there is no rubber washer in sight.Could I have a bad door seal? Maytag Model #DWU7402AAB


Hi there, dishwasher leaking might be due to either of these causes, check these:Main tub sealNote… If the main motor of your dishwasher is mounted vertically, beneath the center bottom of the dishwasher, the foll ... Maytag 24 in. DWU7402 Built-in Dishwasher

I have a whirlpool dishwasher model adp 5550 condenser. The dishes do not get clean. I have had a repair man out twice and he replaced the soap dispenser on Friday but it still doesn't work. I went to the store today and bought every cleaning things I could find for dishwashers and also started to investigate online myself. I took the arms off and cleaned them, I took the filter out and cleaned it, and then I noticed that the plastic bar that runs from the top, along the back and into the bottom


... Dishwashers

The soap dispenser on my ASKO Model 1805 Dishwasher broke, we got a replacement part from ASKO but can't figure out how to get the old one off to replace it?


Hello,\015\012\015\012Remove the outer door panel, the screws around the edge hold it on. The soap cup will depending on serial break be held down with metal flanges or small screws. Bend the flange or remove the screws and push the soap dispe ... Dishwashers

Asko 1805 dishwasher. Bought replacement soap dispenser which is a universal fitting for a number of models. Terminal layout is different from original. Which wire connects to which terminal?


Can you provide details about the wires present in the universal fittings which you bought for your soap dispenser .If possible can you send the serial number present on the universal fitting . ... Dishwashers

HOW DO I REPLACE THE SPRING FOR THE SOAP DISPENSER LID FOR A KENMORE DISHWASHER. IS THERE A SCHEMATIC AVAILABLE THAT SHOWS THE EXACT POSITION THE SPRING SHOULD BE IN.


... Kenmore Dishwashers

I have a Whirlpool Model GU2700xtsq dishwasher. The soap dispenser latch and catch broke off. Now it just stays open and won't close. What is the replacement part#?


Dispenser, Assembly (DISPENSER)\015\012 Part Number: PS2363019 ... Whirlpool GU2700XTSB / GU2700XTSQ / GU2700XTST Built-in Dishwasher

A kenmore dishwasher model 665. The soap dispenser does not open


Hi,\012There are three common problems that cause the Soap Dispenser or Cup not to open. I have a tip that will explain these problems in detail....Dishwasher Repair Problem ... Dishwashers

Ge dishwasher model num.GSD2400G01.soap dispenser not opening during cycle.took it apart to replace broken handle.now i have a hard time opening and closing door.when door is closed,it wont let the soap out.dont know if gear-like parts are lineing up or not.please how can i fix this problem.


Hi\015\012If the soap dispenser door doesn't closes on your GE dishwasher then disconnet the dishwasher from power and check the spring & plastic tab under the timer. Check the plastic tab, it breaks often and will not let the soap door t ... Dishwashers

Model # ending in 665 doesnt dispense soap - Kenmore Dishwashers


Hi,\012There are three common problems that cause the Soap Dispenser or Cup not toopen. I have a tip that will explain these problems in detail....Dishwasher Repair Problem ... Kenmore Dishwashers

Kenmore model 665 dishwasher intermittenly does not allow soap to dispense


Good afternoon, Is the silverware basket located in the lower rack up front?\015\012In most cases the cause for the soap dispenser door not opening is an obstruction preventing the door from opening. Make sure no plates, pans or utensils are in ... Dishwashers

Kenmore dishwasher Model #13673 soap dispenser door will not open during wash cycle.


... Kenmore 13673 Stainless Steel Built-in Dishwasher

KITCHEN AID STAINLESS DISHWASHER MODEL #kuds02frssWe just replaced both springs in the door and the latch mechanism and the soap dispenser that still does not work. Our door will not stay shut. MY HUSBAND NEEDS HELP.. PLEASE HELP. HE IS VERY GOOD AT REPAIRS AND IS STUMPED!!


Hi.Your husband must check wiring harness from electronic control to door lock solenoid.The solenoid should also be tested reading Ohms with a multimeter.Here parts and diagrams: ... KitchenAid 24 in. KUDS02FRSS Stainless Steel Built-in Dishwasher

Kenmore dishwasher model#665 156 0592. detergent cup does not release during wash cycle. after cycle has finished, soap remains in the cup. I did replace the solenoid that controls the latch but the problem still remains.i did receive one response but it was not the answer to correct my problem.


... Dishwashers

After starting wash cycle the rotary dial advances to what appears to be the second phase and stops at about 1 oclock position. I replaced the timer/switch, same problem. Could I have a water temp sensing problem due to a poorly adhered sensor? I thought this may be the issue as the sensor at the water feed near the soap dispenser was loose on inspection. Model Bosch SHU4002UC/U06 Under counter Dishwasher


Check the thermostat sensor. If the sensor is faulty the amchine will not detect that the right temperature is reached and the cycle will not advance.The thermostat will read low ohms (about 1K) using a multimeter at Rx1 at ro ... Dishwashers

The little plastic arm that holds the soap dispenser closed on my model DU1055XTSD2 dishwasher broke off. I can't find the part to replace it.


Must get new soup dispenser ... Whirlpool 24 in. DU1050SS Built-in Dishwasher

A Kenmore dishwasher, model#66513743K603 will wash okay until it drains after cycle that dispenses detergent. Then it takes in half amount of water, wash motor short cycles & then drains.Next cycle works okay. Main control board was replaced but problem wasn,t solved. Rene


... Kenmore Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.2214 seconds