Having problems with your Kenmore Dishwashers ?

Dishwasher fills with water then shuts off - Kenmore Dishwashers


Answers :

Repair Help & Product Troubleshooting for Kenmore Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Kenmore dishwasher will not fill with water model no 630.1609406. It will run a full cycle but not fill. Water was temp shut off to replace kitchen sink and now dishwasher won't fill with water. No fill valve that I can see cleaned filter but still no water.


First, are you sure that the machine is not filling?\015\012I go on calls all the time for this problem and it turns out than the machine fills but the wash motor does not run.This leaves soap in the bottom of the DW so it looks like it did not ... Dishwashers

Dishwasher fills with water then shuts off - Kenmore Dishwashers


... Kenmore Dishwashers

Kenmore dishwasher. The upper rack is not getting clean. Even very light residue remains. And, detergent is left in door at end of cycle. The bottom is filling up, so I don't think it's the intake valve. Also, all the blade openings appear clear. I am noticing that hot water is not filling the dishwasher when I first run the cycle. Even if I have hot water running in the sink, the dishwasher fills with cold or warm water. So, I think this is the problem. What should I do? Thank you in advance!


I find it odd that the dishwasher is filling with cold water if the water is hot at the sink. It sounds like the dishwasher is connected to the cold water line rather than the hot. Check under your sink; if you've got standard plumbing, the dishwas ... Dishwashers

I have a Kenmore Ultra Wash Dishwasher (Model Number 665.15634) that will not fill up properly. When I try to run a cycle (any cycle), the first thing the dishwasher should do is fill up with hot water. But in my case, my dishwasher fills for about 10 seconds, then stops. Then tries to fill again for about 7 seconds, then abruptly stops again. And this process goes on and on and on. The dishwasher never fully fills up nor starts the wash sequence properly. Once the dishwasher fills up, it


... Dishwashers

Dishwasher malfunction MOST OF THE TIME it shuts itself down before fully filling with water - SOMETIMES it doesn't shut down until the minute the wash pump starts - SOMETIMES it washes for 10 or 20 minutes before shutting down - SOMETIMES it will even run a whole cycle, BUT it doesn't open the soap dispenser door - tried doing a diagnostic run but after it turned on all the lights on the panel it started to fill with water and shut itself down......... HELP


Follow this steps and fix it. God bless youFloat Switch\012\012\012The float switch may be hung up and this can cause the dishwasher to be stuck in a cycle. Check the ... Dishwashers

No water is coming thru the water valve to fill the dishwasher. The water is turned on. I had a Kenmore portable dishwasher and we just converted it to a built-in. The electricity is on and the water line installed. When I turn on the dishwasher, it comes on ok but no water is coming into the machine.


Most probable cause a faulty intake solenoid. OK start simple and go from there.If your have power and light etc come on then we know you are good for power. I'll assume that is OK. If\012you are not getting any li ... Dishwashers

My Kenmore Elite dishwasher (model 665.17462300) is not spraying the water from the basin in the bottom up through the rest of the dishwasher. The basin fills with water, then just makes a humming noise and appears to splash a little of the water around the very bottom of the dishwasher. When we cancel the cycle, it does drain out the water from the basin. I cleaned all the gunk and debris out of the basin in the bottom, but it didn't make any difference.


... Dishwashers

I have a Kenmore 363.15655891 Dishwasher. It will not fill with water. I have replaced the fill valve, water is on to the machine. When I check the electric connection for the fill valve it does no


... Dishwashers

Float does not shut off the water when dishwasher is being filled. IWater keeps running, fills up and runs out of the front of the dishwasher. Also it will not pump the water out at end of cycle.


Check the float to make sure it moves freely up and down, and it should click when it moves. Remove float and clean around the float tube-you may need to do this from below, through the access panel. Use white vinegar to scrub the float and ... Maytag MDC4650AW Built-in Dishwasher

Kenmore Dishwasher model 665.1675592 doesn't seem to wash as well as it used to. Seems to have a low water level. Filler valve works, allows water in, but never seems to fill enough. No spray reaches top shelf, I think due to insufficient water level. It's like the timer doesn't stay on long enough for it to fill. Also cycle time seems WAY up, but if the timer is slow, how does it time out filling so fast? Looks like it would be slow all the time. Suggestions?


... Kenmore Dishwashers

My Kenmore ultra wash 6651736 dishwasher broke almost to the month it turned 6 years old and I'm trying to decide if I should fix it or buy new.It washed wonderfully up to the day it stopped .the water fills ,but no water sprays around.the water fills to the correct level and I can feel the water heat. I can push cancel and it will drain. Right before it broke there was a terrible grinding noise for a few loads.No water leaks.the newer models don't seam to last long.this one is replacing one t


Hello,very common issue on these units, the motor had failed, the motor did have a five yer warranty but we are beyond that.You can purchase the part from the link below, ... Kenmore Dishwashers

Kenmore Dishwasher 665.1671590 Leaking water at fill funnel.


Step1Inspect the door gasket. As it ages, the gasket can crack or become hard, preventing it from sealing completely. Step2If the gasket appears solid, adjust the door latch so the door seals tightly. Loosen the screw tha ... Kenmore 15129 Built-in Dishwasher

Water keeps coming into the dishwasher. Had to shut the hot water shut-off to stop the water from continuously filling the unit. How can I make repair myself.


Hello,Welcome to FixYa. ... Bosch 24 in. SHU53 Built-in Dishwasher

I have a Kenmore Model 665.15955792 dishwasher. Water is leaking out the bottom of the door. I changed the door seal and the defusers but it continued. I took off the front of the door and I see the water filling into the base of the machine. When the dishwasher starts the cleam cycle, water is pushed up into the small square holes in the bottom of the door and then splashes up over the lip of the door and out onto the floor. It has never done this before, just started recently. I have had the d


... Kenmore Dishwashers

The clean water fill will not shut off and water overflows from the dishwasher onto the floor. We had to turn off the water supply to the dishwasher to get it to stop.


Fill valve is shot , new one required \015\012\015\012Ps \015\012\015\012Does it still run when you remove the power if so the above applies \015\012\015\012If it shuts off then the problem sits with the pressure s ... Whirlpool Gold 24 in. Built-In Dishwasher Dishwasher

I have a kenmore Ultra Wash Dishwasher, Model 15825691. We were recently hit by lighting. Once hit, the dishwasher started up. Since then, all cycles work, however, at the end of any cycle, the dishwasher continues to run and fill the bottom of the washer up to about two inches and then cuts off, so when we open the washer, there is approx 2 inches of water inside no matter what. I have pressed the "Cancel/Drain" button, in which drains the water after two minutes, but when that is finished, the


There must be a problem wit the fill valve. Check which valve the water enters. Check first the wiring to the valve of the water inlet or where the water comes out to fill the washer. Check for physical evidence of damage on the solenoid (or contr ... Kenmore 24 in. 16539 Built-in Dishwasher

I have a Kenmore Elite dishwasher (2004) and recently it has been leaking internally at a very slow pace. When not in use it will slowly fill until the floor of the unit is filled and then leak onto the kitchen floor unless we press the drain button and then it drains completely. The water seems to be coming from the front of the washer, potentially from the door itself. The amount of leakage is barely discernible but will fill over the course of a 24 hour period. The dishwasher otherwise wo


Hello,\015\012The water is admitted into the dishwasher through a little magnetically controlled valve underneath your dishwasher. This valve opens and shuts electrically. There is a little plunger in it that is pushed shut by a spring when no ... Kenmore Dishwashers

I have a year old kitchen aid dishwasher and during fill cycle it makes a thumping noise. The dishwasher every 5 or 10 seconds shuts off fill cycle then turns back on which I think is what's causing the noise. Not sure but seems like water should run until fill cycle is complete?


Drain Pump\012 \012 \012 \012 \012 \012 \012 \012 \012 \012 If the dishwasher is loud dur ... Dishwashers

The port where the water comes into the dishwasher is pouring out water even when the cycle is complete. The drain works during the cycle but then fills up unless I shut off the valve that allows water to the dishwasher. Thank you.


... KitchenAid KUDKP3DSS Stainless Steel Dishwasher

My frigidaire dishwasher will not shut off the water being pumped into the dishwasher. It just keeps pumping in even after the required fill time and will not shut off, eventually I have to turn off the shut off so that it doesn't overflow. The float is working ok. Is this a sensor,circuit board?


... Frigidaire Dishwashers

My Kenmore Portable Dishwasher model number 665.17769K600 will not fill with water, I have to manually fill with water and it will then work. What could be causing this?


Hi\015\012\015\012\015\012\015\012When the\015\012Dishwasher is not filling in, you'll need to check for the water inlet valve,\015\012the filter screen and the float switch/assembly. Also check ... Kenmore Dishwashers

Water coming out front of dw at start of wash cycle. I leveled the unit. no luck. if you open the door during fill cycle the water does not shut off. also, may be a problem with float shut off working properly. what should I try next? Kenmore Elite 16579


Hi \015\012Check float to insure that it is free to move, it sounds like the dishwasher is over filling. That is assumed that you have not changed the type or amount of detergent being used.Also there is a probability tha ... Kenmore Elite Stainless Steel 24" BuiltIn Dishwasher with TurboZone Rotating Spray Jets 13103

My Kenmore Ultra Wash 2 portable dishwasher is not filling with water, is there a screen or filter that could be dirty? It worked fine yesterday and I can hear the motot running, but it does not fill. ( I did make sure there is water to the faucet, lol)


Check the solenoids on the water inlet valve. Often when they fail they get extremely hot and melt the outside housing. These are cheap to replace and can be done easily. I recommend contacting TheRepairClinic.com and using the online help feature to ... Dishwashers

All of a sudden, my Kenmore dishwasher (Model 363.1411691) will not cycle. When I lock it shut and try to set it to wash, all I hear is a click--no motor running, no water sounds. As I advance the timer knob, I just get clicks where each cycle should begin. There is standing water in the bottom of the dishwasher which does not drain out. Any advice would be much appreciated, for sure.


Hi.The clicks are simply the relays in the timer board that try switching on. The control module is likely working.The cycle does not start because of a different problem.If no light is coming on, then ensure that wall socket ... Dishwashers

I have a Kenmore dishwasher model #17519200. I loaded it last night as usual and closed the door. I pressed the wash cycle I wanted and pressed the start button. I heard it starting to fill with water as usual. After it filled with water it should have gone into the wash cycle mode but it just started making a buzzing noise for about a minute or two then just stopped. I pressed cancel to drain it and it drains fine. I have kept trying to re-run it but it just does the same thing I described.


... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1594 seconds