Having problems with your Kenmore Dishwashers ?

AFTER RUNNING MY DISH WASHER I OPENED THE DOOR THERE WAS ST HALF IN OF WATER IN THE BOTTOM SO I WAS GOING TO WASH AGAIN BUT HAD NO LIGHTS ON CONTROL PANEL HAD POWER TO THE DISH WASHER BUT NOTHING WOULD LIGHT UP? DONT HAVE 10 WASHES WITH THIS UNIT .? MODEL #655-13443K900


Answers :

Hi Bennie, Try http://www.manualowl.com for free PDF for troubleshooting the issue you are having. I hope this helps.
Repair Help & Product Troubleshooting for Kenmore Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

AFTER RUNNING MY DISH WASHER I OPENED THE DOOR THERE WAS ST HALF IN OF WATER IN THE BOTTOM SO I WAS GOING TO WASH AGAIN BUT HAD NO LIGHTS ON CONTROL PANEL HAD POWER TO THE DISH WASHER BUT NOTHING WOULD LIGHT UP? DONT HAVE 10 WASHES WITH THIS UNIT .? MODEL #655-13443K900


Hi Bennie, Try http://www.manualowl.com for free PDF for troubleshooting the issue you are having. I hope this helps. ... Kenmore Dishwashers

Dishwasher model# FGHD2433KBI. washer was purchesed mid July, used 4 times. I just put in some dirty dish's and closed the door. A couple minutes later the washer turned on. No lights were on. After a few minutes I pushed the cancel button. Nothing happened. I opened the door and it sounded like a sucking sound and the pump stopped. No water in unit. I closed the door it started again. I cut the power at the circut box. Waited a few minutes and turned power back on. Power failure light came on.


... Frigidaire 24 in. PLD2850 Built-in Dishwasher

I have a Whirlpool Gold Model GU2700XTSBO its only 4 years old. About two weeks ago i noticed that the green lights were flashing and it would not run, I unpluged it for an hour and pluged it back in and the lights went away and it worked ok for the last two weeks. Last night I went to use it and there is no power at all to the washer, I checked the power source to the outlet and there is power there, so I dont know if there is a reset button or some control panel problem?


... Whirlpool GU2700XTSB / GU2700XTSQ / GU2700XTST Built-in Dishwasher

I just purchased a du920qwdb4 whirlpool dish washer and there is no power cord. I looked all around it and I dont even see where on would go. Do you have any idea of where one would connect with the washer?


You need to supply a power cord; the power supply cord kit (Part No. 4317824), available at your local dealer or parts supplier, should be used, if you want to plug into a standard 3 prong outlet. Alternatively, you can direct wire the unit to the ju ... Whirlpool 24 in. DU920QWD Built-in Dishwasher

Ariston LSI 41 dish washer had intermitant problem of green light not coming on when main power switch turned on and machine not working, the circuit had beed repair before. I played around and got the machine to go through a full circle once then would not go again. So I have put a new circuit board with switch etc. still the switch panel light dose not come on, i found bad connection in connector which comes from small plug on circuit board, (two red wires )I have checked for power to board. W


... Ariston Technologies Dishwashers

I have a 5 year old kenmore 665 15689 dish washer that wont come on at all . No lights no nothing . Before it stopped working the lights on the desplay were not coming on but it seamed to be washing normaly . I checked the breaker and even turned the power off for 5 min.


Theres a fuse in the back of the panel. ... Kenmore 24 in. 15689 Built-in Dishwasher

My dish washer just stopped working, no power no lights no nothing. it is plugged in and the circuit breaker is not tripped the wires for to the plug are tight and i didnt find an loose wires, the gfc plug is not tripped either, any suggestions?


This machine has no power, and i would suspect a broken wire but you say the trip did not trip,have you got a voltage tester?if so set to x1k or until when you touch both points it workes.with the plug in hand put one point on the right plug ter and ... GE 24 in. GSD3630Z Built-in Dishwasher

The clean light on my kitchen aid dish washer kept blinking and would not stop. after reseting it by pushing the buttons 2-3 times it cycles though and stops. then nothing works when i push the buttons. model : kudpo2crbl4


The electronic control looks for a temp. rise of 2-4 degrees. If no temp.rise control assumes a heater fault and blinks clean light 7 times. Bad heater. Water fill when completed can be no less than 1/2 inch below heater. If so, water valve probably. ... Dishwashers

Kenmore elite 1393 worked fine for a week or two then began to stop in mid cycle,we could drain the water and try again but would shut off almost immediately. sometimes trying to restart it there would be NO power to any buttons, after waiting for awhile the buttons/lights would work again but the washer would not run a full cycle.blue light would light then go out within a minute or so.


... Dishwashers

The hidden control panel has only about half the lights showing what function is pressed. A couple of days ago the washer would not start. The only function which would work was the far left sensor light. After trying to cut power and pushing other buttons, to no avail, we let the machine sit a couple days. It now works again with only half the lights on function pad working. It acts like there was a electrical short.


First retrieve the tech spec sheet behind the toe-kick panel located near the floor and run the diagnostics if it will let you do so w/o the full operation of the keys on the pad,then if it wont the touchpad or keyboard on the front that you use to s ... Jenn-Air 24 in. JDB1100AWS Built-in Dishwasher

I have whirlpool Dish washer model GU 120 ES (bought in 2001). When we start the dish washer cycle the unit starts for a minute, then the "start indicator" light flashes. As indicated in the instructions, we press the "start button" for five (5) seconds, at this time the washer clears the water out and stops. If you can assist this would be greatly appreciated. Thanks Jeff


I called the service tech.... ... Whirlpool Dishwashers

Kenmore elite dish washer model 630.1390installed new kenmore dish washer and the power light always stays on,, is this normal


... Kenmore Dishwashers

My electrolux dish washer model eidw6105gso stopped before it completed the cycle. All the selection lights were flashing and i could not get any functions to change. I killed the power at the breaker to try to reset and that didn't work either. I removed the panel on the front on the bottom to see if there was a reset button and found another display that is showing a light on the turbidity location. what is this and what might i do to get my washer back working?


... Electrolux Dishwashers

I have a KitchenAid Dishwasher KUDIO1iLBS2 and none of the lights come on and if I press any of the buttons nothing happens. The unit is getting power to it as I shocked myself. I did ordered and replaced the control board and still nothing is happening. Any suggestions or ideas? Is there a reset button or is there a possible fuse that is out that would make the lights not come on? Please help.


... KitchenAid Dishwashers

I have a F&P dishwasher model DW60CDX1 (around 5 years old) which we cannot start a cycle. The dishwasher turns on (power button and all programme indicators light up) but when you press a programme button nothing happens - the lights don't change. We have switched the power off at the powerpoint and on again a few times but this has not rectified the problem. It was playing up before this in that sometimes the programme would not start when a button was pressed but I just closed the door mor


The micro switch in the door which senses the door closing has probably failled. This is accessible once the inner door cover is removed. Switch should be under $10 from electrical store. Or buy through appliance manufacturer. ... Fisher and Paykel Dishwashers

Will not empty washer and has stopped at the point of pumping out water When switched on power light continuelly flashes an washer light is on first indicator nothing happens


\015\012Q - My dishwasher wont drain, what can I check for ?\015\012A - Please see the dishwasher pages dishwasher pages for more detailed information. ... Dishwashers

Bosch SHX 46L Our dishwasher would complete a cycle everything good. Sometime after, it would spray and wet the dishes leaving water in the bottem of the washer. Now, the pump runs constantly when the washer is powered on and it will not start a wash cycle. Any ideas?


Http://www.computercrowd.com/Itm250480379703_60270_Bosch_Dishwasher_Service_Repair_Manual.aspx\015\012\015\01 ... Dishwashers

Have a dw8w kleenmaid brandt dish washer, lost all warning lights on front paneal. dish washer still works ok but dont know what sical its on


... Dishwashers

Washer is stuck in mid cycle. Have turned of power as the current monitor light is red. maybe electrical problem. when i turn power on again the lights flash on for a few seconds then turn off again.but nothing works.


Step1:Use the diagrams in the manual to locate the food trap. Remove the top\015\012of the food trap and empty out any debris inside. If there is standing\015\012water in the bottom of the dishwasher, watch to see if the water level\015\012rece ... Fisher and Paykel 24 in. DS-603 Built-in Dishwasher

DISHWASHER WAS IN MIDDLE OF CYCLE... HOUSE LOST POWER AND NOW WASHER STOPPED AND WONT FINISH CYCLE NO LIGHTS ON BOARD DOES HAVE POWER TO UNIT HOWEVER NOTHING LIGHTS UP


Remove the rear panel. Gain access to the thermal fuse. (glass tube like fuse)\015\012This does have a tendency to go bad. A faulty door switch can also cause this. ... Kenmore Dishwashers

The dish washer ran its full cycle but won't shut off. the little pump motor in the very bottom keeps cycling water in the bottom. it won't shut off when you open the door, it won't shut off when you push the power button and the front switches won't respond. the little light on the front of the dish washer is blinking and it has never done that befor normally the lites are always on solid.....


The drain stuck cycle ( I presume you mean drain pump running constantly ) are directly related with overfill scenarios for Asko dishwashers of this ... Asko D3122XL 24 in Builtin Dishwasher

I have no power to the dishwasher. I tried the circuit breaker, flipped it. No lights on, nothing. It must have been running when the power might have gone off, may be the power surged or something and it wasn't able to finish running the cycle. I have taken out all my dishes and washed them by hand but I still have water standing in the bottom of the dishwasher. I am a mechanically challenged mom and my husband won't be getting home for two more weeks. The dishwasher is a WhirlPool Gold Quiet


First check and make sure that the units not on a switched receptacle(and is wired into this circuit(i know the dishwasher is "hard-wired",as in the unit doesn't have a plug on it,but it could have been wired into this switched circuit by mistake) un ... Whirlpool Dishwashers

A few days ago the dish washer was running fine, maybe a single wash every day. Then, out of no were the logic seems to have left the machine. If you pressed the "normal cycle" button it would blink for about 30 to 45 seconds then the front panel would go blank. All LED lights would turn off, like it finished doing the diskes, never running a single cycle. I unplugged the machine to let all circuits reset, that worked for two days, two washes in that time. Today I'm back to a machine that will n


Your control panel is faulty and will have to be replaced. This is the main brain of the machine. Normally when a cycle doesn't start the timer is bad, but when your control panel doesn't do anything, then it is faulty. ... Dishwashers

Normal light is flahing unit will not go on sometimes time remaining indicator will flash started awhile back by not being able to change any settings but unit would work now nothing have tried disconnecting power still nothing


HiIf clean light is blinking 7 times then it may be an issue with heater circuit, door switch or wash pump. If yes then please reset the power to the dishwasher. After, 5 minutes check if you are still getting the same ... Whirlpool Gold 24 in. Built-In Dishwasher Dishwasher

I have a zanussi ZSF2440 dishwasher, when it turned on by the power button on the front you can choose a cycle and start it, Once the cycle is started it fills up with water but doesn't stop until it over flows setting off the flood protection, which cuts the power, so all the lights on the display go off and stops the water flow and drains the dishwasher and keeps draining the dish washer while the flood protection is on. It seems as if the dishwasher doesn't know when its reached its correct


... Zanussi Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1238 seconds