Having problems with your Kenmore Dishwashers ?

I have a Kenmore elite dishwasher model #13923K012 that the cancel/drain light is stuck on. How do I get it off so I can operate the dishwasher?

\015 Model# 13923k012\015

Answers :

Unplug the power cord, wait 10 seconds, and plug it back in
Repair Help & Product Troubleshooting for Kenmore Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have a Kenmore elite dishwasher model #13923K012 that the cancel/drain light is stuck on. How do I get it off so I can operate the dishwasher?


Unplug the power cord, wait 10 seconds, and plug it back in ... Kenmore Dishwashers

Hello my Kenmore Elite dishwasher has both the "add a dish" and "drying" red lights stuck on at all times. The machine still works but I want to get these lights to go off!


... Dishwashers

2006 kenmore elite dishwasher 665-17263402- the clean light flashes 7 times , pauses then flashes again 7 times. What does that code mean? Cannot get washer to operate.


The blinking "clean light" is a common problem with some of the Kenmore and Whirlpool models dishwashers. The problem is usually attributed to water supply temperatures being too low when filling. Apparently, there are some issues with th ... Kenmore Elite Stainless Steel 24" BuiltIn Dishwasher with TurboZone Rotating Spray Jets 13103

Kenmore dishwasher I have a kenmore dishwasher and in the middle of a cycle all my front panel lights went off. I have checked the power going into the dishwasher it is fine. I also checked the door latch it is fine. Not sure what else to check? Same exact problem model number 665.15934 We have had nothing but problems with all of our sears products - highly suggest to SHOP SOME WHERE ELSE before you get stuck too.


Check the continuity of the thermal fuse (part # 8193762). It's clipped onto the electronic control inside the console.Let me know if you need more help. ... Kenmore Dishwashers

My Kenmore dishwasher, about 5 years old, is not cleaning well any more. Glasses look cloudy,and I assume the bowls and plates are not clean also, but that's harder to detect unless I hold them up to light. I use a rinse agent. What's the problem? Is it worth having a service person look at it or should I just get a new one? It's a Kenmore Elite ultra wash dishwasher.


Although I used my credit card to pay for the live chat, it bounced me out before the service person could respond. So I tried another service and two people who do home repair told me what the problem was and what it would cost to fix it. Since the ... Kenmore Dishwashers

I have a Kenmore Elite dishwasher (model 665.1315), and the dishwasher will run through the wash cycle as expected, but when it gets to the heated dry cycle , it doesn't appear to dry. It will then flash a fault code 81 (8 short flashes of the 'clean' light, pause, and then 1 more short flash of the 'clean' light, longer pause, and repeat the code). The dishes seem to be somewhat dry, but there is certainly water on the dishes and on the tub (there is never any water standing in the tub, and t


Hi,Check your heating element.. \012A bad heating element causes many problems in dishwashers...Dishwasher Problems The ... Kenmore 24 in. 15932 Built-in Dishwasher

Kenmore elite dishwasher model #665.13942k010 is 1 yr old and stuck in rinse mode..tried combo button pushing....no lights or beeps....tried the breaker in off position....blue light keeps flashing rinseing with 3 bars.....appreciate the help Thanks Steve


... Kenmore Dishwashers

I have a Kenmore Elite dishwasher and the green light on clean just flashes. I can't get the dishwasher to do anything.


Try turning the control knob all the way around a couple times. It worked on mine. ... Kenmore Elite Stainless Steel 24" BuiltIn Dishwasher with TurboZone Rotating Spray Jets 13103

I purchased my Kenmore Elite dishwasher, model # 8542514, in 2003 & replaced the control board in 2006. Recently, I accidently opened the dishwasher during a wash cycle, but it continued working once I closed it. It seemed to work fine for a few more weeks. Now, however, I get nothing--no lights....just doesn't start up. I tried pressing all the code solutions listed on this site, but no luck so far. It seems to me that the control board/panel should last more than 3-4 years.


... Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher

We just installed a new Kenmore Elite #13123K dishwasher. It has power and water but does not run. The lights light up and all but it does not seem to be getting any water.


Is the water inlet valve open? ... Kenmore 24 in. 15173 Stainless Steel Built-in Dishwasher

My Kenmore Elite dishwasher model #665.13113k701, starts washing, then turns off. After awhile, it starts washing again, then stops again. Sometimes the cycle never finishes, sometimes it does, but the red lights flash lightly and I can rarely get it to reset.


Hi,\015\012 \015\012First, check to make sure the electrical connections are all sound. Lose ground, or loose neutral can offer very puzzling symptoms. If the connections are good, check the integrity of th ... Dishwashers

Kenmore Elite Dishwasher clean light ind flashing and won't start


You will have to reset the console. To do this, close the door and press these buttons in sequence...-high temp wash-heated dry-high temp wash-heated dry...all the lights will turn on briefly and the machine ... Kenmore 24 in. 15142 Built-in Dishwasher

Kenmore Elite Quiet Guard Undercounter Dishwasher 66516029402 clean light is stuck on and will not allow me to run wash cycle. What do I do?


... Dishwashers

I just bought this house with this dishwasher built in. I have pushed the door shut, pressed the heat dry button to lock the door and pressed the start button. Nothing happens. Now I can't even get the lights on front to turn off. The lock button flashes as though the door is open, but its not as far as I can tell. I have to press the latch in to open the door. I'd like to use it... any ideas. Its a Kenmore Elite model # 665 17052 402. Thank You


... Kenmore 24 in. 17052 / 17054 / 17059 Built-in Dishwasher

I have a Kenmore Elite Ultra Wash dishwasher. Model #17572. All the lights on the control panel went out. Get no response at all. Circuit breaker is fine. Any reset tips? Or, do I need a new control panel?


... Kenmore 24 in. 17572 Built-in Dishwasher

I have a Kenmore dishwasher, and when we shut the door, without starting a ccyle or anything, the motor will start going!! When we do start a cycle, it will get stuck at some point during the cycle and won't sanitize or show the "clean" display light as being lit.


... Kenmore Dishwashers

I have a kenmore elite dishwasher, right now it seems to be stuck on the clean cycle the green light blinks on clean,, i pressed start and nothing happens i also press cancelle and nothing happens is there away to reset this or would something be broke


Hi,\015\012\015\012You can also pres "normal wash" and "heated dry" buttons back and forth till all lignts comes on, and it will reset the dishwasher and work normal again..\015\012\015\012But if you get this problem frequent ... Kenmore Dishwashers

My Kenmore Elite dishwasher doesn't proceed past the first few minutes of any cycle. It gets stuck at the "add a dish" part of the cycle and then stops and starts. It won't go further into t


... Kenmore Dishwashers

We have a 10 yr Kenmore Elite Dishwasher in our winter home so in reality has only about 5 yrs worth of wear that all of a sudden the lock on light comes on and it will not operate we have tried holding the switch in for 4 seconds but does not help we turned the breaker off and back on washer worked for a few minutes but then shut off...Please advise


The most common type of door interlock is a heater operated delay \015\012lock, which\015\012is why some machines take a time for the door to release. So make sure \015\012you have\015\012waited a minimum of 2 minutes before you open these or conclud ... Kenmore Dishwashers

We have started experiencing a problem with our Kenmore Elite 655.15982 dishwasher. Each time we close the door, NoHeatDry lid would go on immediately. It would stay as is of would go flashing. If you touch any button, LockOn lid would go on. Then no other buttons would respond. And often both NoHeatDry and LockOn indicators would be flashing... We tried turning machine for an extended time on the fuse, etc. At times it would work for some time and then cycle get stuck again at the same p


These errors are due to a faulty control board and needs to be replaced. If its still underranty get it fixed before it expires as it is a costly repair to replace. ... Dishwashers

Kenmore Elite Model 665.16499300 will not operate as though it has no electrical power. No lights.


... Dishwashers

My Frigidaire Dishwasher FDB1050RES2 gets stuck in a rinse cycle. The light on the front will be lit "clean" but the bottom of the washer is full of water. Opening the door does not turn off the "clean" light. For me to get it to run, I have to unplug it, plug it back in, push the start button until the ?washing? light comes on. I then push the start button once more and the dishwasher will begin to drain. I open the door as soon as I hear the water stop draining into the sink drain. This


By the descrition you are giving you will need to replace the main control board.Part number 154568401.you may also need to check the float switch.The part will run about 110.00 dollars from a local parts store ... Frigidaire 24 in. FDB1050RE Built-in Dishwasher

Kenmore elite wash dishwasher cancel/drain light will not stop blinking


... Kenmore Dishwashers

Kenmore Ultra Wash Dishwasher - Lock On Light Stuck!


... Kenmore 17252 Free-standing Dishwasher

Kenmore Elite 665.15929001 Dishwasher, flashing Sani-Rinse light, won't start


Kenmore is **** with a double PP go buy a Maytag or GE and throw it threw the appliance dept like the Discount tire guy did on TV. I have asked the same question on 4 different blog's and no answer. The question to where they were actually built is u ... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1935 seconds