Having problems with your Kenmore Dishwashers ?

Kenmore dishwasher model 363 leaking from tub bottom, motor-pump mechanism. What part should be replaced?


Answers :

Repair Help & Product Troubleshooting for Kenmore Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Kenmore dishwasher model 363 leaking from tub bottom, motor-pump mechanism. What part should be replaced?


... Kenmore Dishwashers

I have a haier dishwasher model WQP12 AFM, I've replaced the wash pump motor and drain pump (they had been damaged with water after last repair person didn't put widget around drain hose which split and water accumulated on bottom). It well for about two weeks, then it would not go through it's cycle and I noted water not heating up. Have checked element with meter, thats fine, I replaced timersince it wasn't going through its cycle and that has not changed anything. Any suggustions?? Cheers


... Haier Dishwashers

Dishwasher is model DWD1SSE type11045 Initially the dishwasher leaked water on the floor On investigation the bottom tray under the dishwasher was wet The motor was wet Tested the motor which was fine although the capacitor on the motor impellor was dead. Replaced capacitor, now no water going around the spray heads so found the impellor inside broken. Replaced that. No hoses are leaking. Machine now works fine heats up etc etc but over fills and the E5 fault shows


... Smeg 24 in. DWD1SSE-1 Built-in Dishwasher

I have a GE potscrubber Dishwasher Model # GSD3630ZZ3WW it has been leaking from the bottom for about a week. I took the bottom off tonight and ran the dishwasher so that I could see where it is leaking from. It is not a hose but the leak seems to be coming from the back of the motor or pump fan where it goes into that plastic housing that attaches to the bottom of the dishwasher seems to be leaking in the very center of that housing where the motor shaft enters the housing. Water is just spray


... Dishwashers

Hello, I have a Kitchen Aid (model # KUDMO1T JWHO) dishwasher that runs the motor in all cycles, with water fill & drain working fine, but the pump is not pumping water during any cycle, as the spinners and the inside of the washer are dry when I open the door, except for the water sitting in the bottom. Also, no normal swishing sound of water when the motor runs in any cycle. Looks to me like a mechanical break in the pump drive. How do I check the pump drive on this model? Do you have any


... KitchenAid Dishwashers

When dishwasher drains the water not all the water is drained. Some stays standing at the bottom and starts getting an odor after awhile. This is a replacement dishwasher in a 35 year old house. How important is the air release part in the draining situation? I was told by someone that the newer dishwashers have the air release part which was not hooked up on this dishwasher when installed last year. Are there some other possibilities of things that can be checked. Model Number is DU


... Whirlpool DU1055XTS Built-in Dishwasher

DISHWASHER NOISE I HAVE A HOTPOINT DISHWASHER MODEL HDA3420Z02BB SERIAL # TT813162Y. IT IS ABOUT 10 YEARS OLD AND JUST TONIGHT DEVELOPED A CLICKING/ GRINDING NOISE AT THE BOTTOM OF THE DISHWASHER. I REMOVED THE LOWER COVERS AND IT APPEARS TO BE COMONG FROM THE MOTOR AREA OR I GUESS THAT IS THE PUMP ATTACHED TO IT. JUST WONDERED IF THERE IS A PATTERN FAILURE WITH THIS MODEL AND IF SO IS IT FAIRLY EASY REPAIRED?


A noise could be created by something getting down into the motor-pump assembly piece of glass, piece of bone, wire tie anything really. If this is the case and you can remove it before it causes further damage problem solved. At ten years old the ... Hotpoint 24 in. HDA3400G Built-in Dishwasher

Whirlpool dishwasher part #3385181. Machine had gone thru wash cycle and was starting to dry. Smelled electrical burning smell, opened washer door and washer was filled with smoke. Turned everything off, cleared smoke, and the washer water dispenser is very hard to turn. Washer has symptoms of burnt up motor that turns water dispenser. Machine is 12 years old. With cost of replacement motor and possible part (pump?) that might have clogged and caused motor freeze up, is it worth fixing or junk


... Dishwashers

Kenmore Dishwasher Model #110703412 leaks, likely around the motor shaft. Are there motor shafts seals and how are they replaced? Does the motor assembly remove through the tub or does it require being removed from the bottom? Do you have to remove the dishwasher from the cabinet to do this job?


... Kenmore Dishwashers

Ge model # gsc3200j01ww dishwasher. when the door latch is closed, nothing happens. motor does not start. if the timer is advanced to the next part of the cycle, water will spray into unit until float valve is triggered. water will not pump out, motor does not start. bailed out water, checked for stuck float valve-ok. removed drain screens and filters, cleaned. no motor, drain, or start. what parts should i check? always rinsed dishes before putting in washer. unit is portable or undercounter


... GE 25 in. GSC3200J Built-in Dishwasher

My KUDD01DPPA KITCHEN AID DISHWASHER BOTH TOP AND BOTTOM DRAWERS have red lights on in the front and the pumps keep pumping . Is there a flood switch that needs replacing? im a plumber by trade. So im very capable of replacing any of the parts.


... KitchenAid 23 in. KUDD01DPPA Stainless Steel Dishwasher

Water will not drain out of bottom of dishwasher.It will go through the whole cycle but will not drain. This is a Frigidaire model no.FDB510LCS3 Serial no.is:noth70219331.Pump hose was disconnected and drained completely,dishwasher was put through another cycle and still ended up with water puddled in the bottom!! Could this dishwasher be called a lemon??? Does the pump need replacing?? I have noticed on your website that many others are having the same problem.To me it appears that it may be sh


Check the input to the drain hose to make sure it is not blocked by something like a cherry pit.  That could cause the water to not drain fully. ... Frigidaire 24 in. FDB510LC Free-standing Dishwasher

I have a McCulloch model number FHH18A/FHH20C. The brass fitting that comes out of the pump has broken. It's brass and plastic. McCulloch claims there is no replacement part, except to purchase a new pump and motor. Is there any after-market check valves that would replace this fitting/valve?


... Pressure Washers

Asko 1375 unit will not wash drains and fills ok  motor at back of unit runs well. Suspect impeller   Does motor have to come off for impeller replacement?? My 1375 is leaking a bit, looks like the seal which was mentioned in the impeller repair case,may be the problem? The other problem I noted was a clogged screen at the bottom of the dishwasher which is on the suction side of the pump, the screen had calcium buildup etc. I cleaned it off with vinigar and reran the dishwasher seemed ot fix th


Do you mean to say that the washer does not go into the wash cycle at all, or washes poorly?An answer to both can be found HERE.This article ... Asko 1375 Dishwasher

Miele Dishwasher Model G1040, Type HG03, NR: 32/65143704 The machine is three years old. The cycle reaches almost to the end, then all three LEDs merge together, and the pump runs continuously, even with the master switch off. I have taken the machine out and removed the base plate. When I first took the machine out of its position, I tipped it backwards and water came out of the bottom. All hoses and parts in the bottom section seem perfect in every way but the inside of the bottom plate indica


... Dishwashers

Our GE model GSD4320Z00B is having a problem with the drain system. I've run the unit in the test mode and it does pump the dishwasher down. The problem is the unit does NOT pump down during a normal wash cycle. The fact that the unit works in test tells me it is not the pump. I've checked all the hoses and drain paths and there are no obstructions, again verified by the fact it works in test mode. Any test that can be used to determine the problem besides replacing parts one by one?


... GE 24 in. GSD4320Z Built-in Dishwasher

Maytag dishwasher model # DWU7402AAB leaking around pump motor shaft. How do I replace the motor shaft seal> do I have to remove the motor to accomplish this?


Hi,Here is the part and they will have instructions with the part.....http://www.partselect.com/PartDetail ... Maytag Dishwasher

We need to replace pump on dishwasher - Model PLDB998CC0 Part#5304463777 wE BOUGHT THE PART, BUT DO NOT KNOW HOW TO INSTALL. CAN YOU HELP?


Which pump is it drain or circulation pump. \015\012also just a thought now that you have saved some money on getting the part yourself,maybe you can call 10 repairmen and tell them how much to install only the pump.which ever has the lowest pr ... Dishwashers

When I press the start button, Bosch dishwasher (model SHY56A 05UC) just keep running the motor pumping the water out of dishwasher, irrespective of: 1) the wash cycle it is on, 2) whether the door is closed or open, 3) whether I cancel drain cycle, as told by Bosch Cust Svc in following steps: - "Cancel Drain" by pressing 'Quick Wash' and 'Regular Wash' buttons together for a minute until it shows 0* - Shut power off for a minute and wait for a minute - Restart on Quick Cycle. Paid


What is happenig i believe and has happened to me 2 times is that the water level float that is on the left side of dishwasher is stuck.\015\012\015\012Either remove side panel and flick lever or pull dishwasher out and tap lower portion ... Bosch SHY56A02 / SHY56A06 Built-in Dishwasher

I have a Kenmore Elite dishwasher (model 630.17303406) and it just stopped working. Doesn't drain what's left in the bottom and just makes a humming sound when turned on. Power is good, sounds like the motor is working. Doesn't seem like it is drawing water in. I want to check the pump and motor, anybody have any advice?


If nothing obvious like blocked / obstructed outlet pipe\015\012You need to check if the outlet pump motor in line with the outlet hose is spinning when in the outlet mode. First check if it is spinning by looking at it and see if the small fan ... Dishwashers

Our GE GLD5900 dishwasher's coarse filter, the large filter on the bottom ,is warping up. this allows food and other particles into spray arms which then fail to circulate. I don't think the fact that it is warping up is good for the pump eitehr since harder particles are not going into the sump for grinding at end of each cycle but circulating though pump. Although this part is cheap, shipping is not, andi I replaced it last year. the new one warped up as well a few months later and is no lon


I found the fix! I have a GHD6711N10, with the same problem. I was in Lowes Edmonton and found a GLD6964R10 dishwasher (same parts,looks identicle,different option on panel) with a steel coarse screen and silicone seal on it, plus the sump intake wa ... GE GLD5900NWW / GLD5900NBB / GLD5900NCC Dishwasher

I have an Asko DW 95.2 model 1706 dishwasher that keeps filling with water. Every morning and evening, the whole bottom of the dishwasher fills with water. What is the solution? Do I need to replace the water inlet valve? If so, what is the part number?


... Asko Dishwashers

I have an Electrolux dishwasher model EIDW6305GS1. It's been broken 3 times in a year! The error code 03 is on now, meaning that the wash pump is bad. How hard is to replace this part? How long should this part be expected to last? This machine is only a year and a half old. Thanks


... Electrolux EIDW6105GB 24 in Builtin Dishwasher

NEED TO REPLACE PLASTIC COVER AT BOTTOM MIELE DISHWASHER MODEL 870SC (PART NO. 4214881 TFSW)G


... Miele Dishwashers

We have Bosch model SHE44C02Uc. The motor seems to run for more than 10 hours, even though the indicator is on "0" minutes. Our dishes are cloudy, there is food always on the bottom, the filters have been cleaned -as much as we can get them clean of calcified dishwashing detergent.


Can you tell me how you can allow this to run for 10 hours ????? Are your sure you mean ten (10) hours?\015\012What in the world are you thinking while this is going almost half the day ? And then you say everything is still dirty.... somethi ... Bosch 24 in. SHE44C02UC / SHE44C06UC / SHE44C07UC Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.2790 seconds