Having problems with your Kenmore Dishwashers ?

363-14074790 manual Spray arm removal


Answers :

Repair Help & Product Troubleshooting for Kenmore Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have a frigidaire dishwasher - model number PLDB998AC1. There are two spray arms in this dishwasher - lower and upper. The lower works fine but the upper spray arms are not spinning. There is what I think adequate water pressure coming in from the top but no movement on the upper spray arm. Here is what I know: 1) The water pressure and spray arms alternate between top and bottom. 2) The upper spray arm moves freely when I push it gently. 3) I have removed the pump and cleaned out an


... Frigidaire 24 in. GLD2162RDC Stainless Steel Built-in Dishwasher

Kenmore BuiltIn Dishwasher Stock 17512 Model 17512200 Type 575-0 Serail FM3309375 Probelm: Water sprays out of lower arm weakly, and not out of upper arm at all. Action taken: Unscrewed the 4 screws holding down the item underneath the lower spray arm, and then the small item under that. Found major refuse from years gone by, removed, cleaned. Reassembled, same issue. I suspect I have to get 1 more level down, to the intake for the pump? found 2 screws to remove, but was not suc


... Dishwashers

My kitchenaid dishwasher leaves food particles on the dishes. There's supposed to be an "Ultra-fine filter" under the spray arm. Perhaps it is clogged, but I don't see how to remove the spray arm so I can check it and clean it. The owner's manual is no help. Can you tell me how to do this?


... KitchenAid Dishwashers

Hi I've inherited a Zanussi DA6142 Dishwasher from a recent house move. It was treated quite poorly by students who I suspect ran it without the filters in place. I've used a dishwasher cleaner and was able to pull out the lower spray arm and rinse out all the crud that was blocking it (small stones, food, plastic, pieces of glass, paper, etc) but I cannot for the life of me work out how to get the upper spray arm out. The PDF manual I've downloaded for this model says DO NOT remove upper spra


... Zanussi Dishwashers

AEG favorit 88010 VI. spray arm blocked message. The manual says do not remove spray arm and unblock with a cocktail stick. Any suggestions about how to clear it properly?


... AEG 23 in. Favorit 44070Vi Built-in Dishwasher

I have a KitchenAid Sculptura dishwasher and it have been leaving food particles on the dishes. I started to take it apart, removing the bottom spray arm. I can see a lot of old food underneath. I'm having a hard time removing the next piece. There is a 1" rubber nut with a screw in the middle. Is this the next step for removal?


Hi\015\012\015\012Thanks for using FixYa. Please post back with the model no of your Kitchen Aid Sculptura Dishwasher so that I can further assist you.\015\012\015\012\015\012Thanks\015\012Ryle ... Dishwashers

Dwu8402aae manual remove lower spray arm


... Maytag Dishwashers

Dishes all cloudy and spotty. Maytag Intellisense plus 1996 dishwasher. I have real hard water that leave white calcium build up. I can remove and clean all of the lower spray arms and filter. How do I remove top spray arm to remand remove deposits? The motor sounds good, hot water, fill ok. On the inside top of center of arm where it meets the center input connection there is gunk to remove. How do I get to it? remove arm? thanks


The problem is hard water. Go to www.dishwasherfilter.com. They have a new product out that solves this problem once and for all. It filters the water entering your d ... Danby 22 in. DDW399 Free-standing Dishwasher

Bosch she44c dishwasher. Dishwasher times down to 1 min and continues to run until until manually turned off. After further investigation the spray arm do not rotate during cycle. We have also noticed a decline in how clean the dishes are


Hello, Welcome to Fixya.. On bosch dishwashers the "1" is actually an error code and not coincidentally the reason it runs forever ( likely doesn't dry or clean well either right ? ). Here`s the most likely reason why it has detected the error... Eve ... Dishwashers

363-14074790 manual Spray arm removal


... Kenmore Dishwashers

Upper spray arm is not turning and I don't think water is coming out. Dishes on top are not coming clean. Dishes on bottom are clean (as clean as they get with this dishwasher). How do I remove upper spray arm. Also I'm not sure how to remove lower dish rack to access upper spray arm. Any help appreicated. Kitchenaid model KUDP01FLSS5 Chris


Hi Chris,It sounds to me like a restriction in the pump. I put together some information here on cleaning it out. If you try these please give me some feedback as to if they help or not.Thanks! ... KitchenAid 34 in. KUDP01FLSS Stainless Steel Built-in Dishwasher

I have a Hotpoint HDA3500N dishwasher and need to replace the base spray arm. I can not get it removed to put in the GE replacement spray arm model #WD22X10055. I'm afraid I'll break my dishwasher trying to remove the base spray arm


... GE Hotpoint HDA3500N Dishwasher

I have a Hotpoint HDA3500N dishwasher and need to replace the base spray arm. I can not get it removed to put in the ge replacement spray arm model #WD22X10055. I'm afraid I'll break my dishwasher trying to remove the base spray arm


... GE Hotpoint HDA3500N Dishwasher

The disk washer doesn't drain at the end of the rinse cycle. There is a humming sound but no water is forced through the hose to the sink/garbabe disposal. At the end of the wash, there is a large amount of dirty water in the bottom of the washer. I removed the spray arms, the spray arm holder and the screen and then removed the water, and found a couple of pieces of plastic. But I don't see how I can remove additional parts from the washer bottom. What could the problem be? Is there a fi


Is the dishwasher drain hooked to the garbage disposer? If so is it new? If so did you knockout the plug in the disposer? If so then you either have something clogging the drain or pump. Or the pump motor is bad. ... Dishwashers

Makes grinding noise.spray arm on top not moving. spray arm on bottom barely moving. grinds when draining too. removed and cleaned out holes in bottom spray arm, didn't help, but found piece of black plastic/porcelain with rust on it in the lower spray arm that looks like it may be part of a bushing?


Very possible that it is a fin off the impellers or could be a bushing ... Dishwashers

Kenmore dishwasher model 665.16033401 doesn't drain well. Drain pump comes on but drain water only trickels out slowly. Obstruction somewhere ? Removed rotating spray arm inside to try & get at the place where the drain water enters pump. Can't remove any parts beyond spray arm. Home: 330-865-4813 Cell: 330-608-3022


... Dishwashers

Do not have any water being pumped into the upper arm spray bar. Removed and checked the feed tube assembly as well as the upper tube leading to the upper spray arm for obstructions and there are none. Also removed the ACCUMULATR and cleaned out the area.


Hi,We somehow got cut off, I am still around, we can chat here if that works for you. The link is here for the clean out ... KitchenAid Dishwashers

Removed lower spray arm of KitchenAid dishwasher and need to reinstall it. This installs over a spray arm nut that is a split ring. The nut goes over the outlet pump. I cannot get the nut to go over the outlet pump and then go inside the spray arm, which is 1/4-inch smaller in diameter.


... KitchenAid KUDS24SE Built-in Dishwasher

My Kitchen Aid KUDS01DJSS0 seems to have water going to the upper spray arm (I see water coming out of the unit just beneath the upper rack), but the pressure doesn't seem to be high enough to clean the upper rack. No evidence that water is coming out of the spray arm on the very top. Lower rack dishes seem to clean OK. I have already removed the whole upper spray arm assembly and inspected the flapper valves that the middle sprayer goes into. I suspect that it's not making good enough contac


... KitchenAid Dishwashers

I have a 13 year old Siemens SE64630GB. It isn't cleaning items in the upper basket and I believe it's due to lack of water pressure in the upper spray arm leading to little or no rotation of the arm. Have cleaned out the drainage pump and removed and cleaned both the water feed pipe to the upper arm (a lot of gunk in there) and the spray arm itself (which also had blocked nozzles) - no apparent blockages now. Could there be a blockage in the circulation pump and if so how do I access this pump


... Siemens Dishwashers

Model PDW8200J10WW Upper spary arm not spinning, dishes in the top tray do not get clean, usually have 'grit' on them. Took spray arm out and verified no blockage in the arm itself but can find instructions to remove the bottom spray arm and pump cover to check for items in the pump intake. Any thoughts??? Thanks...


... GE Dishwashers

Won't Drain I've removed and cleaned lower arm and drain in right corner. How hard to remove the upper spray arm? no parts to remove first? What's the float for in the left corner? ted


I think you need to clean the filter under the lower sprayer...I had to do that once and worked like a charm afterwords. ... Maytag MDB7100AWB Dishwasher

The top spray arm of my Frigidare model FBD4315LFC0 Aqua Surge dishwasher fell off. Their appears to be a missing part. I've been searching online for a schematic and can't find one thorough enough to use. The parts I have are: 1. The top sprayer arm (the one in the top of the tub) 2. The two piece plastic keeper ring that appears to fit into the top of the spray arm. 3. A small white grommet looking item that fit inside the keeper nut. 4. The keeper nut that screws directly onto the wate


Hello there:hey sorry i keep getting disconnected i will be back on really soon i need to find out what is going on i hope these things that i have discussed with you is helping you out the parts are not as hard as they look once yo ... Frigidaire 24 in. FDB435RFR Built-in Dishwasher

My Kitchen Aid KUDS01FLSS2 dishwasher does not spray water thru the wash arms nor do they seem to turn. Additionally, one of the the bottom arms hits the "cap, internal rear feed" where it clips to "feed tube assembly" when rotated by hand. The spray arm assembly appears true on visual examination. The unit fills, cycles and pumps out in an apparent normal way. While on this site a while back I was advised to clean the unit and referred to a downloadable repair manual that was, in fact, not


Hi.The fact that "one of the the bottom arms hits the "cap, internal rear feed" where it clips to "feed tube assembly" would suggest a tubing problem. However there are more faults that will result in no spray. Testing in this case can be ... KitchenAid Dishwashers

Noticed dishes on top shelf not entirely clean. Ran machine empty and opened many times during wash. Noticed that Lower Spray Arm works as expected, but Middle Spray Arm turns only 1/8 or less, then Lower Arm spins again. Schematic with Use and Care manual just says pump motor switches from one to the other in certain cycles, but I don't see this happening. Looked for obstructions to water flow and pressure seems normal. Is control for this function part of the pump, or in the control panel?


Something could be in that checkball, see page 5 ... Frigidaire 24 in. GLDB653A Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1126 seconds