Having problems with your Kenmore Dishwashers ?

Drain and fill hose assembly leaks at faucet on model # 665.17822000 dishwasher


Answers :

Repair Help & Product Troubleshooting for Kenmore Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Drain and fill hose assembly leaks at faucet on model # 665.17822000 dishwasher


... Kenmore Dishwashers

Kenmore dishwasher is leaking at drain and fill hose assembly


... Kenmore Dishwashers

My dishwasher leaks water from the top of my sink when in the drain cycle mode causing a mess on the counter top. How do I stop this leak? The plastic cover to the part which is located next to the faucet is cracked but there appears to be no leaks on the hose or on the part itself. Also, what is the purpose of this part? Is this the actual drain for the dishwasher and if so, why doesn't it tie directly into the drain?


... Whirlpool Dishwashers

I need the steps to change the hose assembly on my Whirlpool portable dishwasher. When I got it someone had cut the sink connections off so my son connected it to the water and drain with my washing machine which was in the kitchen. However, I have moved and want to use it as portable. I purchased the new hose assembly for the sink faucet, I just need instructions on how to take the dishwasher apart and connect the new hoses.....HELP PLEASE!


... Whirlpool 24 in. Portable Dishwasher Dishwasher

Dishwasher is model DWD1SSE type11045 Initially the dishwasher leaked water on the floor On investigation the bottom tray under the dishwasher was wet The motor was wet Tested the motor which was fine although the capacitor on the motor impellor was dead. Replaced capacitor, now no water going around the spray heads so found the impellor inside broken. Replaced that. No hoses are leaking. Machine now works fine heats up etc etc but over fills and the E5 fault shows


... Smeg 24 in. DWD1SSE-1 Built-in Dishwasher

I installed according to guide, but dishwasher will not fill with water. Pump sounds much too loud to be normal. Wiring was checked three times for correct connections. Water supply was checked twice for water getting through, no leaks and water supply on. Drain hose is connected correctly and is connected to house drain.


You state the water supply is on.\015\012Have you loosened the compression nut at the dishwasher ell to see if you have pressure to the water inlet to the dishwasher?\015\012Remember the dishwasher will always run a little to make sure an ... Whirlpool GU2400XTP Built-in Dishwasher

How can I shut off the water supply to the dishwasher? It fills slowly with water from the top (while not running), and then water spills out over the kitchen floor. By pressing the 'Drain' button, the water will drain out, but I have to get to it before it floods. It takes about 4 hours for it to get to the overflow stage. It is a Jennair model, about 9 years old. We have a lot of limescale, it is probably time to replace it, but for the moment my main concern is to stop the leak. Thank you for


Most water supply lines are attached to the hot water supply under the kitchen sink. If not it may be accessible from the basement somewhere under where the dishwasher is located. Regarding the issue with the dishwasher, the inlet water v ... Sears 24 in. 14181 Built-in Dishwasher

I have a Bosch dishwasher that is about 4-6 years old (model SHU8805UC/U12). A few days ago I found clear water in the tub hours after the wash cycle had completed. I drained the tub by resetting the cycle as instructed in the user manual, but the tub gradually filled up with water again after several hours.. will replacing the inlet valve solve this issue?according to what I can tell for my model the water valve assembly (part No. AP3783031) is the part I need. How difficult and expensive


Just pulled mine out last night. You have a different model but it should be the same. Remove the bottom dress panel and detach your inlet hose from the water valve assembly (have a rag handy to catch a little water). Two torx screws on the front ... Dishwashers

I have a Delonghi dishwasher model no. DW67S/W which is coming up with the E4 message. I had this once before and was told to turn it off and on and it righted itself. This time however I used the next bit of advice. I took everything out including the salt cap thing, tipped it on its side and drained all the water out, reconnected the hoses and when I turned it back on it seemed fine....no E4 messaage straight away. It drained out for a while and then starting filling. It has overfilled again


Hi.As you know E4 means overflow. If the problem occurs regularly there is either a problem with drain line, or a fault.Ensured that you have removed all the water from the inside and cleaned thoroughly the drain ... Dishwashers

Whirlpool Dishwasher Model #GU940SCGQ2 waste water from sink drain entering the dishwasher. Drain hose drains into same pipe as sin drain. Drain hose is elevated and looped as high as the top of dishw


... Whirlpool Dishwashers

I have a Kenmore Elite dishwasher (2004) and recently it has been leaking internally at a very slow pace. When not in use it will slowly fill until the floor of the unit is filled and then leak onto the kitchen floor unless we press the drain button and then it drains completely. The water seems to be coming from the front of the washer, potentially from the door itself. The amount of leakage is barely discernible but will fill over the course of a 24 hour period. The dishwasher otherwise wo


Hello,\015\012The water is admitted into the dishwasher through a little magnetically controlled valve underneath your dishwasher. This valve opens and shuts electrically. There is a little plunger in it that is pushed shut by a spring when no ... Kenmore Dishwashers

Miele dishwasher model# g868 could be 4 or u at end, customer complained water not coming into d/w ,when i got there water was coming in.for a few minutes then stopped filling ,drains fine, customer had not operated machine for a few days.i disconected the safety valve hose from under sink to see if water comes through does not when advancing cycle by hand, washes ok when water came in, thanks, Murray


... Dishwashers

The quick connect that hooks up to the faucet does not stay hooked up and leaks on our kenmore dishwasher model # 665.17822000 do i need a new hose and quick connect


... Kenmore Dishwashers

We have a Brandt Aa Class Dishwasher that will start and run the fill cycle for about a minute with the red operating light on but then stops and the red light goes out. I suspect it may be a timer related problem but can you tell me where the timer is on this model ? I have checked the filter and that the water supply and drain hoses are not kinked.


... Dishwashers

I have a fridgidaire Gallery dishwasher model # FDB949GFS2. It was not spraying water while running, so I checked for clogged wash arms and hoses etc. So I replaced the motor assembly and now I hear the motor running, it fills with hot water but it is still not circulating water. Is there something else I need to check. Thanks Tom


Most likely the wash sump is blocked. Refer this diagram. You will have to open the sump (item 14) and loo ... Frigidaire FDB949GF Dishwasher

Maytag dishwasher model MDB7609AWW2 has a blinking clean light. I followed the advice on fixya (thankya!) and by alternating the normal and heated wash buttons I was able to return the lights to normal. However, once I tried to run a normal cycle, it didn't do anything other than fill and drain. I then ran the hot water faucet in the sink until hot and tried another new cycle, but no luck. Any advice is MUCH appreciated!


... Dishwashers

Leaking dishwasher i have an 8yr old hoover dishwasher & it leaks on the rinse cycle. It's coming from underneath on the left hand side as you look at it. I've checked the hoses & clips on hoses, which seem ok. It only leaks as the water is coming into the machine on the rinse cyle. Never any other time, not even when it's filling for the wash cycle!


If your dishwasher leaks, check these:Main tub sealDoor gasket or sealWater-inlet valveHosesMain tub sealNote… If the main motor of your dishwasher is mounted vertically, beneath the center bottom of the dis ... Frigidaire 24 in. PLD2850 Built-in Dishwasher

Miele dishwasher makes grinding noise when turned on, there is a light on front next to inlet/drain. So I poured some boiling water into the dishwasher and then left it turned on and could feel the boiling water coming out of the drain hose so I am assuming it is an inlet problem, as it will drain but will not fill or otherwise work.There are a few small cracks in the outer hose of he inlet hose just below the grey box thing, could that be enough to cause the problem? They are only small so I di


... Dishwashers

Bosch SHU992SUC Dishwasher does not drain. It's not clogged in the external hose, the filters are not dirty. I moved the Dishwasher outside and ran it with the input attached to the garden hose and the output drain hose laying on the ground so there is absolutely no chance of restriction due to the way it's plumbed in. This model does not even show up on Bosch web site. I guess I have to start taking apart the machine blind with no service manual. Ideas? It's less than 10 years old I think. M


PUT THE MACHINE IN DRAIN MODE IF YOU DONT HEAR A HUMMING NOISE THEN THE DRAIN PUMP IS BAD. CHANGE YOUR DRAIN PUMP. ... Bosch SHU9925UC Built-in Dishwasher

My new Dishwasher Won't Drain, ehat to do? I have a GE model GSD2300N00WW dishwasher. A few days ago we noticed that it isn't draining. This dishwasher came installed in our new doublewide mobile home. There is no disposal, the drain hose isn't clogged, there is no air-gap installed, and the sink drains just fine. I have removed the filter and cleaned it (wasn't really dirty). Does anyone have any ideas?


... Dishwashers

Kenmore Ultra wash III will no longer stay connected to faucet after filling...what part should I replace the hose or the faucet adaptor? When we turn the faucet on to start up the dishwasher it falls off...when we finally get it to stay connected with water on...it will fill but then falls off again...get it to stay on, it empties, but then after it has completed filling up again it disconnects from the faucet.


If your adapter that hooks up to the faucet has 4 little white plastic jaws inside it then it can be rebuilt. there is a kit that replaces those 4 jaws, the spring, the attaching clip and the internal seal.. usually runs around 10 buks or so. if i wa ... Kenmore Dishwashers

Kenmore Tumble Action Washer, Model 417,44152400 LEAK! Leaky Door got progressively worse over a month. I replaced the boot and about 10 minutes into the first test wash there was a massive leak under the soap dispenser and down the hinge side of the door during a fill cycle that seemed to be going through the dispenser. This happened again during another fill through the dispenser. No leaks during subsequent fill through the boot hose, before the spin cycle and no leaks around the door


Any of those could be the problem. Theres no other way to diagnose and fix unless/until you open it back up. ... Dishwashers

I have a GE potscrubber Dishwasher Model # GSD3630ZZ3WW it has been leaking from the bottom for about a week. I took the bottom off tonight and ran the dishwasher so that I could see where it is leaking from. It is not a hose but the leak seems to be coming from the back of the motor or pump fan where it goes into that plastic housing that attaches to the bottom of the dishwasher seems to be leaking in the very center of that housing where the motor shaft enters the housing. Water is just spray


... Dishwashers

I have a Maytag mod # mdb7601aws and it seems to be leaking from the fill reservoir on the outside of the dishwasher tub where the hose from the valve goes into the dishwasher. as it fills the water and steam escape from the top of this resevoir and leak down on to the floor. Can you you suggest any fixes for this, is there supposed to be some kind of a lid for this?


... Maytag 24 in. MDB7601AWS Stainless Steel Built-in Dishwasher

Water leak I have water leaking from the second outlet where the drain hose connects to the dishwasher. The part has a rubber top and the water is coming out there instead of the hose to the garbage disposal drain. Is the part bad or is something else wrong.


... Tappan 18 in. MDR251RE Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.2764 seconds