Having problems with your Kenmore Dishwashers ?

Kenmore 5871414 fills but won't wash. spray tower not working.


Answers :

Repair Help & Product Troubleshooting for Kenmore Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Wont run I have a Kenmore QuietGaurd2 it will not run at all. It filled up with hot water, then it quit working. It wont even drain the water out or cycle. Nothing is happening, whats wrong with my dishwasher??


... Kenmore 24 in. 15992 Built-in Dishwasher

Kenmore 5871414 fills but won't wash. spray tower not working.


... Kenmore Dishwashers

I have a Kenmore model 587.1610 dishwasher that doesn't fill all the way when starting a load. I checked the float switch and it is working fine. The fill soleniod is also working fine and is clean. It just seems to time out before it fills all the way.also to compound the problem it doesn't seem to want to start all the wash cycle even after I have re-started the machine and it has filled to capacity. please help thanks Danny


... Dishwashers

I have an inglis ipu5846 built in dishwasher it fills thaen trys to start but wont start or drain now i took off the lower spray armthe part that is screw down under it tryed cancel drain and it worked put thetop bacck on but not the spray arm and it wont work.what stopping that from working there are not any moving parts on that piece


... Whirlpool Dishwashers

The salt warning light came on (red) and went to put salt in but noticed it was filled with water. I have filled it with salt now and the warning light has gone off but now when I try to select a program it wont. I have drained the water in the salt dispenser but it still wont work! Help!


What is the make and model of the item? ... Dishwashers

Kenmore undercounter dishwasher model 66517019400 wont start..I want to purchase a new control board do you think this is the problem? normal cycle light comes on, cancel button works, heat on button works, just wont start ??


It might not start because the water solenoid is failed, or the water level sensor is failed.\015\012\015\012You have to use a meter to test these components first. Put your voltmeter on the two leads going to the water solenoid, and psuh ... Kenmore Dishwashers

Kenmore How To My Kenmore smartwash dishwasher control panel wont work what could be the problem


... Dishwashers

I have a small 18inch Kenmore dishwasher with a #P/N 154435701 inside the door. It will not fill with water on it's own. I fill it by hand then turn the knob to the wash cycle. The following fills work fine. Doesn't seem to respond to the first fill message from it's program. Is there a replacement card or chip?


... Kenmore Dishwashers

Kenmore Dishwasher model 665.1675592 doesn't seem to wash as well as it used to. Seems to have a low water level. Filler valve works, allows water in, but never seems to fill enough. No spray reaches top shelf, I think due to insufficient water level. It's like the timer doesn't stay on long enough for it to fill. Also cycle time seems WAY up, but if the timer is slow, how does it time out filling so fast? Looks like it would be slow all the time. Suggestions?


... Kenmore Dishwashers

Kenmore elite dishwasher wont work


Remove the console panel with T15. then remove the cover from the main control board. top right of center of the main control you will see a removable fuse, either a black disc with a black and a black/w white strip connected. remove one wire from t ... Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher

My dishwasher Kenmore 665.13462k902 worked fine for a little over a year, now it wont even start. At first, the high temp button wouldnt light, then no lights until you pushed start...tonight, nothing works...any help?


... Kenmore Dishwashers

Wont drain.water filled,never washed,then wont drain.I can hear motor for few seconds when i press drain,a click noise,then nothing.I cant remember the reset sequence.I have the kenmore ultrawash quietguard plus.thank you


... Dishwashers

My dishwasher Kenmore 665.13462k902 worked fine for a little over a year, now it wont even start. At first, the high temp button wouldnt light, then no lights until you pushed start...tonight, nothing works...any help?


... Kenmore Dishwashers

My dishwasher is a GE, it wont fill up with water, but when i fill it up by hand it works fine, what would the problem be


... Bosch 18 in. SRS45E02 / SRS45E08 Exxcel Slim-Line Free-standing Dishwasher

Kenmore dishwasher model#587.15142400 It sounds as though it is working, but nothing is working. It does not fill with water and the the water dispenser does not rotate.


... Dishwashers

My Kenmore Ultra Wash 2 portable dishwasher is not filling with water, is there a screen or filter that could be dirty? It worked fine yesterday and I can hear the motot running, but it does not fill. ( I did make sure there is water to the faucet, lol)


Check the solenoids on the water inlet valve. Often when they fail they get extremely hot and melt the outside housing. These are cheap to replace and can be done easily. I recommend contacting TheRepairClinic.com and using the online help feature to ... Dishwashers

Fills ok wash ok at 156 degrees goes into rinse cycle dont seem to have much water comming out shows 0 degrees rinse temp. screen is out so thats not clogged have separate free standing electric heater piped in has been working fine for 5 years that way dont understand 0 degree water temp. on display any help would be great thanks for your time joe


... Hobart AM14-253 Free-standing Dishwasher

I have a GE diswasher model # GSD3900L00BB, the top part of the washer tower broke off and I can't get it reattached. My dishes are not as clean. The rinse agent wont work and some of the detergent in not getting rinsed all the way out of the dispenser. Could all this be cause by the broken water tower? What do I do?


... Dishwashers

Kenmore dishwasher model #: 15829000 It will fill & heat, but won't run/wash on any cycle. I was told the motor may be frozen or jammed by an object, but am not sure how to get to it. I assume i have to remove the lower spray arm assembly? Could there be another reason? This happened before, but it began working fine again a day later. It has worked fine since for almost a year now.


There should be a 665. xxx etc as the model no. before teh 15829000 that you have mentioned.\015\012Will need the full model no. of your dishwasher in order to give you some solutions for the problem. If you are not hearing any sound at the tim ... Dishwashers

I have a Kenmore dishwasher, model 665.16039. Over the past month (we were on vacation 8 days over Xmas, but I assume it would have happened then, too) it has required rebooting using the Normal Wash - Heated Dry reset about 4-6 times. It would then do a couple loads okay, then need resetting. Now, however, it's refusing to reset to a point at which the Start buton will work. When I reset it, it flashes all the lights (incl. Start), and it fills, sprays, empties, etc. just as though it works


Make sure there is no water damage. ... Kenmore 24 in. 16039 Built-in Dishwasher

My masterclean 4000 has been making very loud noises and now it wont finish draining from the last load and when i tried a new load it wont work at all. a water filling soound happens for abt 5 seconds then absolutely nothing happens at all. what do i do?


... Amana 24 in. ADB1500AWS Stainless Steel Dishwasher

My Kenmore Portable Dishwasher model number 665.17769K600 will not fill with water, I have to manually fill with water and it will then work. What could be causing this?


Hi\015\012\015\012\015\012\015\012When the\015\012Dishwasher is not filling in, you'll need to check for the water inlet valve,\015\012the filter screen and the float switch/assembly. Also check ... Kenmore Dishwashers

SIEMANS DISHWASHER wont fill with water on any prog but works when filled manualy


... Siemens 18 in. SF25A061 Slim-Line Built-in Dishwasher

It just wont work! it fills then just humms


Pump motor probably bad ... Bosch 22 in. SKT5108 Free-standing Dishwasher

Kenmore dishwasher mod # 363.14375791 hums, wont fill or run


Are you sure the valve is what is humming? If so, it may have went bad again. Its not unusual for that to happen. You could possibly have a timer going bad, or a ground issue. If it is the valve humming, check your water supply, and be sure you d ... GE Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1262 seconds