Having problems with your Kenmore Dishwashers ?

Cant find drain button

\015 Where is the drain button located so I can drain the water in the bottom of the dishwasher?\015

Answers :

There usually isn\\'t a drain button, when the washer is done it drains the water, either you have a clog in the bottom, in the hose, or the drain pump is bad or blocked.
Read your manual to see how to check bottom screen and clean it.
If you need more help, make a new post with the make and model number, make sure you post the full and correct model number.
Repair Help & Product Troubleshooting for Kenmore Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have a kenmore ultra wash mod# 665.13492k600 dishwasher that in the last couple of days will not drain the last cycle . If you push the cancel /Drain button after the cycle is finished it will then drain but all the dishes have soap spots on them and are very wet .I have checked for clogs but cant find any I have also run a lot of water throug our waste disposla because the dishwasher drains into it help ??


... Kenmore Dishwashers

Cant find drain button


There usually isn\\'t a drain button, when the washer is done it drains the water, either you have a clog in the bottom, in the hose, or the drain pump is bad or blocked.Read your manual to see how to check bottom screen and clean it. If you ... Kenmore Dishwashers

Dishwasher fills with hot water. Float OK - water feed stops when full. Motor humms but no water spray (in all opperating modes). Cancel selection (with cancel button) and close the door. The water drains then the unit shuts off. Water feed OK. Drain Cycle OK. Looks like spray pump hung but do not know. Cannot find a reset button (as with disposal) or way to free hung pump motor. I did see glass pieces in the drain. Possibly a small piece hanging the motor.


If you found broken glass inside the machine some has likely migrated to the pump. about the only way to fix that issue is to remove the pump and either replace it or disassemble it and clean it out. ... KitchenAid 24 in. KUDP01FL Built-in Dishwasher

MY TECHNIKA DISHWASHER WONT DRAIN THE WATER SO IT STOPS HALFWAY IN THE CYCLE. THIS HAPPENED BEFORE AND THE TECHNICIAN MAUALLY DRAINED IT BY PRESSING A SERIES OF BUTTONS AND IT WORKED FINE. WHERE CAN i FIND OUT WHAT BUTTONS TO PRESS TO DRAIN IT MYSELF. THANKS


... Dishwashers

It went thru the whole cycle and when I opened it up - there was water still left in the bottom - hit the cancel/drain button and nothing happened. Unhooked the drain line to the drain pipe under the sink and no water came out. How do I find out if it is the pump ? If I take it out - what do I need to look for and what trouble shoot things do I need to know. I live about one hour from the nearest town - so I would like to find out the problem - before I call a repairman and maybe fix it myse


... Kenmore 24 in. 17462 / 17464 / 17469 Built-in Dishwasher

My Whirlpool dishwasher will wash fine, but when it drains, it's a slow trickle. I've snaked the line from the sink to the washer, but I can't find a clog. If I try to blow into the drain pipe all I accomplish is almost passing out. I can't blow all the way through it. When I hit the drain button, I hear the solenoid kick on with a rattle, then just a hum. Like I said, I just get a trickle, and the basin never drains completely. It's driving me crazy! Help? Thanks.


Ok, don't fret too bad, help maybe just reading.Disconnect the drain hose from the sink/garbage disposal, get a big bucket, stick hose in bucket, making sure that end of drain hose does not get lower then the bottom of dishwasher. Turn di ... Whirlpool 24 in. DU1055XTPS Stainless Steel Built-in Dishwasher

My Whirlpool dishwasher will wash fine, but when it drains, it's a slow trickle. I've snaked the line from the sink to the washer, but I can't find a clog. If I try to blow into the drain pipe all I accomplish is almost passing out. I can't blow all the way through it. When I hit the drain button, I hear the solenoid kick on with a rattle, then just a hum. Like I said, I just get a trickle, and the basin never drains completely. It's driving me crazy! Help? Thanks.


In the bottom of the dishwasher, there is a screen. Remove it and clean it and the drain underneath it. Make sure the POWER IS OFF before you start. ... Dishwashers

I have a model 665.1576 or 1676 my paperwork does not have the number on it and no part number on he machine, but I ordered parts from the catalog which matched. about 7 years old, stopped draining, so I changed the Seal kit, pump base seal, impeller, plus drain cover gasket but not the pump gasket could not find it, reinstalled, pump works but much slower and times out, have to hit drain button to get all water out. Keith


... Kenmore Dishwashers

Its happened before i have a kud101flss6 diashwasher and something trips the computer a repairman came and pressed a sequence of buttons on panel and fixed it cant find repairman and cant remember sequence help


Usually an interruption in the dishwasher program results in a blinking "Clean" light. This commonly indicates a component problem or program malfunction. If a\015\012component is defective, it's usually attributed to the heating cycle or\015\012the ... Dishwashers

I have a bosch SHV43A03GB dishwasher. It has a problem when it cut out water flow in. the guy who repairs it seem s only to have to push a button or switch under the machine to get it to work again, cant find switch/ button- please help!


Programmer not working ... Bosch 24 in. SHU53 Built-in Dishwasher

Hotpoint fdw70 error code A10 have replaced the inlet water valve but still have an error code flashing A10 hoped to find a reset button but cant find it anywhere can u possibl advise.


... Hotpoint 24 in. FDW60 Free-standing Dishwasher

Just installed fisher paykel model 88270 dishwasher, bottom drawer has no power,and top drawer does not fully drain. Cant find another power cord, is there a second one? Cant locate the manual.


... Fisher Dishwashers

I have a ADP5000MT, when I start a cycle it begins but after 5 mins switches to the bottom option - the =30''V symbol button and keeps flashing .. I cant find my manual


CODES: The Express program light Keeps flashing quicklyMEANINGS: Longer inlet timePossible Cause: Faucets is not opened, or water intake is restricted, or water pressure is to low. ... Whirlpool Dishwashers

The dishwasher stop during the wash cycle. It did finish draining the water from the tub. The machine is not showing a power signs, I check the circuit breaker and the fuse is not tripped. I open and closed the door and the door latch seems to be working fine. There is just no power to the washer. Usually when a machine breaks down, there still is power or buttons that light up on the front of the machine. I looked on the internet and many say that the fuse could be tripped. No where can I find


... Whirlpool DU912 Dishwasher

My Whiripool gold (Model Number)gu1200xtkso Does not drain - Everything else works fine but when the cycle is over the water is still Present. I dont know how to unscrew anything. I cant seem to find what to take off.. seems in possible to even check help....


... Dishwashers

Kenmore 665.16762000 We were washing dishes the other night and my husband walked into the kitchen to find water pouring out of the "air gap" in the sink. Now we cant get the unit to come on. Ive tried some of the various combinations of button pushing to re-set, but so far still not operating. I am thinking it may be the "thermal fuse" due to some other questions here, but how can i confirm.... and the biggest question... how much is that gonna cost me to replace if i do it myself?


... Kenmore 16762 Dishwasher

My last rinse cycle did not completely drain. I have about 1 inch or so of water in the bottom of my dishwasher. I tried to restart the washer, but it will not turn on. I looked for some type of "restart" button, but could not find. My washer is not 4 months old.


... KitchenAid KUDS301V Dishwasher

How do i clean the drain or screen at the bottom im getting an odor cant find the manual


Hi,Here is a tip that will help you with how to clean that dishwasher up and get it smelling good again... ... Frigidaire 24 in. FDB1050REC Stainless Steel Built-in Dishwasher

Seems my drain is plugged on my dishwasher it is the magic chef 4500b unit and i now have water all over my kitchen floor. i cant seem to find the product du4500b  so i entered the du2000 , either way there is water on my floor and about 4 inches of water in the bottom of the dishwasher


Ok there are several problems this can be caused from...1. there is usually a float device (I'm not sure about this model) that floats up and turns the water flow off when an appropriate amount of water is injected into the DW...sometimes these ... Magic Chef 24 in. DU2000 Built-in Dishwasher

Not starting Hello, I don't want to seem blonde......But i am staying at my mother in laws while she is out of the country and i cant find the start button. I know it works because there were clean dishes in the washer. I loaded it added the soap, locked it now how do i start it?? Please help


\015\012Getting Started\015\0121. Load dishwasher (See Preparing and Loading Dishes).\015\0122. Add detergent (See Dishwasher Dispenser & Detergents).\015\0123. Add rinse aid, if needed (See Rinse Aid).\015\0124. Cl ... Frigidaire 24 in. FDB1050RE Built-in Dishwasher

FDB105OREC4 My dishwasher is not cleaning my dishes. I push the start button and water seems to be trickling in then it stops and no sounds protrude from the machine for several minutes. Eventually another loud motor seems to turn on and drain the water out of the machine. The soap dispenser usually opens and the soap block that usually dissolves is setting on the bottom of the machine. It seems the water is plenty hot but the rotating washer arms might not be moving. Please help me find the par


... Frigidaire 24 in. FDB1050REC Stainless Steel Built-in Dishwasher

Belling Dishwasher IDW450. When turn on power button it starts bleeping. About 25 times. The you can select your program, it sounds like it is draining but then doesnt do anything else. Cant hear any water running in. I have turned the power off and back on. Water is connected


When you say you have turned the power off and back on. do you mean the switch on the appliance. if so turn off the power by removing the fuse from the fuse panel for the dishwasher. wait about ten minutes, put the fuse back in and see if that res ... Belling 24 in. IDW603 Built-in Dishwasher

I have just aquired a Proline Logic dishwasher DWF1250 P but have no manual for this. I have no idea what all the symbols under the buttons mean so I dont know what wash to put it on. Please can you help, I cant find a manual to print. Thank you.


... Dishwashers

I have a smeg d1612cah intergrated dishwasher I am trying to find a reset button as it is not getting anywater into it, It happened after a plumber called to fi a problem with a radiator and drained the whole system and turned off the power.


... Dishwashers

My asko D3531, has a problem. The message panel is blank. When I turn it on, it sounds like it is draining, but there is not water in the tub. I cleaned the filters and didn't find any obstruction. When I press the start button for 3 seconds as directed in the manual, nothing happends. I can't get anything to come up in the LED display. Please help.


I have the exact same problem - Cindy did you ever figure it out? Please let me know.Thanks ... Asko 24 in. D3530FI Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0710 seconds