Having problems with your Kenmore Dishwashers ?

On my Kenmore Ultra Wash dishwasher, my top rack is not set rightand I don't know how to move it out to fix


Answers :

Repair Help & Product Troubleshooting for Kenmore Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

On my Kenmore Ultra Wash dishwasher, my top rack is not set rightand I don't know how to move it out to fix


... Kenmore Dishwashers

I have a Kenmore Elite Ultra Wash Dishwasher 665.1319 and it uses all of the rinse aid added in 1 day. The setting inside is set at the factory set of 2. Any suggestions on how to fix that?


... Dishwashers

My BOSCH SD14R1B starts humming loudly midwash is there a fix for this as we take good care of it and has never done this before, to stop the humming I move the wash setting forward, but then sometimes starts again. I have noticed it also does it in Heatin/drying setting.


... Dishwashers

My dishwasher so my dishwasher seemed to have quitworking during a cycle. like breaker triped or something. i checked the breaker and thats fine. it seams like its hard wired in though. Would that be right? and is there a fuse or something that could/would blow during a wash? I dont know what model it is or anything it was in the house when i got it. The dishwasher is built in and it seems decently old its a kenmore ultra wash and it has like 10 buttons for the differend cycles on the left and a


Sounds like the fuse on the control blew. you can replace the fuse for\015\012around $20 or you can cut and splice the wires for free. If that doesnt\015\012work then you may have a loose conection in your junction box under the\015\012dishwasher. ... Kenmore 24 in. 15932 Built-in Dishwasher

My smeg dwi 710 dishwasher keeps flashing on the diplay panel and won't change to another wash selection. it wont close and wont start. the light is stuck on the heaviest wash selection and just keeps flashing on and off and on and off. i have tried turning it off, keeping buttons held down and nothing seems to work. there is nothing in the manual that says what the flashing means so i dont know how to fix it.


... Smeg Dishwashers

Have moved into a house with a Bompani Antilla BO 02014 model dishwasher. There is a control knob on the right hand side with settings and it seems like it controls the time the dishwasher is on (similar to top load washing machines). I do not know which settings to use or what they mean. Can you help? Thanks Terry


... Dishwashers

We just moved in to a new house and the dishwasher's spinning piece was dismantled. We dont know how to set it up and we have a few different pieces that dont really match. please help! Thanks


Hi Lorainne.. You ,may be able to get the user manual at this link http://www.fisherpaykel.com/global/customer-care/product-manuals.cfm ... Fisher and Paykel Dishwashers

When I set it to normal wash it takes more than a hour to finish I also press all the other settings dry heat, sanatizer. dont know if I'm doing something wrong


Every setting extends the wash time. You only need sanatizer if your doing a lot of baby bottles. The normal cycle with the strong dishwasher detergent will kill all bacteria anyway. The dry heat extends the time even longer and uses more hydro. Just ... Frigidaire 24 in. FDB1050REC Stainless Steel Built-in Dishwasher

Dishwasher instructions I dont know what setting to use on my dishwasher, it is taking too long to wash and dry


Hello, welcome to Fixya.\015\012\015\012Typically the "normal" wash cycle should be sufficient and take anywhere from 60min to 120min. under normal conditions. ( Though 120 mins is quite long and should only occur if you had ... Bosch Dishwashers

We have just moved in to a house with a built in Zanussi Dishwasher ZDI 6041, the letters have rubbed of the control dial and in 2 weeks have not had a successful wash, as we dont know where to position the dial


... Zanussi 23 in. ZDI6041 Built-in Dishwasher

I have a Bosch DLX Series (SMU4092UC/14) dishwasher that I can't use because the detergent dispenser doesn't open automatically during the wash cycle so the dishes only get sprayed with hot water but no detergent. Is there a fix for this? Or is it time to get a new dishwasher? I know this one is old since I've lived in my house over ten years and it was there when I moved in.


... Bosch Dishwashers

Prima lpr601 problem- filled dishwasher up sa normal set the wash pressed button on far right (dont know what it is but needs to be done), closed door and loud raattling so i opened door to make sure all spray arms were clear which they were, closed the door , again the rattling . now the green light has gone out on far right and cant get it back on so program wont start at all. Any advice?? please help


... Dishwashers

I HAVW A WHIRLPOOL MODEL #DU1055XTSB2 AND I DONT KNOW WHAT TO SET IT ON TO MAKE IT CHANGE CYCLES AND NOT JUST CONTINUE TO WASH


Did you find the problem ... Whirlpool Dishwashers

We just moved to a new place and the dishwasher we have is a Kenmore Ultra Wash III portable dishwasher. We have no clue how to use it and can't find the model #. There is 5 cycle options and settings on the front and a plug in and nozzle with a red button on it. Please help.


The model number will be something like 665. 15xxxxx branded on a plate located in the left side of the dishwasher door inside.Please check this site to see if the manual shows the controls on your dishwasher. ... Kenmore Dishwashers

MATSUI DISHWASHER MS160SL. IT STICKS HALFWAY THROUGH THE WASH PROGRAMME. IT IS NOT GETTING HOT. DONT KNOW IF ONE PROBLEM IS CAUSING THE OTHER IE IF THE ELEMENT NOT HEATING IS CAUSING THE PROGRAMME NOT TO MOVE ON.


I have the same problem and have found that it is caused by as you suspected a burned out heater element. they can be purchased on the web for £15.95 at partmaster .co.uk ... Dishwashers

I actually don't know what type of Bosch I have. I know that is a problem, but maybe you can still help. It has a simple panel that says: Pot Scrubber, regular wash, quick wash, rinse and hold. When I turn on quick wash, sometimes it says 38 min. 45 min. 56 min. We want to keep it at 38 minutes and we don't know why it varies. If we have to open it mid-cycle, it switches to a higher cycle time. How do we set it for 38?


On a Bosch dw, it has a light sensor to sense soil in the water.. if the control feels that the water going through the sensor is not clean/ or clean it will add or minus time..one thing you can do is make sure that your drain line from dw to sink dr ... Bosch 24 in. SHU43 Built-in Dishwasher

I have a whirlpool ADP 451 dishwasher have just set it for its first wash on the normal setting and it moved itself on to the pre -wash. Have read the manual and can find no explanation.


... Whirlpool Dishwashers

Top arm does not turn in most of gibson amana an frigidaire this is done by ball in bottom of pump .it is clean.spray arm are clean .bottom arm move all the time.timer works it hesitates every so often and so ball will move an water should go up to upper arm but doesnt.common problem on these units but dont know how to cure?change ball.didnt work..on one unit changed pump cure problem for 4 months then returned....also does anyone know were u can buy the plastic they used to sell for dishwashers


Can yo give me the make and model number sol I can look at the service manual for you? ... Dishwashers

Hi, I have a bosch SGS43E02Z dishwasher that dont seem to wash clean. It would seem that some times the presure from the spinning washers arnt working well enough as it dont even move rice from plates stacked next to each other. i have checked all filters inside the machine and if you start a wash program the sprayers work and the water is splasing. please help with sugestions.


... Bosch Dishwashers

I just moved into a house that has a Maytag Quiet 300 dishwasher. After about 2 weeks, I'm hearing a VERY loud, almost grinding noise about 6-7 minutes into the wash cycle, then again near the end of the wash cycle. It sounds like a motor thing and I'm hoping to avoid a repair bill right now, the cost of the move wiped us out. Is this something that I can fix, and if not, will continuing to run the dishwasher with the noise kill it?


You can continue to run it. it may correct or else it will get worse.......then u can get back and i will help u decide what to do ... Dishwashers

Several people have posted this problem with the Frigidaire Ultra Quiet 111, but I have seen no solutions. When it is set to wash without extra heat, it cycles normally. But when the extra-heat wash and extra-heat rinse are selected, then it gets stuck first mid-wash at the 7 o'clock position, and if it is manually advanced then it gets stuck again during the rinse cycle just before the 9 o'clock drying position. Both the wash and rinse thermostats have been replaced without solving the problem.


Hi,\015\012\015\012I know that you are going to think that this is dumb... but the only thing that it can really be is the timer....\015\012\015\012 ... Frigidaire 25 in. FDP750RC Free-standing Dishwasher

DWI612C wash cycle runs on and on and on. Believing to be a problem with water heating I tried putting a couple large pan fulls of boiling water into machine during wash cycle and this did move it on from wash to rinse. How do I replace the heating element I cant see it it is not in the dish washing compartment? I dont want to call out a repair agent as one can probably buy a new machine for what that will cost. Thank you.


... Smeg 24 in. DWI612 Built-in Dishwasher

My dishwasher get's stuck during the cycle and just keeps washing. If I dont move the cycle on manually it will wash and wash for hours!! Can any one help??


This is probably heating issue. The cycle will not advance if the water is not up to the proper temperature.Next time you run a cycle, open up the door after a few minutes. A large ball of steam should roll out of the machine. No steam = ... Whirlpool 24 in. ADP5962 Free-standing Dishwasher

LG LD-1403 dishwasher making a whirring noise in wash. think it might be the wash pump but how do I know. If it is the wash pump. How do I fix it?


... LG 24 in. LD-12BW5 Free-standing Dishwasher

I have an SDMO generating set with a Mitsubishi S3 L2SD engine it is supposed to run at 1500 rpm but goes up and down depending on load, if I set the rpm at no load to 1500 as soon as a load is applied the revs drop and so do the cycles from 50 to perhaps 48, if I set the revs on load, then off load the revs go up and the cycles hit 53 plus which means for example my washing machine does not want to know, I suspect the govenor on the pump but do not want to change the pump if this is within para


Set the no load revs such that you get 51 Hz out of the generator, at 80% load this ought to give you something like 48.5 Hz with less than a 3% drop in output voltage. If not, you might have governor problems but I'd try servicing and adjusting it b ... Karcher 2500 PSI Pressure Washer
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1347 seconds