Having problems with your Kenmore Elite 24" Built-In Dishwasher with Ultra Wash HE ?

Bad squek when opening door - Kenmore Elite 24" Built-In Dishwasher with Ultra Wash HE


Answers :

Repair Help & Product Troubleshooting for Kenmore Elite 24" Built-In Dishwasher with Ultra Wash HE

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Bad squek when opening door - Kenmore Elite 24" Built-In Dishwasher with Ultra Wash HE


... Kenmore Elite 24" Built-In Dishwasher with Ultra Wash HE

I have a Sears Kenmore Elite Ultra dishwasher 665.1315 model. For the last 3 weeks, it keeps having the clean light blinking 6 times pause then 1 blink and pause and repeats cycle again. I have turned off the breaker...I have reset by pressing the heated dry and normal wash until all lights are flashing. It then completes some type of cycle and looks ok. When I opened the door, steam came out and all was hot inside. However, once I try any new wash cycle, it seems to wash but after 1-2 hours and


Call sears service and tell them you need service there is a service flash and will be no charge ... Kenmore 24 in. 15932 Built-in Dishwasher

I just bought this house with this dishwasher built in. I have pushed the door shut, pressed the heat dry button to lock the door and pressed the start button. Nothing happens. Now I can't even get the lights on front to turn off. The lock button flashes as though the door is open, but its not as far as I can tell. I have to press the latch in to open the door. I'd like to use it... any ideas. Its a Kenmore Elite model # 665 17052 402. Thank You


... Kenmore 24 in. 17052 / 17054 / 17059 Built-in Dishwasher

We have a Kenmore Ultra Wash Dishwasher, several years old. The lock light went on yesterday and we could not put it on wash or anything. We hit cancel, unplugged the machine, left the door open so it would stop the cycle...nothing worked. How do you get the lock off when it goes on like that? I just went into the kitchen, shut the door and the lock was off, strange.


There is a key (usually the dry key) that needs to be held for 4 seconds to turn the child lock on or off. If it comes on again try holding this key for 4 seconds.If it was pressed and held by mistake this could cause the lock to activate ... Kenmore Dishwashers

I have a kenmore ultra wash dishwasher mdl nbr 665.1304 that wont close. the lock appears to be stuck but the door is open and i cant get it to close. any help would be appreciated. i am a single m


... Kenmore Dishwashers

I have a Kenmore Ultra Wash built-in Diswasher. The flap on the detergent door does not open as it should during wash cycle. Also, I thought the rinse aid was empty so I went to fill it and its obvious that it has not been dispensing either. Otherwise the dishwaser seems to work ok, but we have hard water & I've tried everything and still have residue on dishes.


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks for using FixYa. First of all please check the\015\012Water temperature by using a thermometer inside the dishwasher to measure ... Kenmore PRO 24 in BuiltIn Dishwasher with Ultra Wash HE Filtration 13173

Dishwasher Kenmore Ultra Wash model #1777990 the 2 hour delay light is on and when I try to cancel the door lock button starts flashing I hit cancel and open the door and shut it and the 2 hour delaay button cmes on and will not go off. Is there a reset button anywhere.


... Dishwashers

Item: Whirlpool Ultra Dishwasher Age: 3 yrs Problem: Not enough water to effectively wash the dishes. State: When the dishwasher is started, the fill valve opens as normal. Only about 1/2 the amount of water is let in when the pump turns on and the washing cycle begins. Opening the door shows that the water level does not reach the bottom of the float. When I close the door, the wash cycle begins again but stops after a few seconds. This is when the water begins to fill again. This time, the wat


Larry,The float is generally for overflow conditions and will interrupt power to the fill valve solenoid. If you are not filling completely in the time allowed by the timer, it is most likely a flow restriction in the water ... Whirlpool GU2400XTP Built-in Dishwasher

I have a kenmore elite smart ultra wash that used to be pretty quiet then got noisier and now it cycled thru very slowly but did not clean anything. the door for the detergent opened and the tablet dissolved but i dont think any water was used. both swing arms seem to be free and spin. water is going to the unit and it definitly has power.


Do u have hard water is so go to your local hardware and get that solution for it to remove hardwater stains and run it threw your system..it could be cloging up.. ... Kenmore Dishwashers

Control panel not working - Kenmore 24 in. Elite Built-In Dishwasher w/ Ultra Wash Filtration


... Kenmore 24 in. Elite Built-In Dishwasher w/ Ultra Wash Filtration

Cannot get it to turn on - Kenmore 24 in. Elite Built-In Dishwasher w/ Ultra Wash Filtration


... Kenmore 24 in. Elite Built-In Dishwasher w/ Ultra Wash Filtration

Help My Kenmore ultra wash quiet guard 1 dishwasher door will not open. There is power. All the cycles work.


Wow that could be a tough one there is no door lock on a dishwasher only a door latch what happens when you depress the door latch and can you send me a model number so i can pull up the blue prints and see if we can figure out a way to open it try p ... Kenmore 24 in. 15932 Built-in Dishwasher

Kenmore Elite Ultra Wash Dishwasher Model665.1379 leaks out of the front door.


... Kenmore Dishwashers

I have a Sears Kenmore Quiet Guard Standard built-in dishwasher that doesn't dispense the soap during the wash cycle. The soap door opens but the soap cube we use is just laying on the bottom of the tub.


... Kenmore Dishwashers

Kenmore dishwasher My Kenmore dishwasher model 630.16302401 is not successfully completing wash cycle. When I hit "normal" and turn it on, water enters the d/w, and the sprayers (both top and bottom), spray water. Approx. 10 mins. later, the water is drained. At that point, it appears that water never again enters the d/w to complete the wash cycle. In fact, the soap in the dispenser does get released, and the door opens. However, the soap will just run down the inside of the door and pool on th


... Maytag Dishwashers

Kenmore elite ultra wash dishwasher mode 665.13972K014 door will not latch


... Kenmore Dishwashers

Door squeaks when opening and closing on my kenmore ultra wash dishwasher


WD40 spray ... Dishwashers

Detergent door on my Kenmore Elite Stainless Steel dishwasher will not open during the wash cycle.


\012Hi,\012\012There\012are three common problems that cause the Soap Dispenser or Cup not to\012open. I have a tip that will explain these problems in\012detail....Dishwasher Repair Problem ... Kenmore Dishwashers

Soap dipenser My whirlpool built-in dishwasher model DU930PWPB0 serial # FR4104078. The door to the soap dispenser will not open. I have been washing the dishes with the door open all the time. When I close it(door) it won't pop open when it should. to dispense the soap in the wash cycle.


Try this... Wipe out the soap dish with white vinegar and a soft cloth.. make sure you get everything off the edges of the door and look for any nicks, blemishes or deformation of the dispenser door to make sure it is not mechanically binding up when ... Whirlpool 24 in. DU930PWP Built-in Dishwasher

We recently installed a Kenmore dishwasher, Mfr Model# 13943. We have used the dishwasher approximately six times since Thanksgiving. Each time, after the wash cycle is complete, when we open the door, water has collected on the interior of the door, and water remains standing on some of the washed dishes. Is this normal?


... Kenmore Dishwashers

Kenmore elite dishwasher runs until it is manually shut off by opening the door? My Kenmore Elite runs continuously until I manually drain (cancel) the cycle. Then I have to rewash with no soap to simulate the rinse and again manually drain (cancel) the cycle. This was a $650 dishwasher. I am not sure how to reset the controller or even trouble shoot for an error code. Any suggestions?


It appears your timer/main controller/CCU has failed in this instance.For replacement parts - head on over to PartSelect.com or RepairClinic.com and enter in your full model number for a full parts listing.I recommend both sites bec ... Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher

Cranky dishwasher I have to admit my wife's solution is the only one that works. Our ten-year-old Superba built-in usually starts a normal cycle part-way through, at the wash part, without filling or opening the dispenser door. Therefore the dishes come out with the soil now baked on. Closing the door, selecting normal and start results in a pump-out sound, or at least just the pump running to wash the dishes. The dishwasher ignores any cancel button push,and the light does not come on over t


You want to make sure that the dishwasher is level and secure first of all. Then I would look into the door latch assy. Sounds to me that you are not making all the latch switches when closing normally. When you are slamming it, you are making the s ... KitchenAid KUDS24SE Built-in Dishwasher

Kitchen Aid Dishwasher KUDS03ST We built our house and had this dishwasher sitting in the box for almost 2 yrs before finally using it. After finally installing it I find that occasionally the door to the soap does not open for washing as I find out when the dishes are supposed to be clean and I open the door to hear the soap then pop out of the dispenser. How do I fix this problem?


I have seen a lot of dishwashers that have this problem if they have a flip open lid for the soap .. often its caused by the top adjustable tray blocking the soap door from opening .. i put a camera inside to figure out what was happening ..in some ... KitchenAid Architect? II U SERIES KUDS03ST Stainless Steel Built-in Dishwasher

Dishwasher hums I have a 2003 Kenmore Elite Ultra Wash Dishwasher model #665.17469300. I started the wash today. The water came in the unit and started washing then I heard it stop and it just started making a humming noise. I was afraid it was going to overheat or something so I cancelled the washed and it drained out. I started the unit up on a different cycle and the water came in the unit but did not wash it just hummed so I cancelled and drained it again. I did that on all cycles and the sa


... Kenmore Dishwashers

Kenmore Elite Ultra Wash Dishwasher 665 1343 leaks intermittently from bottom of control panel


... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.2802 seconds