Having problems with your Kenmore Elite Stainless Steel 24" BuiltIn Dishwasher with TurboZone Rotating Spray Jets 13103 ?

There is not enough water pressure to properly operate. (House pressure is unchanged..)


Answers :

Make sure you have the appropriate size inlet water line. if it is to small it won't provide the necessary amount of water. This is usually the problem, you may have a pump issue, but check the inlet line size first
Repair Help & Product Troubleshooting for Kenmore Elite Stainless Steel 24" BuiltIn Dishwasher with TurboZone Rotating Spray Jets 13103

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

There is not enough water pressure to properly operate. (House pressure is unchanged..)


Make sure you have the appropriate size inlet water line. if it is to small it won't provide the necessary amount of water. This is usually the problem, you may have a pump issue, but check the inlet line size first ... Kenmore Elite Stainless Steel 24" BuiltIn Dishwasher with TurboZone Rotating Spray Jets 13103

Have a LG model LD-14AW2 dishwasher which has done good service for many years However, it now sems not to have enough water pressure to operate all the rotary sprayers at the one time - thereby not cleaning properly Have purchased a manual and raken the whole machine apart looking for a partial blockage of the water ways - non found - all looks perfect - still no water pressure I would suspect the pump - however, would have thought a pump either gave full service or stopped - not parti


Hi The issue seems to be with the float switch assembly that is bad and should be replaced. Float assembly is found inside the dishwasher's tub, on the bottom. The water that ... Dishwashers

I have an shx65905uc bosch dishwasher that runs and works except for that there is not enough water pressure to rotate the top wand or operate the top sprinkler. The bottom wand does have water and turn and does the top but it is not enough to turn it. If i remove the bottom wand and plug it off then the top will work properly. I have cleaned all screens and removed the plate to access the pump and all seems fine. Any Thoughts


... Bosch SHX65P05UC Dishwasher

I have a kitchenaid Model KUDW03CTBL2 dishwasher. It is pumping water, but the top sprayer and the one under the top rack just have a little water coming out. Not enough to make them spin. We also noticed the water in the bottom when opened is not as much and it is cool not hot. The dishes on the top rack will not clean, and the bottom is not completely clean. We have checked water pressure and water tempurature through the house, All is operating fine. This dishwasher is only 1 year and 10month


... KitchenAid Dishwashers

D63 continually empties. is there a bypass valve on the pump, as although water is coming in, (and being pumped out the drain hose), there is also a jet coming back into the filter housing, so the arms don't have enough pressure to spin above about 6 rpm! The time switch appears to be operating correctly.


Flame sensor is dirty or faulty ... Indesit 24 in. D63S Free-standing Dishwasher

My Kenmore Elite dishwasher doesn't wash dishes properly. I think that it is not getting enough water in the machine. It only allows about an inch of water to get into machine and then starts. I do not think that there is enough water to spin wash arms. I have 40 PSI coming into the house. I am on well water and found debris in the intake orfice. I did my best to flush. Could it still be bad?


I am having the same problem with my brand new Dishwasher. ... Kenmore Dishwashers

Hi, I have a 3 year old Nemo F&P dishwasher which turns itself on and off for about 3 seconds each on/off continually.Eventually it does get enough water to wash but never goes into the wash cycle properly, ie the water just sits at the bottom. We dont think it's water pressure and it was working fine until recently.Could it be an electrical problem with the signal to fill properly not getting through? Thanks


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks for using FixYa. If the cycle doesn't\015\012complete, then the first thing ... Fisher and Paykel Dishwashers

It does not seem that my dishwasher arms are putting out enough water pressure. the top arm does not spin at all the water just spits out of them. my water pressure has not changed in the house and it does this with nothing loaded in it.


Sounds like the water pump is clogged,remove hose and **** out with shop vac,thanks-mike ... Kenmore Dishwashers

Asko model 1503 upper spray arm is not cleaning dishes properly ,have cleaned spray holes makes no difference it seems that not enough water is there to wash properly have adjusted water pressure to 80 seconds but still no good any suggestions


... Dishwashers

The pump doesn't seem to put out enough water pressure to turn the various revolving heads/nozzles in the washer - all washing heads are operable (ie unblocked) while the S shaped nozzle at the base and the small round nozzle at the top/ceiling of the cabinet do revolve slightly or slowly - but the two main nozzles spout water but not enough to revolve Is this a defective pump or a partially blocked pump ? - or something else - I have checked everything else and they appear to be functioning


It will be helpful to know the make and model number of the dishwasher to diagnose the problem you have.\015\012\015\012Generally this is attributed to a blocked chopper assembly in the wash circuit but hard to be sure if your model has o ... Dishwashers

Dishes don't get very clean. Especially anything oily or greasy. I don't think the water hot enough or the pressure isn't good. House water pressure is fine. Using gel soap.


If they have a residue or spots the problem is hard water. www.dishwasherfilter.com has a product to solve this problem once and for all. It filters the water going into ... Dishwashers

I just bought a used Kenmore standalone dishwasher and ran it for the first time. The dishes on the top did not get clean and the soap did not come out of the closed soup dish. at one point I took a shower and was wondering if that might have influenced the water pressure enough to cause the problem. Is the soap supposed to open during the wash and could the poor water pressure prevent the top shelf from getting properly washed?


The inlet filter is probably clogged. Try letting it fill up. Open the door to stop it right after it starts to wash Pour a gallon or two of hot water in and see it it works better Stop and do this everytime it goes to fill up. If the door opens ... Dishwashers

Inglis MOD#IPU58460 Dishes not cleaned properly...thought that enough water was not being filled into tub because more water added manually and washes great! I checked inlet water valve operation and lines for possible lime buildup and timed "fill" time. All was good and time right to spec! Water level after fill is just to bottom of mesh screens. Under further trouble shooting I held door open slightly while holding door switch closed to observe wash cycle and found as pump starts water shoots


The sprayer arm may be clogged with debris.Here's a step-by-step troubleshooting guide. ... Dishwashers

Hi threr I have the following problem with my Haier DW12-EFM dishwasher: The dishwasher seems to operate properly for the first several minutes untill program selector knob stops betwin position 2 and 3. After I turn it manually it keeps on turning and than it stops again after I turn it again it operates till the end of the program but the dishes are not clean enough to be used. I also noticed that the heater does not operate (water is cold). Do you know wht the problem might be. Reg


... Haier 24 in. ESD100 Built-in Dishwasher

Not enough water entering dishwasher even though house pressure is good.


... Bosch 24 in. SHX46A05 Stainless Steel Built-in Dishwasher

My kenmore 665.1384 is not cleaning well. There seems to be not enough water coming through as soap remains in the cup after it completes. It is not a new installation, water is hot and pressure is good and it does drain properly,


Found repair video on handyman website ... Kenmore Dishwashers

Whirlpool adp 8540 dishwasher not washing properly. Not getting enough water pressure to spin the arms or even take the granules out of the wash powder compartment. Have checked hoses and water supply all Ok. Is is something simple that can fix myself or do I have to call an expensive repairer?


... Whirlpool Dishwashers

Whirlpool adp 8540 dishwasher not washing properly. Not getting enough water pressure to spin the arms or even take the granules out of the wash powder compartment. Have checked hoses and water supply all Ok. Is is something simple that can fix myself or do I have to call an expensive repairer? L


I have had the same problem, for me it was caused by small pieces of food, normally woody grains, it blocks the outer jets.\015\012\015\012When looking you may not see that it is blocked because they seem to move around.\015\012 ... Dishwashers

Arm does not spin. Water trickles out of holes in arm under what appears to be normal house water pressure. Drains out properly. Dishwasher is 5 years old.


Check inlet strainer & water pump in the machine. ... Bosch 24 in. SHY56A05 Stainless Steel Built-In Dishwasher

Hobart FX30E Not enough water pressure when washing


... Hobart Dishwashers

Not cleaning dishes especiialy the ones on top rack. Found some broken glass pieces in bottom. No obstructions in line leading up to top washer. It looks like the pump is not pumping enough water pressure and/or volume for the top washer to function properly. Please help. Whirlpool Quiet Parnter I. Approx. 2-3years old.


If you remove the filter in the sump area underneath the lower dish rack (removing the screws to do so) you may find debris blocking/jaming the impeller area. Be very careful of almist invisible broken glass. Inspect the impeller to make sure it is ... Dishwashers

I installed a whole house water filter and now my aqua booster is not working properly . It will not stop at the old setting of 60 pounds of pressure. How can I correct this?


... Pressure Washers

I have a problem with my Sears 18" dishwasher. It doesn't get enough water pressure to properly clean the dishes. Should I call an appliance repair person or a plumber?


Hi,\015\012You need to cal an appliance repair professional...the dishwasher fills from the house plumbing, but if it is not washing right that is an internal problen with the dishwasher....probably there is stuff in the pump or the pump is goi ... Kenmore 18 in. 14432 / 14439 Built-in Dishwasher

The bottom rack is not cleaning properly. Its as if the water pressure is not enough to wash the plates clean.


Ensure that forks or other cuttlery is not poking out the bottom of the basket and obstructing the lower wash arm.Check to see that the lower arm is receiving water(and not blocked) to do this empty the machine and put a plastic bag around the ... LG Dishwashers

I have a model du1145XTPQ dishwasher. I doesn't seem to fill with enough water so I have to add with every cycle. The repairman says that there is no filter and my water pressure wasn't high enough. The water company was out and said water pressure was at 75pounds and that was not my problem. Is there a filter somewhere that might be cloged? thanks


The dishwasher has a float switch which detects if the dishwasher is filled. If the travel of the float is not sufficient it may be triggering early and causing the inlet valve to shut. Also see page 21 in the ... Whirlpool 24 in. DU1148XTP Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1610 seconds