Having problems with your Kenmore Elite Stainless Steel 24" BuiltIn Dishwasher with TurboZone Rotating Spray Jets 13103 ?

How to replace a motor on kenmore dishwasher 587.15233900


Answers :

Repair Help & Product Troubleshooting for Kenmore Elite Stainless Steel 24" BuiltIn Dishwasher with TurboZone Rotating Spray Jets 13103

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have a not quite 2 year old Kenmore dishwasher model #665.1322.(I believe built by Whirlpool) The motor has burnt out. That seems ridiculous to me when there is just my husband & I using it and I've had dishwashers in the past that have lasted 10 - 15 years. Anyways - we have no warranty so we thought we would try to replace th motor - but I can't find anything online. We live in south western Ontario - any suggestions of where we could find a replacement motor?


I have recently had the same problem with the same model. Do you think there's a connection? I'm going to report this to Consumer Reports. ... Kenmore Dishwashers

I have a Kenmore Dishwasher Model #665.168790000 and the water fills just fine and empties fine when cancelling cycle but when pressing any wash cycle the pump/motor just makes a loud humming noise and does nothing. I took apoart the lower assemblies to clean everything out but the problem hasn't gone away. Do I need to replace the motor or the whole motor assembly (also contains impeller kit)??? Also, I don't think I need to replace the whole sump & motor assembly do I???


... Kenmore Dishwashers

Kenmore Dishwasher Model #110703412 leaks, likely around the motor shaft. Are there motor shafts seals and how are they replaced? Does the motor assembly remove through the tub or does it require being removed from the bottom? Do you have to remove the dishwasher from the cabinet to do this job?


... Kenmore Dishwashers

Have a Kenmore Elite Dishwasher (66513123K701). Was not cleaning dishes very well so we ran diagnostics on it and found a problem with the diverter motor (W10155344) so we replaced it. Now, the dishwasher is leaking from the diverter. There was a o-ring from the original diverter that we had to keep since the new motor did not come with it. Wondering if we should get a new o-ring/seal, but I cannot find mention of such a part anywhere. Is there a certain way to seat the o-ring? Is it ok to


I have experienced the same diverter motor leaking problems. I have the whirlpool gold with the diverter motor (w10155344). I bought the unit new 4 years ago. The fix is remove the the two screws that hold the diverter motor and pull the motor. ... Kenmore Elite Stainless Steel 24" BuiltIn Dishwasher with TurboZone Rotating Spray Jets 13103

I HAVE A 8 YEAR OLD KENMORE ELITE (WHIRLPOOL) DISHWASHER . THE THERMAL FUSE BLEW AND I REPLACED IT AND THE MAIN CIRCUIT BOARD. NOW THE UNIT APPEARS STUCK IN CANCEL 2 MINUTE CANCEL/ DRAIN/MODE AND THE RELAY CLICKS ON AND OFF TO THE DRAIN MOTOR. I HAVE BENCH TESTED THE DRAIN MOTOR AND IT WORKS FINE WHEN IPT 120VOLTS DIRECT TO IT ANY SUGGESTIONS . WHAT AMPERAGE SHOUD DRAIN MOTOR DRAW?


Hi\015\012\015\012\015\012The drain motor is of 120 V, 50-60Hz and 0.6 amp rating. Dishwasher not draining issue usually occurs due to kinked drain pipe, clogged drain filter or drain pump. Check the drain hose for any visibl ... Whirlpool Dishwashers

I have a Kenmore Elite dishwasher model number 665.16483300. The motor is very loud and have been told by a technician that it needs to be replaced. I am looking for a service manual that may allow me to replace it myself at a fraction of the cost. Is this too difficult a task for a "Do it Yourselfer"?


THE DISHWASHER is no doing good, foot soil left on dishes, I alreary check water temperature 50 F, I clean inside, the pressure at the water supply is good 50psi. and the machine it sound quiet, Is the pump no working right?? is derty inside?? ... Dishwashers

How to replace motor kenmore elite dishwasher 15962990


Youtube teaches all. try it. ... Dishwashers

KUDSo1Ijbs1 dishwasher stopped cleaning. Counter continued to 0. Tech came to house said I needed new motor, which I did replace and still won't clean. Soap dispenses, but does not dislove. Last t


... KitchenAid Kitchen Aid Diswasher Part 4171958 Timer

How to replace a motor on kenmore dishwasher 587.15233900


... Kenmore Elite Stainless Steel 24" BuiltIn Dishwasher with TurboZone Rotating Spray Jets 13103

How do i remove the impeller from my kenmore dishwasher motor in order to replace the seal? it is leaking.


... Kenmore Dishwashers

Drain pump motor overheating on Kenmore dishwasher,model#665139223K014.Motor replaced but problem is still there. Rene


How do you know it is OVERheating? Those pump are "designed" to run hot, but if it is getting so hot that the wires that go to it are melting, then that is too hot. Make sure your drain hose is clear, so the drain pump doesn't have to run aln longe ... Kenmore Dishwashers

I have a kenmore dishwasher 665.16872 and does not drain , i replaced drain motor still wont drain


... Kenmore 16872 Built-in Dishwasher

Kenmore dishwasher model 363 leaking from tub bottom, motor-pump mechanism. What part should be replaced?


... Kenmore Dishwashers

Need to replace motor on Kenmore Elite dishwasher, model 665.1605


... Kenmore Dishwashers

A Kenmore dishwasher, model#66513743K603 will wash okay until it drains after cycle that dispenses detergent. Then it takes in half amount of water, wash motor short cycles & then drains.Next cycle works okay. Main control board was replaced but problem wasn,t solved. Rene


... Kenmore Dishwashers

I had to replace the chopper in my dishwasher. It is a kenmore. I had to unhook the wire from the motor and 2 sensors. I don't know if I have them hooked up correctly or in reverse. HELP!!


... Kenmore Dishwashers

Dishwasher is model DWD1SSE type11045 Initially the dishwasher leaked water on the floor On investigation the bottom tray under the dishwasher was wet The motor was wet Tested the motor which was fine although the capacitor on the motor impellor was dead. Replaced capacitor, now no water going around the spray heads so found the impellor inside broken. Replaced that. No hoses are leaking. Machine now works fine heats up etc etc but over fills and the E5 fault shows


... Smeg 24 in. DWD1SSE-1 Built-in Dishwasher

I have a problem that appears to be a bad motor on a Whirlpool dishwasher. The motor costs $300 and the dishwasher is about 6 years old...Does it make sense to replace the motor or just replace the whirlpool diswasher (18 in unit = $600 new)...your thoughts?


Hello, W/D here.I try to work replacement vs. repair like this:If the cost of repair is greater than 50% of replacement, I always go for the replacement. My reasoning is that the remainder of the appliance is more likely to develop fault ... Dishwashers

Problem for Kenmore 24 in. 15992 Built-in Dishwasher Previously answered by Ginko but have not had any responses since June 18 and problem not solved. No water flow into dishwasher. Actual model is Kenmore Elite undercounter dishwasher 665.15982990. Float is not stuck. Worked fine for 10 years until mid May. Display shows cycle is on and counting, for all the different cycles. No valve or motor sound when starting cycles, only a single electronic click. When cycle is canceled, motor does s


Hi.Sorry about your old query.If there is no power on black wire and no filling, then check and eventually replace the thermal fuse. The thermal fuse is attached to control board. If it is faulty it will read continuity, norma ... Kenmore 24 in. 15992 Built-in Dishwasher

If motor needs replacement, is it better to get a NEW dishwasher?


Replacement usually costs about 250.00-450.00 usually.. you can look at partsdirect.com or repairclinic.com for the parts.. both even dive you a schematic so you can see how they both go together ... Neff 24 in. S5443X2 Built-in Dishwasher

I have a Kenmore Elite Dishwasher about 7... Problem with the Kenmore Dishwashers I have a Kenmore Elite Dishwasher about 7 years old. The Model # is 665-16462300. It works beautifully, except that about every 2 months the spray flow intensity ( and the cleanliness of the dishes) drops significantly. The cause is the metal screen located just upstream from the sump is clogged with food particles. I have taken apart the dishwasher several times to remove, clean and replace the screen. This fix wo


Check the inlet hoses; if the catch screens have sediment build up, that will reduce the pressure of the rinse water. Also, look for missing plugs on the rinse arms... ... Kenmore 24 in. 16462 / 16464 / 16469 Built-in Dishwasher

I am replacing a frigidaire dishwasher washmotor. Everyone and videos tell me how to replace the motor. In the instructions in the box they say replace the sump bottom also. Why would i have to replace the sump also and not just the new motor?


Hello, chris\012 \012 I was trying to help\012 you out here. I was going back to some customers that asked questions \012in the past and it appeared that no one answered them, so I thought I \012would take some ... Amana ADB1400AWB Dishwashers

We getting the error message LE on the dishwaser model #LDF6810ST. The repair Official repair man that came out to supposedly fix the dishwasher called LG to find out what was wrong with it and they told him to tell us that we need to replace the motor and wiring harness and the Technician told us to order the "motor and wiring harness" charged us $100 and left and the dishwasher that is only 2 years old and we paid a little over $800 for is still broke. Now when trying to order the "motor and w


Motor assy pn# 4681ED1004A is the motor you will need. ... LG Dishwashers

I have a fisher & Pakel dishwasher and it appears to have brown a fuse inside the machine which means it does not work at all and the problem occurred during the wash cycle. This means the seal (which is a top piece that's lifted and lowered by two motors. When the seal is in the lowered position it creates a complete seal but it also locks the drawer (single drawer dishwasher) so it cannot be pulled out. I repaired the dishwasher two years ago. One of the lifter motors didn't work. I replaced t


According to the service manual there is no problem in manually forcing open the drawer in the situation where the power has failed part way through the diswasher cycle.\015\012\015\012The problem is that once you force the lid open, you ... Fisher and Paykel Dishwashers

I have a Kenmore Ultra Wash Dishwasher model 665.16379301. The spinner from the top of the dishwasher has come off. I have a replacement part but need to know what is required to replace it. Do I need to remove the feed tube assembly in order to replace it?


... Kenmore Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1967 seconds